1 Safety and warnings Introduction Installation Remote Controller TV Operation Trouble shooting...

Transcription

1 LE24D1000

2

3 1 Safety and warnings Introduction Installation Remote Controller TV Operation Trouble shooting

4 IMPORTANT SAFETY INSTRUCTION 1) Read these instructions. 2) Keep these instructions. 3) Heed all warnings. 4) Follow all instructions. 5) Do not use this apparatus near water. 6) Clean only with dry cloth. 7) Do not block any ventilation openings, install in accordance with the instructions. 8) Do not install near any heat sources such as radiations, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9) Do not defeat the safety purpose of the polarized plug, If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. 10) Protected the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. 11) Only use attachments/accessories specified by the manufacturer. 12) Unplug this apparatus during lighting storms or when unused for long periods of time. 13) Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. 14) Mains plug is used as the disconnect device, the disconnect device shall remain readily operable. 15) The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloth, curtains, etc. 16) No naked flame sources, such as lighted candles, should be placed on the apparatus. 17) Attention should be drawn to the environmental aspects of battery disposal. 18) The use of apparatus in moderate climate. 19) The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN! CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK).NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The symbol indicates that dangerous voltages constituting a risk of electric shock are present within this unit. The symbol indicates that there are important operating and maintenance instructions in the literaturac companying this unit. WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. WARNING: The batteries shall not be exposed to excessive heat such as sunshine, fire or the like. This symbol indicates that this product incorporates double insulation between hazardous mains voltage and user accessible parts. When servicing use only identical replacement parts. This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling. -2-2

5 If you are going to clean the product,unplug the TV,use soft fabric,no water,never chemicals. 3

6 Infrared Remote Control Users s Manual 199 E- waste Guideline Manual Warrnaty Card QSG Battery 61cm 1366x768 PAL/BG Frequency TV MHz MHz AC V 50/60Hz 45W 2 x 6W Earphone PC Audio x 1 AV Out x 1 Note:This product uses a panel consisting of sub pixels which require sophisticated technology to produce. However, there may be a few bright or dark pixels on the screen. These pixels will have no impact on the performance of the product. 4

7 INSTALLATION Stand Assemble Instruction Place the TV with the display side down on a flat surface. Use a cloth to protect the display. Attach the stand base set to the bottom of the TV b y f irmly tightening the supplied 4pcs screws. INSTALLATION NOTES Locate the TV in a room where light does not strike the screen directly. Total darkness or a reflection on the screen can cause eyestrain. Soft and indirect lighting is recommended for comfortable viewing. Allow enough space between the TV and the wall to permit ventilation. Please do not attempt to rotate the TV on the stand. Avoid excessively warm locations to prevent possible damage to the cabinet or premature component failure. Wall Mounting Installation Guidelines Use the four screws to fix the TV onto a wall mounting bracket (not included) via the four VESA standard holes on the back of the television. 200 M4 M4 100 M4 M4 (24 ) 5

8 STAND BY FAV- FAV SOURCE MENU CH SLEEP FAV+ ASPECT DISPLAY ENTER PMODE SMODE MUTE ROOT EXIT VOL FREEZE VOL+ VOL - CH+ CH- MENU INPUT (POWER) INPUT (POWER) AV IN Component IN VIDEO L R Y Pb Pr HDMI EARPHONE OUT PC-VGA PC AUDIO EARPHONE, AV IN, COMPONENT IN, HDMI, PC-VGA, PC AUDIO. RF IN USB AV OUT RF IN, USB, AV OUT. 6

9 RF. AV IN Component IN VIDEO L R Y Pb Pr HDMI EARPHONE OUT PC-VGA PC AUDIO 7

10 8

11 RF IN USB AV OUT TV AV IN Component IN VIDEO L R Y Pb Pr HDMI EARPHONE OUT PC-VGA PC AUDIO L 9

12 Standby or switch on the TV. Set to mute or return to previous sound level. STAND BY FAV- FAV+ FAV ASPECT SOURCE DISPLAY MUTE ROOT 0-9 Select the TV channel you want to view by using the number buttons. RED/GREEN/ YELLOW/BLUE FREEZE SLEEP ROOT Channel Edit when setting up your TV. Press to freeze the picture. Press to set the sleep timer. Return to the previous channel after channels have been changed. To back to home page IN USB. ENTER ENTER Up/Down/Left/Right. Enter button. MENU EXIT MENU Display or exit MENU. PMODE EXIT Exit the MENU. CH VOL CH+/- Channel up/down. SMODE VOL+/- Increase/decrease the volume level. P.MODE Cycle through available vide picture modes. S.MODE Cycle through different sound settings. DISPLAY Display info of the current channel. SLEEP FREEZE SOURCE Press to open the input source list. FAV - Channel favorite channel Down. FAV + Channel favorite channel Up. FAV To open favorite channel list. ASPECT To select the aspect ratio of the screen. / Play previous / Play next. / / / Play back faster / Play forward faster. Play or pause. Stop and back to the folder interface. 10

13 Installation Guide The First Time Setup screen will appear when the TV is first switched on or reset to the factory setting. ENTER button to confirm, First Time Setup C H A N N A L Auto Tuning ATV Manual Tuning OSD Language English P I C T U R E Programme Edit S O U N D Mode Setting Home Mode T I M E S t a r t O P T I O N M o v e M e n u E N T E R E n t e r E x i t Press the buttons to navigate the menu and buttons to change the settings. Select your desired language, Home/Shop Mode! et o displayed on the menu. ATV First Time Setup S e l e c t t h e u s a g e m o d e? S h o p m o d e i s f o r s h o p u s a g e o m l y. Shop mode Home Mode ATV Manual Tuning Current CH 1 Color System PAL Sound System BG Fine-Tune MHZ AFC On Search Home or Shop modes When the unit is turn on for the very first time, it will show Initialization set-up menu. After the OSD language is set, the user can choose betw een "shop mode" and "home mode". When the screen shows the following setting menu and the cursor stays on the "home mode" choice, press to adjust, and "ENTER " to enter the menu. Choose "ENTER " to enter the next prompt Auto Tuning Menu P r o g r a m m e E d i t D e l e t e R e n a m e M o v e S k i p E N T E R E n t e r F a v M e n u 11

14 ENTER button to confirm, C H A N N A L Sound Mode Standard Tr e b l e 5 0 P I C T U R E S O U N D T I M E B a s s B a l a n c e Auto Volume Audio Only O P T I O N M o v e M e n u E N T E R E n t e r E x i t FAV Fav ENTER button to confirm, C H A N N A L C l o c k P I C T U R E S O U N D T I M E Off Time On Time Sleep Timer Auto Sleep OSD Timer 1 0 S O P T I O N ENTER button to confirm, M o v e M e n u E N T E R E n t e r E x i t C H A N N A L Picture Mode Standard C o n t r a s t 5 0 P I C T U R E S O U N D T I M E B r i g h t n e e s C o l o r Ti n t S h a r p n e e s Color Temperature M e d i u m O P T I O N M o v e M e n u E N T E R E n t e r E x i t You can adjust the Aspect Ratio, Blue Screen, Reset, Software Update(USB), Key Lock, Hotel Mode. Medium 12

15 C H A N N A L P I C T U R E S O U N D T I M E OSD Language Aspect Ratio Blue Screen Key Lock Hotel Mode R e s e t Software Update ( USB) English 1 6 : 9 O n O P T I O N M o v e M e n u E N T E R E n t e r E x i t ENTER ENTER ENTER ENTER ENTER ENTER 13

16 V I D E O S O N G _ R o y _ R e s o l u t i o n : x A u d i o Tr a c k : 1 / 1 S u b t i t l e : P r o g r a m : S i z e : - - / / KByts C l o s e ATTENTION: 1. USB HDD compatibility is not assured. 2. Some format video is not played for some file reason. 3. Haier will not bear any responsibility for saving facility quality problem or date missing. In option MENU you can adjust the Hotel mode through ENTER key then press number button 0000 to enter into Hotel mode, then press button to select On or Off. C H A N N A L Hotel Mode P I C T U R E O n S O U N D T I M E O P T I O N Source Lock Default Source Default Prog Max Volume Channel Lock Default Volume M o v e M e n u E N T E R E n t e r E x i t C H A N N A L Clear Lock P I C T U R E E n t e r Set Password S O U N D T I M E O P T I O N M o v e M e n u E N T E R E n t e r E x i t Source Lock : Lock the input source which you want. Default Source : Set the default input source when tuning on your TV. Default Prog : Set the default input prog when tuning on your TV. Max Volume : Set max volume limited, this option allows you to set the max volume level. Channel Lock : Lock the channel which you preferred. Default Volume : Power on default volume,press the button to select the default volume. Clear Lock : Recall the default settings in Hotel mode. Set Password : Set the password as you like. 14

17 TROUBLE SHOOTING Trouble phenomenon Picture Audio Inspection Snow Noise antenna position, direction or connection Ghost Normal audio antenna position, direction or connection Interfere Noise electronic equipment, car/ motorcycle, fluorescent light Normal Picture No Picture Mute Mute Volume (inspect wether the mute function on the remote control are started, or audio system are correct or not) Power cord is not inserted Power switch is not opened Contrast and brightness/volume setup Press standby key on the remote control for inspecting No color Normal audio color control Scramble Normal audio or weak retune channel No color Noise Audio system Special Explanation: The accessories such as remote control is not belongs to the guarantee

18