Smart-1 Quick Start Guide

Transcription

1 Smart-1 Quick Start Guide Version R71 Includes Check Point Software Blades

2 1 Power Up Your Check Point Smart-1 Appliance Connect the power cable to the power port on the Smart-1 appliance rear panel and plug it into a power outlet. Turn the power on. 2 Connect Your PC for Initial Setup Initial setup must be done from a PC connected to the appliance s internal interface via the included Ethernet cable. After completing the initial connection, the First Time Configuration Wizard will guide you through the process of configuring the appliance. Before continuing, make sure your PC is configured correctly.

3 3 For Windows XP Operating Systems Click > Settings > Control Panel > Network Connections. Double-click Local Area Connection. In the General tab, click Properties. In the IP address field, enter In the Subnet mask field, enter Leave the Default gateway and DNS settings fields empty. Click OK and close the dialog boxes. For Windows 7 and Windows Vista Operating System Figure 1: Internet Protocol (TCP/IP) Properties Click > Control Panel > Network and Internet > Network and Sharing Center > Manage network connections. Right-click Local Area Connection, and then click Properties. If you are prompted for an administrator password or confirmation, type the password or provide confirmation. Click the Networking tab. Under This connection uses the following items, click Internet Protocol Version 4 (TCP/IPv4), Figure 2: Internet Protocol (TCP/IP) Properties and then click Properties. In the IP address field, enter In the Subnet mask field, enter Leave the Default gateway and DNS settings fields empty. Click OK and close the dialog boxes.

4 4 Configure Your Smart-1 Appliance Launch the Web browser and type in the address bar. Note When using the Internet Explorer 8.0 browser, you might receive a certificate error page due to a known, unresolved browser conflict. Click Continue to this Web site. Log in with the default system administrator login name/password, admin/admin, and click Login. Figure 2: Smart-1 Appliance Login page Note Popups must always be allowed on After logging in for the first time and changing the default login name and password, the First Time Configuration Wizard will begin automatically. The wizard will guide you through the connection setup process. Fill in the parameters as required and click Finish. Figure 3: First Time Configuration Wizard Welcome page Figure 4: First Time Configuration Wizard Summary page For additional information regarding setting up your appliance, refer to the Smart-1 Getting Started Guide.

5 5Registration and Technical Support Appliance Registration Smart-1 appliances require a license to be installed prior to operation. To license and register your appliance, please visit: If you are evaluating a Smart-1 appliance, you will have access to a 15-day evaluation license key. Note The MAC address is required to obtain a license, and it can be found on the Information > Appliance Status page of the Web management interface. Appliance User Center For further information about the Smart-1 appliance, see: For technical assistance, contact Check Point 24 hours a day, seven days a week at: (Americas) (International)

6 Smart-1 Quick Start Guide Version R71 w w w. c h e c k p o i n t. c o m 2010 Check Point Software Technologies Ltd. All rights reserved. Check Point, the Check Point logo and Smart-1 are trademarks or registered trademarks of Check Point Software Technologies Ltd. or its affiliates. All other product names mentioned herein are trademarks or registered trademarks of their respective owners. The products described in this document are protected by U.S. Patent No. 5,606,668, 5,835,726, 6,496,935, 6,873,988, and 6,850,943 and may be protected by other U.S. Patents, foreign patents, or pending applications. P/N: