LM048 Bluetooth v2.0, v2.1 RS232 Serial Adapter Standalone (With Embedded Bluetooth v2.0 / v2.1 Stack)

Transcription

1 Bluetooth v.0, v. RS Serial Adapter Revised /JAN/0.mm mm mm Features World s smallest Bluetooth Serial Adapter (RS) Bluetooth v.0, v. wireless technology 8 dbm Tx Power and -8 dbm Rx Sensitivity Serial (RS) interface Serial Port Profile (SPP) available Programmable Standalone Module (With Embedded Bluetooth v.0 / v. Stack) Unique patented firmware enabling serial printer functionality Up to 00m range (in open space).mm x mm x mm Powered by USB - Mini USB, DB9 or AC adaptor DTE / DCE (Master / Slave) mode switch DTR / DSR Handshaking and RTS / CTS Flow control lines Full Duplex for simultaneous communication between sender and receiver Ease of configuration and setup using the LM9 software Configurations pre-installed on production Fully Certified Solution including FCC, CE, RED Directive, SIG, Anatel, IC, IDA, KC, MoC NBTC, NCC, NOM / NYCE, RCM, MCMC, SRRC, TELEC Typical Industries EPOS Aviation MM Automotive LNG Overview The is the world s smallest Bluetooth serial adapter (RS), providing a secure and reliable Bluetooth v.0, v. connection. This wireless connection reaches a range of up to 00m in open space, replacing RS cables between a master (DTE) device and slave (DCE) devices such as printers, data loggers and digital signalling devices. The patented firmware allows the serial configurations to be used. The firmware controls the RS signals, including DTR / DSR handshaking and RTS / CTS flow control lines. The is powered by USB - Mini USB, DB9 or AC adaptor and all settings and configurations are even retained when the adapter is powered down. Our LM9 software is used to change the settings and configurations; including the auto connect function, discoverable / non-discoverable function, device name, baud rate, data bits and flow control. The AT Command set is used to change the configurations, plus the developer can also configure and modify the settings of a remote from a local. Customised configurations and settings can be preloaded to the, simplifying the manufacturing and testing process. Page of

2 Bluetooth v.0, v. RS Serial Adapter General Specification Wireless Bluetooth Standard v.0 and v. wireless technology Adapter Type Standalone (Configurable with AT Commands) Profiles SPP Hardware Chipset CSR Antenna IC Antenna Onboard Flash Memory 8 Mbit RAM 8 KB Interfaces Serial (RS) Power Supply V to V DC Crystal Oscillator MHz LED Indicators Link (BLUE), Data (ORANGE) and Power (RED) RS (Serial) RS Interface D_SUB 9 pin female Signal RxD, TxD, DTR, DSR, RTS, CTS and GND Full Duplex Yes Baud Rate.,.,.8, 9., 9., 8.,.,., 0., 0.8 and 9. Kbps RF Characteristics Tx Power 8 dbm (Maximum) Rx Sensitivity -8 dbm (Typical) Antenna Gain dbi to dbi (Maximum) Current Consumption 90 ma (Typical) Range (in open space) Up to 00m Data Rate Up to Mbps Frequency. GHz to.8 GHz Hopping,00/sec, MHz channel space Modulation Scheme GFSK-Mbps, DQPSK- Mbps, and 8-DPSK-Mbps Physical Characteristics Operating Temperature -0 C to +0 C Dimensions (L x W x H).mm x mm x mm Weight. g Certifications FCC, CE, RED Directive, SIG, Anatel, IC, IDA, KC, MoC NBTC, NCC, NOM / NYCE, RCM, MCMC, SRRC, TELEC Compliance Page of RoHS, REACH and WEEE

3 Bluetooth v.0, v. RS Serial Adapter Signals Female DB9 9 8 Pin out for Adapter Pin RS Signal DTE to DCE Direction DCE to DTE Direction Description CD Not Connected RxD Receive Data TxD Transmit Data DTR Data Terminal Ready GND n/a n/a Signal Ground DSR Data Set Ready RTS Request to Send 8 CTS Clear to Send 9 Vcc Power Supply Factory Settings The factory settings of the COM Port are as follows: Baud Rate Data Bits Parity Stop Bits Flow Control 900 bps 8 None None Customised settings are available as factory settings upon special request; Bonding, Pre-Pairing, different Baud Rates, Data Bits, Parity and Flow Control Settings. Page of

4 Bluetooth v.0, v. RS Serial Adapter Hardware Structure Link LED. Data LED. Power LED. Mini USB Connector. RS Connector. Slide Switch. Reset Button. Switch Functions Reset Button By pressing the Reset Button you can: Disconnect a wireless connection (after a short press). Restore the factory settings (after over seconds press). Slide Switch The slide witch can swap TxD / RxD, RTS / CTS and DTR / DSR Signals. By switching, you can set the adapter as a DTE (towards antenna connector) or a DCE (towards RS connector). Physical Dimensions Page of

5 Bluetooth v.0, v. RS Serial Adapter See Below Packaging Options AO - Adapter Only x Bluetooth Serial Adapter SRP - Single Retail Pack x Bluetooth Serial Adapter x DB9 male to female connector x USB - mini USB Cable for power supply x All in one power supply (UK, EU and US) Optional LM0 Slim Line 9 pin to pin Convertor Twin Pack Pre-Paired x Bluetooth Serial Adapter TRP - Twin Retail Pack x Bluetooth Serial Adapters x DB9 male to female connector x USB mini USB Cable for power supply x All in one power supply (UK, EU and US) Optional LM0 Slim Line 9 pin to pin Convertor See our website to download any applicable Software, Manuals and Notes - Page of