STATIC CONE PENETRATION TEST CPT1



Similar documents
HAULBOWLINE, CORK STATIC CONE PENETRATION TESTS FACTUAL REPORT

CPT interpretation in marine soils less than 5m depth examples from the North Sea

Ingeniería y Georiesgos Ingeniería Geotécnica Car 19 a Nº of 204 ; TEL : igr@ingeoriesgos.com

Site Investigation. Some unsung heroes of Civil Engineering. buried right under your feet. 4. Need good knowledge of the soil conditions

CPTic_CSM8. A spreadsheet tool for identifying soil types and layering from CPTU data using the I c method. USER S MANUAL. J. A.

CE 366 SETTLEMENT (Problems & Solutions)

Soil behaviour type from the CPT: an update

Cone Penetration Testing in Geotechnical Practice. Tom Lunne Peter K. Robertson John J.M. Powell

PAPAMOA EAST URBAN DEVELOPMENT PART 1 AREA LIQUEFACTION HAZARD REVIEW Technical Report

Numerical Simulation of CPT Tip Resistance in Layered Soil

Washington ,

Improvement in physical properties for ground treated with rapid impact compaction

Geotechnical Testing Methods II

ASSESSMENT OF SHEAR WAVE VELOCITY FROM INDIRECT INSITU TESTS

Toe Bearing Capacity of Piles from Cone Penetration Test (CPT) Data

Jack-in Piling Environmental Friendly Piling System

SUGGESTION ABOUT DETERMINATION OF THE BEARING CAPACITY OF PILES ON THE BASIS OF CPT SOUNDING TESTS

Correlation of Standard and Cone Penetration Tests for Sandy and Silty Sand to Sandy Silt Soil

CONE PENETRATION TESTING AND SITE EXPLORATION IN EVALUATING THE LIQUEFACTION RESISTANCE OF SANDS AND SILTY SANDS ABSTRACT

How To Prepare A Geotechnical Study For A Trunk Sewer Project In Lincoln, Nebraska

Anirudhan I.V. Geotechnical Solutions, Chennai

Statistical identification of homogeneous soil units for Venice lagoon soils

A case study of large screw pile groups behaviour

How To Design A Foundation

Eurocode 7 - Geotechnical design - Part 2 Ground investigation and testing

ON THE INTERPRETATION OF SEISMIC CONE PENETRATION TEST (SCPT) RESULTS

Geotechnical Measurements and Explorations Prof. Nihar Ranjan Patra Department of Civil Engineering Indian Institute of Technology, Kanpur

TERMOSIGN APPLICATION INSTRUCTIONS

Classification and probabilistic description of a sand site based on CPTU

2009 Japan-Russia Energy and Environment Dialogue in Niigata S2-6 TANAKA ERINA

INSITU TESTS! Shear Vanes! Shear Vanes! Shear Vane Test! Sensitive Soils! Insitu testing is used for two reasons:!

USE OF CONE PENETRATION TEST IN PILE DESIGN

NOTES on the CONE PENETROMETER TEST

G-126 (Continued) MTA Westside Subway Extension Los Angeles, California. Figure: A-2.22c

c. Borehole Shear Test (BST): BST is performed according to the instructions published by Handy Geotechnical Instruments, Inc.

EVALUATING THE IMPROVEMENT FROM IMPACT ROLLING ON SAND

Fundamentals of CONE PENETROMETER TEST (CPT) SOUNDINGS. J. David Rogers, Ph.D., P.E., R.G.

Module 1 : Site Exploration and Geotechnical Investigation. Lecture 4 : In-situ tests [ Section 4.1: Penetrometer Tests ] Objectives

Abstract. Keywords. Pouya Salari 1, Gholam Reza Lashkaripour 2*, Mohammad Ghafoori 2. * lashkaripour@um.ac.ir

Fellenius, B. H., and Eslami, A.

LABORATORY CLASSIFICATION OF SOILS FOR ENGINEERING PURPOSES

A Ground Improvement Update from TerraSystems

Cone Penetration Test (CPT)

EARTHWORKS COMPLETION REPORT ELLEN STIRLING PARADE, ELLENBROOK. Ellenbrook, W.A. Georgiou Group Pty Ltd

Pavements should be well drained both during and upon completion of construction. Water should not be allowed to pond on or near pavement surfaces.

VOLUME III GEOLOGY, HYDROGEOLOGY & GEOTECHNICAL REPORT CAPITAL REGION RESOURCE RECOVERY CENTRE

FREDERICK SHERRELL LTD

ODOT/OSU collaboration on the development of CPT Capabilities for use in Ohio Transportation Projects

Penetrometer testing in residual soils from granitic rocks in the South of Portugal

Equivalent CPT Method for Calculating Shallow Foundation Settlements in the Piedmont Residual Soils Based on the DMT Constrained Modulus Approach.

COMPARISON OF THE CONE PENETRATION RESISTANCE OBTAINED IN STATIC AND DYNAMIC FIELD TESTS

Offshore Work Packages

SPECIFICATION FOR DYNAMIC CONSOLIDATION / DYNAMIC REPLACEMENT

INDIRECT METHODS SOUNDING OR PENETRATION TESTS. Dr. K. M. Kouzer, Associate Professor in Civil Engineering, GEC Kozhikode

Soil Classification Through Penetration Tests

CPTWD (Cone Penetration Test While Drilling) a new method for deep geotechnical surveys

Instrumentations, Pile Group Load Testing, and Data Analysis Part II: Design & Analysis of Lateral Load Test. Murad Abu-Farsakh, Ph.D., P.E.

KWANG SING ENGINEERING PTE LTD

King Saud University College of Engineering Civil Engineering Department DEFORMATION OF PARTIALLY SATURATED SAND. Sultan Musaed Al-Ghamdi

How To Use The Static Cone Penetration Test

Geotechnical Investigation Report London Street Generating Station Peterborough, Ontario. February 2012

EVALUATION OF BEARING CAPACITY OF PILES FROM CONE PENETRATION TEST DATA

THE PANDA LIGHT-WEIGHT PENETROMETER FOR SOIL INVESTIGATION AND MONITORING MATERIAL COMPACTION

Report. Geotechnical Investigation Proposed Easy Access Upgrade Marrickville Railway Station Station Street, Marrickville, NSW

CPT AND CPTu DATA FOR SOIL PROFILE INTERPRETATION: REVIEW OF METHODS AND A PROPOSED NEW APPROACH *

Standard Test Method for Mechanical Cone Penetration Tests of Soil 1

Multiple parameters with one Cone Penetration Test. by Mark Woollard

COMPENDIUM OF INDIAN STANDARDS ON SOIL ENGINEERING PART 2

Effect of drainage conditions on cone penetration testing in silty soils

Otta Seal BACKGROUND GENERAL DESCRIPTION DESIGN ASPECTS. Category : Technical Information/On-carriageway/

CHAPTER 1 INTRODUCTION

Area No. 8 Test Pit No. 191

Interpretation of cone penetration tests a unified approach

SEISMIC SETTLEMENT OF SHALLOW FOUNDATIONS

An Improved Technique for Evaluating the CPT Friction Ratio. M. B. Jaksa, W. S. Kaggwa and P. I. Brooker

PREDICTING THE HYDRAULIC CONDUCTIVITY OF MAKASSAR MARINE CLAY USING FIELD PENETRATION TEST (CPTU) RESULTS

Design and Construction of Auger Cast Piles

product manual HS-4210 HS-4210_MAN_09.08 Digital Static Cone Penetrometer

IN SITU GEOTECHNICAL TESTING USING LIGHTWEIGHT PLATFORMS. Peter Zimmerman, MSCE David Brown, P.G. Geoprobe Systems Salina, Kansas.

CHAPTER 9 LONG TERM MONITORING AT THE ROUTE 351 BRIDGE

Field tests using an instrumented model pipe pile in sand

Assessment of stress history in glacial soils on the basis of cone penetration tests

International Journal of Energy Science and Engineering. Vol. 1, No. 2, 2015, pp

EVALUATION OF TEXAS CONE PENETROMETER TEST TO PREDICT UNDRAINED SHEAR STRENGTH OF CLAYS HARIHARAN VASUDEVAN

Modeling of Cone Penetration Test Using SPH and MM-ALE Approaches

Penetration rate effects on cone resistance measured in a calibration chamber

Some issues related to applications of the CPT

Storing of CO 2 offshore Norway, Criteria for evaluation of safe storage sites

STABILITY ANALYSIS OF AN EARTH DAM FOUNDATION IN TUNISIA

QUESTION TO AUDIENCE

Cone penetration testing, CPTu

CHAPTER 9 SOIL EXPLORATION 9.1 INTRODUCTION

The physical survey is that part of site investigation which aims to determine the physical properties of the ground. These are required:

DYNAMIC CONE PENETRATION TEST INSTRUCTIONAL MANUAL GEOTECHANICAL

CIV SITE INVESTIGATION AND EXPLORATION TABLE OF CONTENTS

Transcription:

Report No:CPT STATIC CONE PENETRATION TEST CPT Cheked by: Date: / / Cone Resistane, q [ MPa ] Frition Ratio, R [ % ]........... Sleeve Frition, s [ MPa ]..... MADE GROUND (Very dense sand) MADE GROUND (Hard sandy lay) Completely weathered CHALK Completely to highly loally partly weathered CHALK End o CPT run at. m Coordinates (metres) : CPT F.CKE/V E - N

Report No:CPT STATIC CONE PENETRATION TEST CPT Cheked by: Date: / / Cone Resistane, q [ MPa ] Frition Ratio, R [ % ]........... Sleeve Frition, s [ MPa ].... MADE GROUND (Medium dense loally loose silty sand with oasional layers o very sti lay) MADE GROUND (Medium dense beoming loose silty sand) Possibly CHALK Completely beoming highly weathered CHALK End o CPT run at. m CPT F.CKE/V

Report No:CPT STATIC CONE PENETRATION TEST CPT Cheked by: Date: / / Cone Resistane, q [ MPa ] Frition Ratio, R [ % ]........... Sleeve Frition, s [ MPa ].... MADE GROUND (Medium dense silty sand) MADE GROUND (Medium dense loally loose and dense silty sand with oasional layers o very sti sandy lay) Possibly CHALK Highly beoming partly weathered CHALK End o CPT run at. m Coordinates (metres) : CPT F.CKE/V E - N

Report No:CPT STATIC CONE PENETRATION TEST CPT Cheked by: Date: / / Cone Resistane, q [ MPa ] Frition Ratio, R [ % ]........... Sleeve Frition, s [ MPa ]...... MADE GROUND (Very dense sand) MADE GROUND (Interbedded medium dense silty sand and hard slightly sandy lay) MADE GROUND (Dense to very dense loally medium dense silty sand with oasional layers o hard slightly sandy lay) MADE GROUND (Medium dense very silty sand) Possibly CHALK Unable to penetrate through very dense or hard material. End o CPT run at. m Coordinates (metres) : CPT F.CKE/V E - N

Report No:CPT STATIC CONE PENETRATION TEST CPT Cheked by: Date: / / Cone Resistane, q [ MPa ] Frition Ratio, R [ % ]........... Sleeve Frition, s [ MPa ]. MADE GROUND (Very dense sand). Unable to penetrate through very dense or hard material. End o CPT run at. m Coordinates (metres) : CPT F.CKE/V E - N

Report No:CPT STATIC CONE PENETRATION TEST CPT Cheked by: Date: / / Cone Resistane, q [ MPa ] Frition Ratio, R [ % ]........... Sleeve Frition, s [ MPa ].. MADE GROUND (Very dense oasionally medium dense silty sand with some layers o hard sandy lay). Unable to penetrate through very dense or hard material. End o CPT run at. m Coordinates (metres) : CPT F.CKE/V E - N

Report No:CPT STATIC CONE PENETRATION TEST CPTA Date:........... Sleeve Frition, s [ MPa ] Cheked by: Cone Resistane, q [ MPa ] Frition Ratio, R [ % ].. MADE GROUND (Very dense silty sand). Unable to penetrate through very dense or hard material. End o CPT run at. m CPTA F.CKE/V

Report No:CPT STATIC CONE PENETRATION TEST CPTB Cheked by: Date: Cone Resistane, q [ MPa ] Frition Ratio, R [ % ]........... Sleeve Frition, s [ MPa ]..... MADE GROUND (Medium dense silty sand) MADE GROUND (Very sti to sti sandy lay) Completely to highly weathered CHALK Partly to slightly weathered CHALK End o CPT run at. m CPTB F.CKE/V

Report No:CPT STATIC CONE PENETRATION TEST CPT Cheked by: Date: Cone Resistane, q [ MPa ] Frition Ratio, R [ % ]........... Sleeve Frition, s [ MPa ]....... MADE GROUND (Medium dense to dense silty loally very silty sand) MADE GROUND (Hard beoming very sti lay) MADE GROUND (Medium dense silty sand) MADE GROUND (Interbedded medium dense silty sand and hard to very sti sandy lay) Highly weathered CHALK Partly beoming slightly weathered CHALK End o CPT run at. m CPT F.CKE/V

Report No:CPT STATIC CONE PENETRATION TEST CPT Cheked by: Date: Cone Resistane, q [ MPa ] Frition Ratio, R [ % ]........... Sleeve Frition, s [ MPa ]...... MADE GROUND (Very dense loally dense sand) MADE GROUND (Medium dense beoming loose silty loally very silty sand) MADE GROUND (Sti lay) MADE GROUND (Very dense to dense silty sand) Completely to highly weathered CHALK End o CPT run at. m CPT F.CKE/V