User s Manual Model KB990W

Transcription

1 Wireless Internet Keyboard & Optical Mouse User s Manual Model KB990W

2 FCC Statement This device complies with part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction guide, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and the receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult a service representative for help. Properly shielded and grounded cables and connections must be used in order to comply with FCC emission limits. Micro Innovations is not responsible for any radio or television interference caused by using other than recommended cables and connectors, or by unauthorized changes or modifications to this equipment. Unauthorized changes or modifications could void the user s authority to operate the equipment. Responsible party: Micro Innovations Corp. 400 Clearview Ave. Edison, NJ Telephone: Tested To Comply With FCC Standards FOR HOME OR OFFICE USE 2 Wireless Internet Keyboard & Optical Mouse

3 Table of Contents Welcome! System Requirements Features & Benefits Keyboard & Mouse Features Getting Started Configuring the Hot Keys & Mouse Buttons Install the Drivers Configure the Hot Keys Configure the Mouse Buttons Modify, Repair, or Remove the Drivers Care & Maintenance Troubleshooting Technical Support Table of Contents 3

4 Welcome! Congratulations and thank you for purchasing the Micro Innovations Wireless Internet Keyboard & Optical Mouse! The advanced design of your new keyboard and mouse makes them simple to install and customize, so you can hit the ground running and connect to any USB-enabled PC with ease. System Requirements To use your new Micro Innovations Wireless Internet Keyboard & Optical Mouse, your system must include the following: IBM or 100% compatible PC Windows 2000/XP/Vista USB Port CD-ROM Drive Features & Benefits Wireless Keyboard & Optical Mouse 2.4 GHz RF USB Receiver Multimedia & Internet Hot Keys Customizable Mouse Buttons Slim, Full-Size Keyboard The information included in this manual will help you get the most out of your Wireless Internet Keyboard & Optical Mouse by guiding you through the installation and customization process, as well as by offering some tips for using and maintaining your keyboard and mouse. 4 Wireless Internet Keyboard & Optical Mouse

5 Keyboard & Mouse Features Multimedia & Internet Hot Keys Wireless RF USB Connectivity Side Mouse Buttons Keyboard & Mouse Features 5

6 Getting Started 1. Unpack the box. 2. Install batteries in the keyboard and mouse. Note: Note: 3. Insert the USB receiver into a USB port. The keyboard and mouse automatically link to the USB receiver. Note: Your mouse can run on one or two batteries. To increase the operating life, install two batteries. Remove any existing keyboard or mouse connections before continuing. Your mouse and keyboard must be within two meters (6.6 ft.) of the USB receiver during installation. 4. Begin using your new keyboard and mouse. Wireless Keyboard Optical Mouse 2.4 GHz RF USB Receiver 4 AAA Duracell Batteries Installation CD User s Manual Quick Installation Guide Warranty Information 6 Wireless Internet Keyboard & Optical Mouse

7 Configuring the Hot Keys & Mouse Buttons Install the Drivers 1. Close all open programs, and insert the CD into your CD/DVD drive. The Driver Installation dialog displays. 2. Click Install to begin the installation. The Install Shield Wizard dialog displays and indicates Preparing to Install. Then, the Welcome to Setup dialog displays. 3. Click Next. The Choose Destination Location dialog displays and indicates the default Destination Folder. Configuring the Hot Keys & Mouse Buttons 7

8 4. To select a different location in which to install the files, click Browse, select a location, and then click OK. The Choose Destination Location dialog re-displays. 5. Click Next. The Setup Status dialog displays. Note: When you click Next, the installation procedure may automatically reboot your system. 8 Wireless Internet Keyboard & Optical Mouse

9 System Tray Icons Mouse Keyboard Number Lock Caps Lock Scroll Lock Once the installation is complete, the Setup Status dialog disappears, and the mouse and keyboard icons display in the system tray. Note: Scroll Lock, Caps Lock, and Number Lock icons display in the system tray only when you press the corresponding keys to activate these functions. The multimedia & Internet hot keys at the top of the keyboard will now automatically operate. Configuring the Hot Keys & Mouse Buttons 9

10 Configure the Hot Keys The hot keys at the top of your keyboard include multimedia and Internet keys, which are all pre-programmed with default settings to complete an action or launch a program. You can set the actions of the customizable hot keys to launch a variety of programs. Note: The system keys cannot be customized. Customizable Hot Keys Launch Media Player Open User s Favorites Folder Launch Program Launch Internet Home Page System Keys Media Player Volume Media Player Play/Pause System Standby 10 Wireless Internet Keyboard & Optical Mouse

11 To Set the Customizable Hot Keys 1. Double-click the keyboard icon in the system tray. The Key Settings window displays. 2. Click an icon to set the action of the corresponding key. The Setup function of the key dialog displays. Launch Media Player Launch Internet Home Page Open User s Favorites Folder Launch Program Configuring the Hot Keys & Mouse Buttons 11

12 3. To set the action of a key, select the Choose a function option, and then click the drop-down list to select an option. Note: To restore the default system settings, click Restore to default. 12 Wireless Internet Keyboard & Optical Mouse

13 4. To change the action of a key to run a program not included in the function list, select the Select a program to run option, and then click Browse to navigate to the desired program. 5. Click OK to accept the changes, or Cancel to discard the changes and exit the dialog. Configuring the Hot Keys & Mouse Buttons 13

14 Configure the Mouse Buttons You can customize the mouse buttons on the side of your mouse to complete a variety of actions. You can also change the settings for the pointers and mouse wheel. To Customize the Mouse Buttons 1. Double-click the mouse icon in the system tray. The Mouse Properties dialog displays. 2. Select a tab to view or change the settings for the mouse. Config of mouse button side mouse buttons. Pointers Set the commands for the Select a scheme for mouse pointers. Pointer Options Set motion, action, and visibility options. Config of the mouse wheel Adjust the mouse wheel scroll speed and volume settings. About Wireless Mouse Driver View software copyright information. 14 Wireless Internet Keyboard & Optical Mouse

15 3. To set the operation of the side mouse buttons and, select the Config of mouse button tab. 4. Click a drop-down list to select an action for each button. Note: To restore the factory default settings, click Restore to default. Configuring the Hot Keys & Mouse Buttons 15

16 5. Double-click the jack-in-the-box to ensure your double-click speed is set correctly. The jack-in-the-box pops up. Note: If the jack-in-the-box does not pop up, your double-click speed setting is too fast or too slow. Slide the Speed of double click arrow toward Slow or Fast to change the speed setting. 6. Click Apply to accept the changes and proceed to another tab, OK to accept the changes and exit, or Cancel to discard any changes and exit. 16 Wireless Internet Keyboard & Optical Mouse

17 Modify, Repair, or Remove the Drivers 1. Insert the CD into your CD/DVD drive. The installation program runs automatically. The InstallShield Wizard Welcome dialog displays and then the Micro Innovations Install dialog displays. 2. Select Install. The Welcome dialog displays. 3. Select an option: Modify Changes the settings. Repair Reinstalls features. Remove Uninstalls and removes all currently installed features. 4. Click Next. The Install Progress dialog displays. When installation is complete, the Maintenance Complete dialog displays. 5. Click Finish to exit setup. Configuring the Hot Keys & Mouse Buttons 17

18 Care & Maintenance To keep your Micro Innovations keyboard and mouse looking new and functioning properly: Use and store them only in normal temperature environments. Keep them dry; if they get wet, wipe them dry immediately. Handle them carefully; do not drop them. Keep them away from dust and dirt, and gently wipe them with a damp cloth occasionally. Modifying or tampering with the keyboard s or mouse s internal components can cause a malfunction and might invalidate the warranty. 18 Wireless Internet Keyboard & Optical Mouse

19 Troubleshooting Problem Solution Technical Support My mouse and/ or keyboard won t work. The cursor does not move, and/ or the keyboard does not work. My computer is asleep. Check the USB receiver connection. Try inserting it into a different USB port. Verify the batteries are inserted correctly. Verify the optical sensor on the mouse is clean. Install new batteries. Restart your computer. Reinstall software drivers. Install new batteries. Move the mouse and keyboard to within 10 meters (33.3 ft.) of the receiver. Reinstall software drivers. Move the mouse or press a key on the keyboard to wake up your system. For technical assistance with your keyboard and mouse, visit or call toll-free Technical Support is available Monday Friday, from 8:30 am to 7:00 pm E.S.T. Product Information For quick reference later, enter information about your keyboard and mouse below. Product Name: Model Number: Serial Number: Place Purchased: Date Purchased: Troubleshooting 19

20 2008 Micro Innovations Corp., 400 Clearview Avenue, Edison, NJ USA All brand and product names are trademarks or registered trademarks of their respective companies. Printed in China