M O N I T O R I N G S O L U T I O N S INFRASTRUCTURE MANAGEMENT SOLUTIONS. Varicontrol-P. The Integrated Rack Management System

Transcription

1 V RICONTROL M O N I T O R I N G S O L U T I O N S TM INFRASTRUCTURE MANAGEMENT SOLUTIONS Varicontrol-P The Integrated Rack Management System

2 CONTROLLERS Varicontrol-P2, Varicontrol-P4 and Varicontrol-P6 rack controllers enable monitoring and control of power, environment and access control, using both a secure Web-based interface and SNMP. With multiple, programmable warning thresholds for every parameter, users can effectively monitor for critical events. An on-board clock and datalog (P4 and P6 models only) ensure that vital information is available for reporting in the event of a network failure. Alarm information can be transmitted direct from the controllers via , thence to SMS via SMTP from an client. MIB file supplied which can be used with most network management and SNMP management platforms. Infrastructure management requirements in data centres are becoming increasingly complex. The need to efficiently monitor and control power consumption (whether directly through the IT equipment, or indirectly via the cooling system) is priority number 1 for most data centre managers. Minimising downtime means not only knowing exactly what environmental conditions prevail in and around the racks, but also ensuring that unintentional or malicious tampering with equipment is Varicontrol-P2 Varicontrol-P4 Varicontrol-P6 impossible. Early warning of potential problems is essential. The baby of the family, 0U The 1U height Varicontrol-P4 extends the The 1U height Varicontrol-P6 further extends the device, monitors / controls 2 scope for monitoring and control via scope for monitoring and control via the network, THE SOLUTIONS Varicontrol-P range gives the possibility to install a fully integrated, scaleable infrastructure monitoring and control solution in each rack in a datacenter. Environmental data, power monitoring and control and access control may be managed through a single IP address per rack! Varicontrol-P hardware typically interfaces, via simple network management protocol (SNMP) over the IP network, with a network management system or SNMP trap-management application, but at the basic level can also use Syslog as a data capturing application and send alarms directly to , straight from the box. The on-board, web-based firmware is fully customer configurable to receive data and multi-level incident alarms into up to 10 NMS stations and 5 SNMP trap receiver stations. Installations use standard network cabling and compatibility with corporately-approved applications is assured. Whether deployed in a small computer room or a multi-national network of data centres, the Varicontrol-P range brings the IT infrastructure under control. power strips and 2 environmental sensors. The optimum solution for basic in-rack power management, providing all data via a single IP address. the network, with: 4 inputs for power strip monitor / control, 6 auto-sensing inputs for temperature, humidity, digital or analogue signals from environmental sensors, 2 inputs for access control units (keypad or HiD card reader), 2 relay outputs for control of ancillary devices such as door locks. with: 6 inputs for power strip monitor / control, 12 auto-sensing inputs for temperature, humidity, digital or analogue signals from environmental sensors, 2 inputs for access control units (keypad or HiD card reader), 4 relay outputs for control of ancillary devices such as door locks. One of the access control inputs on the Varicontrol-P6 may be used as an expansion port for power monitoring. Used in conjuction with the Varicontrol-P18 expansion unit, up to 24 intelligent power strips may be monitored/controlled through a single IP address!

3 INTELLIGENT POWER STRIPS Varicontrol-P intelligent power strips connect Inlet Outlets Mounting Monitor Remote switching IN-LINE MONITORING UNITS Varicontrol-P In line Monitoring Units connect to the CL-AMP The CL-Amp is an innovative solution for easily adding networked to the network via Varicontrol-P controllers. 16A, 1φ 6 x C U network via Varicontrol-P controllers. power supply monitoring to existing ICT installations. The CL-Amp 16A, 1φ 3 x C x GST U Monitoring specifications are the same as for the uses patented technology to measure current in data centre, Real-time data provided (also on a local LCD 16A, 1φ 14 x Schuko (D/NL) Vertical intelligent power strips beside. computer room and PC environments at up to 60A. For instance, the display) is true Volts, Amps, power factor and 16A, 1φ 20 x Schuko (D/NL) Vertical These units provide a method of adding monitoring to CL-Amp can be used to bring network-monitored functionality to either kwh or kva. 4-level alarms via SNMP 16A, 1φ 10 x UTE (F/B) Vertical existing installations, or to stand-alone equipment in standard rack power strips. trap can be configured for all these 32A, 1φ 4 x C U the computer room. The CL-Amp at last provides a parameters. 32A, 1φ 12 x C19 Vertical We provide solutions made for your requirements solution to bring visibility of High accuracy (<2% error) is ensured by the 32A, 1φ 16 x C x C19 Vertical please ask! power consumption to data real-time measurement of voltage instead of 32A, 1φ 20 x C x C19 Vertical centre managers who need to an average calculation, as used in some other intelligent systems. Sampling to the 33rd harmonic, provides reliable results for reporting or charging purposes. 16A, 3φ 15 x C19 (5 per phase) Vertical 16A, 3φ 18 x C x C19 (6+3 per phase) Vertical 32A, 3φ 18 x C19 (6 per phase) Vertical Inlet Outlets Mounting 2 x 32A, 1Ф 2 x 32A 19 1U 2 x 32A, 3Ф 2 x 32A, 3Ф 19 3U run legacy installations round-the-clock! Features Optionally, each outlet can be remotely switched via the controller s secure web interface or via SNMP management If your requirement is not listed here, call your local office. For quantities >25 units we can supply almost any configuration of intelligent power strip on request in less than 5 weeks. ENVIRONMENTAL SENSORS Attachment does not require power-down of the equipment to be measured. software. Various environmental sensors are available, allowing a wide The CL-Amp fits over single- Monitoring of load per outlet is available as range of monitoring and control requirements to be met. phase 3-core cables with a an option. Temperature diameter of 8 to 18mm. We provide many solutions in accordance Humidity Remote monitoring is achieved via the same SNMP with the specification received from our Water leaks (contact and rope-styles) controllers used for our intelligent power strips customers the selection beside is just a Shock / vibration (Varicontrol-P2/P4/P6). Information is made available sample of what we can provide. Smoke via an embedded web-browser based interface, and/ Magnetic door / panel sensor or can be sent to a network/snmp management NOTE! The units listed beside are intended Movement (PIR) system and database. only for inclusion in an electrical installation Additionally, all Varicontrol-P controllers will accept digital A simple, client-based software package can be where circuit protection is provided at a (switched) signals and 0-5V proportional analogue sensor supplied to simultaneously monitor up to 50 CL-Amps, central distribution unit. They are not suitable inputs. Contact your local office for advice. for companies not running a network management for a domestic or office environment. A 12Vdc supply is available at each sensor input to power system with SNMP capability. active sensors. Input connector pin designations are available on request. Typical deployment Our access control inputs will interface with various card, fob 2 x CL-Amps, 3 x RJ45 patch cables and a Varicontrol-P2 controller can and biometric readers. Please contact us for an up-to-date be deployed in a matter of minutes to start networked power compatibility list. monitoring in a dual-feed rack. It is that simple!

4 SMALL INSTALLATIONS (UP TO 5 CONTROLLER) LARGER / MULTI-SITE INSTALLATIONS

5 Minkels Netherlands Eisenhowerweg 12 P.O Box AA Veghel tel. +31 (0) Minkels Belgium Remysite Remylaan 4C - Bus Wijgmaal (Leuven) tel. +32 (0) info-be@minkels.com Minkels France Parc d activits de Malnoue 28, Rue Vlad. Jankelevitch Emerainville tel. +33 (0) info-fr@minkels.com Minkels Switzerland Riedstrasse 3-5 CH-6330 Cham tel. +41 (0) info-ch@minkels.com Minkels United Kingdom Unit 6, Union Way Hillbottom Road Sands Industrial Estate High Wycombe Bucks, HP12 4HJ tel. +44 (0) info-uk@minkels.com A N A E G I D E C O M P A N Y VCL-P-BRV01-EN