Articulating TV Wall Mount for 19" to 70" Flat Panel TVs

Transcription

1 THIS INSTRUCTION BOOKLET CONTINS IMPORTNT SETY INORMTION. PLESE RED ND KEEP OR UTURE REERENCE. Lot Number: Date: rticulating TV Wall Mount for 19" to 7" lat Panel TVs Model No: DCD1319 Option 1 Option +5 MX:15.75 in / mm MIN:.95 in / 75 mm -15 MIN:.95 x.95 in / 75 x 75 mm MX:3.9 x 3.9 in / 1 x 1 mm MIN:3.7 in / 78 mm MX:1.65 in / 55 mm MIN:.95 in / 75 mm MX:3.6 in / 6 mm MIN:3.7 in / 78 mm MX:1.65 in / 55 mm Product Warranty: The Manufacturer, warrants to the original purchaser that its products are free defective in materials or workmanship, we shall repair or replace the product at our discretion. This warranty does not cover accidental damage, misuse, improper care or alteration and excludes claims for incidental or consequential loss. This limited warranty applies to product also have other rights which vary from State to State. The warranty duration is one year. Keep this Instruction Manual for future reference. Keep your original proof of purchase (store receipt). If parts are missing, DO NOT return to the store. To order missing / replacement parts or for assembly assistance please contact customerrelations@tvmountsnow.com Or call M- T h, 8am-5pm, ri, 8am-1pm, P.S.T.

2 ssembly Tips: Become familiar with the instructions and all parts. Make sure that all parts are in the box and in good condition. Do not install on a sloping surface. Caution: Never let children climb on product or play with product. Do not sit or stand on furniture. Do not place a weight that is heavier than the recommended load rating on the product surface. If you do not understand these instructions, or have doubts about the safety of r. The manufacturer is not liable for damage or injury caused by incorrect mounting, assembly or use. The unit will hold a 19 to 7 in (8.6 to cm) Plasma or LCD TV. The weight of the TV must not exceed 13 lbs (6 kgs). The wall must be capable of TV plus the mount. Improper handling can result in cuts and lacerations. Images are for reference only. Care Instructions: Use electrostatic dust cloths to clean product surfaces.

3 Parts List Item Components Qty Item Components Qty 1 B 1 8 C H 1 D Tools Needed (Not Included) 3/16 in. or 5 mm Safety Hammer Wood Drill Bit Phillips Drill Stud inder lasses Screwdriver Note: before assembly. Wood Double Stud 16 in.6 cm

4 PLESE CHOOSE BEST INSTLLTION OPTION BSED ON TV BCK PNEL HOLE SPCIN: OPTION 1:.95 in x.95 in / 75 mm x 75 mm or 3.9 in x 3.9 in / 1 mm x 1 mm 1 16 /6mm B Remove TV mounting plate (B) from wall bracket (). This mount is designed to be attached into wood studs. DO NOT use wall anchors. Using a stud pencil, mark the hole locations at the desired height, making sure you are level. Use wall bracket () as a template to mark the two remaining holes. Drill pilot holes at pencil marks.5 in. (6mm) deep, using a 3/16 in. or 5 mm diameter drill bit. ttach wall bracket () to the wall with washers and screws (). 3 B ttach TV mounting plate (B) to the back of the TV, by selecting mounting hardware and then using instructions on page 5. We strongly recommend two people, one on each side, hold the TV. Carefully position the TV over the wall bracket () until it locks in place. Tighten safety screws. 3

5 PLESE CHOOSE BEST INSTLLTION OPTION BSED ON TV BCK PNEL HOLE SPCIN: OPTION : (7.87 to 3.6) in x 15.7 in / ( to 6) mm x mm 1 16 /6mm H C B D This mount is designed to be attached into wood studs. DO NOT use wall anchors. Using a stud a pencil, mark the hole locations at the desired height, making sure you are level. Use wall bracket () as a template to mark the two remaining holes. Drill pilot holes at pencil marks.5 in. (6mm) deep, using a 3/16 in. or 5 mm diameter drill bit. Measure the hole spacing on the back of your TV. Position two TV mounts (C) onto horizontal attachment arms (D) at the same spacing. Using llen wrench (H), attach both TV mounts (C) to attachment arms (D) with screws (). Using llen wrench (H), attach TV mounting plate (B) to attachment arms (D) with screws (). ttach wall bracket () to the wall with washers and screws (). 3 safety screws ttach TV mounting assembly from Step to the back of the TV, by selecting mounting hardware and then using instructions on page 5. We strongly recommend two people, one on each side, hold the TV. Carefully position the TV over the wall bracket () until it locks in place. Tighten safety screws.

6 Parts List PLESE CHOOSE BEST INSTLLTION OPTION BSED ON TV BCK PNEL HOLE SPCIN: THIS INSTRUCTION BOOKLET CONTINS Lot Number: OPTION IMPORTNT 1:.95 : SETY (7.87 in x.95 to INORMTION. 3.6) in / 75 in mm x 15.7 x PLESE 75 in mm / ( or to 3.9 6) in mm x 3.9 x in / 1 mm mm x 1 mm RED ssembly Item ND KEEP OPTION OR Tips: Components UTURE 1 REERENCE. OPTION Qty Item Components Date:.95 in x.95 in / 75 mm x 75 mm (7.87 to 3.6) in x 15.7 in 3.9 in x 3.9 in / 1 mm x 1 mm ( to 6) mm x mm Become familiar with the instructions and all parts /6mm Make sure that all parts are in the box and 1 in good condition. 16 /6mm Qty ssemble the product on the open flat carton or a rug to protect the product and your floor. This Remove TKE mount EXTR TV Dmounting is designed CRE ND plate to PY be (B) attached TTENTION from wall into WHEN wood YOU This STEN mount Measure THE is designed TV the MOUNT(S) hole to spacing be TO attached THE on the into back wood of your TV. studs. bracket BCK DO TV (). PNEL NOT use IN wall STEP anchors. Option 3. MKE 1 Using SURE TO a stud USE THE studs. PPROPRITE Position DO NOT two use MOUNTIN TV wall Option mounts anchors. HRDWRE (C) onto Using horizontal a stud attachment the arms center (D) at of the two same adjacent spacing. studs. Using With llen a finder, OR YOUR find the TV. center of two adjacent studs. With finder, find 18 a Caution: Tools Needed (Not Included) 1. pencil, Select mark the correct the hole Mounting locations Hardware at the desired 18 according pencil, to the wrench mark screw the hole (H), hole attach size locations on both your at TV TV. the mounts Discard desired (C) any height, to attachment sure you arms are (D) level. with Use screws wall bracket (). () as a height, remaining making Never let screws sure you children and are spacers. level. Use wall making climb on product 1/ or in. or play 7 mm with product. 18 bracket () as a template to mark the two remaining. Carefully holes. Drill lay pilot your holes TV face at down pencil on marks a non-abrasive template to mark the two remaining holes. Drill pilot in. holes surface, at Using pencil laying llen marks padding wrench.5 underneath in. (H), (6mm) attach TV deep, it to mounting protect using a plate Do not sit or stand on furniture. +5 (6mm) the screen. deep, using a 1/ in. or 7 mm diameter 1/ in. or (B) 7 to mm attachment diameter arms drill bit. (D) with screws (). drill 3. OPTION bit. Do not 1: place Place a the weight TV plate that (B) is in heavier the appropriate than the position, recommended making load sure it rating is CENTERED on the on the product Safety back surface. of TV Hammer and LEVEL. Wood Drill Bit ttach -15 Phillips wall bracket Drill () to the Stud wall inder with washers and ttach wall bracket +5 lasses () to the wall with washers Screwdriver screws (). and -15 OPTION screws If you (). : do Place not understand the right and these left TV instructions, mounts their or have appropriate doubts about the safety of positions, making sure they are this installation, CENTERED contact the customer back of the service TV and or LEVEL call a with qualified one another. contractor. The 3 manufacturer is not liable for damage or injury caused by incorrect mounting, assembly or use. Mounting Note: Please Hardware use wood List stud Q ty finder Mounting Hardware List Q ty Wood Double Stud The unit to find will the hold stud a in 37 the to wall 6 in (93.98 to cm) Plasma or LCD TV. The I weight before of M8 the assembly. X TV 16 must not exceed Q 13 lbs M (6/ kgs). M 5 washer The wall must be capable of J supporting B M6 five X 1times the weight R of the TV M6 plus / Mthe 8 washer mount. KProduct Improper Warranty: handling M5 X 1 The Manufacturer, can result in cuts warrants and to lacerations. the original purchaser that its products are free from defect in materials or workmanship. S M8 / M6 spacer If after inspection, we find that the product was defective Images in are materials for reference or workmanship, only. L M X 1 T we shall repair M / or M5 replace spacerthe product at our discretion. This warranty does not cover accidental damage, misuse, improper care or alteration and excludes claims for incidental or consequential loss. This limited warranty applies to product M M8 X purchased in the U.S. and Canada. stud finder This warranty gives you specific legal rights and you may also have other rights which vary from State to State. The warranty duration is one year. ttach N TV mounting M6 assembly X 35 from Step to the We strongly recommend two people, one on back of Care the TV, by Instructions: selecting mounting hardware each side, hold the TV. Carefully position the TV and ttach then OKeep Use TV using this mounting electrostatic Instruction instructions M5 plate X 3dust Manual (B) on to cloths page the for back 5. future to clean of reference. product We strongly surfaces. over recommend the wall bracket two () people, until it one locks on in each place. side, the TV, Keep by your selecting original mounting proof of hardware purchase (store receipt). hold the Tighten TV. Carefully safety position screws. the TV over the wall and Pthen If parts using are instructions missing, M X 3 DO on NOT page return 5. to the store. bracket () until it locks in place. Tighten safety screws. To order missing / replacement parts or for assembly assistance please contact customerrelations@tvmountsnow.com 3 Or call M- T h, 8am-5pm, ri, 8am-1pm, P.S.T. 5 MIN:3.7 in / 78 mm MX:1.65 in / 55 mm rticulating TV Wall Mount for Do not B install on a sloping surface. 1 37" to 6" lat Panel TVs C Model B No: DCD1319 MIN:.95 x.95 in / 75 x 75 mm MX:3.9 x 3.9 in / 1 x 1 mm H C 1 B D MIN:3.7 in / 78 mm MX:1.65 in / 55 mm 16 in.6 cm MIN:.95 in / 75 mm MX:3.6 in / 6 mm 8 MX:15.75 in / mm MIN:.95 in / 75 mm safety screws

7 HDMI Cable Information: This Kit includes 1 HDMI cable Each HDMI cable measures 6 feet (188.8 mm) in length. 1. Version Supports Ethernet and 3D O.D.: 6.mm Single molding 6