Huawei NE5000E 400Gbps Flexible Line Processing Unit

Transcription

1 Huawei NE5000E 400Gbps Flexible Line Processing Unit Huawei NE5000E 400Gbps Flexible Line Processing Unit Overview The Huawei NetEngine5000E router (NE5000E) is a high-end IP core network router. It is targeted for Internet backbone networks, IP dedicated backbone networks, or IP metropolitan core networks covering large cities and regions. It can also function as an egress router on the Internet data center (IDC). It is intended for network operators, enterprises, and public institutions. As the network traffic volume increases, boards of core nodes cannot meet customer demands for higher throughput of network elements. Therefore, Huawei has developed 400G Flexible Card Line Processing Unit (LPUF-400, 2 sub-slots) and 10 GE, 40 GE, and 100 GE flexible cards (CP400) for the LPUF-400. The large capacity meets the bandwidth requirements of operators and intranets, and helps customers conduct cost-effective and personalized capacity expansion. The LPUF-400 is designed to improve the slot capacity, and provides 400 Gbps line-rate forwarding capacity, and provides two full-height half-width sub-slots. Each sub-slot of LPUF-400 holds one CP400 flexible card. Figure 1-1 shows the appearance of the LPUF-400. Figure G Flexible Card Line Processing Unit (LPUF-400, 2 sub-slots) The LPUF-400 supports 4 types of flexible card. Each CP400 flexible card takes one sub-slot of the LPUF-400. It includes the following CP Port 100GBase LAN-CFP flexible card (CP GE-CFP, 1 sub-slots). Figure 1-2 showed the appearance of CP GE-CFP. 2-Port 100GBase LAN-CXP flexible card (CP GE-CXP, 1 sub-slots). Figure 1-3 showed the appearance of CP GE-CXP. 6-Port 40GBase LAN-QSFP+ flexible card (CP GE-QSFP+ 1 sub-slots). Figure 1-4 showed the appearance of CP GE-QSFP+. 20-Port 10Gbase LAN/WAN-SFP+ flexible card (CP GE-SFP+, 1 sub-slots). Figure 1-5 showed the appearance of CP GE-SFP+.

2 Specifications Figure Port 100GBase LAN-CFP flexible card (CP GE-CFP, 1 sub-slots) Figure Port 100GBase LAN-CXP flexible card (CP GE-CXP, 1 sub-slots) Figure Port 40GBase LAN-QSFP+ flexible card (CP GE-QSFP+ 1 sub-slots) Figure Port 10Gbase LAN/WAN-SFP+ flexible card (CP GE-SFP+, 1 sub-slot) Specifications Table 1-1 lists the specifications of the LPUF-400. Table 1-1 LPUF-400 Specifications Name Software Version Slot Dimensions (W D H) LPUF-400 NE5000E LPUF-400 Flexible Card Line Processing Unit V800R005 Two full-height half-width sub-slots 400 mm 520 mm 40 mm (15.75 in in in.)

3 Specifications Power consumption Heat dissipation Weight Storage temperature Operating temperature Relative humidity LPUF W 1382 BTU/hour 9.5 kg (20.95 lb) -40 C to +70 C (-40 F to 158 F) Long-term: 0 C to 40 C (32 F to 104 F); Short-term: -5 C to 50 C (23 F to 122 F) Long-term: 5% to 85%; Short-term: 0% to 95% (working environment) MIBs ENTITY-MIB.mib (RFC 2737) HUAWEI ENTITY MIB (HUAWEI-ENTITY-EXTENT-MIB.mib) HUAWEI DEVICE MIB (HUAWEI-DEVICE-MIB /HUAWEI-DEVICE-EXT-MIB) HUAWEI-BASE-TRAP-MIB.mib HUAWEI-PORT-MIB.mib Table 1-2 lists the specifications of the CP400. Table 1-2 CP400 Specifications CP400 (Sub-card of LPUF-400, 1 sub-slot) 1 100GE-CFP 2 100GE-CXP 6 40GE-QSFP GE-SFP+ Power consumption 35 W 42.5 W 58.8 W 49 W Heat dissipation BTU/hour BTU/hour BTU/hour BTU/hour Weight 1.3 kg (2.86 lb) 0.95 kg (2.09 lb) 0.95 kg (2.09 lb) 0.85 kg (1.87 lb) Software Version Dimensions (W D H) Storage temperature Operating temperature Relative humidity V800R mm mm 37.2 mm (7.02 in in in.) (W D H) -40 C to +70 C (-40 F to 158 F) Long-term: 0 C to 40 C (32 F to 104 F); Short-term: -5 C to 50 C (23 F to 122 F) Long-term: 5% to 85%; Short-term: 0% to 95% (Working environment) MIBs ENTITY-MIB.mib (RFC 2737) HUAWEI ENTITY MIB (HUAWEI-ENTITY-EXTENT-MIB.mib) HUAWEI DEVICE MIB (HUAWEI-DEVICE-MIB /HUAWEI-DEVICE-EXT-MIB) HUAWEI-BASE-TRAP-MIB.mib HUAWEI-PORT-MIB.mib

4 Standards Compliance Standards Compliance Table 1-3 lists the standards that the LPUF-400 and sub-cards comply. Table 1-3 Standards compliance Standard Safety IEC EN UL CAN/CSA C22.2 No AS/NZS BS EN EMC/EMI ETSI EN VCCI V-3/ Class A IECS-003 Class A AS/NZS CISPR 22 Class A CNS Class A IEC/EN IEC/EN EN ITU-T K20 GR-1089 (NEBS) FCC Part 15 Class A EN CISPR 22 CISPR 24 GB 9254 Immunity IEC/EN : Electrostatic Discharge Immunity (8-kV Contact, 15-kV Air) IEC/EN : Radiated Immunity (10 V/m) IEC/EN : Electrical Fast Transient Immunity (2-kV Power, 1-kV Signal) IEC/EN : Surge AC Port (4-kV CM, 2-kV DM) IEC/EN : Signal Ports (1 kv) IEC/EN : Surge DC Port (1 kv) IEC/EN : Immunity to Conducted Disturbances (3 Vrms) IEC/EN : Power Frequency Magnetic Field Immunity (30 A/m) IEC/EN : Voltage DIPS, Short Interruptions, and Voltage Variations

5 Ordering Information Standard Environment ETS ETS IEC IEC GB 2423 GB 4798 GB/T ISTA GR-63 (NEBS) Environmental protection RoHS Ordering Information The initial version of LPUF-400 and its sub-cards is V800R005. Table 1-4 lists the ordering information for the LPUF-400. Table 1-4 Ordering information for the LPUF-400 and sub-cards Product Model CR5DLPUFK061 CR5D00E1NC61 CR5D00E2NC61 CR5D00E6MF61 CR5D00LEXF61 Description Flexible Card Line Processing Unit (NE5000E LPUF-400, 2 sub-slots) 1-Port 100Gbase-CFP flexible card (CP GE-CFP, 1 sub-slot) 2-Port 100Gbase LAN-CXP flexible card (CP GE-CXP, 1 sub-slot) 6-Port 40Gbase LAN-QSFP+ flexible card (CP GE-QSFP+, 1 sub-slot) 20-Port 10Gbase LAN/WAN-SFP+ flexible card (CP GE-SFP+, 1 sub-slot) Table 1-5 lists the optical modules supported by the LPUF-400. Table 1-5 Optical modules supported by the LPUF-400 and sub-cards Module Transmission Distance Working Mode Wavelength (nm) CFP 10 (km) Single-mode 1310 (nm) CXP 0.1 (km) Multi-mode 850 (nm) QSFP+ 10 (km) Single-mode 1310 (nm) 80 (km) Single-mode 1550 (nm) SFP+ 40 (km) Single-mode 1550 (nm) 10 (km) Single-mode 1300 (nm) 0.3 (km) Multi-mode 850 (nm)

6 Service and Support Service and Support For more information, please visit Copyright Huawei Technologies Co., Ltd All rights reserved. No part of this document may be reproduced or transmitted in any form or by any means without prior written consent of Huawei Technologies Co., Ltd. Trademarks and Permissions and other Huawei trademarks are trademarks of Huawei Technologies Co., Ltd. All other trademarks and trade names mentioned in this document are the property of their respective holders. Notice The purchased products, services and features are stipulated by the contract made between Huawei and the customer. All or part of the products, services and features described in this document may not be within the purchase scope or the usage scope. Unless otherwise specified in the contract, all statements, information, and recommendations in this document are provided "AS IS" without warranties, guarantees or representations of any kind, either express or implied. The information in this document is subject to change without notice. Every effort has been made in the preparation of this document to ensure accuracy of the contents, but all statements, information, and recommendations in this document do not constitute a warranty of any kind, express or implied. Huawei Technologies Co., Ltd. Address: Website: Huawei Industrial Base Bantian, Longgang Shenzhen People's Republic of China support@huawei.com