Material Safety Data Sheet Section 1. Chemical product and company identification Trade name Product use Supplier Code Date of issue OASIS 266 OASIS 266 All Purpose Cleaner Ecolab Co. 5105 Tomken Road Mississauga ON L4W 2X5 1-800-352-5326 985606 10-February-2006 EMERGENCY HEALTH INFORMATION 1-800-328-0026 Outside United States and Canada CALL 1-651-222-5352 (in USA) Section 2. Composition, information on ingredients Name CAS number% by weight poly(oxy-1,2-ethanediyl),.alpha.-(nonylphenyl)-.omega.-hydroxy- 9016-45-9 5-10 acetic acid, (ethylenedinitrilo)tetra-, tetrasodium salt 64-02-8 1-5 xylenesulfonic acid, sodium salt 1300-72-7 1-5 quaternary ammonium compounds, benzyl-c12-c16-alkyldimethyl, chlorides 68424-85-1 0.5-1.5 ethanol 64-17-5 0.1-1 Section 3. Hazards identification Physical state Emergency overview Routes of entry Liquid. (Liquid.) CAUTION! MAY CAUSE RESPIRATORY TRACT, EYE AND SKIN IRRITATION. Avoid contact with eyes, skin and clothing. Avoid breathing vapour or mist. Keep container closed. Use only with adequate ventilation. Wash thoroughly after handling. contact, Eye contact,, Potential acute health effects Moderately irritating to eyes. Moderately irritating to the skin. Moderately irritating to the respiratory system. No known significant effects or critical hazards. See toxicological information (section 11) Section 4. First-aid measures Eye contact Contact In case of contact, immediately flush eyes with cool running water. Remove contact lenses and continue flushing with plenty of water for at least 15 minutes. Get medical attention if irritation persists. Wash with soap and water. Get medical attention if irritation occurs. Wash clothing before reuse. If inhaled, remove to fresh air. Do NOT induce vomiting unless directed to do so by medical personnel. Never give anything by mouth to an unconscious person. If potentially dangerous quantities of this material have been swallowed, call a physician immediately.
OASIS 266 Page 2/5 Section 5. Fire-fighting measures Auto-ignition temperature Flash point Flammable limits Upper Lower Products of combustion Fire-fighting media and instructions > 100 C Use an extinguishing agent suitable for the surrounding fire. Dyke area of fire to prevent runoff. No specific hazard. Special protective equipment for fire-fighters Fire fighters should wear appropriate protective equipment and self-contained breathing apparatus (SCBA) with a full face-piece operated in positive pressure mode. Risk of explosion of the product in the presence of mechanical impact Risk of explosion of the product in the presence of static discharge Section 6. Accidental release measures Personal Precautions Environmental precautions Methods for cleaning up Ventilate area of leak or spill. Do not touch damaged containers or spilled material unless wearing appropriate protective equipment (Section 8). Stop leak if without risk. Prevent entry into sewers, water courses, basements or confined areas. Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains and sewers. If emergency personnel are unavailable, contain spilt material. For small spills, add absorbent (soil may be used in the absence of other suitable materials), scoop up material and place in a sealable, liquid-proof container for disposal. For large spills dike spilled material or otherwise contain material to ensure runoff does not reach a waterway. Place spilled material in an appropriate container for disposal.-- Section 7. Handling and storage Handling Storage Avoid contact with eyes, skin and clothing. Keep container closed. Use only with adequate ventilation. Avoid breathing vapour or mist. Wash thoroughly after handling. Keep out of the reach of children. Keep container tightly closed. Keep container in a cool, wellventilated area. Do not store above 50 C Section 8. Exposure controls, personal protection Engineering controls Provide exhaust ventilation or other engineering controls to keep the airborne concentrations of vapours below their respective occupational exposure limits. Personal protection Eye protection recommended. Hands For prolonged or repeated handling, use Impervious gloves. No protective equipment is needed under normal use conditions. Respiratory Avoid breathing vapour or mist. Name Exposure limits ethanol ACGIH TLV (United States, 1/2004). TWA 1880 mg/m 3 8 hour(s). Form All forms TWA 1000 ppm 8 hour(s). Form All forms
OASIS 266 Page 3/5 Section 9. Physical and chemical properties Physical state Colour Odour ph Boiling/condensation point Melting/freezing point Specific gravity Vapour pressure Vapour density Odour threshold Evaporation rate LogKow Liquid. (Liquid.) Yellow. citrus 8.25 (100%) >100 C 1.04 (Water = 1) Not applicable. Section 10. Stability and reactivity Stability The product is stable. Conditions of instability Reactivity Slightly reactive to reactive with acids. Incompatibility with various substances Hazardous Decomposition Products Section 11. Toxicological information Potential acute health effects Moderately irritating to eyes. Moderately irritating to the skin. Moderately irritating to the respiratory system. No known significant effects or critical hazards. Irritancy of Product Hazardous by WHMIS criteria. Potential chronic health effects Carcinogenic effects No known significant effects or critical hazards. Mutagenic effects No known significant effects or critical hazards. Teratogenic effects No known significant effects or critical hazards. Reproductive effects No known significant effects or critical hazards. Sensitization to Product No known significant effects or critical hazards. Synergistic products (toxicologically) Toxicity data Ingredient name Test Result Route Species poly(oxy-1,2-ethanediyl), 1310 mg/kg Rat.alpha.-(nonylphenyl)-.omega.- hydroxyquaternary ammonium compounds, benzyl-c12-c16- alkyldimethyl, chlorides 426 mg/kg 919 mg/kg Rat Mouse ethanol Target organs LDLo LDLo 7060 mg/kg 6300 mg/kg 3450 mg/kg 1400 mg/kg 5500 mg/kg Rat Rabbit Mouse human Dog Contains material which causes damage to the following organs eye, lens or cornea.
OASIS 266 Page 4/5 Section 12. Ecological information Ecotoxicity data Ingredient name Species Period Result poly(oxy-1,2-ethanediyl),.alpha.- (nonylphenyl)-.omega.-hydroxy- acetic acid, (ethylenedinitrilo)tetra-, tetrasodium salt quaternary ammonium compounds, benzyl-c12-c16- alkyldimethyl, chlorides ethanol Products of degradation Oncorhynchus mykiss (LC50) Pimephales promelas (LC50) Pimephales promelas (LC50) Daphnia magna (LC50) Section 13. Disposal considerations 1.3 mg/l 4.7 mg/l 7.6 mg/l 7.9 mg/l >10 mg/l >1000 mg/l 486 mg/l 1030 mg/l 2070 mg/l 3092 mg/l 0.0059 mg/l 0.037 mg/l 0.052 mg/l 0.28 mg/l 0.32 mg/l 0.51 mg/l 2 mg/l 9.3 mg/l 13000 mg/l Oncorhynchus mykiss (LC50) These products are carbon oxides (CO, CO 2) and water, nitrogen oxides (NO, NO 2...), sulphur oxides (SO2, SO3, etc.). Some metallic oxides. Waste disposal The generation of waste should be avoided or minimised wherever possible. Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains and sewers. Disposal of this product, solutions and any by-products should at all times comply with the requirements of environmental protection and waste disposal legislation and any regional local authority requirements. Consult your local or regional authorities. Section 14. Transport information Regulatory information TDG Not Classification regulated. UN number Proper shipping name Class Packing group - - - - Additional information APPLIES ONLY DURING ROAD TRANSPORT Any variation of the shipping description based on the packaging is not addressed. Section 15. Regulatory information WHMIS Class D-2B Material causing other toxic effects (Toxic). This product has been classified in accordance with the hazard criteria of the Controlled Products Regulations and the MSDS contains all the information required by the Controlled Products Regulations.
OASIS 266 Page 5/5 Section 16. Other information Date of issue 10-February-2006. Responsible name Regulatory Affairs Date of previous issue 04-January-2006. Notice to reader The above information is believed to be correct with respect to the formula used to manufacture the product in the country of origin. As data, standards, and regulations change, and conditions of use and handling are beyond our control, NO WARRANTY, EXPRESS OR IMPLIED, IS MADE AS TO THE COMPLETENESS OR CONTINUING ACCURACY OF THIS INFORMATION.