DVB USB-Tuner Catcher Hardware Engineering Specification 3 th October 2005 Rev R01 1/11
Revision History Project Name DVB USB-Tuner Catcher Rev. Date Page Section Description R01 10/3/2005 All All Initial Release. 2/11
TABLE OF CONTENTS 1. Introduction..... 4 1-1 General Description.. 4 1-2 System Overview.. 4 2. System Architecture..... 6 2-1 Block Diagram.. 6 2-2 Function Description. 7 2-2-1 Master Chipset Description.... 7 2-2-1-1 MicroTuner MT2060....... 7 2-2-1-2 Demodulator AF9005..... 8 3. Electrical Characteristic.. 9 3-1 Absolute Maximum Ratings... 9 3-2 Recommended Operating Conditions. 9 3-3 Leakage Current and Capacitance.. 9 3-4 DC Electrical Characteristics of 3.3V I/O Cells 10 3-5 USB Transceiver Charscterisrics...10 4. Environmental Specifications....... 11 3/11
1. Introduction 1-1 General Description The DVB-T enables you to receive free digital TV channels in DVB-T standard format on your PC or notebook computer. This small 8cm long multi-function piece of equipment fits into any shirt pocket. Thanks to the included antenna you can enjoy the same advantages as a bigger DVB-T receiver offers; for instance: Electronic Program Guide (EPG), Video text or playing 16:9 and 4:3 file formats. 1-2 System Overview Fully integrated tuner with low-noise amplifier(vlna),first IF filter(fiff), variable-gain IF amplifier(vga),mixers and frequency synthesizers, integrated voltage controlled oscillators(vcos),and serial interface 48MHz to 860MHz input frequency range 5V power supply with multiple power modes Single-ended RF input reduces BOM by eliminating input balun Eliminates the need for the 28V to 33V supplies typically required by traditional cable tuners Works seamlessly with all analog and digital demodulators Low power dual-conversion architecture Minimal external components No tunable parts required 4/11
Integrated IF variable gain amplifier for direct connection to digital demodulators Can drive two second IF SAW filters to support mixed analog/digital applications with no additional circuitry Low phase noise for excellent performance in QAM 64 and QAM 256 systems Low noise figure Software shutdown mode Frequency synthesizers fully programmable via serial-control interface Two general-purpose outputs controllable via serial-control interface Intermediate frequency (IF)output fully compatible with NTSC,PAL, SECAN,DAVIC,DVB-C,DOCSIS,EuroDOCSIS and other standards Integrated temperature sensor Integrated USB controller Enhance portability performance to meet mobile scenario(90~100km/h) Application: PC/NB Low power consumption(<400mw) Digital carrier frequency offset correction +/- 500KHz Digital crystal freq. jitter +/- 100ppm compensation 5/11
2. System Architecture 2-1 Block Diagram DVB antenna Standard IEC or F connector (75ohm MCX) USB A Type connector NB/PC 6/11
2-2 Function Description 2-2-1 Master Chipset Description 2-2-1-1 MicroTuner MT2060 The MicroTuner MT2060 is an advanced,low-power single-chip broadband tuner that has been optimized for high-performance cable modems and digital cable set-top boxes that require low composite distortion and noise under digital cable environments. It supports all high performance video,voice,and data applications. Voice over IP (VoIP) Telephony Modems Cable Modems Digital Set-top Boxes(STB) Home Gateways PC TV Multi-media Applications LCD Flat Panel TVs PacketCable E-MTAs Digital terrestrial Enhance portability performance to meet mobile scenario(90~100km/h) 7/11
2-2-1-2 Demodulator AF9005 Digital carrier frequency offset correction +/- 500KHz Digital crystal freq. jitter +/- 100ppm compensation Integrated USB IP Hardware PID filter integrated for high bit rate DVB-T TV programs Offers superior performance Robust Doppler immunity in mobile/portable reception Superior dynamic multi-path performance in long echo environment Integrated ADC,PLL,and dual SD (sigma-delta) AGC (RF and IF) Digital carrier frequency offset correction +/- 500KHz Digital crystal freq. jitter +/- 100ppm compensation 8/11
3. Electrical Characteristic 3-1 Absolute Maximum Ratings Table 3-1 Absolute Maximum Ratings 3-2 Recommended Operating Conditions Table 3-2 Recommended Operating Conditions 3-3 Leakage Current and Capacitance Table 3-3 Leakage Current and Capacitance 9/11
3-4 DC Electrical Characteristics of 3.3V I/O Cells Table 3-4 DC Electrical Characteristics of 3.3V I/O Cells 3-5 USB Transceiver Charscterisrics Table 3-5 USB Transceiver Charscterisrics 10/11
4. Environmental Specifications High / Low Temperature Cycling test Durability test Insertion/Removal Cycling test Vibration test Mechanical Shock test Drop test Regulation * Operating(read function) : - 20 to 65 * Test Cycles: 10.000 cycles * Cycle rate: 500 cycles / hour *Wave form: sine wave *Frequency : 10 ~ 55 Hz *Amplitude : 1.52mm *Sweep rate : 0.5minutes/sweep *Direction : X, Y, Z axes *Duration : 120minutes / axis *Wave form: Half sine wave *Acceleration : 50G *Pulse durstion : 11mS *Shock direction : 6 face *Drop height : 100cm *Drop sequence : X, Y, Z axes *Test surface : steel plate of 1cm thickness *CE 11/11