RoHS CERTIFICATE OF COMPLIANCE FOR ACCUTOUCH SCREENS (Excluding AT4 Touch Screens)

Transcription

1 RoHS CERTIFICATE OF COMPLIANCE FOR ACCUTOUCH SCREENS (Excluding AT4 Touch Screens) TITLE: RoHS Certificate of Compliance for AccuTouch Screens (excluding AT4 Touch Screens) NUMBER: RC REVISION: D Sheet 1 of 6

2 Change History Rev. Description of Change Release Date Changed By A Released per ECO /22/05 Kevin Seitz B Revised per ECO Add China RoHS requirements (Tic-Tac-Toe HazMat chart and EPUP) C Revised per ECO Document correction on item 1: Change Intellitouch to Accutouch and Super Flat Profile to AT4 Touch Screens D Revised per ECO Added new RoHS contact name, updated China RoHS table and analysis information, changed logo on header and Change prefix from ES to RC600715, which is the correct prefix for Declaration of Compliance. New Document Number RC is replacing ES /25/07 Leo Alejandro 11/06/07 Leo Alejandro 9/28/11 Don Ballard TABLE OF CONTENTS 1.0 PURPOSE CERTIFICATE OF ANALYSIS INFORMATION RoHS IDENTIFICATION AND LABELING DISCLAIMER...5 Sheet 2 of 6

3 1.0 PURPOSE This document certifies that all Accutouch screens with the exception of AT4 Touch screens are in compliance with: Directive 2002/95/EC of the European Parliament and of the Council of 27 January 2003 on the restriction of the use of certain hazardous substances in electrical and electronic equipment (RoHS Directives), as well as in regards to Directive 91/338/EEC (Cadmium) and Directive 2003/11/EC (PBB s/pbde s). These products may contain an exempted material as noted in the Annex of the RoHS Directive. China RoHS Compliance 2.0 CERTIFICATE OF ANALYSIS INFORMATION Material: Glass Lead ppm <1000 Exempt per RoHS Annex Material: Cable Assembly Lead ppm <78 Trace amounts below limit Polybrominated diphenyl ethers ppm <10.0 Trace amounts below limit Polybrominated biphenyls ppm 10.1 Trace amounts below limit Material: Solder Flux Material: DSCA Material: Spacer Dot Ink Sheet 3 of 6

4 Material: Cover Sheet ND = Not Detected P= Parts Per Million Test Methods: Test Item Method MDL RoHS Limit (P) Cadmium ICP-AES per EN1122, method B:2001 or other acid digestion Chromium (VI) As per US EPA 7196A and US EPA 3060A Lead ICP-AES per US EPA 3050B or other acid digestion Mercury ICP-AES per US EPA 3052 or other acid digestion Polybrominated USEPA 3540 or USEPA diphenyl ethers Polybrominated biphenyls MDL = Method Detection Limit Analysis done by HPLC/DAD, LC/MS or GC/MS USEPA 3540 or USEPA 3550 Analysis done by HPLC/DAD, LC/MS or GC/MS RoHS IDENTIFICATION AND LABELING All products mentioned above are RoHS compliant and are shipped with the label shown below attached to the shipping carton. Sheet 4 of 6

5 4.0 CHINA ROHS INFORMATION TIC-TAC-TOE (HAZMAT) CHART APPLICABLE EPUP SYMBOL Sheet 5 of 6

6 5.0 DISCLAIMER Users are advised to ensure that this information is brought to the attention of the employees, agents, or contractors handling this product. Distributors of this product are advised to forward this document, or the information contained herein, to their purchaser. Tyco Electronics obligations shall be only as set forth in Tyco Electronics standard terms and conditions of sale for this product and in no case will Tyco Electronics be liable for any incidental, indirect or consequential damages arising out of the sale, resale, use or misuse of the product. Users of Tyco Electronics products should make their own evaluation to determine the suitability of each such product for the specific application and to establish safe handling and installation procedures. I hereby certify that this Certificate of Compliance is accurate. Don Ballard September 9, 2011 Environmental Compliance Engineer Elo TouchSystems (a division of TE Connectivity) Sheet 6 of 6