DDNS and Mobile configuration

Size: px

Start display at page:

Download "DDNS and Mobile configuration"

Amanda Lee Snow
8 years ago
Views:

1 DDNS and Mobile configuration Build P a g e

2 Table of Contents Step 1: Networking... 3 Step 2: Device Configuration... 4 Step 3:Router Configuration... 8 Step 4: DDNS registration Step 5: Mobile configuration P a g e

3 Step 1: Networking Connect the DVR / NVR to router/switch through a lan cable. On your PC >> Start Run cmd ipconfig According to the default gateway IP assign your device an IP in the same range. For eg. If the default gateway is : then device IP will be: or If default gateway is: then device IP will be: P a g e

4 Step 2: Device Configuration Menu Configuration Network General Disable DHCP Assign local ip to the device in IPv4 segment Give Preferred DNS server address 4 P a g e

Menu Configuration Network Extranet Access Disable ezviz cloud Enable DDNS DDNS type-hiddns / Hkddns / EasyDDNS Server address : asdev.hik-online.

5 Menu Configuration Network Extranet Access Disable ezviz cloud Enable DDNS DDNS type-hiddns / Hkddns / EasyDDNS Server address : asdev.hik-online.com Device domain name eg: hik_dvr, steve, etc After applying, if registered successfully, no message will be displayed. If it shows Communication to the server failed, kindly double check the network and DNS settings. 5 P a g e

6 Menu Configuration Network NAT Disable UPNP 6 P a g e

7 Menu Configuration Network more settings Change RTSP port to 1024(Vodafone Users) In case, you have more than one DVR/NVR to be configured online, please change the next device s HTTP port to 81, 82 Server port to 8001, 8002 and RTSP port to 1026, respectively 7 P a g e

8 Step 3:Router Configuration Advance Setup NAT Disable Firewall, SPI, UPNP, port scan (if option is available) Enable DMZ Host Put device s local IP in DMZ host 8 P a g e

9 Note: If you have a single device then port forwarding can be done using DMZ host. If you have more than one device, please follow the port forwarding procedure mentioned in Virtual server and disable DMZ host. 9 P a g e

10 Open ping.eu website on your browser Ping.eu port check Check whether ports 80, 8000 and 1024 are open. 10 P a g e

11 If ports are closed, go to router page Advance Setup NAT Virtual Server Port forwarding using your device s local IP as shown in figure below: Check for the open port status If ports are not open, contact your ISP (Internet Service Provider). If ports are open, proceed further. 11 P a g e

Step 4: DDNS registration Open Internet Explorer in the address bar, type IP address of DDNS Management Server http://asdev.hik-online.

12 Step 4: DDNS registration Open Internet Explorer in the address bar, type IP address of DDNS Management Server If you don t have an account, please click register new user to create a new user. Register a new account and login into the DDNS page using the same username and password 12 P a g e

13 When you login at the first time, it will pop up a tip to remind you to select the country. The country cannot be changed once saved, so please select it prudently. For better device management, it s highly recommended to set it same as the one you set for your device. 13 P a g e

14 After registration is done, login with registered username and password A link will be sent to your registered mail id, click on the link as shown in the snapshot so as to confirm your id: 14 P a g e

15 In Device management, click on Add option. Enter in Device name and serial number. By default, http port of device is 80. If http port of device was changed from 80, please enter new port in http Port area. Note: Please input here the registered domain name in the device domain area and correct device serial no. 15 P a g e

16 Click Device Status to show all added devices information like Serial number, Dynamic IP, HTTP port, DDNS IP address. You can access the device using the Device Link URL. If the device status is offline, you can click diagnose to check the reason. 16 P a g e

17 Step 5: Mobile configuration To view device online through Mobile you need to download ivms 4500 from play store. Menu Devices 17 P a g e

18 Click on PLUS sign (+) to add your device. Select Manual Adding. 18 P a g e

19 Select register mode as HiDDNS 19 P a g e

20 Feed the information as shown below- Device Domain Domain name registered in DDNS management system Username and password of DVR/NVR. Click on save. 20 P a g e

21 After the device is saved, click on Start Live View hik_dvr 21 P a g e

22 There is a provision of adjusting the live stream according to the network bandwidth by selecting the options shown in above image. 22 P a g e

23 Thanks You! 23 P a g e

Quick Guide of Remote Monitoring via PC or Mobile Phone

Quick Guide of Remote Monitoring via PC or Mobile Phone (DVR or NVR as the back-end surveillance device) Thank you for purchasing our product. This manual applies to remote viewing via PC or mobile phone.