ANNEX III BUDGET PROPOSAL AS PER LOTS Item no. UNIT COSTS WITH DELIVERY Comment Technical Specification Quantity Specification Offered INCLUDING INSTALLATION AND PUTTING INTO OPERATION Technical Specification of L2 Switch LOT (without VAT) Technical specification of L2 SWITCH - 48 0/00 PoE (Power over Ethernet) ports + 48 x 0/00 (PoE) + 2 x SFP + 2 x 0/00/000 is based on Cisco Catalyst 2960-48PST-S PoE.. Device Type: Switch - 48 ports - managed Enclosure Type: Rack-mountable - U Ports: 48 x 0/00 PoE + 2 x SFP + 2 x 0/00/000 for uplink Power over Ethernet (PoE): Yes Performance: Switching capacity: 6 Gbps Forwarding performance (64-byte packet size): 3.3 Mpps MAC Address Table Size: 8K entries 204 Page of
Remote Management Protocol: SNMP, SNMP 2, RMON, RMON 2, Telnet, SNMP 3, SNMP 2c, HTTP, HTTPS, TFTP, SSH-2 Encryption Algorithm: SSL Authentication Method: RADIUS, TACACS+, Secure Shell v.2 (SSH2) Features: Layer 2 switching, auto-sensing per device, DHCP support, power over Ethernet (PoE), auto-negotiation, VLAN support, autouplink (auto MDI/MDI-X), IGMP snooping, Syslog support, DiffServ support, Broadcast Storm Control, Multicast Storm Control, Unicast Storm Control, Rapid Spanning Tree Protocol (RSTP) support, Multiple Spanning Tree Protocol (MSTP) support, Dynamic Trunking Protocol (DTP) support, Port Aggregation Protocol (PAgP) support, Quality of Service (QoS), Link Aggregation Control Protocol (LACP), Port Security, MAC Address Notification RAM: 64MB Flash Memory: 32MB Interfaces: 48 x 00Base-TX - RJ-45 - PoE 2 x 000Base-T - RJ-45 x console - RJ-45 - management 2 x SFP (mini-gbic)) Power device: Power supply - redundant - Internal power supply Cable: AC Power Cord (Europe) C3 CEE 7.5M Voltage Required: AC 20/230 V (50/60 Hz) Power Consumption Operational: 52 Watt Software Included: Cisco LAN Base software Dimensions 204 Page 2 of
Depth (cm) 33. Height (cm) 4.4 Width (cm) 44.5 Wight (kg) 5.4 Miscellaneous: Rack Mounting Kit Warranty: Year Note: Technical specification of network device is developed based on Cisco Catalyst 2960-48PST (WS- C2960+48PST) LAN Base. 2 Technical Specification of L2 Switch Technical specification of L2 SWITCH - 48 0/00/000 + 2 x SFP + 2 x 0/00/000 is based on Cisco Catalyst 2960S-48TS-L 2. Device Type: Switch - 48 ports - managed Enclosure Type: Rack-mountable - U Ports : 48 x 0/00/000 + 2 x SFP + 2 x 0/00/000 for uplink Power over Ethernet (PoE): No Performance: Switching capacity: 76 Gbps Forwarding performance (64-byte packet size): 77.4 Mpps MAC Address Table Size: 8K entries Remote Management Protocol: SNMP, SNMP 2, RMON, RMON 2, RMON 3, RMON 9, Telnet, SNMP 3, SNMP 2c, HTTP, HTTPS, TFTP, SSH Encryption Algorithm: SSL Authentication Method: Secure Shell (SSH), RADIUS, TACACS 204 Page 3 of
Features: Layer 2 switching, auto-sensing per device, dynamic IP address assignment, auto-negotiation, BOOTP support, ARP support, load balancing, VLAN support, autouplink (auto MDI/MDI-X), IGMP snooping, Syslog support, DiffServ support, Broadcast Storm Control, IPv6 support, Multicast Storm Control, Unicast Storm Control, Rapid Spanning Tree Protocol (RSTP) support, Multiple Spanning Tree Protocol (MSTP) support, DHCP snooping, Dynamic Trunking Protocol (DTP) support, Port Aggregation Protocol (PAgP) support, Access Control List (ACL) support, Quality of Service (QoS), Link Aggregation Control Protocol (LACP), Port Security, MAC Address Notification, Remote Switch Port Analyzer (RSPAN) RAM: 28MB Flash Memory: 64MB Interfaces: 48 x 0Base-T/00Base- TX/000Base-T - RJ-45 2 x 000Base-T - RJ-45 2 x SFP (mini-gbic) x console - mini-usb Type B - management Power device: Power supply - redundant - Internal power supply Cable: AC Power Cord (Europe) C3 CEE 7.5M Voltage Required: AC 20/230 V (50/60 Hz) Power Consumption Operational: 52 Watt Software Included: Cisco LAN Base software Dimensions Depth (cm) 29.9 Height (cm) 4.5 204 Page 4 of
Note: Width (cm) 44.5 Wight (kg) 4.77 Warranty: Year Miscellaneous: Rack Mounting Kit Technical specification of network device is developed based on Cisco Catalyst 2960S-48TS-L (WS-C2960S- 48TS-L) LAN Base. 3 Technical Specification of L3 Switch Technical specification of 24 x 0/00/000 + 4 x Gigabit SFP is based on Cisco Catalyst 3560G- 24TS. 3. Device Type: Switch - 24 ports - L3 - managed Enclosure Type: Desktop - U Ports: 24 x 0/00/000 + 4 x Gigabit SFP Performance: Forwarding performance (64- byte packet size): 38.7 Mpps Routing Protocol: RIP-, RIP-2, EIGRP, HSRP, static IP routing, RIPng Remote Management Protocol: SNMP, RMON, RMON 2, RMON 3, RMON 9, Telnet, SNMP 3, SNMP 2c, HTTP, SSH-2 Authentication Method: Kerberos, Secure Shell v2 (SSH2), RADIUS, TACACS+ Features: Full duplex capability, Layer 3 switching, Layer 2 switching, auto-sensing per device, IP-routing, DHCP support, autonegotiation, ARP support, trunking, MPLS 204 Page 5 of
support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, manageable, Spanning Tree Protocol (STP) support, Rapid Spanning Tree Protocol (RSTP) support, Multiple Spanning Tree Protocol (MSTP) support, DHCP snooping, Dynamic Trunking Protocol (DTP) support, Port Aggregation Protocol (PAgP) support, Trivial File Transfer Protocol (TFTP) support, Access Control List (ACL) support, Quality of Service (QoS), DHCP server, Virtual Route Forwarding-Lite (VRF-Lite), MLD snooping, Dynamic ARP Inspection (DAI), Time Domain Reflectometry (TDR), Per-VLAN Spanning Tree Plus (PVST+), Cisco EnergyWise technology, Uni-Directional Link Detection (UDLD), Link Aggregation Control Protocol (LACP) RAM: 28MB Flash Memory: 32MB Interfaces 24 x 000Base-T - RJ-45 x console - RJ-45 - management 4 x SFP (mini-gbic) Power device: Power supply - redundant - Internal power supply Power Consumption Operational: 00 Watt Cable: AC Power Cord for Catalyst 3K-X (Europe) Voltage Required: AC 20/230 V (50/60 Hz) Software Included: Cisco IOS IP Base Dimensions Depth (cm) 37.8 Height (cm) 4.4 Width (cm) 44.5 204 Page 6 of
4 Note: Wight (kg) 5.4 Warranty: Year Technical specification of network device is developed based on Cisco Catalyst 3560G-24TS (WS-C3560G- 24TS-S) IP Base. Technical Specification of Storage Device LOT 2 4. Device Type: Storage Device x Monolithic disk array system with 2 controllers for data storage (block storage) Note: disk-system should include the following components:. Redundant system of power supplies 2. Redundant FAN system 3. Controller configuration: ACTIVE-ACTIVE 4. Rack-mount kit 5. Separate Gb Eth port for remote control (installation, control, supervision) 24 x 900GB 0k SAS HDD Minimum 24GB DDRAM memory (cache) Possibility of installation of minimum 220 hard-discs with no replacement or additional controller Enclosure Type 2U, maximum. Note: Due to the limited space (in terms of height) in server rack, the maximum height of monolithic disk-array system should be 2U Rack-mount kit for installation of monolithic 204 Page 7 of
disk-array system Battery protection of cache memory Note: In case of disruption in power supply, the functionality of recording data on SSD media in disc-array controller must be available, thus safeguarding data for unlimited time Minimum 4 FC 8Gb connection (2 FC connections per controller) for connection of server units Note: 4 FC cables for the link between diskarray system and server units Note: Expansion to 2 FC ports with no replacement or addition of disk-array controllers (6 FC ports per controller) Possibility of installation of 0Gb iscsi connections (minimum 2 per controller) Thin Provisioning licence provided Licences for production of full copy - mirror copy virtual disks provided Possibility for direct FC connection of diskarray system to the servers (without FC switch device) Zero Data Detection (i.e. that zeroes are not recorded on disks) licence provided Option to simultaneously create various types of RAIDs on the same disks (e.g. RAID 0 and RAID 5, because of the limited number of disks) Disk-array system must support the following RAID types: 0, 0, 5 and 6 Option to manage disk-array system from GUI and CLI Note: Licences should be provided (attached) 204 Page 8 of
Warranty: 3 years Note: 3-year support with 4-hour response time Compatibility and unification with the configuration of Server Units and Disk Backup System for the purpose of simple, efficient and successful maintenance and support. 5 Technical Specification of Servers 5. Device Type: Server Unit 2 x Intel Xeon E5-2630 v2 Processor (6 core-ova, 2.0GHZ, 95w) Note: The server unit should include the following components:. Redundant system of 400W power supplies, and possibility of installation of 200W units 2. Redundant FAN system 3. Rack-mount kit 4. Possibility of installing 8 disks, and with server upgrade, possibility of installing 6 disks 5. 3 PCIe additional slots with the possibility of expansion to 6 6. Separate Gb Eth port for remote control (installation, control, supervision) 7. DVD ROM 24 slots for memory - 64GB RAM memory 2 204 Page 9 of
installed Server Form Type 2U, maximum Note: Due to the limited space (in terms of height) in server rack, the maximum height of server unit should be 2U 2 x 2-port FC 8Gb cards for direct connection of disk-array system (without FC infrastructure and FC switch) Minimum 4 x Gb Ethernet network adapter 2 x 300GB 0k disks with relevant RAID controller with minimum 52MB FBWC Warranty: 3 years Note: 3-year support with 4-hour response time Compatibility and unification with the configuration of Storage Device and Disk Backup System for the purpose of simple, efficient and successful maintenance and support. 6 Technical Specification of Disk Backup System 6. Device Type: Disk Backup System x Disk backup system with included deduplication system Raw capacity 8TB (4 x 2TB NL-SAS 7200 rpm discs) net capacity 5.5 TB Minimum 4 x Gb Ethernet network adapter 204 Page 0 of
7 for iscsi, NFS, CIFS, etc. Disk backup system Form Type U, maximum Note: Disk backup system unit should include the following components:. Redundant system of power supplies 2. Redundant FAN system 3. Rack-mount kit Note: Due to the limited space (in terms of height) in server rack, the maximum height of disk backup unit should be U Disk backup system should include support for VTL and NAS emulation Maximum number of cartages emulated 700 Compatibility and unification with the configuration of Storage Device and Server Units for the purpose of simple, efficient and successful maintenance and support Warranty: 3 years Note: 3-year support with next-business-day response time. Technical Specification of Operating System and Licenses LOT 3 7. Operating System Type: Windows Server 202 R2 DataCenter No. of licenses 2 NOTE: a) PLEASE INDICATE TOTAL VAT AMOUNT PER EACH LOT b) PLEASE INDICATE THE AMOUNT OF CUSTOMS DUTIES PER EACH LOT 204 Page of