Material Safety Data Sheet

Transcription

1 Page: 1/5 Printing date 08/05/2008 Version No.1 1-) Identification Of Substance Product name : TP 100 Y Trade Name : Hammerfast TP 100 Y Manufacturer/Supplier: Emergency information: For Chemical Emergency Spill Leak Exposure or Accident Call respective authorities (fire brigade, health institutions etc.) and AYK YAPI KİMYASALLARI SAN.LTD.ŞTİ. TEL: ) Composition/Data on components Chemical Characterization Mixture of the substances listed below with nonhazardous additions. Dangerous components: Cas-Nr : Dolomite CaMg(CO3) % Cas-Nr : Portland Cement 10-35% 3-) Hazard Identification Information pertainnig to particular danger for man and environment: The product has to be labbelled due to the calculation procedure of international guidelines. Irritating to eyes and skin. Contains cement and reacts alkaline under influence of dump. Therefore eyes and skin protection is necessary. 29-5

2 Page 2/5 4-) First aid measures After inhalation: Avoid breathing of dust, supply fresh air, consult a doctor in case of complaints. After skin contact: Immediately wash with water and soap and rinse thoroughly. After eye contact: Rinse opened eye for several minutes under running water. Then consult a doctor. After Swallowing: Rinse out mouth, drink water and immediately call for a medical help. 5-) Fire figthing measures Suitable extinguishing agents: For safety reasons unsuitable extinguishing agents: Protective equipment: No special measures required. 6-) Accidental release measures Person-related safety measures: Wear dust mask. Avoid formation of dust. Measures for environmental protection: Do not allow to enter sewers/surface or ground water. Inform respective authorities if product reaches water or sewage system. Measures for cleaning/collecting: Pick up mechanically. 7-) Handling and storage Information for safe handling: Prevent formation of dust. İnformation about protection against explosions and fires: No special measures required. Requirements to be met by storerooms and receptacles: No special requirements. Information about storage in one common storage facility: No required. Further information about storage conditions: Store in dry conditions. Do not store together with edibles or other consumable substances.

3 Page 3/5 Material Safety Data Sheet 8-) Exposure controls and personal protection Additional information about design of technical systems: No special measured required. Components with limit values that require monitoring at the work place: This product contains portland cement, CAS No: The relevent exposure limit for working place for this materyal is 5 mg/m3 (total dust). General protective and hygienic measures: Prevent formation of dust. Wash hands before breaks and at the and of work. Avoid contact with the eye and skin. Personal protective equipment Breathing equipment: Wear suitable dust musk, partical fitler P1 P3 Protection of hands: Use nitrile impregnated cotton-gloves Penetration time of glove material: The exact break trough time has to be found out by the manufacturer of the protective gloves and has to be observed. Eye Protection: Tightly sealed goggles 9-) Physical and chemical properties Form: Powder Color: Grey Odor: Odorless Change in condition Vapour pressure: Viscosity: Flash point:. Auto igniting: Product is not selfigniting. Danger of explosion: Product does not present an explosion hazard. Density: 1400 kg/m3 Solubility in water: Insoluble. ph-value at 20 C : ) Stability and reactivity Thermal decomposition / conditions to be avoided: No decomposition if used according to specifications. Dangerous reactions: No dangerous reactions known. Dangerous products of decomposition: No dangerous decomposition products known.

4 Page 4/5 11-) Toxicological information Primary routes of entry: Inhalation, skin contact, eye contact. Primary irritant effect: on the skin: Iritant to skin and mocous membranes. on the eye: Irritating effect. Subacute to chronic toxicity: Respirable crystalline silica (quartz) may cause a severe lung desease named silicosis. Symptoms of silicosis may be shortness of breath, fever or cough. Silicosis is reported to increase the risk of carcinogenicity caused by continuous inhalation of respirable crystaline silica. Though. the product itself does not contain respirable crystaline silica, respirable crystaline silica may be generated from working procedures such as grinding e.g. In general, inhalation of silica dust should be avoided. Therefore for your own safety wear a suitable NIOSH-approved respirator in all occasions when handling of the product generates dust. 12-) Ecological information General notes: Do not allow the product to reach ground water, waste water, soil, water course sewage system. 13-) Disposal consideration Must not be disposed of together with household garbage. Do not allow product to reach sewage system. Mix product residues with water, allow to harden, then dispose of as construction waste. Disposal should be inaccordance with respective legislation. Use packages for recycling when totally empty. 14 -) Transport information Not regulated as hazardous meterial according to the IMDG, ICAO- TI / IATA-DGR, RID/ADR, ADNR specifications.

5 Page 5/5 15-) Regulations Classification and labelling according to GEFstoffv Symbols of danger Xi Irritant R-phrase R 38: Irritating to skin R 41: Risk of serious damage to eyes S-phrase S 2: Keep out of reach of children S 22: Do not breath dust S 24 : Avoid contact with skin S 26: In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. S 36/37: Wear suitable protective clothing and gloves 16-) Other Information This information is based on our present knowledge. However, this shall not constitute a guarantee for any specific product features and shall not establish a legally valid contractual relationship.