CANING AND RUSH SUPPLIES

Transcription

1 ORDERING INFORMATION All prices subject to change without notice. It has always been our policy to give the BEST QUALITY MATERIALS for the lowest prices possible. We pay NO postage so kindly be sure to include sufficient money when remitting with orders. We assume no liability for non-deliver or damage to packages. Packages are insured by UPS, FEDEX or US Postal Service. In the event that you send too much money we will refund the balance due to you by check or stamps. It is not advisable to send cash through the mail. We recommend that you remit a check or money order with your order. New Jersey residents add 7% sales tax on cost of materials plus postage. Customers having NJ sales tax licenses must list their license number on each order to receive tax exemption. NO CREDIT CARDS. CHECKS OR MONEY ORDER ONLY TWISTED SEA GRASS Sold in full hanks only. This fiber is used as a substitute for genuine Rush woven seats on chairs. Approx. Diameter Approx. Weight Price /Hank 5/32 3 lbs $14.95 FIBER RUSH Sold in full spools only (35 to 45 lb each) For imitation rush seats Fiber Rush is used as a substitute for Genuine Rush for chairs with four rails as part of the seat frame. widths weight price 1 average seat 4/32 One pound $ 6.49 each lb lbs Telephone:

2 FLAT REED & FLAT OVAL REED For Chairs, Rockers & Stools Three hanks flat oval or flat reed will do about one seat and one back. In addition to basketry and seat weaving, reed and wide binder are used in the repair and construction of wicker and rattan furniture and accessories. Widths Hanks Approx. Ft. /Hank 3/8 Flat Oval Reed $15.49 each 295 ft. 3/8 Flat Reed $15.49 each 295 ft. 1/2 Flat reed $15.49 each 185 ft. 5/8 Flat Reed $15.49 each 120 ft. PRIME ROUND REEDS These selected smooth and uniform in diameter prime long round reeds are used for basketry, as well as, wicker and rattan furniture repair. You may send sample of size if in doubt. We will match diameter as close as possible. A hank weighs about 1 lb. Strands within the hank vary in length. Also, hanks available in flat and flat oval reeds for hand caning. Size No. Approx. Diameter Hanks each Approx. ft./hank 2 5/64 $ /32 $ /64 $ /64 $ /64 $ /64 $ /32 $ /4 $ /64 $ /8 $ Less than 1 hank #2-3 /0.35 #4-5/0.40 #6-7/0.45 #8-11/0.50 per ft

3 MACHINE CANE Pre-woven cane comes in a roll. It is used in those chair frames which have a groove routed in the seat frame rather than holes drilled. The cane is held into the groove by reed spline and white glue. Choose the size machine cane (mesh) by measuring the hole size and comparing the size to those listed in our booklet. If unsure send us a cutting of the old cane with your order. To determine the measurements of the sheet you need to measure the seat frame (from groove to groove) side to side and front to back adding 2 to each dimension in order to allow for insertion. 7/16 Finefine 1/2 Fine 5/8 Medium Closed Weave Prices are the same for: FINE available in ALL SIZES FINEFINE 24 widths only MEDIUM 18 & 24 widths CLOSED 18 & 24 widths Widths are exclusive of marginal ends. Shipping weight of cut lengths averages one pound for each five lineal feet. WIDTHS LENGTH/FOOT WEIGHT 10ft ROLL 18 wide $12.95 per foot 2.00 lbs 20 wide $14.95 per foot 2.25 lbs 24 wide $16.95 per foot 2.50 lbs Rattan Wedge for inserting spline $2.49 each

4 WIDE BINDER CANE 6mm or 1/4 width. This cane is used for herringbone patterns on seat frames. Can be used in place of flat and flat oval reeds to create a strong finely woven pattern on your seat frame. Binder cane is also used as wrapping and repair material for wicker and rattan furniture. One hank will do approximately an 18x18 seat, weighing about 1 1/4 lbs and 500 long. Binder Cane comes in hanks of 500 feet. Binder by the strand is approximately 9 to 11 feet in length. Binder Hanks Each Approx. weight/hank Approx.9 to 11 foot strand $2.49 per strand Length Varies Wide Binder $39.95 per hank 22 oz. TAPERED CANING PEGS $5.69 per dozen. These hardwood pegs are used in the hand caning process to keep the hand cane snug in its hole and in place until it is tied underneath the seat. REED SPLINE Spline is the wedge shaped material used to hold machine cane in the groove. Specify size by measuring across the stop of your sample. If not sure, send a sample or indicate the width of the groove. Spline should always be narrower than the groove to allow for the cane insertion. Under 12 feet $7.95 per piece 13 and more $0.49 per foot. strands of spline average about 2 oz. each. #7 size Approx. 1/8 Wide #8 Size Approx. 5/32 Wide #9 Size Approx. 3/16 Wide #10 Size Approx. 7/32 Wide #11 Size Approx. 9/32 Wide

5 HAND STRING CANE Hand (string) cane is used in those chairs with holes drilled through the perimeter of a seat frame. It is a weaving process done by hand. The process requires taking cane and weaving it through the holes in the frame while following a specific pattern. The last step in the process uses Regular Binder cane to cover the holes for appearance. Wide Binder Cane is used for producing a herringbone pattern on chair frames with four rails and for repairs on wicker and rattan furniture. SIZE HOLE DIAMETER CENTER TO CENTER FINEFINE 3/16 7/16 TO 1/2 FINE 3/16 TO 1/4 1/2 TO 5/8 MEDIUM 1/4 5/8 TO 3/4 NARROW MED 3/16 5/8 TO 3/4 COMMON 5/16 3/4 TO 7/8 When ordering string cane be sure to specify size of cane wanted (i.e. FINE cane). If size is in doubt enclose sample taken from old seat or measure both the distance between the holes (center to center), as well as, the diameter of the hole. Cane Size 1-9 Hanks Approx. Weight per Hank Finefine $ oz Fine $ oz Medium $ oz Narrow Med $ oz Common $ oz FI- NE and MEDIUM are the most commonly used sizes of Hand Cane.

6 ORDER FORM Company Name: Contact Name: Address 1: Address 2: City: State: Telephone: Fax: Zip: No. Item width length price total total NJ sales tax shipping Use separate sheet if more space is needed Sub total PAYMENT BY CHECK OR MONEY ORDER ONLY Contact us for shipping information , telephone or mail to HERITAGE HOUSE INTERIORS