OLDING INANT AR SAT STATION OR HOM AND AWAY Read all instructions BOR assembly and US of product. KP INSTRUTIONS OR UTUR US. Remove product from the box and remove all packaging materials. aution: make sure to throwaway all packaging materials. Make sure to inspect every part to make sure there are no broken or missing parts. If so, do not use and contact us! MODL # GT111003 A PRN: AIM-GT111003-PNX [15.06.04]
WARNING WARNING: Please follow all of these instructions to ensure the safety of your child. Keep these instructions for future reference. WARNING: Adult assembly required. WARNING: ailure to follow these instructions could result in serious injury or death. Avoid serious injury from falling or sliding out, always use the safety harness and insure that the children are properly positioned according to these instructions. WARNING: Never leave children unattended. WARNING: are must be taken when folding and unfolding the GoTo to prevent finger entrapment. WARNING: Prevent serious injury or death from falls or sliding. Always use seat belt. Secure your child at all times with the restraint. WARNING: This product is designed to be used by a child up to 3 years of age. Maximum weight 40 pounds (18kg). aution: Be certain the GoTo is completely opened and locked in place before allowing a child near the product. Never use near steps or uneven surfaces. Never allow your GoTo to be used as a toy. heck your GoTo for loose screws, worn parts, torn materials or stitching on a regular basis. Replace or repair parts as needed. Discontinue use should it malfunction or become damaged. Please contact our customer care department to arrange for repair or obtain replacement parts if needed. If you experience any difficulty with the use of our product or have a question regarding these instructions, please contact our customer care department at 800-704-9058. To clean use only mild household soap or detergent and warm water on a sponge or clean cloth. ustomer are: www.phoenix-baby.com 2
HARDWAR A Padded Bar (x2) B-1 (x1) B (x3) B ross Bar (x4) Hook D-L D eet (x4) D-R Lower (x4) Bolt (x8) Padded Bar Adjuster Bottom Sliding Lever Top Side (x2) 3
ASSMBLY INSTRUTIONS 1 STP 1A or ease of assembly your GoTo has been partially assembled. If any of the parts come apart when you unpack the product from the box. Please turn to page 11. D STP 1B Grab the foot of the GoTo and rotate outward until it locks-as shown. Make sure fingers are not close to joint. Repeat with the 3 other legs. STP 1 D D Warning : Avoid INGR NTRAPMNT : Use care when folding and unfolding the GoTo. 4
ASSMBLY INSTRUTIONS 2 When attaching the crossbars, one of the bars has 2 holes, make sure to place that bar thru 1 of the feet part B-1 in step 4. Bolt bars in using the bolt part (). B-1 D-R 3 B 5
ASSMBLY INSTRUTIONS 4 B B B B-1 D-L D-R 5 Label B-1 Line up the sleeve in the fabric and slide across the tubes. Make sure the cut out area in the fabric lines up with B-1 so that the vibrator can be attached. 6
ASSMBLY INSTRUTIONS 6 D-R Hook D-L Attached second side to unit using bolts (). 7 Make sure to tighten all bolts (). B B Label B B-1 7
ASSMBLY INSTRUTIONS 8 Label D-L B-1 D-R 9 1. Make sure the 4 adjusters are pointing up. If you need to adjust them, push in the adjuster button and rotate til pointing up. 2. Make sure all adjusters line up, you may need to slide them as shown to line up. Push in slider level to move. Slider Level Label 8
ASSMBLY INSTRUTIONS 10 Label D Attach the 4 elastis loops on the fabric basket to the 4 hooks on the lower legs. B B Label D-L D-R 9
ASSMBLY INSTRUTIONS 11 A Label Push padded Bar (A) down until it locks in the down position. Pull up to make sure part (A) is loked down. Repeat on other slide with part (A) A Label 10
ASSMBLY INSTRUTIONS If a part has separated when they were unpacked. Please follow this steps. Then go to back page. 1 Slide feet part (D) onto lower leg () and insert bolt () thru feet part (D) Note: there are right and left sides to the feet Make sure you match the part to the photo. Repeat on all 4 feet. Make sure all 4 feet are flush to the floor-as shown. Hook D-L D-R 2 Make sure hook is facing in and the adjuster button is facing out. Hook Slide together part () and Part () as shown. Insert bolt () thru hole. See step 2A and 2B in next page. 11
ASSMBLY INSTRUTIONS 2A 3A D-L Hook D-R 12
ASSMBLY INSTRUTIONS 1 A 2 A 3 A 13
TO OLD 1 2 Pull down on the lower bar (B)until the 2 legs separate from part (). ontinue to fold legs until they are underneath as shown, repeat on other side. 14
TO OLD 3 Push in Adjuster button and rotate padded bar dow as shown 4 Warning: AVOID INGR NTRAPMNT: Use care when folding and unfolding. Make sure no children are near. 15
PRODUT RGISTRATION IMPORTANT: Please fill in your contact info on the bottom part of the card, separate from top card and mail to us. Note, postage is prepaid if mailed in the United States. Keep the top portion for your records. This information is important to us should we need to contact you regarding the safety of this product. Manufacturer's ontact Information/oordonnées du fabricant Phoenix Baby, LL. (c/o RBO, LL.) 501 S 9TH Street, Reading, PA 19602 USA ustomer are: 1-800-704-9058 -Mail: customercare@phoenix-baby.com www.phoenix-baby.com Product Model/Modèle de produit#: www.phoenix-baby.com Shipment Ref./Réf. d'xpédition#: Manufacture Date/date de fabrication: www.phoenix-baby.com KP THIS TOP PART OR YOUR RORDS. ILL OUT AND RTURN BOTTOM PART. GARDR TT PARTI SUPÉRIUR POUR VOS DOSSIRS. RMPLIR T RNVOYR PARTI INÉRIUR. Name/nom Mailing Address/Mailing Address ity/ville State/état Zip ode/ode postal Telephone Number/numéro de téléphone Phoenix Baby, LL. c/o RBO, LL. PO BOX 91058 ALLNTOWN PA 18109-9917 ront -mail Address/Adresse -mail Product Model /Modèle de produit#: Shipment Ref./Réf. d'xpédition#: Manufacture Date/date de fabrication: Back PRODUT PAKAGING INORMATION Model #: GT111003 501 S 9th street, Reading, PA 19602 USA www.phoenix-baby.com MAD IN HINA olor: Shipment Ref. #: Date: 16