shake TALL CHEST assembly hardware mounting hardware tools required components 12 - wood dowels 12 - bolts 32 - screws 4 - plastic anchors

Transcription

1 assembly hardware 12 - wood dowels mounting hardware 12 - bolts 32 - screws Thank you for purchasing the Shake Tall Chest. This page lists all the contents included in the box. Please take the time to identify the hardware as well as the individual components to this product. As you unpack and prepare for assembly, place the contents on a carpeted or padded area to protect them from damage. Note: 2 people are recommended to safely assemble this product. 4 - plastic anchors 4 - small screws 4 - large screws 4 - mounting brackets 2 - wall straps Missing hardware? Please call for replacements. tools required phillips head screwdriver (We recommend the use of hand tools instead of power tools) components 1 - top 2 - side s (1 left, 1 right) 1 - bottom 1 - center 1 - back 4 - drawer fronts 8 - drawer sides (4 left, 4 right) 4 - drawer backs 4 - drawer bottoms Page 1 of 6

2 bottom left and right side s top Insert 2 wood dowels into left and right side 1 s as shown. 2 Insert 4 wood dowels into top and bottom. left side Note: Do not over tighten the bolts center 3 With assistance of another adult, fit dowels of left and right side s into corresponding holes of center and attach with 4 bolts. Secure, but do not over tighten, bolts with a phillips head screwdriver. right side Page 2 of 6

3 bottom 4 Fit dowels of bottom into corresponding holes of assembly and attach with 4 bolts. back top With assistance, position unit upright. Insert back 5 into corresponding grooves of assembly. 6 Fit dowels of top into corresponding holes of assembly and attach with 4 bolts. Page 3 of 6

4 left drawer side drawer front drawer bottom Attach left drawer side to drawer front with 2 screws. Secure, but do not over tighten, screws 7 with a screwdriver. 8 Fit drawer bottom into corresponding grooves of drawer assembly. drawer back right drawer side Attach drawer back to left drawer side with 2 9 screws. 10 Attach right drawer side to drawer assembly with 4 screws. Repeat steps 7-10 for remaining drawers. Page 4 of 6

5 NOTE: Make sure glides are pulled out of the case and ball bearings are at the front of the extended glides. To prevent damage to glides, keep drawer assembly level during installation. 11 Fit drawer glides of each drawer into corresponding drawer glides of case assembly. Make sure drawer glides securely engage. Assembly is now complete. drawer assembly cleaning and care Clean surfaces with a dry or damp soft cloth. Do not use abrasive cleaners. Page 5 of 6

6 C D A E optional wall mounting instructions For added safety and stability, it is recommended that the wall mounting hardware be installed. For safe mounting, it is essential to use wall anchors appropriate to your wall type (i.e. plaster, drywall, concrete, etc.). Mount to wood studs whenever possible. NOTE: If you are unsure about your wall type or what mounting method you should use, consult a qualified professional or your local hardware store. A. Attach 2 brackets to the top of the assembled unit with 2 small screws per bracket. B. With the assistance of another adult, place the unit in desired location against the wall. Mark the location of the hole in the bracket on the wall. Move the unit out of the workspace. C. Drill holes slightly smaller in diameter than the anchors. Insert 1 plastic anchor into each hole until they are flush to the wall. D. Insert 2 large screws through each bracket and plastic anchor. Secure, but do not over tighten with a phillips head screwdriver. E. Place the unit back into position against the wall and thread the wall strap through both brackets and pull until tight. Wall mounting assembly is now complete. Page 6 of 6