GS505 User Manual Preface Thank you for purchasing this traveling data recorder from our company. In order to help you operate it correctly, please read this instruction carefully before using. Copyright infringement/ privacy notice Please note that this product is for personal use only, the method of use shall not violate the goods infringe on domestic or international copyright laws. Even recorded images for personal use only, please note that in some
cases to use this product to record performances, exhibitions or business activities of the images may infringe the copyright or other legal rights and interests of others. Installation notes This product should be installed near the rearview mirror, in order to get the best view. To get a better view, please ensure that the recorder is out of the windshield wiper range. Don't touch the lens with fingers, because the finger print may remain on lens and affect video or photograph, so please clean the lens regularly. The matters needing attention Please use the original factory standard charger Please do not open or disassemble the product without authorization, which may lead to electric shock, or equipment damage. Power line modification needs professional operation. Products accessories Below is the standard accessory list and selecting list. If there is any missing or damaged items, please contact your dealer immediately. Standard Selecting Bracket Car charger Manual High speed TF Product structure
Keys and interface function No. name Function 1 MODE For video / picture / the mode button to switch between playback function; 2 Up Menu options to choose, on the function keys; standby or video mode, digital zoom function keys; 3 Down Menu options, downward selection function keys; standby or video mode, digital 4 Menu Continuous short press this key can switch each other in the settings menu; 5 Pause Press this button, the screen becomes black will enter standby mode; 6 TF card slot TF memory card slot, please install in the correct direction prompt; Camera / camera / validation keys, camera mode short press the key to start the camera, 7 OK another short press stop camera; Photo mode short press the key to take photos; menu mode to confirm key; 8 HDMI output HDMI output port,used to connect high-definition display devices. 9 HDMI slot HD output port, used to connect high-definition display devices ; 10 Mount hole The recorder is suspended from the front windshield.; 11 USB slot Used to connect the PC data transmission; the power supply interface, provide working power supply; 12 On/Off Long press the on / off; short press the on / off screen 13 Speaker Voice broadcast; 14 Infrared light In the case of the lighting is not ideal, can choose to open 15 microphone The tape receiving port; 16 Reset System restart reset button; Installation 1. Insert a memory card: please insert the memory card following the suggested direction. The memory card must be a high speed card (above CLASS6). The recorder video storage of high speed card, pay attention to the memory card must be high speed card
(above CLASS6). Note: Please format the memory card for first time use. 2. Remove the memory card: press the inserted card, it will pop out. Note: Please turn off the camera fist, then insert or remove the card. Or it might be damaged. 3. It is better to install it behind the rearview mirror in front of the windshield. 4. Connect to power supply The recorder will only work when plug in to car charger. Note: The wire can be hidden as the above picture shows. 5. Turn on / off (1) Boot device will automatically switch to video mode as soon as you start the engine. Once engine turn off, the device will automatically save the recording and shut down in 15 seconds. (2) Manual on / off: long press button, the device will turn on or off. Set the date and time: 1. As the camera is taking video as soon as turn on, you need to press the OK button to stop recording, then device enters the standby state. 2. Then press the M button twice, then, or to select the date/time, then press the OK button to enter the setting 3. You can pressing the buttons to adjust the value, press the OK button to enter another field. When you complete date and time settings, press M exit. Video Operations 1. When the car engine is started, the device is automatically turned on and start recording. When the engine stalled, then it will automatically stop recording. Or press the OK button. Way manually stop recording.
Note: Some vehicle s cigarette lighter is consistently power on, even after engine turn off. In this situati on, please take the following steps: manually turn on/off the device, or pull the car charger out of the ci garette lighter. 2. Other types of camera: Press the OK button, then start recording ; Press the OK button again, then stop recording. Note: (1) Every 1,3,5 minute, it will save video, please refer to the circulation camera menu. (2) The video will be saved in the camera memory card, if a memory card is full, the oldest file is automatically overwritten memory card. (3) Emergency or for gravity sensing camera, video can not be automatically overwritten, you need to manually delete. 3. Emergency camera Note: If you start a gravity sensor, and detects a collision, the device will automatically lock the current record video will not be overwritten. Photograph operator 1. Press the OK button to stop recording, then press the key to switch to the camera mode, camera icon in the upper left corner of the screen display. 2. Press the OK button to take pictures, take pictures of the screen flashes once to indicate camera complete. Video / photo playback operations 1. As in the camera mode, you need to press the OK button to stop recording. 2. Press the key to switch to the playback mode, the upper left corner of the screen to display the playback iron. 3. Press key up or down to select the file. 4. Press the OK button to play the selected video file ; short press again to pause playback. Menu setting 1, You need to press the OK button to stop recording first. 2. Short press once to M ring up the setup menu, twice on the menu page. 3. By a short press or key, you can cycle up and down to select items in each set. 4. Select the settings you want to change, press the OK button to enter the changes through short. 5. After setting, short press key M to exit standby mode. Special features: 1.Gravity sensor function When the gravity acceleration starts, the machine will automatically save the video when the accident occurred, and the file was not deletable. Gravity sensor can be adjusted in the menu high - medium - low, medium factory default. 2.File locking feature If you press the key while recording, the device will save the current video as a undeletable file.
3. Parking guard function (1) After you start parking guard, when the vehicle turn off, the recorder automatically shutdown, but if the car get external vibration, the recorder will automatically taking video for 10~15 seconds, then shut down; when the car detected shock again, the recorder will record again. (2) Parking guard video is 1080P 30 frames / sec, and the file is automatically locked. Note: The parking guard function must only work in the case of the recorder automatic shutdown, manual start or shutdown, the parking guard does not work. 4.Motion detection function (1) If you set motion detection on, when you press OK to start recording, 10 seconds later it will automatically switches to motion detection standby mode, on the upper left corner of the screen there is a flashing yellow dots, when an object is detected moving, the recorder start recording, the yellow flashing light spot becomes red spot ; motion detection will record 10-30 seconds, then it will automatically enters standby mode, the upper left corner of the screen will again switch to the yellow dot flashes; when once again detects moving objects, the camera function starts again! (2)When the G-sensor gravity sensor starts, the key icon will appear on the screen indicates the current video is locked video ; 5. USB mode Connect the USB cable to the computer, the recorder will automatically pop up the USB menu, there will be the following options: (1) Disk This mode allows you access the video or photo file. (2) Camera Select this mode will bring up the USB video equipment, may carry on the real-time web photo or video chat, can be uses as a PC computer camera. 6.Battery instructions Battery indicator, please refer to the: Sufficient power A low power Low battery The electricity shortage After connected to vehicle power supply, red indicator will light on in the process of charging, the charging time is about 180 minutes, the red indicator will off automatically after full charged. Note: The built-in battery is only for saving the file when parking off, the battery operating time is limited, please link it to vehicle power in daily use. 7.Reset If in the using procedure, the machine is abnormal or dead, you can press the Reset key by using a needle through the holes to reset the machine system. Display interface icons
1. :Camera icon indicates camera mode; :Photo icon indicates photograph mode; :Playback icon, indicating the playback mode; 2. : Flashing red indicates that the camera is work; Yellow dot blinking indicates motion detection is in standby 3. :Gravity sensor icon After opening the gravity sensing this icon will be displayed on the screen; indicates the recording process, when the external shock exceeds the set value, the current camera video will be locked, will be saved as a noncovering non-delectable files. Lock icon is displayed when the video. 4. :Night vision icon; Short press the power button, open and close lamp, or in the menu Settings. When infrared light is on, the screen shows the icon. 5. :Lock icon is displayed when the video is lock; When the G-sensor gravity sensor starts, the key icon will appear on the screen indicates the current video is locked video ; 6. : Sound Recording Open icon. Sound Recording Close icon. Set on or off in the Settings menu and synchronized this icon appears, indicating the current sound recording
function on or off ; Short press the Menu key while recording, you can quickly open and close the sound recording. 7. 00:00:00 Yellow font - memory cards remaining recording time / red font - current segment recording time ; After inserting a memory card, when standby, the white font shows the remaining space of can recording time; red font shows the current time- segmented; 8. 1080FHD: Video resolution icons ; Display the currently selected video resolution ; 9. Parking guard icon ; Display icons for parking guard function turned on 10. Battery level icon ; shows the current power ; 11. 22:16:49 Time display shows the current time ; Please set it up before first use ; 12. 2014/01/01 :Date display, showing the current dates, please set it up before first use ; 13. :Motion detection icon ; when the left side of the screen displays the icon, it indicates that the feature is activated. 14. :EV exposure compensation icon indicates the currently selected exposure parameters ; 15. :Wide dynamic icon: when the left side of the screen displays the icon, it indicates that the feature is activated. Recommend it for often open. 16. :Cycle Record icon representing the cycle time is 3 minutes; Menu options are:3-5-10-off Settings Menu Menu Explanation Available options Resolution Set the video resolution 1080FHD 720P VGA Loop recording Set up each video file length 3minute, 5 minutes, 10minutes, turn off; if you choose to close the case, the card will not automatically cycle full coverage. WDR Wide Dynamic automatic adjustment of light On, Off, the proposed full-time open Exposure Underexposed, dim the screen, you need to fill +0.0-1/3-2/3-10 -4/3-5/3-2.0 +2.0 +5/3 +4/3 Compensation light +10+2/3 +1/3 Motion Detection In standby mode,automatic record when etecingt On, Off moving object Sound recording The sound recording function is on or off On, Off Date Label Watermark of date on camera video On, Off Gravity sensor Collision generated video never be covered High, medium, low, off Date / Time Date and Time You can set the year, month, day, hour, minute, second Beep During operation, the key is with sound On, Off Language Settings Language shows in menu Traditional,Simplified Chinese, Russian, Japanese, French, Italian, German, Spanish, English, Korean Light frequency Lights flicker frequency 50Hz. 60Hz, Automatic shutdown No automatic shutdown operating state 1minute, 3minutes, 5minutes, off
Night Lights Fill light in the dark state by [R On, Off Parking guard After parking, if the car get external vibration, On, Off the recorder will automatically taking video License Plate Can shows your license no. in video recording A00000 Format Micro SD The default setting Restore factory settings Cancel, OK Screen Saver Recorder automatically turns off the display work On, Off Version Software version shipped software version number Product Specifications: Product Name HD drive recorder Division date Support Built in memory (total amount: Product Features Extremely wide angle of 170 degrees,1080p Full HD Vector Media 1024MB) G-sensor Built-in ( under the car accident case of emergency save, not to be deleted) Camera mode 1200M LCD screen size 3.0 inch high definition LCD screen Photo format JPEG Shot A + grade high-resolution 170-degree ultra- wide-angle lens Memory Card Micro SD (Max support 64GB) Language Russian, English, Chinese(Traditional ), Korean, Japanese, etc. Microphone Support File Format MOV Built-in stereo Support Video Resolution 1920*1080P 1280*720P IR Support video format H. 264, Audio: AAC Video Format PAL/NTSC Color effects Standard Current Frequency 50HZ/60HZ Continuous loop recording Seamless loop recording, no leakage seconds USB 1: USB-Disk 2: PC-Camera Auto on/off Support auto ignition on, turn off Power supply interface 5V 1A Motion detection Support Battery Batt-in300mAh Troubleshooting: The trouble you might meet: Unable to boot: Check if the recorder and car charger connected correctly, please manually turned on, check if the battery level is too low needs recharging.if it is procedural questions please press the Reset button to restore to factory settings. The camera automatically stops recording, or do not cycle record: Due to the huge high-definition video data, Please use the high-speed TF card, such as C10 high speed card. Not cycle recording is also possible that gravity sensor opens, the memory card are all locked file. Please close gravity sensor, and format the memory card. Each recording time is different with the setted cycle time: Check to see if motion detection function open, because the recording time is depending on if there is movement, when motion detection function on. The video recorded is not clear: Please check whether there is swag, finger print on the camera lens.
Please clean the lens before shooting, and keep the lens clean. Images have streaks: This is due to the wrong setting of " light frequency" and caused under the fluorescent lights, the domestic light frequency is "50HZ". When the machine is crash: When the machine is crash, briefly press the "Reset" button to restore restart.