Watertreatment and primary care. BALLING Light. Calcium, Magnesium, Alkalinity +Trace Elements. www.faunamarin.com



Similar documents
ENE 806, Project Report 3 CHEMICAL PRECIPITATION: WATER SOFTENING. Grégoire Seyrig Wenqian Shan

Comparison of the Effects of Increased CO 2 in the Air to Seawater and Distilled Water

Chloride and Salinity

5.0 EXPERIMENT ON DETERMINATION OF TOTAL HARDNESS

Determination of calcium by Standardized EDTA Solution

ACID-BASE TITRATIONS: DETERMINATION OF CARBONATE BY TITRATION WITH HYDROCHLORIC ACID BACKGROUND

Understanding ph management and plant nutrition Part 5: Choosing the best fertilizer

WATER CHEMISTRY AND POOL WATER BALANCE

Factors Affecting Precipitation of Calcium Carbonate

VIPCLEAN Via Goretta 96/A Mappano di Caselle (TO) Tel Fax

Best Practice in Boiler Water Treatment

Ion Exchange Design Hand calculation. Brian Windsor (Purolite International Ltd)

After the reactor has been running and the air in the chamber has been purged the co2 can be introduced and the dial in process can begin.

Simulation of the determination of lead azide content in waste water from explosives manufacture

Additional Lecture: TITRATION BASICS

ION EXCHANGE FOR DUMMIES. An introduction

Preparation of frequently used solutions

Estimation of Hardness of Water by EDTA Method

ECOAZUR BLUEWATER WATER PURIFICATION PLANTS

DEIONIZATION IN A "NUT SHELL"

4.0 EXPERIMENT ON DETERMINATION OF CHLORIDES

Cadmium Reduction Method Method to 30.0 mg/l NO 3 N (HR) Powder Pillows or AccuVac Ampuls

Quaternary Ammonium Compounds DOC

Complexometric Titration Analysis of Ca 2+ and Mg 2+ in seawater

Properties of Acids and Bases

ph Regulation of Seawater: The Role of Carbonate (CO3) and Bicarbonate (HCO3)

USEPA 1 FerroVer Method 2 Method to 3.00 mg/l Fe Powder Pillows or AccuVac Ampuls

Testing Water for Gardening and Lawn Irrigation

FerroVer Method 1 Method to 3.0, 1.0 to 30.0 and 10.0 to mg/l Fe Powder Pillows

Determining the Quantity of Iron in a Vitamin Tablet. Evaluation copy

Adjusting Chemical Levels in a Swimming Pool

Scientific Opinion on the safety and efficacy of sodium carbonate (soda ash) for all species 1

Dimethylglyoxime Method Method to 6.0 mg/l Ni TNTplus 856

Swimming Pool and Spa Water Chemical Adjustments

North East Regional Heat Schools Analyst Competition Coral in Distress

ALS TRIBOLOGY Engine Coolant Reference Guide

Determination of the amount of sodium carbonate and sodium hydroxide in a mixture by titration.

Product list Magnesium, Calcium and further mineral compounds

ION EXCHANGE RESINS INTRODUCTION

4 Stage Barracuda RO/DI Instruction & Owner s Manual

It's in the details. JOST MINERAL GUIDE

Chapter 5, Lesson 3 Why Does Water Dissolve Salt?

b. Alkalinity make your life easier and get the alkalinity between 80 and 120 PPM. c. ph from 7.2 and 7.8 so that the other chemicals work properly

WATER QUALITY CRITERIA

RO / NF Cleaning Guidelines

Elemental composition of commercial seasalts

8 Chemicals from water treatment and distribution

Complexometric Titrations

STOCKMEIER water chemicals Strong bonds for clear water

the importance of ph in water purification the importance of ph in water purification Water Purification Systems UK

Troubleshooting Your RO

Properties of Hydrates Prelab. 3. Give the chemical formula for copper(ii) nitrate pentahydrate.

Wastewater Reuse. Typical treated wastewater is:

Fountain Solution in Offset Printing INK ACADEMY

CONDUCTIVITY SENSOR. Description D0382. Figure 1. The Conductivity Sensor

THE USE OF OZONE IN COOLING TOWERS

drinking water medication short guide

Lead Testing and On Site Calibration for Water Testing Detection Range: 2 100ppb

Exp 13 Volumetric Analysis: Acid-Base titration

Keeping Your Swimming Pool and Spa Healthy Environmental Health Guide

Test Methods for the Colour Fastness of Leather & Dyes. TFL Leather Technology Ltd. Quality and Environment February 2004 Version 1.

KODAK Developer System Cleaner and Neutralizer

Compounds vs mixtures. Physics and Chemistry IES Jaume Salvador i Pedrol February 2009

DRINKING WATER - LAB EXPERIMENTS. Coagulation and flocculation LAB EXPERIMENTS. Jartest

Hydrochemistry. Deacidification. Junianti Roslinda Sihombing. Practical Date : Monday, Report Delivery : Monday,

Organic Chemistry Lab Experiment 4 Preparation and Properties of Soap

Ion Exchange Softening

Solutions: Molarity. A. Introduction

The role of CO 2 in pool water

SODIUM CARBOXYMETHYL CELLULOSE

Ultrasonic cleaning technology and cleaning chemicals

Molarity of Ions in Solution

Chapter 16: Tests for ions and gases

The Relationship between ph and Deionized Water

TOTAL PROTEIN FIBRINOGEN

Teacher Demo: Turning Water into Wine into Milk into Beer

This value, called the ionic product of water, Kw, is related to the equilibrium constant of water

CHEMICAL PRECIPITATION: WATER SOFTENING

Phosphorus, Reactive (Orthophosphate)

Experiment 5. Chemical Reactions A + X AX AX A + X A + BX AX + B AZ + BX AX + BZ

Portable Swimming Pool Reverse Osmosis Systems

ACID START-UP FOR POOL BUILDERS & SERVICE PROFESSIONALS

Inferred ph in Steam Plant Water Chemistry Monitoring

Water Info. What is Reverse Osmosis?

Sodium and Potassium chlorate synthesis, the complete guide

Number of moles of solute = Concentration (mol. L ) x Volume of solution (litres) or n = C x V

The Chemical Adjustment Reference Cheat Sheet

Experiment 12- Classification of Matter Experiment

CERTIFICATE OF ANALYSIS Methyl 4-Hydroxybenzoate

Water Softening for Hardness Removal. Hardness in Water. Methods of Removing Hardness 5/1/15. WTRG18 Water Softening and Hardness

Design of Purified Water and Water For Injection Systems. Hugh Hodkinson Engineers Ireland Chemical & Process Division

Chem101: General Chemistry Lecture 9 Acids and Bases

Chapter 4, Lesson 5: Energy Levels, Electrons, and Ionic Bonding

C-100E Strong Acid Cation Exchange Resin (For use in water softening applications)

AIRMoN, ph and Conductivity Field Measurement

IMPORTANT: Spa Owner, save this manual. Installer, leave this manual with the spa owner.

DRUG CALCULATIONS. Mathematical accuracy is a matter of life and death. [Keighley 1984]

Calculation of Molar Masses. Molar Mass. Solutions. Solutions


FERTIGATION. Lawrence J. Schwankl

Transcription:

High Quality Reef Keeping Products High Quality Reef Keepin Watertreatment and primary care BALLING Light Calcium, Magnesium, Alkalinity +Trace Elements www.faunamarin.com

Introduction The well-known and popular Balling method is an extremely simple method for providing your aquarium with calcium, magnesium, carbonate hardness and trace elements. In Germany this method has practically replaced the previously popular calcium reactor. An increasing number of marine aquarists also use our Fauna Marin Balling salts with a calcium reactor in order to manually compensate for chemical imbalances, such as those that can occur when operating such a reactor. To provide an optimum supply for a marine aquarium, these substances are added daily by hand or using a dosing pump. Strong lighting, stony coral husbandry, artificial reef decoration and special bacterial preparations have changed the water chemistry requirements and made it necessary for the Balling Classic method to be adapted. With this in mind, Fauna Marin have developed a new Balling method approach and adapted it to the present conditions of modern reef aquaristics.

Introduction Our salts comply with pharmaceutical purity levels and are packaged accordingly in a protected manner. Not only do we take the datasheet into consideration we also check organic and inorganic trace elements as well as the effectiveness of the salts. In our salts we use additional bioactive stabilisers, ph buffers and special minerals which significantly increase the stability of the chemical parameters in the aquarium. The added trace elements are more stable in the solution and are thereby more accessible to the coral. By using salt mixtures, this Balling Light method brings with it minerals and trace elements that are either missing from or only present in small amounts in commercially available sea salts. The supply of bioactive components and the purity of the salts prevents the coral from darkening and enhances its growth and colouration. Fauna Marin Balling salts are simply beyond comparison! More effective, thanks to the highly purified salts with extremely low water content Salt mixtures for improved stability of important parameters Tailored to modern sea salts Stable PH value Supply of bioactive substances for improved colouration and coral growth

Fundamental Values The following values should be produced during continuous operation. Calcium 380 420 mg/litre Magnesium 1200 1350 mg/litre Alkalinity 6,5 8 dkh Salinity 33 35 per mil Instructions for the Balling Light method Three 5-litre canisters are to be prepared separately CAUTION Always add the salt to the water never the other way round! 1st Canister - Calcium Dissolve 2.0 kg of Fauna Marin calcium chloride dihydrate mixture into 4 litres of osmosis water and then fill the canister with osmosis water. Then add: 25 ml Ultra Trace B Color and Grow Elements (1) - strontium/barium complex 25 ml Ultra Trace B Metabolic Elements (2) - heavy metal complex to the canister.

2nd canister - magnesium Dissolve 2.0 kg Fauna Marin magnesium chloride hexahydrate mixture into 4 litres of osmosis water and then fill the canister with osmosis water. The new method does not require magnesium sulphate as it becomes too strongly concentrated and causes ion displacement in the aquarium water. Nothing else is added to this canister! 3rd canister - alkalinity/carbonate hardness Dissolve 500 g of sodium bicarbonate mixture into 4 litres of osmosis water and then fill the canister with osmosis water. Then add: 25 ml Ultra Trace B Health Elements (3) - iodine/flour complex to the canister. Tipps und Hinweise Larger canisters can also be used; you will simply need to extrapolate the quantities added for each canister Use lukewarm water to dissolve the carbonate. A small residue will always be left over in this canister. However, this has no effect on the stability of the solution. A slight discolouration of the solutions is normal, and is due to the addition of bioactive substances and trace elements. This has no impact on the quality or stability of the solutions. After dissolution the solutions can be stored indefinitely.

The reguarly doasge The more regularly the solutions are added - the more stable are the values in your system. We recommend using the Fauna Marin Balling Light dosing computer, which has been specially developed for this method, or the corresponding model from GHL for the Profilux aquarium computer. The three canisters are now connected to an appropriate dosing computer via 4/6 mm PVC tubes. Tip - Drill a small hole into the lid of the canister and insert a 4 mm PVC rod all the way down into the canister. Then connect the rod to the 4/6 mm tube. You can then use the entire contents of the canister. Adding the solutions Depending on the content of the aquarium, the individual solutions are now metered manually in order to determine the actual requirements. Before doing this, determine the current water values and make a note of the results. (Ca, Mg, Alk) Example: 50 ml of canister 1 into a 500-litre aquarium. Value before dosing = 380 mg of calcium. After 2 hours, repeat the test the calcium value after the 2nd test is then 400 mg of calcium. In this example, the addition of 50 ml of the solution from canister 1 increases the calcium value by 20 mg/litre for a 500-litre aquarium. Now program the dosing computer to add 7 ml of solution 1 once a day, i.e. 50 ml of the solution spread over a week. After a week measure the calcium value again and note it has only risen to 390 mg/litre, although in a pure arithmetic sense this should have risen to 400 mg/litre. This method determines the actual loss of calcium that is to be compensated in the system. Due to chemical precipitation, growth or the use of water treatment agents, the actual calcium loss that is determined may differ from the calculated value. You can now easily adjust the dosage level by increasing the value by 3 ml per day. 50 ml = +20 mg/7 days = 7 ml Therefore, to obtain the value + 30 mg, 75 ml/7 days = 10 ml must be added. Using this simple 3-part calculation you can easily adjust each of your desired values and set an automatic dosing schedule in just a few days. A daily inspection of the calcium (Ca test), magnesium (Mg test) and dkh values (KH test) is to be conducted at the start and the dosing quantity must be adjusted on the device if necessary.

Advice The Fauna Marin dosing computer is ideal for this application, as each channel can be individually adjusted and the substances can be dosed at 5 minute intervals twice per day. After no more than 2 weeks, you will have determined the specific requirements for your aquarium and set the dosing unit accordingly. The fact that mineral salt is no longer used for the Balling Light method (this is used in the traditional method) is not only due to regular water changes, but the volume of dissolved trace elements in our aquariums, which is generally too high. Therefore, the often mentioned ion displacement factor is only applicable based on theoretical consideration of the Balling method. The regular exchange of water helps your system to dilute unwanted substances and it makes it very easy to adjust and control salinity levels. The addition of trace elements in the canister is used to compensate (balance) the Balling solutions and provides a nature similar water chemistry in your reefaquarium. If you have the need for an additional dose of elements (coloration), use our new Color Elements. T hese additional elements can significantly enhance the colors of your corals and stimulate growth. Naturally, the system is also suitable for manual dosing. To do this add the solutions to a well-circulated area of the tank. There should be an interval of approx. 10 minutes between the doses. Start by adding magnesium, then calcium and carbonate. Correct measure We recommend that you verify your water tests with the reference solution from Fauna Marin. We can also provide you with an exceptionally accurate KH test for marine aquariums. Please measure the salinity of your aquarium on a regular basis and adjust it if necessary. To do this, use a refractometer (regularly calibrated with the Fauna Marin Multi Reference) or a high-quality aerometer, e.g. from Tropic Marin. Questions, contacts, support We wish you lots of success using this new method and we are happy to answer any further queries you may have. info@faunamarin.de www.facebook.com/claude.schuhmacher.9 www.meerwasserforum.info www.riffaquaristikforum.net www.ultimatereef.net www.reef2reef.com

High Quality Reef Keeping Products Fauna Marin GmbH Gottlieb-Binder-Str. 9 D-71088 Holzgerlingen High Quality Reef Keep Tel.:+49 (0) 7031 427 1142 Fax:+49 (0) 7031 238 592 www.faunamarin.de