DIGITAL CABLE TV RECEIVER OPERATION MANUAL DVB-C8080AL DIGITAL CABLE RECEIVER DEAR CONSUMER

Transcription

1 DIGITAL CABLE TV RECEIVER OPERATION MANUAL DVB-C8080AL DIGITAL CABLE RECEIVER DEAR CONSUMER GREAT APPRECIATION FOR PURCHASING OUR PRODUCT TO ENSURE THE BEST PERFORMANCE AND THE HIGHEST SAFETY, PLEASE READ THE FOLLOWING EXPLANATION CAREFULLY PLEASE READ THIS MANUAL WITH SUFFICIENT CAREFULNESS AND PATIENCE PRECEDE THE CONNECTION AND INSTALLATION

2 Dear Subscriber, Congratulations for choosing the digital service from IN Digital. Now, you can take total control of your entertainment and avail of the best that digital television has to offer. In our continuing commitment to you, our valuable subscriber, we present the digital Set Top Box (STB) - your gateway to a whole new world of high quality pictures and sounds on your television. The STB also comes with an in-built electronic program guide and an all-new remote control to make for the best possible viewing experience. The IN Digital service brings to you everything from program schedules /synopsis to 24/7 customer support at your fingertips. Welcome to the digital experience Welcome to IN Digital

3 CONTENT SAFETY INSTRUCTION FRONT PANEL REAR PANEL REMOTE PRECAUTIONS ABOUT BATTERIES PREPARATION OF REMOTE OPERATION SCOPE OF THE REMOTE USEFUL PROMPTION CONNECTION STARTING UP THE FIRST TIME USING THIS RECEIVER CHANNEL MANAGER SPECIFICATION CERTIFICATE OF WARRANTY WARRANTY CARD PACKING LIST ITEM QUANTITY DIGITAL RECEIVER BATTERY MANUAL REMOTE RCA CORD

4 SAFETY INSTRUCTION IMPORTANT SAFETY INSTRUCTIONS Read Read these these instructions Keep Keep these these instructions. instructions Heed Heed all all warnings. warnings Follow Follow all all instructions. instructions. 5. Do not use this apparatus near water Do Clean not use only this with apparatus dry cloth. near water Clean Do not only block with dry any cloth. ventilation openings. Install in accordance with the manufacturer s instructions Do Do not not block install any near ventilation any heat openings. sources Install such in as accordance radiators, with heat the registers, manufacturer s stoves, instructions. or other apparatus (including 8. amplifiers) Do not install that near produce any heat heat. sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that 9. produce The parameter heat. of the using power source should be accordance with which indicating on the rear panel, 9. otherwise The parameter the machine of the using will power work source improperly should and be even accordance be ruined. with which indicating on the rear panel, otherwise the machine 10. Protect will work the improperly power cord and from even being ruined. walked on or pinched particularly at plugs, convenience receptacles, 10. and Protect the point the power where cord they from exit being from walked the apparatus. on or pinched particularly at plugs, convenience receptacles, and the point 11. Only use attachments/accessories specified by the manufacturer. where they exit from the apparatus. 12. To prolong the useful life of this machine, the interval of the continuous switch action must be above one 11. minute. Only use attachments/accessories specified by the manufacturer To Use prolong only the the useful cart, life stand, of this machine, tripod, bracket, the interval or of table the continuous specified switch by the action manufacturer, must be above or one sold minute. with the 13. apparatus. Use only the When cart, a stand, cart is tripod, used, bracket, use caution or table when specified moving by the the manufacturer, cart/apparatus or sold combination with the apparatus. to avoid When injury a cart from is used, tip-over. use caution when moving the cart/apparatus combination to avoid injury from tip-over Unplug this this apparatus during during lightning lightning storms storms when or unused when unused for long periods for long of periods time. of time Refer Refer all servicing all servicing to qualified to qualified service service personnel. personnel. Servicing Servicing is required is when required the apparatus when the has apparatus been damaged has been in any way, damaged such as in power-supply any way, such cord as or power-supply plug is damaged, cord liquid or plug has been is damaged, spilled or liquid objects has have been fallen spilled into the or apparatus, objects have the apparatus fallen into has the been apparatus, exposed the to rain apparatus or moisture, has does been not exposed operate to normally, rain or or moisture, has been does dropped. not operate normally, or has been dropped Warning: Warning: This This unit unit should should only only be be serviced serviced by an by authorized an authorized and and properly properly trained trained technician. technician. Opening Opening the cover the or cover other or attempts other attempts by the user by to the service user this to service unit may this result unit in may serious result injury serious or death injury from or electrical death from shock, electrical and may increase shock, the and risk may of fire. increase the risk of fire The The MAINS MAINS plug plug or an or appliance an appliance coupler coupler of the apparatus of the apparatus is used as the is used disconnect as the device, disconnect the disconnect device, device the shall disconnect remain readily device operable. shall remain readily operable The The signal signal cable cable must must be earthed be earthed to the to system. the system No No naked naked flame flame sources, sources, such such as lighted as lighted candles, candles, should should be placed be on placed the apparatus. on the apparatus. Note: Note: All All the the OSD OSD and and illustrations illustrations in this in manual this manual may be somewhat may be somewhat different from different the actual from situation. the actual Please situation. take the Please take the actual RECEIVER as the standard. actual RECEIVER as the standard. WARNING: To reduce the risk of fire or electric shock, do not expose this product to rain or moisture. WARNING: Apparatus To shall reduce not the be exposed risk of fire to or dripping electric shock, or splashing do not expose and no this objects product filled to rain with or liquids, moisture. such as vases, shall Apparatus be placed shall on not the be apparatus. exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on Refer the apparatus. to the identification/rating label located on the back panel of your product for its proper operating Refer voltage. to the identification/rating label located on the back panel of your product for its proper operating voltage. 1 4

5 FRONT PANEL MENU. menu entry/ menu goes back 2. Status indicator/ remote sensor/ displaying panel Channel / cursor movement 5. volume decrement/ operation confirmation 6. volume increment/ menu goes back 7. The spot where opens the lid to insert a smart card REAR PANEL terminal, antenna signal insert 2. terminal, antenna signal loop out 3. terminal, coaxial digital audio signal output 4. terminal, video signal output 5. terminal, audio signal output, R 6. terminal, audio signal output, L 7. power switch 8. plughole, power cord 5

6 REMOTE It s recommended to operate each function of the keys on the Receiver by using the key on the remote controller. Please read this section to lend itself to advance your understanding of the function of the Receiver STANDBY FAV Instruct the receiver into standby mode or normal watching mode Non-menu, display FAVORITE LIST interface MUTE 0-9 MENU EPG LIST Mute the receiver or open its sound Menu, input value Non-menu, channel selection Menu entry Non-menu, enter EPG interface, press the OK key to switch cursor from columns of channel and program Non-menu, enter TV LIST interface EXIT MENU, return to the last grade interface U P / DOWN LEFT/ RIGHT OK V+/- MENU, cursor movement Non-menu, channel turning MENU, state alteration Non-menu, volume adjustment MENU, operation confirmation Non-menu, TV LIST Non-menu, volume adjustment

7 P+/- TV/ RAD BACK INFO AUDIO GAME Non-menu, channel turning; channel infor, page turning Non-menu, switch channel mode between TV and radio MENU, go back Non-menu, display an information tape of the present channel, press the key once more to deploy its brief depiction Non-menu, display audio options, press the directional key to opt for an option, press the OK key to confirm, press the EXIT key to exit Non-menu, deploy game options HELP Non-menu, deploy STB information F1-4 Special functional keys in certain situation PRECAUTIONS ABOUT BATTERIES Improper use of batteries may cause corrosion or fluid leakage. Please observe the following instructions for the safe use of batteries 1. Do not mistake the polarities of batteries 2. Never leave dead batteries in the remote control 3. Remove batteries from the remote controller it is not going to be used for a certain time 4. Do not attempt to disassemble, short-circuit, heat, recharge or throw the batteries into the fire source 5. Do not use new batteries and old one together, or which is different type 6. Wipe away any electrolyte fluid inside the remote controller, and insert new batteries 7

8 PREPARATION OF REMOTE CONTROL Load the batteries to the groove of the remote control and then enable you to operate the native 1. Open the lid 2. Load the batteries (AAA type) and attend whether the anode and cathode of battery are corresponding to the polarity indicated on the remote controller 3. Close the lid OPERATION SCOPE OF THE REMOTE CONTROLLER Make the controller toward the inductive window of native and then press the keys Distance: about seven meters in front of the inductive window Angle: about 30 degree right or left refer to the frontispiece of the native s front panel INDUCTIVE WINDOW OF FRONT PANEL USEFUL PROMPTING To prolong the useful life of this machine, the interval of the continuous switch action must be above one minute The parameter of the using power source should be accordance with which indicating on the rear panel, otherwise the machine will work improperly and even be ruined When the picture that the unexpected non-respondency happening, please turn on the machine again To maintain the suitable antenna installation position, the proper antenna installation angle, the adequate antenna earthing, the normal antenna anti-interference measure. Keep the earthing of the outdoor antenna separating with the indoor equipment s 5 8

9 CONNECTION»» connect the audio and video output terminals with the corresponding input terminal on a TV set»» Insert the digital antenna cable into the [CABLE IN] terminal on the rear panel, please notice that the connection effect should effectual»» The [CABLE OUT] loop out terminal can form the loop connection with another receiver, can also be linked with the RF IN input on a TV set to provide RF signal.»» Don't bundle the antenna cable with a power cord in case cause interference»» The terminal [COAXIAL] can connect with a coaxial input on an amplifier TYPICAL CONNECTION 1.Insert the digital antenna cable into the [CABLE IN] terminal on the rear panel of the receiver 2. Connect one end of yellow terminal on a RCA cable to the VIDEO output on this receiver and the other end to the VIDEO input on a TV set 3. Connect one end of red terminal on a RCA cable to the AUDIO R output on this receiver and the other end to the AUDIO R input on a TV set; Connect one end of white terminal on a RCA cable to the AUDIO L output on this receiver and the other end to the AUDIO L input on a TV set VIDEO AUDIO SIGNAL 3. Plug the connector of power cord into a socket and turn on the receiver and TV set. 9

10 STARTING UP 1. Plug the connector of power cord into a socket, turn on the power switches of this receiver and a TV set, the receiver enters into its normal mode. 2. Render the remote towards the inductive panel of the receiver to instruct the machine into its standby mode, re-press the key, restore it to its normal watching state. 3. Once the signal has been locked, the signal indicator lights up. THE FIRST TIME USING THIS RECEIVER The first time using the receiver, the screen appears a dialog box, [No valid program to be played, start auto searching now?]. Use the OK instruction to start automatic searching. After searching, the receiver returns to its program-watching state. Press the UP/DOWN key to turn channel and the LEFT/RIGHT key to adjust volume. 10

11 CHANNEL MANAGER On Main Menu, highlight the Channel Manager. Press the OK key to enter. >Auto Search. Highlight [Auto Search], press the OK key to get into its next menu. Press the BACK key to go back. Press the OK key to start searching automatically. After searching, the screen goes back to its program-watching status. Press the UP/DOWN key to turn channel and the LEFT/RIGHT key to adjust volume. 11

12 >Manual Search. Highlight [Manual Search], press the OK key to get into its next menu. >>Frequency, Symbol Rate. Press the digit-key to input concrete value. >>Modulation. Press the LEFT/RIGHT key to alternate an option. As for the accurate value, please refer to the local program provider. Press the red key to start single Frequency search, press green key to start auto search After searching, the screen goes back to its program-watching status. Press the UP/DOWN key to turn channel and the LEFT/RIGHT key to adjust volume.

13 SPECIFICATION SPECIFICATION Tuner: Input Frequency Input level Frequency band Symbol rate Demodulation type Input impedance Video: Decode format Output system Output terminal Picture definition Video output range Audio: Decode format Frequency respondence Sampling frequency Output terminal Output level Power: Voltage Consumption Environment: Temperature Mass MHz 45dBuV-90dBuV(75Ω) 8 MHz 6.900MBaud 16, 32, 64, 128, 256 QAM adjustable 75Ω MPEG2.MP@ML PAL, NTSC RCA (PAL) 700±70mVpp MPEG2(Layer 1 2) 20Hz-20KHz 32/44.1/48KHz RCA, COAXIAL adjustable (600Ω unbalance) V~ 50/60 Hz 10W or so kg or so 13 16

14 CERTIFICATE OF WARRANTY This certificate of warranty should produced for servicing under the terms of the warranty. CONDITIONS OF WARRANTY 1)Within one year from the date of purchase, if any component(s) is found to be defective due to faulty workmanship or defective material will be made and repairs executed free of charge and defective part replaced. Parts repaired or replaced are under warranty throughout the remainder of the original warranty period only. Repairs under warranty may also be carried only by authorized service centres or the authorized local cable operator. 2)This warranty does not cover any from of damage resulting from accident, misuse, application of incorrect voltage or any use contrary to the operating instruction supplied along with the equipment. 3)NO responsibility will be accepted for damage arising out of unauthorized modification or alterations of any nature made to the Digital Set Top Box. 4)NO responsibility will be accepted for damage or less incurred during transit of Digital Set Top Box. 5)This warranty is not valid if the serial number of the Digital Set Top Box has been deleted, defaced or altered. 6)This certificate of warranty should accompany the Digital Set Top Box if service under warranty period is required to be carried out at the authorized service centres. 7)The STB conforms functionally to the appropriate BIS standards. 14

15 WARRANTY CARD Customer Details Name: Invoice Number& Date: Purchase Date: / / / / Installation Date: / / Digital Set Top Box Model&Type: Precautionarty measure: Please ensure that the following bar coded sticker is common between Set-Top-Box, Retail Box,and this user manual. IncableNet in Digital Franchisee /independent cable operator s Details Signature:- Date: Franchisee/cable operator 15

16