Roofer Dies After Gust of Wind Knocks Him And A Co-Worker Off Roof



Similar documents
A 53-Year-Old Male Iron Foreman Dies After Fall From Steel Decking

Out-of-State Electrician Electrocuted While Restoring Service at a Personal Residence Incident Number: 08KY065

Temporary Electrician Helper Steps into Unguarded Elevator Shaft and Dies

Director, National Institute for Occupational Safety and Health. California Fatality Assessment and Control Evaluation (CA/FACE) Program

Owner/ Operator Hauling Asphalt Flux Dies After Driving into a Ravine and Striking Trees

FACE Fatality Assessment and Control Evaluation Program

F.A.C.E. INVESTIGATION REPORT

Does this topic relate to the work the crew is doing? If not, choose another topic.

Fatality Assessment and Control Evaluation Project. FACE #95-NJ Cable TV Installer Killed After Falling 21 Feet From a Ladder

Death in the line of duty... June 10, 2002

WORKER FELL OFF A ROOF Type of Incident: Fatality Date of Incident: August 29, 2009

Bulldozer Owner / Operator Drowns While Trying to Repair a Pond Incident Number: 03KY073

This material was produced under grant number SH F-48 Occupational Safety and Health Administration, U.S. Department of Labor.

MA FACE Occupational Fatality Report

INJURY NARRATIVE. Construction Worker Falls 14 Feet from a Beam onto Concrete and Suffers Serious Brain Injury. Industry: Framing Contractors

Does this topic relate to the work the crew is doing? If not, choose another topic.

Level 1 Award in Health and Safety in a Construction Environment

Safe ladder use. Construction Safety Series. When climbing up or down, workers should:

Los Angeles Fire Depart m ent

F.A.C.E. INVESTIGATION REPORT

Director, National Institute for Occupational Safety and Health. California Fatality Assessment and Control Evaluation (CA/FACE) Program

An Introduction to Practical Fall Protection for Pest Control

FALL PROTECTION PROGRAM

F.A.C.E. INVESTIGATION REPORT

WEEKLY SAFETY MEETING

FALL PROTECTION WORK PLAN

Staying on Your Feet: Fall Prevention for Construction

Massachusetts FACE Occupational Fatality Report

FACE 88-06: Plumber Falls to His Death Through a Roof opening INTRODUCTION

MA FACE Occupational Fatality Report

THE UNIVERSITY OF SHEFFIELD WORK AT HEIGHT POLICY

Fatality Assessment and Control Evaluation Project

Fall Protection Safe Work Plan Fall Distance of 7.5M or More

v. OSHRC DOCKET ELGIN ROOFING COMPANY, NO Administrative Law Judge Sidney J. Goldstein DECISION AND ORDER

EMPLOYEE FALL PROTECTION

STATE OF NEW YORK DEPARTMENT OF HEALTH

Director, National Institute for Occupational Safety and Health. California Fatality Assessment and Control Evaluation (CA/FACE) Program

North Carolina Department of Labor Occupational Safety and Health Division. Raleigh, North Carolina. Field Information System Standards Notice 65

Chapter 3: Fall Protection/ Scaffolding Safety

How To File A Worker S Compensation Claim In Azoria

Fall Protection Plan for Residential Roofing Construction. Tim Graboski Roofing, Inc.

RESCUE PLAN FALL PROTECTION PROGRAM

Fall Protection Susan Harwood Grant Training Program 2013 Commercial Roof Fall Safety. OSHA Susan Harwood Training - AGC

Walking/Work Surfaces Fall Protection Program

Death in the line of duty...

Fall Hazards 1/3/2014. Introduction

Work at Height. John Frontczak Construction Manager Facilities Engineering Chevron Corporation. All rights reserved.

working surface can be a potential fall hazard.

Fall Protection Program

OSHA Scaffold Standard for Construction. 29 CFR 1926 Subpart L

WORK AT HEIGHT. STFC Safety Code No 9. Rev. 1.4, Issued April, 2015

ELEVATED WORK POLICY

Fall Prevention In Construction

BCIT. CNST 1100 Construction Safety Officer Training. Lesson Plan

Director, National Institute for Occupational Safety and Health. California Fatality Assessment and Control Evaluation (CA/FACE) Program

Construction OS&H Working at height

ACCIDENT INVESTIGATION GUIDELINES WITH LITIGATION IN MIND

RISK RATING SAFE WORK METHOD STATEMENT 1 HIGH 2 MEDIUM 3LOW. I approve the use of this Safe Work Method Statement: NAME: POSITION: Department Manager

WORKPLACE SAFETY. Table 1: Industries with highest fatalities rates and types of highest fatal* / non fatal^ injuries

Construction Safety and Health Newsletter Protecting your most valuable resource your workers.

Independent Contractor Policy

CAUSES AND MEASURES OF FALL ACCIDENTS ON RESTORATION WORK AFTER THE GREAT EAST JAPAN EARTHQUAKE

STATE OF MINNESOTA OFFICE OF ADMINISTRATIVE HEARINGS FOR THE DEPARTMENT OF LABOR AND INDUSTRY

Elkhorn Construction, Inc. Safety Manual Title: Fall Protection Policy Effective Date:

COURSE INFORMATION SHEET

Fall Protection Safety Program

Life Saving Rules. Working Safely at EPCOR

SAFE WORK PROCEDURE SWP 015 WORKING AT HEIGHT SEPTEMBER 2013 DOC. NO. D13/248399

SITE SPECIFIC FALL PROTECTION PLAN

NEW! Highway Construction Training Offered at Richland

falls Fall from scaffold Fall from a horse Mechanism and circumstances of fatal incidents Occupation

SAFETY STAND DOWN Focus Four Hazards

`Fall Protection Guidelines in Construction

RRC SAMPLE MATERIAL WORKING AT HEIGHT- HAZARDS AND RISK CONTROL LEARNING OUTCOMES

RESIDENTIAL ROOF TRUSS INSTALLATION PROCEDURES

Fall Protection Training Guidebook

Can Worker Behavior Be the Cause? How workplace pressure can lead to serious injury

68 Metal Industry Guidelines for Safe Work

Slips, Trips and Falls. AR 2012 DMME Division of Mineral Mining

Environment, Health and Safety Technical Guidance

7. PRINCIPAL STEPS 8. POTENTIAL HAZARDS 9. RECOMMENDED CONTROLS

ELECTRICAL SAFETY & ARC FLASH Handbook

Fall Protection Basics for Construction Activities

Fall Protection Susan Harwood Grant Training Program 2013 Wood Frame Construction

Slips, Trips and Falls

CONSTRUCTION. Protect Them. Sons And Daughters.

Injury Prevention for the Construction Industry

A Great Workforce A Great Workplace. 19 August 2015 OSH Inspectorate OSHD, MOM

Fixed and Portable Ladders- A Guide to OSHA Rules

Director, National Institute for Occupational Safety and Health. California Fatality Assessment and Control Evaluation (CA/FACE) Program

WALKING-WORKING SURFACES (SLIPS, TRIPS, AND FALLS)

Total s Golden rules

Fall Protection. Office of Risk Management. uottawa.ca. Guide

Fact Sheet Fatality Inspections Construction Safety & Health Division Fatal Accident 01/11/12 at the Ambassador Bridge

OSHA GUIDANCE DOCUMENT FALL PROTECTION IN RESIDENTIAL CONSTRUCTION

Fixed Access Ladders. Table of Contents. 1. Legislative Requirements

This document is in the public domain and may be freely copied or reprinted. DISCLAIMER ORDERING INFORMATION

Walking and Working Surface Checklist:

Transcription:

Roofer Dies After Gust of Wind Knocks Him And A Co-Worker Off Roof Incident Number: 13KY059 The fall took place from this structure. Photograph property of KY FACE Program Kentucky Fatality Assessment and Control Evaluation Program Kentucky Injury Prevention and Research Center 333 Waller Avenue Suite 242 Lexington, Kentucky 40504 Phone 859-323-3981 Fax 859-257-3909 www.kiprc.uky.edu

Kentucky Fatality Assessment and Control Evaluation (FACE) Program Incident Number: 13KY059 Release Date: Subject: Roofer Dies After Gust of Wind Knocks Him And Co-worker off Roof SUMMARY: Around 11:00 a.m. on a windy fall day, a 73-year-old roofer and a roofing coworker arrived at the commercial construction site to roof a newly constructed building. The two roofers climbed an extension ladder to access the roof to determine where they were going to place their anchors to tie off. While reviewing the backside of the commercial structure, a gust of wind around 33 m.p.h. made the two roofers lose their balance and fall from the roof. The 73-year-old roofer landed first and the second roofer landed on top of him. Both men fell 15 feet and 6 inches and landed on a sloped grassy area. To prevent future occurrences of similar incidents, the following recommendations have been made: Recommendation No. 1: Employers should not allow their roofers to access roofing areas in times of windy, wet, or icy or conditions to prevent falls. Recommendation No. 2: A roofer should use a personal fall protection system during all phases of a roofing job. Recommendation No. 3: Employers should have a written fall protection program in place. Recommendation No. 4: Employers should fully plan their fall protection system before it is used. Background The roofer was a part-time employee for the past five years. He had been a brick mason and was still employed as a part-time farmer who helped the family owned business as he was needed. The roofing company has been in business since 2006 and employs six workers, two of them are roofers. The company has a worker safety program in place and had trained all their employees on working safely. However, the training wasn t specific to fall protection or documented. There was no written fall protection plan but there was a competent person assigned and trained at the time of the incident. On the day of the incident, the temperature ranged from 60-71 degrees Fahrenheit with no precipitation. The wind was blowing 18 to 20 mph with gusts up to 33 mph.

Investigation The Kentucky Fatality Assessment and Control Evaluation Program was notified of by Kentucky Occupational Safety and Health an occupational fatality involving a fall from a roof. A site visit was made the day of the incident and photographs were taken; employees and witnesses interviewed. Around 11:00 a.m. on a windy fall day, a 73-year-old roofer and roofing coworker arrived at the commercial construction site to roof a newly constructed building. The two roofers climbed the extension ladder to access the roof of the one story commercial building, to decide where they were going to place their anchors to tie off. They had not yet put on their personal fall protection gear. While reviewing the backside of the commercial structure, a gust of wind around 33 m.p.h. made the two roofers lose their balance and fall from the roof. At 11:09 a.m., the 73-year-old roofer landed first and the second roofer landed on top of him. Both roofers fell 15 feet 6 inches and landed on a sloped grassy area next to the commercial building. Roofer #2 stated that he heard roofer #1 yell, I m falling. Right after roofer #2 heard roofer #1 yell, roofer #2 knew he was falling as well due to the wind gust and landed on top of roofer #1.Roofer #2 said that they were both looking to see where they were going to install the tie-off anchors and as he turned, a gust of wind came through causing them both to lose their balance and fall 15 feet 6 inches to the ground below. Roofer #2 was very upset. Roofer #2 was related to the roofer #1, who was killed. Roofer #2 said that everything happened so fast and that was all he could remember about the fatal incident. Another sub-contractor, a supervisor for a different company on the jobsite immediately began CPR because Roofer #1 was unresponsive. A call was placed to 911 at 11:14a.m. EMS arrived at 11:25 a.m. and took over. Roofer #1 did not have a pulse and was not breathing. Roofer #1 was transported to the nearest local hospital and was pronounced dead upon arrival at the hospital, at 11:50 a.m. The roofer s body was sent to the state medical examiner s office for autopsy. The toxicology report was negative for substance abuse. Cause of Death The cause of death was blunt force injuries of the head and neck, due to fall. Recommendations and Discussions:

Recommendation No. 1: Employers should not allow their roofers to access roofing areas in times of windy, wet, or icy conditions. The weather was the major contributor to the fatal incident since the wind gusts were up to 33 mph and the construction zone was in a flat area. Employers should never allow their roofers to get on the roof during windy situations, wet or iced areas due to possible slips and falls. Employers should adapt to the OSHA standards for scaffolding use 1926.451 (f)(12) that states work on or from scaffolds is prohibited during storms or high winds unless a competent person has determined that is safe for employees to be on the scaffold and those employees are protected by a personal fall arrest system or wind screens. Wind screens shall not be used unless the scaffold is secured against the anticipated wind forces imposed. This same standard should be applied to roofers as well. Recommendation No. 2: A roofer should use a personal fall protection system during all phases of a roofing job. If the roofers had been wearing personal fall protection gear they could have placed their first anchor at the peak of the roof with a minimum of 6 feet from the edge and tied off immediately possibly saving them from the gust of wind that caused them to lose their balance and fall. It is unclear how much impact having one roofer land on the other roofer played into the fatal fall. It is not known if roofer #1 would have survived if this had not been a factor. However, it did add to the force of the trauma. Only one roofer should access the roof to install anchors limiting the exposure. Recommendation No 3 Employers should have a written fall protection program in place. OSHA standard 1926.503 states that an employer shall assure that each employee has been trained as necessary, by a competent person qualified in the following areas: the nature of fall hazards in the work area; the correct procedures for erecting, maintaining, disassembling, and inspecting the fall protection systems to be used: the use and operation of guardrail systems, personal fall arrest systems, safety net systems, warning line systems, safety monitoring systems, controlled access zones, and other protection to be used; the role of each employee in the safety monitoring system when this system issued; the limitations on the use of mechanical equipment during the performance of roofing work on low-sloped roof; the correct procedures for handling and storage of equipment and materials and the erection of overhead protection; and the role of employees in fall protection plans. Training must keep a written certification record containing the name or the employee trained, the dates of training and the signature of the person who conducted the training. Recommendation No. 4 Employers should fully plan their fall protection system before it is used.

According to the Construction Industry OSHA standard 1926.503 under fall protection, related to tie off considerations, one of the most important aspects of personal fall protection systems is to fully plan the system before it is put into use. The amount of time your employees are at risk is therefore eliminated. Keywords Construction Roofing Fall protection References CCH safety professional series OSHA Standards for the Construction Industry fall protection 1926.500 http://www.osha.gov http://www.download.bls.gov/ Acknowledgements The Kentucky FACE program would like to thank the coroner s office, KYOSH inspectors and KYOSH Safety Supervisor Shannon Lancaster, and the company for their assistance with this report. The Kentucky Fatality Assessment & Control Evaluation Program (FACE) is funded by grant 2U60OH008483-09 from the Centers for Disease Control and Prevention and the National Institute for Occupational Safety and Health. The purpose of FACE is to aid in the research and prevention of occupational fatalities by evaluating events leading to, during, and after a work related fatality. Recommendations are made to help employers and employees have a safer work environment. For more information about FACE and KIPRC, please visit our website: www.kiprc.uky.edu

Area of impact where employees landed from fall. Photograph property of KY FACE Program