BiPAC 3011G WLAN 11g USB Adapter. Quick Start Guide

Transcription

1 BiPAC 3011G WLAN 11g USB Adapter Quick Start Guide

2 This product is in compliance with the essential requirements and other relevant provisions of the R&TTE directive 1999/5/EC. Product Name: Model Name : BiPAC 3011G WLAN 11g USB Adapter BiPAC 3011G MAX. OUT POWER COUNTRY CHANNELS INDOOR OUTDOOR Spain MHz 1-13 < 100 mw EIRP < 100 mw EIRP France MHz 1-8 < 100 mw EIRP < 100 mw EIRP France MHz 9-13 < 100 mw EIRP < 10 mw EIRP Italy MHz 1-13 < 100 mw EIRP < 100 mw EIRP UK MHz 1-13 < 100 mw EIRP < 100 mw EIRP Netherlands MHz 1-13 < 100 mw EIRP < 100 mw EIRP Germany MHz 1-13 < 100 mw EIRP < 100 mw EIRP Austria MHz 1-13 < 100 mw EIRP < 100 mw EIRP Belgium MHz 1-13 < 100 mw EIRP < 100 mw EIRP Switzerland MHz 1-13 < 100 mw EIRP < 100 mw EIRP Luxemburg MHz 1-13 < 100 mw EIRP < 100 mw EIRP Ireland MHz 1-13 < 100 mw EIRP < 100 mw EIRP Portugal MHz 1-13 < 100 mw EIRP < 100 mw EIRP Norway MHz 1-13 < 100 mw EIRP < 100 mw EIRP Denmark MHz 1-13 < 100 mw EIRP < 100 mw EIRP Finland MHz 1-13 < 100 mw EIRP < 100 mw EIRP Iceland MHz 1-13 < 100 mw EIRP < 100 mw EIRP Greece MHz 1-13 < 100 mw EIRP < 100 mw EIRP Lichtenstein MHz 1-13 < 100 mw EIRP < 100 mw EIRP Sweden MHz 1-13 < 100 mw EIRP < 100 mw EIRP 1

3 FCC INFORMATION FCC Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communication. However, there is no grantee that interference will not occur in a particular installation. If this equipment dose cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/tv technician for help. Notice: The Part 15 radio device operates on a non-interference basis with other devices operating at this frequency. Any changes or modification not expressly approved by the party responsible could void the user s authority to operate the device. REGULATORY INFORMATION BiPAC 3011G WLAN 11g USB Adapter must be installed and used in strict accordance with the instructions. This device complies with the following radio frequency and safety standards. USA - Federal Communications Commission (FCC) This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference that may cause undesired operation. 2

4 1. Overview 1.1 Product Feature Complies with the IEEE802.11b/g 2.4GHz (DSSS) standard High-speed data transfer rate up to 54Mbps Support 64/128-bit WEP Data Encryption function for high level of security Supports peer-to-peer communication among any wireless users, no Access Point required Automatic fallback increases data security and reliability Supports the most popular operating system: Windows 98SE/ME/2000/XP Portable and mini-size design Suitable for Any Notebook or Desktop PC 1.2 Application Wireless LAN network defined by IEEE b standard committee could be Configure as: Ad Hoc wireless LAN or Infrastructure wireless LAN. Ad Hoc network is a group of notebooks with wireless LAN adapter, called a BSS (Basic Service Set). These notebooks use their wireless LAN adapter to communicate with each other directly. Figure Ad Hoc wireless network 3

5 The most obvious differentiation between Infrastructure wireless network and Ad Hoc wireless network is that the notebooks in Infrastructure wireless network can make use of the resource in the Internet through Access Point. Figure Infrastructure wireless network To set up your notebook s network as the type of Ad Hoc or Infrastructure wireless network depends completely on your requirement. Generally, if your network environment has an Access Point, it s recommend that you set it as Infrastructure mode to connect to the Internet. 1.3 Package Contents Item: BiPAC 3011G WLAN 11g USB Adapter BiPAC 3011G WLAN 11g USB Adapter drivers/utility BiPAC 3011G WLAN 11g USB Adapter User Manual BiPAC 3011G WLAN 11g USB Adapter Quick Start Guide Location: BOX CD-ROM CD-ROM CD-ROM 1.4 System Requirements Notebook PC or desktop PC with one free USB 2.0 port 32MB memory or greater 300MHz processor or higher Microsoft Windows XP / 2000 / Me / 98SE 4

6 2 Driver installation 1. Insert the BiPAC 3011G WLAN g USB Adapter CD in the CD-ROM drive and wait until first page appears. Note: In case this screen does not appear, in Windows Explorer browse to your CD-ROM and double-click the Setup.exe file. 2. Click Install Driver and click next in the next page. 5

7 3. Click [Next] to accept, or [Browse] to change the default destination folder. 4. Click [Next] to accept, or change the default Program Folder name. 6

8 5. Click [Yes] to accept add shortcut to Desktop, or [No] to next setp. 6. Click [Yes] to accept the driver install. 7. Click [Yes] to accept the driver install 7

9 8. Now connect your BiPAC 3011G WLAN 11g USB Adapter to the USB port of your computer. In the Find New Hardware Wizard that appears on your screen select [No, not this time], and click [Next]. 9. Select [Install the software automatically (Recommended)], and click [Next] 10. Click [Finish] to finalize the installation. Your BiPAC 3011G WLAN 11g USB Adapter is now ready for use. 8