Cleanroom Safety Training. 2 nd Edition, NR



Similar documents
Standard Operating Procedure for a Chemical Spill

Revised: June 6, 2007

College of Biological Science - Standard Operating Procedure Chemical Spills Date: 8-Feb-2008 Prepared by: A Doane Revision: New Supersedes: n/a

Chemical Spill Response Guideline

IX. EMERGENCY PLANNING

Biosafety Level 2 (BSL-2) Safety Guidelines

Particularly Hazardous Substances (PHS) Standard Operating Procedure (SOP)

Safety, Cleaning, and Chemical Disposal Procedures

Best Practices for Handling Nanomaterials in Laboratories

LABORATORY & CHEMICAL SAFETY GUIDELINES. Dr. Mobin Shaikh Convener SAFETY COMMITTEE DISCIP INE OF CHEMISTRY SCHOOL OF BASIC SCIENCE

CHEMICAL SPILL RESPONSE GUIDE

JILA SAFETY MODULE Clean Room Safety with David Alchenberger

Chemotherapy Spill Response:

UNH SAFETY AUDIT Office of Environmental Health and Safety

Chemical Fume Hoods. Environmental Health and Safety

PI s Name Date Bldg./Rm# CDC Biosafety Level 3 (BSL-3)

CHEMICAL SPILL MANAGEMENT GUIDELINES

EOSMS 204C Effective Date: 12/8/2014 Page 1 of 8

HAZARDOUS CHEMICAL SPILL CLEANUP GUIDELINES

CHEMICAL SPILLS. (revised April, 2013)

GEORGIA INSTITUTE OF TECHNOLOGY ENVIRONMENTAL HEALTH AND SAFETY PERSONAL PROTECTIVE EQUIPMENT

FDNY C14 Certificate of Fitness Quiz

Standard Operating Procedure

Autoclave Safety. Autoclaves are sterilizers using high pressure and high temperature steam. The potential safety risks for the operators are:

Parallel Circuits Charles Lang

SPILLS & SPILL KITS. Spills -General Guidelines:

Conservation of Momentum Greg Kifer

Laboratory Safety and Environmental Health Assessment Program

Biosafety Spill Response Guide

Carnegie Mellon University s Policy and Procedures for Recombinant and Synthetic Nucleic Acid Materials Spills

Safety in the Chemistry Laboratory General Safety Equipment Fire extinguisher Red fire alarm Fire blanket Safety shower Drench hose Eye wash station

Hazardous Waste Generator Training

School Science Lab Safety Guidelines

THE UNIVERSITY OF NEWCASTLE- SCHOOL of BIOMEDICAL SCIENCES

Biosafety Level 2 Criteria

Guidance sheet 4: Chemical Spill Management

Safety in the Chemistry Laboratory

BSL 1 Laboratory Biosafety Manual

PERSONAL PROTECTIVE EQUIPMENT (PPE)

Safety introduction. In the event of fire and accidents, you have a responsibility to know the location of:

Palm Beach State College Florida s First Public Community College CHEMICAL SPILL RESPONSE PLAN

The following standard practices, safety equipment, and facility requirements apply to BSL-1:

TEMPLE UNIVERSITY ENVIRONMENTAL HEALTH AND RADIATION SAFETY

CLEAN ROOM TRAINING CLEAN ROOM AREAS

K-State Entomology Department GOOD LABORATORY SAFETY PRACTICES

Any other time call the SFASU Police at Emergencies 911 Non-emergencies

Extraction: Separation of Acidic Substances

Hazardous Waste Procedures. Faculty of Science University of Ottawa

COMMON LABORATORY APPARATUS

Guidelines for Ethidium Bromide Waste Management & Disposal. University of Tennessee-Knoxville

Hazardous Drugs Spill Kit

Laboratory Biosafty In Molecular Biology and its levels

NTU Chemical Spill Guideline

PENNY IN A CUP: DEMONSTRATING THE LAW OF INERTIA

Pesticide Spills. Chapter 26. In This Chapter. Keywords. Accidents. Pesticides Act and Environmental Protection Act

Biosafety Program University of Colorado. BSL-1 Audit Checklist

ASTCCR2 - SQA Unit Code H Carry out and complete clean-room cleaning operations

Safety and Laboratory Procedures from the CWU Department of Chemistry CHEM 101 Laboratory Manual

Responding to Accidents and Emergencies

Using a Pendulum to Measure Gravity s Acceleration Elizabeth B. Chesick

OESO Ergonomics Division ERGO(3746) Duke Police Corporate Risk Management

Level I Inspection Guidance Document 2014

INSTITUTIONAL POLICY AND PROCEDURE (IPP) Department: Manual: Section:

Beware that ordinary prescription glasses do not provide adequate protection. This is also true with poorly fitting safety glasses.

TITLE: Storage and Management of Hazardous Medications & Chemicals APPLIES TO: Pharmacy Staff

Biological Safety Program

Safety and Health Office WORKPLACE SAFETY CHECKLIST

Standard Operating Procedure Working with Osmium Tetroxide

Chemistry 112 Laboratory Experiment 6: The Reaction of Aluminum and Zinc with Hydrochloric Acid

Department of Environmental Health and Safety & Emergency Management

Laboratory Safety Inspection Checklist (Biology and Biochemistry)

STANDARD OPERATING PROCEDURES SPILL RESPONSE AND CLEAN-UP OUTSIDE BIOSAFETY CABINET

Policies. Prep Room Policies

Sample Pharmacy CLEANING AND SANITIZING PROCEDURE P-304.1

Blood Collection and Processing SOP

Fire Safety in Laboratories. University of Tennessee Environmental Health and Safety

Automotive and Diesel Lab Safety Guidelines

Occupational Health and Safety in the Laboratory (Undergraduate Students)

Laboratory Hazardous Waste Disposal Guidelines

SPILL RESPONSE PROCEDURE

Hazardous Waste Procedures

Lab PPE Guide Examples of Personal Protective Equipment

EMERGENCIES. Emergencies

(616) Ann Street N.W. Emergency Phone Grand Rapids, MI 49504

Mechanical Systems Competency 1.20

STANDARD OPERATING PROCEDURES Safe Autoclave Operations

Brock University Facilities Management Operating Procedures

Coating and Extraction of Honeycomb Denuders

Acids, Bases, and ph

#10 Introduction to the Chemistry Lab: Safety Comes First Sharyl A. Majorski, Central Michigan University, Mount Pleasant, MI 48859

Job Hazard/Safety Analysis For the Lab Worker

MSDS (Material Safety Data Sheet)

Standard Operating Procedure for Blood Borne Infectious Disease Control Measures at Calvin College

Transcription:

Cleanroom Safety Training 2 nd Edition, NR

All users must first complete the annual safety training offered through the WUSTL Environmental Health and Safety department. http://ehs.wustl.edu/training/pages/default.aspx

Areas of the Cleanroom Class 10,000 Bay Entry Wipe Down Entry Vestibule Gowning Class 1,000 Bay Class 1,000 Bay Class 100 Bay Main Entrance/Exit Emergency Exit First Aid Kit Shower & Eye Wash Station

Personal Safety Eating, drinking, smoking, handling contact lenses and applying cosmetics is STRICTLY PROHIBITED in areas where hazardous laboratory chemical or biological materials are used or are intended for use. Storage of food and beverage in containers or in areas that are intended or are used for storage of hazardous laboratory materials is PROHIBITED.

Off-hours Use Operation of equipment or completion of any process off-hours requires a MINIMUM of 2 authorized users in the cleanroom at all times. 20 hours of daytime use and an additional training are required for off-hours instrument and cleanroom use. No Hydrofluoric Acid use off-hours.

User s Chemicals and Samples NEW chemicals must first be approved by Staff. Confirm there is a MSDS for the chemical you wish to bring in. You are responsible for providing an MSDS if there is not a copy in the MSDS notebook. All chemicals and samples brought into the lab must be clearly labeled with user name, group name, contact info, chemical name and the date. Unlabeled chemicals and samples are subject to disposal. Liquid-filled containers in fume hood must be labeled with contents, user name, PI, expected time of disposal and phone number. The maximum time for unattended chemicals is 12 hours.

Allowed & Prohibited Items Prohibited Cardboard and paper Pencils Cloth items Hats and coats Plastic items Allowed Cleanroom paper and notebooks Pens Synthetic fabrics(polyester, nylon) Paper items sealed in plastic Cleanroom notebooks are required for taking notes in the cleanroom. Cleanroom paper will be available for notes. All approved items that are brought into the cleanroom must be wiped down to remove dust particles and oil.

Cleanroom Gowning Standard laboratory dress code applies under all cleanroom attire.

Cleanroom Gowning Users may store personal items in one of the lockers outside of the gowning area. Frequent users will receive there own locker to share with their group.

Cleanroom Gowning Each user receives a hood, a garment, and a pair of cleanroom boots to be worn in the class 1,000 and class 100 bays. Class 10,000 bay users only need shoe covers, a hairnet and lab coat.

Class 1000/100 NRF Gowning Process 1. Put your name, instrument used, gases and chemicals used on the dry erase board. 2. Sign into the FOM system and log into the instrument.

Class 1000/100 NRF Gowning Process 3. Clean shoes with motorized shoe cleaner. 4. Put on shoe covers and hair net. 5. Swipe card key and enter cleanroom.

Class 1000/100 NRF Gowning Process 6. Place all items on the wipe down table and put on a pair of gloves. 7. Using the spray bottle, moisten a cleanroom wipe with the water/isopropanol solution and wipe down all the items being brought into the cleanroom.

Class 1000/100 NRF Gowning Process 8. Put on the cleanroom hood and snap the hood under the chin. 9. Put on the cleanroom suit being careful not to drag the suit on the floor in the process. Tuck the bottom of the hood into the suit, zip it up and snap the top snap. 10.Put on two boots and be sure to snap them on the back of the legs.

Class 1000/100 NRF Gowning Process 11. When exiting the cleanroom, simply reverse the steps, placing the coverall and hood on a hanger and the boots in the storage rack. Gloves can be placed in the trash and shoes covers and hairnets can be placed in locker for later use. Once in the cleanroom, your suit should not be opened or unzipped. Return to gowning room to retrieve items from within suit. Anything that a user needs access to while in the cleanroom(cell phones, electronics, ect) should be taken out while in the gowning room and wiped down.

Hazardous Waste All cleanroom waste must be properly disposed.

Hazardous Waste Containers Solvent Waste lass 0 Bay Class 1,000 Bay Hydroflouric Acid Waste Class 100 Bay Photolithography Solid Waste

General Waste Container lass 0 Bay Class 1,000 Bay Class 100 Bay All non contaminated waste.

Cleanliness As an open facility we rely on users to clean up after themselves. Maintaining cleanroom cleanliness is a matter of courtesy and safety.

While Working in the Fume Hoods Do not leave funnels in waste containers No containers are to be left in the sinks Hazardous materials should be at least 6 inches behind the sash of the fume hood

While Working in the Fume Hoods All manipulation (transferring containers, pipetting, etc ) of chemicals should take place in a fume hood.

While Working in the Fume Hoods Clean photo resist spinners after each use Wipe up any spills immediately. If a hazardous chemical spill occurs outside of a fume hood, you should evacuate the lab immediately and notify NRF staff and University Police(5-5555).

Cleanliness Be considerate of others and clean up after yourself. Please leave amenities in the cleanroom as clean or cleaner than you found it.

Hydrofluoric Acid Hydrofluoric acid can pose significant health risk and should be handled cautiously. Special training is required to use HF and it should never be used while alone.

Hydrofluoric Acid Safety Hydrofluoric acid (HF) presents a significant health hazard! HF is used in the cleanroom in both its pure and dilute form. HF is the active component in Buffered Oxide Etch (BOE) Used to etch silicon dioxide and for stripping native oxide prior to processing. Both liquid and vapor can cause severe burns, which may not be immediately painful or visible. HF will penetrate skin and attack underlying tissues, including bone.

Hydrofluoric Acid Exposure Exposure to HF requires medical attention. If exposure to HF occurs, remove yourself and victim from contaminated area. Immediately wash burned area with water for at least 5 minutes and apply 2.5% calcium gluconate gel. Calcium gluconate is a topical antidote that should be applied liberally after any HF exposure. Calcium gluconate can be found in the cleanroom first aid kit. Always follow proper notification protocol and report accidents and emergency situations to NRF staff.

Hydrofluoric Acid Use HF etches glass thus it must not be kept in a glass bottle or used in a glass beaker. Regardless of concentration of HF, it may NOT be disposed of down the drain. HF must be used only in the HF designated area in the acid fume hood. It may not be removed in a beaker from the hood. Full face shield, acid apron, neoprene outer gloves and nitrile inner gloves are required when using HF or BOE.

Consumables Consumable cost will be passed on to users.

Consumables Available Chemicals Solvents Acetone Isopropanol (IPA) Methanol Photoresists SU-8 2010 SU-8 2050 SU-8 2 PMMA AZ 5214 E Developers AZ 327 MIF SU-8 Developer Acids Hydrochloric Acid (HCl) Hydrofluoric Acid (HF) Nitric Acid (HNO 3 ) Sulfuric Acid (H 2 SO 4 ) Buffered Oxide Etch (BOE)

Available Materials Open Use Cleanroom Wipes Plastic Pipettes Petri Dishes Aluminum Foil Upon Request Gold Pellets Silver Shot Aluminum Pellets Copper Pellets Chromium Pieces Titanium Pellets 2, 3, 4 Si Wafers 3 x 1 Glass Slides Material prices are passed on to users and are subject to change.

Cleanroom Gases BCl 3 HBr NF 3 Cl 2 SF 6 O 2 Ar He N 2 CH 4 H 2

Alarms A variety of reactive gases are used in the cleanroom and an alarm system monitors these chemicals using sensors throughout the cleanroom.

Alarm Protocols Yellow Alert In the event of a YELLOW alarm all personnel in the cleanroom should exit via the gowning area and IMMEDIATELY notify NRF Staff.

Alarm Protocols Red Alarm In the event of a RED alarm all personnel in the cleanroom should IMMEDIATELY exit via the doors to the hallway and notify NRF Staff. DO NOT exit through the gowning area or the service chase. In the event of a RED alarm ALL PERSONNEL should exit the basement until NRF Staff has confirmed that the area is safe. If you believe someone has collapsed in the cleanroom area DO NOT attempt to retrieve them! Call 935-5555 and request a Hazmat team. DO NOT attempt to diagnose an alarm condition or turn off an alarm on your own. Always wait for NRF Staff to respond to the situation.

Citation Requirement The NRF is supported by the National Science Foundation through the Nanotechnology Infrastructure Network. It is important for users to properly cite the support of facilities of the NRF in all publications and presentations made possible by work performed at the NRF. For papers, a suggested acknowledgement reads: This work was performed in part at the Washington University in St. Louis Nano Research Facility, a member of the National Nanotechnology Infrastructure Network, which is supported by the National Science Foundation (Grant ECS-0335765).

Before your safety training is completed you need to: Take Our Safety Training Quiz: http://www.surveymonkey.com/s/vjcgfc3 Take a Cleanroom Tour Have a Follow-up Cleanroom Safety Training with a NRF Staff Member