Datasheet SGD GWTS80MNFG1E0 SG

Transcription

1 Datasheet SGD GWTS80MNFG1E0 SG The information contained in this document has been carefully researched and is, to the best of our knowledge, accurate. However, we assume no liability for any product failures or damages, immediate or consequential, resulting from the use of the information provided herein. Our products are not intended for use in systems in which failures of product could result in personal injury. All trademarks mentioned herein are property of their respective owners. All specifications are subject to change without notice.

2 A 2015,AUG,26 1 / 23 Thin-Film-Transistor LCD Module Acceptance Solomon Goldentek Display Corp. NO. 18 Ta-Yeh St., Ta-Fa Industrial Park,Ta-Liao Hsiang, Kaohsiung Hsien 831, TAIWAN, R.O.C. FAX: Approved and Checked by Approved by Checked by Made by

3 A 2015,AUG,26 2 / 23 Revise Records Rev. Date Contents Written Approved A 2015/08/26 Preliminary Specification Alex Roger Special Notes Note1. Note2. Note3. Note4. Note5.

4 A 2015,AUG,26 3 / 23 Contents 1. General Description and Features LCD Module 4 2. Mechanical Information 4 3. Electrical Specifications Signal Timing Specifications 7 4. Optical Characteristics Optical characteristic of the LCD I/O Terminal Pin Assignment Block Diagram Displayed Color and Input Data Reliability Condition Dimensional Outlines Incoming Inspection Standards 20

5 A 2015,AUG,26 4 / General Description and Features GWTS80MNFG1E0 is a transmissive type color active matrix TFT (Thin Film Transistor) liquid crystal display (LCD) that uses amorphous silicon TFT as a switching device. This model is composed of a TFT-LCD module, back-light unit. Graphics and texts can be displayed with 1600 (W) x RGB x 480 (H) dots with 16.7M colors. The following table described the features of GWTS80MNFG1E LCD Module 2. Mechanical Information Item Min. Typ. Max. Unit Note Horizontal (H) mm Module Size Vertical (V) mm Thickness (T) mm (1) Weight g -- Note (1) Not Include Component. Refer to the Outline Dimension Drawing as attached.

6 A 2015,AUG,26 5 / Electrical Specifications Electrical Absolute Maximum Ratings TFT-LCD Module Backlight Unit

7 A 2015,AUG,26 6 / DC Electrical Characteristics of the TFT LCD

8 A 2015,AUG,26 7 / Signal Timing Specifications Timing Parameters (Sync mode)

9 A 2015,AUG,26 8 / 23

10 A 2015,AUG,26 9 / LVDS Rx Interface Timing Parameter

11 A 2015,AUG,26 10 / Power On/Off Sequence Power on Power off

12 A 2015,AUG,26 11 / Optical Characteristics 4.1 Optical characteristic of the LCD

13 A 2015,AUG,26 12 / 23 a. Test equipment setup After stabilizing and leaving the panel alone shall be warmed up for the stable operation of LCM, the measurement should be executed. Measurement should be executed in a stable, windless, and dark room. Optical specifications are measured by Topcon BM-7(fast) with a viewing angle of 2 at a distance of 50cm and normal direction. b. Definition of response time: Tr and Tf The response time is defined as the following figure and shall be measured by switching the input signal for black and white. c. Definition of contrast ratio: Brightness measured when LCD is at white state Contrast Ratio (CR) = Brightness measured when LCD is at black state d. Measured at the center area of the panel when all the input terminals of LCD panel are electrically opened.

14 A 2015,AUG,26 13 / 23 e. View Angle f. Definition of Luminance of White: Luminance of white at the center points Light Source of Back-Light Unit LED Type g. Definition of White Uniformity Min. luminance of white among 9-points White Uniformity = x 100% Max. luminance of white among 9-points

15 A 2015,AUG,26 14 / I/O Terminal 5.1 Pin Assignment

16 A 2015,AUG,26 15 / 23

17 A 2015,AUG,26 16 / Block Diagram

18 A 2015,AUG,26 17 / Displayed Color and Input Data

19 A 2015,AUG,26 18 / Reliability Condition

20 A 2015,AUG,26 19 / Dimensional Outlines

21 A 2015,AUG,26 20 / Incoming Inspection Standards 9.1 Inspection and Environment Conditions Inspection Conditions:

22 A 2015,AUG,26 21 / 23

23 A 2015,AUG,26 22 / 23

24 A 2015,AUG,26 23 / 23

25 Our company network supports you worldwide with offices in Germany, Great Britain, Turkey and the USA. For more information please contact: Distec GmbH Augsburger Str. 2b Germering Germany Phone: +49 (0)89 / Fax: +49 (0)89 / info@datadisplay-group.de Internet: Display Technology Ltd. 5 The Oaks Business Village Revenge Road, Lordswood Chatham, Kent, ME5 8LF United Kingdom Phone: +44 (0)1634 / Fax: +44 (0)1634 / info@datadisplay-group.co.uk Internet: Apollo Display Technologies, Corp. 87 Raynor Avenue, Unit 1Ronkonkoma, NY United States of America Phone: / Fax: / info@datadisplay-group.com Internet: Sales Partner: DATA DISPLAY BİLİŞİM TEKNOLOJİLERİ İÇ VE DIŞ TİCARET LİMİTED ŞİRKETİ Barbaros Mh. Ak Zambak Sk. A Blok D: Ataşehir / Istanbul Turkey Phone: +90 (0)216 / Fax: +90 (0)216 / info@data-display.com.tr Internet: