Code of Practice on Management of Contractors Working in B & C Sector. Abu Dhabi EHSMS Regulatory Framework



Similar documents
Abu Dhabi EHSMS Regulatory Framework (AD EHSMS RF)

Construction and Civil Work Management

Management of Health and Safety for Work and Services Contractors Policy June 2010

Occupational Health and Safety Management Framework Abu Dhabi An Overview of Requirements

Procedure. Work Health and Safety Contractor Management. Document number: PRO Rev no. Description Process Owner Approved for issue

Procedure. Work Health and Safety General construction. Document number: PRO Description Process Owner Approved for issue. Rev no.

Corporate Standard. Contractor Management

OH&S Management Systems Audit Checklist (NAT, E3)

WHS CONTRACTOR MANAGEMENT PROCEDURE

Corporate Standard. Contractor Management

WHS Contractor Management Procedure

OH&S MANAGEMENT SYSTEM CHECKLIST - AS 4801:2001 (STATUS A = Acceptable; N = Not Acceptable; N/A = Not Applicable)

Abu Dhabi EHSMS Regulatory Framework (AD EHSMS RF)

AFTRS Health and Safety Risk Management Policy

INTRODUCTION Purpose Policy Exception for Short-Term Workplace Visits Relevant Legislation and Regulations...

Vendor Management Program

CONTRACTOR SAFETY MANAGEMENT PROGRAM

CONTRACTOR SAFETY MANAGEMENT PROCEDURE

ENVIRONMENTAL POLICY & MANAGEMENT SYSTEM GUIDE

May Duke Energy EHSMS Manual. Environmental, Health and Safety Management System Manual

Excavation & Trenching Procedure

Contractor Safety Program Office of Environmental Health and Safety University of Toronto

Contractor Environment, Health and Safety Management Plan

Introduction to SOP. Background. Background. Principles of SOP Act. Objectives of SOP Act

WORKPLACE HEALTH AND SAFETY AUDITING GUIDELINES

Management of Contractors and Suppliers Procedure

Guide Document for Development of WHS Management Plans

Health and Safety Policy and Procedures

CCF Systems Gap Analysis Checklist. Civil Contractors Federation. Civil Construction Management Code

Procedure: OHS CONTRACTOR MANAGEMENT

Supplier Environmental Health and Safety Certification

Work Health & Safety Policy Document Number: WH&S Ver 1

ENVIRONMENTAL, HEALTH & SAFETY MANAGEMENT SYSTEMS MANUAL

Health and safety policy

Bawden Contracting Services Ltd Job Profile. Contracts Manager. Purpose of the Job

ASTRAZENECA GLOBAL POLICY SAFETY, HEALTH AND ENVIRONMENT (SHE)

WORK HEALTH AND SAFETY

Accident/Incident Investigation & Reporting Procedure

Regulations on the obligation to provide information, the obligation to ensure compliance, and the right of inspection

Health and safety in construction procurement

Health and Safety Management Standards

Hastings Borough Council

Corporate Health and Safety Policy

The Fort McMurray Catholic Board of Education is committed to the protection of our employees, contractors, volunteers and the students we serve.

SUPPLY CHAIN PREQUALIFICATION PACKAGE

QUALITY MANAGEMENT PLAN

EH&S STANDARD PRACTICE SP-010 CONTRACTOR ENVIRONMENT, HEALTH AND SAFETY PROGRAM

H-0123 Contractor Safety Program

Asbestos Policy ASBESTOS POLICY. Version 2 / Jun 2015 Page 1 of 11 Asbestos Policy

Global Health & Safety Policy and Management Standards

This is Document Schedule 5 Part 1 referred to in this Contract SCOTTISH MINISTERS REQUIREMENTS SCHEDULE 5 PART 1 QUALITY MANAGEMENT SYSTEM

Health and Safety Policy Part 1 Policy and organisation

OHS Contractor Management Procedure

REPORT 4 FOR DECISION. This report will be considered in public

Managing health and safety in construction

R000. Revision Summary Revision Number Date Description of Revisions R000 Feb. 18, 2011 Initial issue of the document.

The following paragraphs, identified to coincide with the OHSAS 18001:2007 numbering system, provide a clause-by-clause summary of the standard.

USACE NAVFAC Sample QA/QC Plan 20 selected pages (out of )

Contractor Safety Management

Contractor. Management

Health, Safety and Environment Management System

Owner-User Pressure Equipment Integrity Management Requirements

BLOOM AND WAKE (ELECTRICAL CONTRACTORS) LIMITED QUALITY ASSURANCE MANUAL

For the Provision of animal collection and impound services.

This AGREEMENT made the... day of... between the HUNTER WATER CORPORATION (hereinafter called the Corporation ) and ...

Jonathan Wilson. Sector Manager (Health & Safety)

CONTROL OF POLLUTION ACT 1974, SECTION 61 PRIOR CONSENT APPLICATION CONSTRUCTION AND DEMOLITION SITE NOISE

Abu Dhabi EHSMS Regulatory Framework (AD EHSMS RF)

Dutch Labour Standards Foundation The Standard for reliability. Information set about Standard NEN 4400 and the Labour Standards Register

Middle East Region. Atkins minimum requirements for construction safety

AS/NZS 4801:2001. Safety Management Systems (SMS) Self-Assessment Checklist. Revision 1 (January 2014)

Facilities Division Integrated Safety Management Plan March 16, 2006

Release 1. BSBWHS508A Manage WHS hazards associated with plant

Project & Task Work Health and Safety Risk Management Procedure

OHSMS Implementation Guide

Introduction to Social Compliance & Its Business Benefits

The anglo american Safety way. Safety Management System Standards

1500 Post Road Anchorage, AK DUNS Number Phone Fax GSA Contract Number GS-10F-0018V

ISLINGTON & SHOREDITCH HOUSING ASSOCIATION JOB DESCRIPTION. Operations. Operations Director

Work Breakdown Structure Element Dictionary Construction

Corporate Health and Safety Policy

Title: Rio Tinto management system

A guide to appointing an architect

Classification: SAFETY PROGRAM. Accountabilities

HEALTH, SAFETY AND WELFARE POLICY HSM010

Managing Occupational Health and Safety on Queensland Government Building Projects A Management Systems Approach D Evans

Policy for the Management of Asbestos in Council Premises (Corporate and Housing)

ISO & ISO Legal Compliance Know Your Risk - Reduce your Risk"

Abu Dhabi EHSMS Regulatory Framework (AD EHSMS RF)

GUIDE TO IMPLEMENTING A REGULATORY FOOD SAFETY AUDITOR SYSTEM

Request for Proposal

Environment of Care Safety Management Plan

8.0 ENVIRONMENTAL PROTECTION MONITORING AND FOLLOW-UP

HEALTH AND SAFETY POLICY AND PROCEDURES

STATE OF NEVADA Department of Administration Division of Human Resource Management CLASS SPECIFICATION

WHS Inspector. This is a re-advertised position. Closing date Wednesday 06 June 2012 at 11.00pm (Australian Western Standard Time)

Preparation for ISO OH&S Management Systems

Health and Safety Activity Checklist

The Role of Construction Managers. FIDIC offers two contributions on the question of the role of a construction manager in a construction contract:

Transcription:

Code of Practice on Management of Contractors Working in B & C Sector Abu Dhabi EHSMS Regulatory Framework 28-30 March, 2011

Aims: Guidelines for sectors and nominated entities for the management of contractors/subcontractors in Abu Dhabi Emirate Systematic approach Focal point of responsibility on sites with multiple Contractors/Subcontractors Specific requirements for B & C Sector in relation to construction Contractors hierarchy for reporting, control and monitoring of multiple contractors/subcontractors on construction projects/development

Definition of Contractor/Subcontractor A person, an organization, their employees or a nominated representative engaged to carry out work for the Developer

Definition of an Entity Every Client / developer, Consultant, contractor, and Supplier for the B&C Sector Regulatory Authority Projects is considered as an entity Definition of a Nominated Entity An entity that has been selected by a relevant SRA that is required to develop and implement an EHSMS in compliance to the AD EHSMS RF, based on EHS hazards and risks

Management of contractor process Nominated Entities shall implement the following contractor management process: Establishment of Project EHS requirements Evaluation/Selection Contractual Agreement Co-ordination and Communication Mobilization/Work in progress Monitor Performance Commissioning Demobilization/Decommissioning Contract Close-out

Appointment of Principal contractor process Definition of Construction Work Definition of Developer/Client for Construction Work Definition of Project Manager/Client Representative/Supervising Consultant/Resident Engineer for Construction Work Definition of Principal Contractor for Construction Work Requirement for the Appointment of a principal Contractor

Definition of construction work Construction work includes: Work to erect, construct, extend, alter, convert, fit-out, commission, renovate, repair, refurbish, disassemble, demolish and/or decommission a structure/building/services infrastructure Work connected with site preparation, earthworks, land reclamation, excavation, piling, provision of services infrastructure, or part of a structure/building /services infrastructure or landscaping for work mentioned above Assembly or installation of prefabricated components to form a structure/building/services infrastructure for work mentioned above Disassembly of prefabricated components for work mentioned above

Definition of Developer/Client for Construction Work Developer/Client is the person/entity who finances and/or commissions the construction work and: May engage a Project Manager/Client Representative/Supervising Consultant/Resident Engineer to plan, manage and monitor the project on their behalf May appoint a Principal Contractor to manage, supervise and perform the construction work

Definition of Project Manager/Client Representative/Supervising Consultant/Resident Engineer Entity appointed by the Developer/Client to carry out the management, planning and monitoring of the construction work on their behalf If the Developer/Client fails to appoint a Project Manager/Client Representative/Supervising Consultant/Resident Engineer to the workplace the Developer /Client is taken to be the Project Manager/Client Representative /Supervising Consultant/Resident Engineer

Definition of Principal Contractor Entity appointed by the Developer/Client to manage, supervise and perform the work, including overall control of the site and subcontractors If the Developer/Client fails to appoint a Principal Contractor the Developer/Client is taken to be the Principal Contractor

Requirement for the Appointment of a principal Contractor Developer/Client shall obtain the relevant approval/permit/license/no objection from the relevant authorities Developer/Client shall appoint a Principal Contractor if: Construction work will take 30 days or longer Construction work will take less than 30 days but SRA understand the project involve sufficient hazards and risks for the appointment of a Principal Contractor

Typical Workplace Hierarchy Developer/Client (Supervisory Role Ultimate Responsibility) Project Manager/Client Representative/Supervising Consultant/Resident Engineer (Supervisory Role on Behalf of Developer/Client) Principal Contractor (Active Role Primary Responsibility) Non-Nominated Sub-contractor Non-Nominated Sub-contractor Nominated Sub-contractor Nominated Sub-contractor Non-Nominated Sub-contractor Nominated Sub-contractor

Obligation of key stakeholders Competent Authority EHS Centre B & C Sector Regulatory Authority (DMA/WRM/AAM/ADM) Developer/Client Project Manager/Client Representative/Supervising Consultant/Resident Engineer Principal Contractor Sub-Contractor

Obligation of the Competent Authority Monitoring the implementation of the principal contractor process and mechanism by the Building and Construction Sector Regulatory Authority

Obligations of the Building and Construction Sector Regulatory Authority The B & C SRA shall ensure implementation, monitoring and enforcement of the principal contractor process and mechanism by: ensuring all relevant requirements of the AD EHSMS are met as part of the approval process, reviewing the submissions by clients / developers to ensure appropriate entities have been selected as principal contractor maintaining a register of project / developer appointed principal contractors monitoring compliance to this code of practice; and enforcement including penalties for non-compliance If the developer / client is an individual (e.g. Building a personal villa), the B & C SRA shall provide appropriate mechanisms to ensure the appointment of principal contractor process is implemented

Obligations of the Developer / Client Responsible for ensuring compliance to all EHS legislative requirements. Appoint a principal contractor Ensure that the PM and PC are competent and have adequate EHS resources Obtain all relevant licenses, permits, non-objection certificates from all relevant government agencies Ensure prior to any work commencing, PC has developed a CEHSP which has been approved by B&C SRA Consult with Designer, PM and PC so as to minimize EHS risks Conduct EHS inspection and audits

Obligations of the Project Manager / Client Representative / Supervising Consultant / Resident Engineer Ensure work is planned and managed in a way that prevents or minimizes EHS risk Participate in all EHS activities Notify principal contractor of all hazards and non-compliances Monitor and coordinate all EHS aspects during the design process ensuring that risks and hazards are reduced to as low as reasonably practicable Monitoring & auditing the principal contractor and sub-contractor to ensure compliance to all regulatory and EHS requirements Report non-conformance by the principal contractor and/or sub-contractor to the developer / client

Obligations of the Principal Contractors Plan, coordinate, supervise and oversee construction and demolition work to prevent or minimize EHS risks Develop and implement project specific construction/demolition EHS plan Consult and communicate with stakeholders on EHS risks Monitor and enforce the compliance to all EHS obligations Investigate all incidents and non-compliances Ensure all appropriate incidents are reported to relevant authorities Protect members of the public from injury or illness caused by work activities at or near the workplace

Obligations of Construction Subcontractors Comply with all provisions of this code of practice and to recognize the important supervisory and coordination role that the appointed principal contractor has been granted on a site where Construction Work is conducted under this code of practice

EHS Performance and Incident Reporting Process Principal contractors to report EHS performance and incident data to SRA for their operations and all construction subcontractors that are not nominated entities All EHS incidents at the workplace shall be reported to the principal contractor If a sub-contractor or project manager is involved in an EHS incident and they are nominated, they are also responsible for reporting the incident to the SRA in their monthly report If a sub-contractor or project manager is involved in an EHS incident and they are not nominated the principal contractor is responsible for reporting the incident to the SRA

Management of Contractors For more info visit: www.ehs.dma.abudhabi.ae For any queries or suggestions please email to: ehs@wrm.abudhabi.ae hse@adm.abudhabi.ae Info.hse@am.ae