SHDSL.bis and Fiber Access Platform Ddd & Management FlexGain Platform Universal Access Platform Features Universal Multiservice Platform Multipurpose 19 Mechanics Universal Desktop Housings Extensive Management Options Fail-Safe through Redundancy Flexible and Modular Design Scalability Industrial Quality The FlexGain Access Platform brings a broad range of universal transmission platforms together. Alongside Castlerock SNMPc management software, the FlexGain Platform is a powerful telecommunication solution for telecom, utility, and campus applications. While hosting FlexDSL Orion1, Orion2, Orion3, MiniFlex and Discovery products and providing an extensive range of SHDSL connectivity, the FlexGain Platform additionally supports fiber optic, cross connect (DACS) and voice and data multiplexers for a broad range of TDM and packet based applications. The FlexGain Platform is designed with front access shelves and it is the missing link between fiber and copper transmission requirements. These features and others, ensure that the FlexGain Platform family is the first choice solution when flexibility, cost effectiveness, reliability, and quality are the required attributes. Unlike traditional repeater bay, DSLAM, or DLC products, the FlexGain Access Platform is not just a product, it is a comprehensive solution offering the opportunity to start with a small footprint and to grow as you go. This approach secures investments while providing an upgrade path to future applications and businesses. There are no more debates about the various benefits of TDM or IP centric applications. Both technologies have their strength and these strengths have been combined in the FlexGain Platform by allowing coexistence and convergence of both technologies in the same platform. With DSL, Fiber, DACS, Mux, TDMoIP, Ethernet Switch, and Management options FlexDSL walks the talk! Possible Application: Central Office Equipment (FG-R-W, V2) Slot 1: ACU (FG-ACU-SR, V1) Slot 2: Fiber Modem Slot 3-7: Copper Modem, SHDSL Slot 8-14: Not equipped, future use Switzerland Page 1/5
Subrack LTU with 14 Slots FG-R-W, V2 19 or ETSI, 6U, 483x266x248mm (WxHxD), 3.6kg 4 Backplane: Only upper backplane. To be used for all applications except voice. Power: Require ACU or TCU Through first slot with TCU or ACU Through second slot for redundancy with ACU Remark: All line cards do have an own power supply (36-72VDC) on board. The ACU or TCU is only needed to filter the applied power. Blind frontplates have to be ordered separately (FG-BLD) FG-R-PCM/W, V2 19 or ETSI, 6U, 483x266x271mm (WxHxD), 4.0kg 4 Backplane: Upper and lower backplane. Lower backplane is used for voice applications. Power: Require ACU or TCU Through first slot with TCU or ACU Through second slot for redundancy with ACU Remark: All line cards do have an own power supply (36-72VDC) on board. The ACU or TCU is only needed to filter the applied power. Blind frontplates have to be ordered separately (FG-BLD) FG-ACU-SR, V1 Connects and filters the applied power for the subrack Power Input: 2x 36 to 72VDC (redundant), max. 8A Power Input DB3 HC (Power), DB9 (LCT & Alarms), RJ45 (Clock), DIN41612 (Back) < 3.0 Watts FG-TCU-SR, V1 Connects and filters the applied power for the subrack Additional Management possibilities Power Input: 2x 36 to 72VDC (redundant), max. 8A Power Input Alarms: Major and Minor alarm optocoupler inputs Management: 4x Ethernet 10/100BaseT (Switch) for Telnet, SNMP V1 DB3 HC (Power), DB9 (LCT & Alarms), RJ45 (Ethernet), RJ45 (Clock), DIN41612 (Back) < 6.5 Watts FG-21SWU-SR,V2 Ethernet switch for the subrack Additional Management possibilities & Uplink module (connect all line cards) 8x Ethernet 10/100BaseT (Auto Sensing) 13x Ethernet 10/100BaseT (Auto Sensing) to backplane for line cards 2x Gigabit Ethernet 1000Base-T 2x Gigabit Ethernet SFP 1x Local craft terminal (Backplane) RJ45 (Ethernet), SFP (Ethernet), DIN41612 (Back) Switzerland Page 2/5
Management: L3 Features: L2 Features: Power: Local Craft Terminal, Telnet/SSH, SNMP v1 and V2c, RMON V1 NAT (Network Address Translation) Spanning Tree and Ethernet Ring IEEE 802.1D Spanning Tree Protocol (STP) IEEE 802.1w Rapid Spanning Tree Protocol (RSTP) IEEE 802.1s Multiple Spanning Tree Protocol (MSTP) Ethernet Ring Protection Mechanism, 50ms rapid switching and protection Port Mirroring, Jumbo Frames support (up to 9216 bytes) VLAN 4K IEEE 802.1q VLANs Port-based VLAN, MAC-Based VLAN, Private VLAN GVRP, Q-in-Q, VLAN Translation Link Aggregation Static Trunk, Dynamic Trunk, IEEE 802.3ad LACP, Load Balancing Multicast Features IGMP v1. v2, v3, IGMP Snooping, IGMP Groups, Multicast VLAN Quality of Service 8 Priority Queues/port WRR, Strict Priority and WRR/WDDR+Strict Priority 802.1p, Port-Based CoS, CoS based on MAC DA/SA, Bandwidth Control per Port Access Control List MAC+Port binding, IP+Port binding, IP+MAC binding, TCP/UDP port allow/deny, VLAN + Port Binding Port Security Trust Port, Port Blocking, Private VLAN, Port Powering Off MAC address learning limit per port, DoS check, Management IP list Authorization and Authentication Radius and IEEE 802.1x support 18-72VDC < 15.0 Watts MiniRack with 1 Slot FG-MRN-AC/DC 19, 1U, 483x44x255mm (WxHxD), 3.13kg Interfaces Power Input: 36-72VDC and/or 100-240VAC IEC-60320 C14 (AC Power), DB9 (LCT & Alarms), RJ45 (Clock) Screw Terminals (Back for 36-72VDC Power & FXx Interfaces) Remark: AC input power is only for local power and not remote power feeding 36-72VDC input power can be uses for remote power feeding FG-MRN-DC-24V 19, 1U, 483x44x255mm (WxHxD), 3.13kg Interfaces Power Input: 18-36VDC and/or 36-72VDC Screw Terminals (18-36VDC Power), DB9 (LCT & Alarms), RJ45 (Clock) Screw Terminals (Back for 36-72VDC Power & FXx Interfaces) Remark: 18-36VDC input power is only for local power and not remote power feeding 36-72VDC input power can be uses for remote power feeding Switzerland Page 3/5
UTT1 with 1 Slot FG-UTT1-48 1U, 288x44x335mm (WxHxD), 2.46kg Interfaces Power Input: 2x 36-72VDC DB9 (LCT & Alarms), Molex (DC Power) Remark: 19 require additional holders (FG-UTT1-Holder19 ) FG-UTT1-48AF230 1U, 288x44x335mm (WxHxD), 2.70kg Interfaces Power Input: 2x 36-72VDC and/or 100-250VAC IEC-60320 C14 (AC Power), DB9 (LCT & Alarms), Molex (DC Power) Remark: 19 require additional holders (FG-UTT1-Holder19 ) UTT4 with 4 Slots FG-UTT4-48A 149x287x278mm (WxHxD), 2.80kg Number of Slots: 4 Interfaces Power Input: 2x 36-72VDC DB9 (LCT & Alarms), Molex (DC Power) Remark: 19 holders are not possible FG-UTT4-48A-230 149x287x278mm (WxHxD), 3.95kg Number of Slots: 4 Interfaces Power Input: 2x 36-72VDC and/or 100-250VAC IEC-60320 C14 (AC Power), DB9 (LCT & Alarms), Molex (DC Power) Remark: 19 holders are not possible Dinrail and 19 Number of Units: Remark: FG-RAIL-MRN-1U 483x44x228mm (WxHxD) 2 (Orion) 5 (MiniFlex) 3 positions can be set up in depth Number of Units: Remark: FG-RAIL-R-2U 483x88x260mm (WxHxD) 9 (Orion) 10 (MiniFlex) 3 positions can be set up in depth Switzerland Page 4/5
Subrack NTU with 14 Slots FG-R-NTU 19, 5U, 483x222x170mm (WxHxD), 2.55kg 4 Power: Every unit has to be powered separately Special power unit FG-PWR-14 with power cable FG-CAB-Power-Molex Remark: The subrack is just a system to hold the Orion NTU PCB s For cabling you can order FG-CableTray Interfaces Output Power: FG-PWR-14 19, 1U, 483x44x170mm (WxHxD), 2.0kg Power Input: 2x 48VDC and/or 2x 100-240VAC Alarm (relay output) for each AC Power input Power Output: 14x 48VDC IEC-60320 C14 (AC Power), Screw Terminals (DC Power & Alarms) Max. 110 Watts @ 48VDC Switzerland Page 5/5