NZQA registered unit standard version 1 Page 1 of 5

Similar documents
NZQA registered unit standard version 4 Page 1 of 5

Diploma of Practice Management

QUALIFICATION HANDBOOK

Waste Management Policy

NZQA registered unit standard version 3 Page 1 of 5

Training on Standard Operating Procedures for Health Care Waste Management Swaziland 12 May, 2011

Safe Handling of Cytotoxic Materials

Mercyhurst University Athletic Training Program Bloodborne Pathogens Exposure Control Plan

INFECTION CONTROL POLICY MANUAL

Linen and Laundry Guidance. Infection Control

CASTLEHEAD MEDICAL CENTRE JOB DESCRIPTION

Biosafety Spill Response Guide

Brock University Facilities Management Operating Procedures

We are the regulator: Our job is to check whether hospitals, care homes and care services are meeting essential standards.

Hygiene and Infection. Control advice in the home

EAST CAROLINA UNIVERSITY INFECTION CONTROL POLICY. Methicillin-resistant Staph aureus: Management in the Outpatient Setting

Bed Cleaning Procedure

The following standard practices, safety equipment, and facility requirements apply to BSL-1:

Hazardous Precautions. Prepared By: Hazardous Precautions Working Group Updated: March 2014

Shop Safety. Action Tattoo 3525 Del Mar Heights Rd., Suite 7 San Diego, CA 92130

AORN Recommended Practices. AORN Practices. RPs Related to Environmental Services. Joan Blanchard, RN, MSS, CNOR, CIC September 10, 2008

EXPOSURE CONTROL PLAN (sample) 1 Child Care Directors and Employers

GUIDELINES FOR THE CLEANING UP OF BODILY FLUIDS

NZQA registered unit standard version 6 Page 1 of 5. Demonstrate and apply knowledge of safeguards for use with portable electrical appliances

OSHA s Bloodborne Pathogens Standard

Biosafety Level 2 (BSL-2) Safety Guidelines

Part of The Revised Healthcare Cleaning Manual

Guidelines for Water, Sanitation and Hygiene in Cholera Treatment Centres

QUALIFICATION HANDBOOK

Hand Hygiene and Infection Control

4. Infection control measures

Clean Water: Supply side potable water, not wastewater. Gray Water/Sewage: Wastewater originating from a drain (sink, toilet, urinal).

Guidelines for Mold Remediation (Removal)

Biological Safety Program

Precautions for Handling and Disposal of. Dead Bodies

BIO-HAZARDOUS WASTE & AIRCRAFT PEST CONTROL BEN WHITE

NZQA registered unit standard version 7 Page 1 of 5. Explain and use contact centre equipment and systems

Chemotherapy Spill Response:

Safe Work Procedure Sharps and Bio-hazardous waste handling and disposal

Biosafety Level 2 Criteria

Infection Control Checklist for Dental Settings Using Mobile Vans or Portable Dental Equipment. Guiding Principles of Infection Control:

Procedures for Cutting and Handling of Asbestos Cement Pipe. City of Richmond Public Works Operations

Lead Exposure Management Plan

Rockhampton Office Brisbane Office Tarong Site. Barron Gorge Hydro PS Kareeya Hydro PS Mica Creek PS

To provide direction for the safe handling, administration and disposal of hazardous drugs.

Bloodborne Pathogens. Updated

Risk Assessment: Biosafety Cabinet

UBC Plant Operations Asbestos Work Procedures April 2004

Environmental Management of Staph and MRSA in Community Settings July 2008

Promote security system and service sales

8 OPERATING THEATRE AND ANAESTHETIC SERVICES

Precautions for Handling and Disposal of Dead Bodies

Welcome to the Health and Community Services Module.

Baseline assessment checklist for the AICG recommendations

Guidelines for Cleaning Staff on Managing Mould Growth in State Buildings

EAST CAROLINA UNIVERSITY INFECTION CONTROL POLICY

PI s Name Date Bldg./Rm# CDC Biosafety Level 3 (BSL-3)

Re: Addendum to Preliminary Water Damage Report, Mendocino Public Health Branch, 1120 South Dora Street, Ukiah, CA

The methods of implementation of these elements of the standard are discussed in the subsequent pages of this ECP.

OCCUPATIONAL SAFETY AND HEALTH ADMINISTRATION (OSHA)

53 (or depending on optional strand)

Massachusetts Department of Developmental Services MRSA, VRE, and C. Diff Management Protocol

Knowledge and Awareness of Proper Waste Disposal and Routine Biosafety Measures Among HealthCare Workers in Karachi, Pakistan (JUW-BEP-BSAP Project)

Edith Cowan University Faculty of Health, Engineering and Science Work Health and Safety Committee

Purpose: The purpose of this guideline is to minimize or eliminate employee exposure to communicable diseases.

Quality Assurance Calendar Maintenance Responsible Party Jan Feb Mar Apr May Jun Jul Aug Sep Oct Nov Dec

NZQA registered unit standard version 2 Page 1 of 5. Develop and implement a project plan to deliver on an Infrastructure works contract

Recommendations for Environmental Services, Biohazardous Waste Management, and Food and Linen Management for Ebola Virus Disease (EVD)

Biosafety Guidelines. 5. Pipetting Mechanical pipetting devices must be available and used. Mouth pipetting is prohibited.

BODY SUBSTANCE ISOLATION (BSI): THE STANDARD OF CARE

Leader s Guide E4017. Bloodborne Pathogens: Always Protect Yourself

Prevention and control of infection in care homes. Summary for staff

THE BLUE WASHING BOOK

Standard Operating Procedure for Blood Borne Infectious Disease Control Measures at Calvin College

BLOOD BORNE PATHOGENS

Ebola Treatment Centres - Preventing Infection

4.Infection Control. A. Introduction to Infection Control

RECOMMENDED CLEANING PROCEDURES FOR NOROVIRUS OUTBREAKS. General Recommendations:

STANDARD OPERATING PROCEDURES SPILL RESPONSE AND CLEAN-UP OUTSIDE BIOSAFETY CABINET

HAINES CITY POLICE DEPARTMENT GENERAL ORDER

British Columbia Institute of Technology. BCIT Safety Manual ASBESTOS MANAGEMENT

The following exciting career opportunities are available:

CARE HOMES AND NURSING HOMES

Inspecting Informing Improving. Hygiene code inspection report: South Western Ambulance Service NHS Trust

Don t Spread Lead. A Do-It-Yourself Guide to Lead-Safe Painting, Repair, and Home Improvement

Definitions. This plan. membrane, These are. additions and. and. weeping a source of. withstand the. demands of to or from a

BLOODBORNE PATHOGENS EXPOSURE CONTROL PLAN

Lab Biosafety Level 3 Checklist (dates: April 16, 1998)

Bloodborne Pathogens (BBPs) Louisiana Delta Community College

VRE. Living with. Learning how to control the spread of Vancomycin-resistant enterococci (VRE)

CYTOTOXIC PRECAUTIONS A GUIDE FOR PATIENTS & FAMILIES

Carnegie Mellon University s Policy and Procedures for Recombinant and Synthetic Nucleic Acid Materials Spills

C. difficile. Answers to frequently asked questions about. at the Jewish General Hospital. SIR MORTIMER B. DAVIS JEWISH GENERAL HOSPITAL

GUIDELINES TO PREVENT TRANSMISSION INFECTIOUS DISEASES IN SCHOOLS

Guidelines for the Management of Spillage of Cytotoxic Drugs. No changes have been made as evidence base remains current.

Recommendations for the Safe Use of Handling of Cytotoxic Drugs

CLEAN UP FOR VOMITING & DIARRHEAL EVENT IN RETAIL FOOD FACILITIES

CONSTRUCTION HEALTH AND SAFETY, AND INJURY PREVENTION Research and develop accident and incident investigation procedures on construction sites

High to Low. Remember the Cleaning Basics

How to safely collect blood samples from persons suspected to be infected with highly infectious blood-borne pathogens (e.g.

Transcription:

Page 1 of 5 Title Clean an operating theatre Level 3 Credits 5 Purpose This unit standard is for people in the cleaning industry. People credited with this unit standard are able to: prepare to clean an operating theatre; clean an operating theatre; and complete job related tasks. Classification Cleaning and Caretaking > Health Sector Cleaning Available grade Achieved Entry information Critical health and safety prerequisites Recommended skills and knowledge Unit 7442, Follow safe work practices in the cleaning industry, or demonstrate equivalent knowledge and skills. Unit 7183, Clean health care facilities; Unit 7184, Follow standard precautions set by infection control personnel; or demonstrate equivalent knowledge and skills. Explanatory notes 1 Competence demonstrated in assessment against this unit standard must comply with the requirements of: Employment Relations Act 2000; Hazardous Substances and New Organisms Act 1996; Health and Safety in Employment Act 1992; Privacy Act 1993; Smoke Free Environments Act 1990; Code of Health and Disability Services Consumers Rights Regulations 1996, Health and Disability Commission; Guidelines for the Prevention of Falls, Occupational Safety and Health 2000; Guidelines for Preventing the Transmission of Mycobacterium Tuberculosis in Health Care Facilities, 1994, Centres for Disease Control and Prevention; NZS 8134.1.4:2008 Health and Disability Services (Core) Standards Safe and appropriate environment; NZS 8134.3.1:2008 Health and Disability Services (Infection Prevention and Control) Standards Infection control management; NZS 8134.3.2:2008 Health and Disability Services (Infection Prevention and Control) Standards Implementing the infection control programme;

Page 2 of 5 NZS 8134.3.3:2008 Health and Disability Services (Infection Prevention and Control) Standards Policies and procedures; NZS 8134.3.4:2008 Health and Disability Services (Infection Prevention and Control) Standards Education; NZS 8134.3.5:2008 Health and Disability Services (Infection Prevention and Control) Standards Surveillance. 2 Equipment and cleaning agents must be used in accordance with manufacturer s recommendations. 3 Definitions Industry best practice refers to any enterprise or establishment or facility requirements, practices, policy procedures, methods and protocols which are in accordance with applicable legislation, regulations and New Zealand Standards. Sharps refer to potential health hazards to cleaners such as needles (contaminated or otherwise), surgical equipment, ampoules, and any potentially skin penetrating objects. Hazardous waste/biomedical waste/clinical waste are terms used in the health care industry and includes human products, stained bandages, swabs, incontinence pads, disposable underpants, dirty or disposable cleaning cloths and paper towels, waste products, and contaminated waste. Standard precautions is a term acknowledged and used in the health care industry to cover infection control procedures common across all health care areas. In addition to these, there are requirements relating to particular areas, which are under the control of the facilities' infection control personnel. Standard precautions are precautions to be taken by all personnel and applied to all patients/residents/areas regardless of their presumed infection status. Standard precautions combine the major features of universal precautions and body substance isolation. Infection control addresses factors related to the spread of infections within the health-care setting (whether patient-to-patient, from patients to staff and from staff to patients, or among-staff), including prevention (via hand hygiene/hand washing, cleaning/disinfection/sterilization, vaccination, surveillance), monitoring/investigation of demonstrated or suspected spread of infection within a particular health-care setting (surveillance and outbreak investigation), and management (interruption of outbreaks). It is on this basis that the common title being adopted within health care is "Infection Prevention & Control". Flat mop is a type of microfibre mop and may be used in a wet/damp or dry condition. Mop refers to either a string/cotton type or a sponge type or a microfibre type or a flat mop. 4 A vacuum cleaner used in a health care setting (eg a hospital or aged care centre) must be fitted with a genuine HEPA (High Efficiency Particulate Air) filter. Outcomes and evidence requirements Outcome 1 Prepare to clean an operating theatre.

Page 3 of 5 1.1 Infection control policies, procedures and standard precautions set by the facility are followed at all times during cleaning operations. 1.2 Equipment is either selected individually or from single station equipment and is hygienic and in working condition in bucket, mop/flat mop, plug hole brush, colour coded cloths or alternative system. 1.3 Warning signs are displayed in at least one of warning signs, cordons, barriers. 1.4 Personal protective equipment (PPE) suitable for the task being undertaken is used at all times during cleaning operations. gloves, gown/uniform/apron, shoe covers, face mask/n-95 mask, safety glasses/goggles. 1.5 Approved cleaning and disinfecting agent/s is selected in accordance with disinfectant, detergent. 1.6 Cleaning solution is prepared in accordance with manufacturer s recommendations. Outcome 2 Clean an operating theatre. 2.1 Operating theatre floor is checked for human products and are removed in 2.2 Hazardous waste and sharps are bagged and sealed in accordance with bio-hazard bags, sharps containers. 2.3 Contaminated linen is bagged and sealed in accordance with industry best practice. laundry bags.

Page 4 of 5 2.4 Handling practices which ensure non-infection of the operator are followed at all times in hazardous waste, sharps. 2.5 Sinks and basins are rinsed in 2.6 Non-technical equipment is washed/rinsed down using an approved cleaning agent in 2.7 Non-technical equipment is wiped down using an approved disinfectant in 2.8 All surfaces are washed/rinsed down using an approved cleaning agent in 2.9 All surfaces are wiped down using an approved disinfectant in accordance with 2.10 Operating theatre is set up in 2.11 Hand washing technique is performed between all cleaning operations in 2.12 PPE is changed and bagged between areas where cleaning operations are taking place in 2.13 All cleaning operations are completed with regard to infection control and standard precautions. Outcome 3 Complete job related tasks. 3.1 Clean laundry bags, biohazard bags and sharps containers are placed in the respective holders. 3.2 Cleaning equipment is cleaned and stored in accordance with industry best practice. 3.3 Task is completed without risk or damage to operator, equipment, fixtures, or fittings in 3.4 If required, cleaning equipment is sent for laundering in accordance with 3.5 Soiled cleaning solutions are disposed in accordance with the Hazardous Substances and New Organisms Act 1996.

Page 5 of 5 3.6 Contaminated gown/uniform/aprons are placed in the appropriate bag in Planned review date 31 December 2016 Status information and last date for assessment for superseded versions Process Version Date Last Date for Assessment Registration 1 15 March 2012 N/A Consent and Moderation Requirements (CMR) reference 0004 This CMR can be accessed at http://www.nzqa.govt.nz/framework/search/index.do. Please note Providers must be granted consent to assess against standards (accredited) by NZQA, before they can report credits from assessment against unit standards or deliver courses of study leading to that assessment. Industry Training Organisations must be granted consent to assess against standards by NZQA before they can register credits from assessment against unit standards. Providers and Industry Training Organisations, which have been granted consent and which are assessing against unit standards must engage with the moderation system that applies to those standards. Requirements for consent to assess and an outline of the moderation system that applies to this standard are outlined in the Consent and Moderation Requirements (CMR). The CMR also includes useful information about special requirements for organisations wishing to develop education and training programmes, such as minimum qualifications for tutors and assessors, and special resource requirements. Comments on this unit standard Please contact the info@careerforce.org.nz if you wish to suggest changes to the content of this unit standard.