DELUXE DIGITAL TIRE INFLATOR OWNER S MANUAL

Similar documents
15GAL STEEL OIL DRAIN WITH 110V PUMP

Mini Pallet Jack OWNER S MANUAL

1000-LB. TRAILER JACK OWNER S MANUAL

National- Spencer Inc.

tire inflator with pressure gauge

8" BENCH GRINDER OWNER'S MANUAL

SBC90. Abrasive Blast Cabinet Assembly & Operating Instructions

Hydraulic Punch Driver Kit

staple gun with 5/16 Long staples

Hand Held Metal Detector

Air vacuum pump with r134a & r12/22

48 INCH PAN AND BRAKE BOX

7 FUNCTION DIGITAL MULTIMETER

TURN TABLES 1.5 TON CAPACITY / 2 PC. Model 45742

MODEL T-4 TRENCHER. Operators Manual

FJ2. 2 Ton Trolley Floor Jack Assembly & Operating Instructions

Auto Feed Screwdriver

Cable Drum Machine. Operation Manual BC260 SERIES. Cleans 1 1/4" to 3" lines up to 50'

Flat Bottom Long Ram Hydraulic Jack

Machine/Woodworking Shop The Basic Rules

7 Watt Solar Charger Solar Panel

ROUTER TABLE INSERT ASSEMBLY AND OPERATING INSTRUCTIONS

8 ton air/hydraulic long ram jack

Notes. Material 1. Tools the employee is expected to operate

Owner s Manual & Safety Instructions

PAINT SPRAY GUN WASHER

PNEUMATIC PLANISHING HAMMER

1 HP MINI DUST COLLECTOR

Owner s Manual & Safety Instructions

Seven function digital multimeter

6 FUNCTION HAMMER DRILL

1 / 4 IN. FFL x 4 FT. 9 IN. 1 / 2 IN. ACME x 4 FT. 9 IN. Gauge Accuracy +/-2% Set includes Quick Disconnect Valves

General Shop Safety. 3. Wear hearing protection devices when using or when others are using loud equipment in the mechanics laboratory.

1 Ton Telescoping Gantry Crane

3/4 PIPE CLAMP WITH STAND

Curtain Guards Made of PVC and designed to protect the operator from the risk of airborne chips or tool fragments.

METAL DETECTOR OWNER S MANUAL

60 WATT LED TRIPLE BEAM WORKLIGHT

Hammer Drill JCB-HD900-2

Machine Guarding and Operator Safety. Leader Guide and Quiz

SUBMERSIBLE SEWAGE PUMP 66119

DIGITAL MINI COMPRESSOR

Mini-led spotlight with magnetic base

COMPRESSED AIR DRYER

12 WATT LED AMBER LIGHT BAR

12V Diesel Transfer Pump

SAFETY AND OPERATING MANUAL

Student Shop Safety Policy GS92 Page 1

Digital Fingerprint safe

PS ARC Welder Assembly & Operating Instructions

Strut Spring Compressor

SAFETY AND OPERATING MANUAL. Cordless rotary hammer WX382 WX382.1 WX382.2 WX382.3

PEDAL CAR - GO CART ASSEMBLY & OPERATING INSTRUCTIONS

AIR HYDRAULIC RIVETER

12 Volt 30 Amp Digital Solar Charge Controller

Hammer Drill HP1630 HP1631 INSTRUCTION MANUAL

HYDRAULIC LIFT TABLE CART 2200-LB.

Table of Contents WARNING SYMBOLS AND DEFINITIONS

Cylinder Leak- Down Tester

Visit our website at: our technical support at:

HYDRAULIC TABLE CART 500-LB.

4 in 1 Air Compressor

section 5 machine guarding and lockout

DUST COLLECTOR 70 GALLON, 2 HP

OPERATOR S MANUAL 18 VOLT, 1 HOUR CHARGER

Tech Shop Safety Level 2 - FN Tech Shop / Tool Safety Operations. (Fermilab machines not covered in course FN000258)

Owner s Manual & Safety Instructions

School of Engineering University of Glasgow

MODEL T200-F18 MODEL T125-F18 Finish Nailers

Owner s Manual & Safety Instructions

Instructions For SF 6 Refill Kit

harbor cub Electric Remote Control Airplane Model assembly & Operating Instructions

PALLET JACK TON

Operating Manual Please Read Before Operating Unit

FACILITY SAFETY SIGNAGE GUIDE: 10 SIGNS TO SPOT DURING A PLANT WALKTHROUGH

OAK WORKBENCH WITH 2 DRAWERS

Keys Master, submaster and valet key Key number Door locks Power door locking switches

Digital Photo Picture Frame. Operation Manual

Air/Hydraulic Bottle Jack

Hot-Shot Operating Instructions

Gen-Eye POD, MINI-POD & X-POD Video Pipe Inspection/Location System Operating Instructions

Blast Gun With Gravity Feed

RT-1261A Ear and Forehead Thermometer Owner s Manual

PENNY IN A CUP: DEMONSTRATING THE LAW OF INERTIA

SAFETY & OPERATING INSTRUCTIONS

Electric Meat Grinder

ENGLISH (Original instructions) INSTRUCTION MANUAL. Hammer Drill HP1640 HP1640F HP1641 HP1641F DOUBLE INSULATION. IMPORTANT: Read Before Using.

Job Hazard/Safety Analysis For the Paint & Finish Worker

lamp post light Set up and Operating Instructions

BLAST CABINET ABRASIVE Rev SAVE THESE INSTRUCTIONS. Important Safety Instructions are included in this manual

AMW. Robert Bosch GmbH Power Tools Division Leinfelden-Echterdingen Germany. F 016 L (2013.

MODEL G300 BRAKE BLEEDER

K-45 Drain Cleaning Machine

HYDRAULIC TABLE CART

Abrasive Wheel Grinder Safety

Job Hazard/Safety Analysis For the Lab Worker

2 HP / 4 GALLON AIR COMPRESSOR OWNER'S MANUAL

GEORGIA INSTITUTE OF TECHNOLOGY ENVIRONMENTAL HEALTH AND SAFETY PERSONAL PROTECTIVE EQUIPMENT

PET-10 INSTRUCTION MANUAL PRESSURE TANK

Ireland Australia New Zealand

Transcription:

DELUXE DIGITAL TIRE INFLATOR OWNER S MANUAL WARNING: Read carefully and understand all ASSEMBLY AND OPERATION INSTRUCTIONS before operating. Failure to follow the safety rules and other basic safety precautions may result in serious personal injury. Model# STF-30DG

Thank you very much for choosing this product! For future reference, please complete the owner s record below: Model: Purchase Date: Save the receipt, warranty and these instructions. It is important that you read the entire manual to become familiar with this product before you begin using it. This machine is designed for certain applications only. TGB cannot be responsible for issues arising from modification. We strongly recommend this machine not be modified and/or used for any application other than that for which it was designed. If you have any questions relative to a particular application, DO NOT use the machine until you have first contacted TGB to determine if it can or should be performed on the product. For technical questions please call 1-952-938-5222. TECHNICAL SPECIFICATIONS Easy to Read LCD Display According to EN12645: 1998 (86/217/EEC) Four Units Choice (PSI, BAR, KPA, KGF) Prolongs Tire Life GENERAL SAFETY RULES WARNING: Read and understand all instructions. Failure to follow all instructions listed below may result in serious injury. CAUTION: Do not allow persons to operate or assemble this digital tire inflator until they have read this manual and have developed a thorough understanding of how the digital tire inflator works. WARNING: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions or situations that could occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator. SAVE THESE INSTRUCTIONS Page 2 of 6

WORK AREA Keep work area clean, free of clutter and well lit. Cluttered and dark work areas can cause accidents. Keep children and bystanders away while operating a digital tire inflator. Distractions can cause you to lose control, so visitors should remain at a safe distance from the work area. Be aware of all power lines, electrical circuits, water pipes and other mechanical hazards in your work area, particularly those hazards below the work surface hidden from the operator s view that may be unintentionally contacted and may cause personal harm or property damage. Be alert of your surroundings. Using a digital tire inflator in confined work areas may put you dangerously close to cutting tools and rotating parts. PERSONAL SAFETY Stay alert, watch what you are doing and use common sense when using a digital tire inflator. Do not use a digital tire inflator while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating a digital tire inflator may result in serious personal injury. Dress properly. Do not wear loose clothing, dangling objects, or jewelry. Keep your hair, clothing and gloves away from moving parts. Loose clothes, jewelry or long hair can be caught in moving parts. Use safety apparel and equipment. Use safety goggles or safety glasses with side shields which comply with current national standards, or when needed, a face shield. Use as dust mask in dusty work conditions. This applies to all persons in the work area. Also use non-skid safety shoes, hardhat, gloves, dust collection systems, and hearing protection when appropriate. DIGITAL TIRE INFLATOR USE AND CARE Do not modify the digital tire inflator in any way. Unauthorized modification may impair the function and/or safety and could affect the life of the equipment. There are specific applications for which the digital tire inflator was designed. Always check of damaged or worn out parts before using the digital tire inflator. Broken parts will affect the digital tire inflator operation. Replace or repair damaged or worn parts immediately. Store idle digital tire inflator. When digital tire inflator is not in use, store it in a secure place out of the reach of children. Inspect it for good working condition prior to storage and before re-use. Page 3 of 6

OPERATION WARNING: To avoid the risk of personal injury, especially to the eyes, face or skin, DO NOT direct the air stream at any person. 1. Remove tire valve cap. 2. With clip-on air chuck lever depressed, firmly press chuck onto tire valve stem and release lever, ensure that no air leaks. 3. Press the grip to inflate, press the grip half-way to deflate. 4. On: Press the on/unit/light button to turn on the inflator. The inflator has an auto shut off to prolong battery life: it will turn off automatically 90 seconds later. 5. Backlight: When the inflator is on, press the on/unit/light button to turn on the backlight, so to read the pressure easily in darkness, the backlight will extinguish automatically in 5 seconds. Backlight will not be activated by turning on the inflator, can only be activated by pressing the on/unit/light button. 6. Unit Change: Press on/unit/light button above 3 seconds, enter unit change mode, then press on/unit/light button shortly to choose the desired unit. The unit chosen will be default unit for following usage. 7. The inflator s battery is CR2450, 2.4-3.6VDC, if the voltage is below 2.4V, the low battery signal on the top left will be flashing continuously, to remind user to change the battery. Refer to the battery changing directions in this manual. 8. Measuring Range: 0-12BAR (0-175PSI). Reading Accuracy is 0.01BAR (0.1PSI). Max. Inlet Pressure is 15BAR (218PSI). Page 4 of 6

MAINTENANCE Maintain your digital tire inflator. It is recommended that the general condition of any digital tire inflator be examined before it is used. Keep your digital tire inflator in good repair by adopting a program of conscientious repair and maintenance. If any abnormal vibrations or noise occurs, have the problem corrected before further use. Have necessary repairs made by qualified service personnel. Page 5 of 6

WARRANTY One-year limited warranty TGB PO Box 202 Hopkins, MN 55343 Made in China Page 6 of 6