Instruction Manual. Window Wiper AFW900. (Read carefully before use)

Size: px

Start display at page:

Download "Instruction Manual. Window Wiper AFW900. (Read carefully before use)"

Phoebe Griffin
8 years ago
Views:

1 Instruction Manual Window Wiper AFW900 (Read carefully before use)

2 When using electrical appliances, basic precautions should always be followed, including the fact READ ALL INSTRUCTIONS IN THIS MANUAL PRIOR TO USE AND FOLLOW ALL INSTRUCTIONS RECOMMENDED, particularly to avoid the risk of fire, electric shock, injury or damage to your device. We recommend that you keep this booklet carefully and refer to them in case of problems or doubts of use, and transmit to all prospective new owners. Safety Recommendations This appliance is intended for domestic use only. This appliance is not intended to be used by persons whose physical, sensorial or mental abilities are reduced (children and teenagers included), or by persons without any experience or knowledge, except if they have been given supervision or preliminary instructions for use of the appliance by somebody responsible for their safety. Children shall be supervised to ensure they do not play with the appliance. In hazardous locations (service station for example) you must comply with the relevant safety requirements. In dangerous places with explosion risks, use is forbidden. Do not place the appliance near a source of heat. Never plunge the appliance in water or any other liquid. Never leave the appliance unattended when plugged. Never leave packing materials (plastic bags, polystyrene, etc.) within reach of children, as these are sources of potential danger. Do not connect the device to an outlet whose voltage is not in accordance with the manufacturer's instructions, listed on the nameplate on the charger or on the device. Use only original wipes. Always unplug the appliance after use and when it is not being used. To avoid any risk of electric shock, do not dismantle or attempt to repair the appliance on yourself. If the power cable is damaged, it should be replaced by the manufacturer, its after-sales service or similarly qualified technical persons in order to avoid any danger. In case of damage or malfunction, you must contact your distributor or an authorized service center. Never insert objects into the ventilation slots. (12) Never touch the power plug with wet hands. You should under no circumstance dismantle the device by yourself under penalty of cancellation of the warranty. Avoid liquid splashes on electrical components, such as plug, switch, cable, stereo equipment, computer screen, or appliances. Do not use the appliance on delicate or glued materials: water paint, silk, terylene, leather, velvet, wallpaper, unvarnished wood, waxed or glossy wood, or any other materials not resistant to moisture. In case of doubt regarding

We recommend that you keep this booklet carefully and refer to them in case of problems or doubts of use, and transmit to all prospective new owners.

3 resistance of the support to moisture, it is better to always test the surface to be cleaned on an invisible part by rapid passing. The manufacturer does not assume any responsibility in case of damage of any support to be cleaned. After each use, empty and rinse the tank (6), never forget to wash the small filter (8) and put it back. Only use the appliance on smooth, solid, flat surfaces that are able to withstand moisture. Do not add additives, dangerous goods as caustics or acids, or cleaning products not originally intended for the same type of cleaning. Only use clear and pure water. PARTS OF THE APPLIANCE

After each use, empty and rinse the tank (6), never forget to wash the small filter (8) and put it back.

4 Charging the battery HOW TO USE YOUR WINDOW CLEANER Connect the charger to charger socket (11) and take the terminal on the other hand to power supply, which must comply with the standards. A red light will illuminate and change to green when the battery is fully charged. We recommend that you unplug your charger when charging is fully completed (green light on) after 2 hours of charging It is better to store the unit only after recharging for optimum battery life. Filling and cleaning the tank 1 Open the tank cap (7) remove the small filter (8) Figure 1, fill the tank with clean water by slightly tilting the appliance (head down), Figure 2, to facilitate the exit of air. The appliance must be disconnected from the charger during all operations. Then replace the clean filter and cap. After each use, empty and rinse the tank (6), never forget to wash the small filter (8) and put it back. Never place the appliance under the tap to fill the tank without first unplugging the charger, Figure 3. Effectiveness With its EMERY wipe this appliance does not need detergent but in case of heavy dirt or in heavily polluted environments, diluted cleaning products may be added or even just a few drops vinegar or alcohol. This solution is more convenient, ecological and economic. Finish off your cleaning with the microfiber wipe.

We recommend that you unplug your charger when charging is fully completed (green light on) after 2 hours of charging It is better to store the unit only after recharging for optimum battery life.

5 Cleaning Press on the spray trigger (2) Figure 4, and place the water or the mixture on the surface to be cleaned by directing the spray (10) in its direction. You can turn around the device by grasping handle B, and then you can rub your smooth surface with either one of the 2 wipes. Once this is done you return your hand to handle A and suck the water through the scraping joint (4) by scraping up and down while maintaining the suction control (1) at on position Figure 5. It is not necessary to press too hard on the device during the finishing scraping operation. Sometimes a slight grip is necessary to achieve best results. Do not project spray to eyes with or without product, or on surfaces of electronic components, such as plug, switch, cable, stereo equipment, computer screen, or household appliances. Replacing the water tank The dust and dirt is left on the cloth and the residual water is sucked for recycling. Generally, it is not necessary to change the water in the tank too often during use. You can, depending on the state of cleanliness of the surfaces. Recycled water may have a little color but will not affect the result of expected cleanliness.

Once this is done you return your hand to handle A and suck the water through the scraping joint (4) by scraping up and down while maintaining the suction control (1) at on position Figure 5.

6 Setting and cleaning wipes Put the wipe support (3) in front of you Figure 6, then position the pad in place taking care to keep even the entire length, then press the entire surface to increase the effect of scraping. The change of wipe will simply be made by tearing it off Figure 7. Wipes should be replaced regularly during work according to their cleanliness. We cannot give you an idea of the rate of change, it varies and it is at your sole discretion. These wipes are machine washable. You do not have to iron or use fabric softener or bleach, and do not put in dryer. Charger The charger must not be exposed to direct sunlight, fire, or heat, as there is a risk of explosion. Never insert objects into the charger socket. In case of unexpected loss or destruction of your charger, do not use any other charger than the original. Contact your supplier immediately. Otherwise any other charger with the same characteristics would likely destroy your device. Never attempt to repair the cable from your charger. If it is damaged, replace it. Before you connect your charger, make sure the voltage of your power outlet is the same as indicated on the label. Never unplug the charger by pulling the cable but take care to grasp the plug. It is advised to store your charger in dry area between 5 C and 40 C maximum. Never open your charger, potentially harmful substances may emerge and affect your health, and short-circuit is always possible. Battery charge level Your appliance is equipped with 2 safety systems: one is the battery and the other is the electrical circuit. They cut the battery when necessary so as not to over

We cannot give you an idea of the rate of change, it varies and it is at your sole discretion. These wipes are machine washable.

7 discharge which would be detrimental to your battery life. Therefore there is no monitoring or control light, your device automatically stops. Technical problems and solutions Problems encountered Possible identifications Proposed solutions The device suddenly Battery charge is too low Recharge the battery stops or does not start No liquid spray Needs more cleaning water Exit hole is blocked Fill the tank Unclog the exit Marks are left on cleaned surface Scraping joint is dirty Wipe is dirty Scraping joint is damaged There is too many detergent Water is dirty Clean the flexible seal Replace clean wipe Replace the scraping joint (Service assistance) Reduce the dosage Change water in tank All these solutions are basic elements to perform before any requests for technical assistance. For all other possible problems, contact your dealer or the manufacturer. Specifications (subject to technical modifications) Nominal power of the appliance 8 Watts Nominal LITHIUM battery voltage 3.6 Volts Nominal battery capacity 2000 mah Nominal charger voltage 5 Volts Nominal charger capacity 900 mah Duration of use in full charge 30 Minutes Maximum charging time 2 Hours Tank volume 130 ml Noise level 62 db(a) Product weight 0.7 Kg Working width 28 Cm This appliance complies with CE, IPX 4, EMC, Low Voltage, Reach, and ROHS regulations.

spray Needs more cleaning water Exit hole is blocked Fill the tank Unclog the exit Marks are left on cleaned surface Scraping joint is dirty Wipe is dirty Scraping joint is damaged There is too many

Meaco 30L and Meaco 40L dehumidifier instruction manual

Meaco 30L and Meaco 40L dehumidifier instruction manual Please read this instruction manual before using the dehumidifier and keep safe for future reference SAFETY INSTRUCTIONS PLEASE READ ALL INSTRUCTIONS