INSTRUCTION MANUAL Thermoelectric wine cellar

Transcription

1 Thermoelectric wine cellar Model: DX-12.35DG This manual contains important information including safety and installation instructions about the appliances. Please read it carefully before use and follow all the safety information & instructions. It is recommended that you keep this manual for reference so that you are familiar with the operation of the appliance.

2 --CONTENTS-- GENERAL SAFETY PRECAUTIONS...2 Caution... 2 TECHNICAL DATA...3 ILLUSTRATED STRUCTURE...4 DISPLAY FUNCTIONS...4 ELECTRIC PRINCIPLE DIAGRAM...5 OPERATION OF REFRIGERATOR...5 PARTICULAR PRECAUTIONS...6 MAINTENANCE...6 TROUBLESHOOTING...7 1

3 GENERAL SAFETY PRECAUTIONS - After removing the wine cooler from the package, make sure it is in good condition. In case of doubt, do not use it and contact your own dealer or an authorized service center. - Plastic bags, nails, etc. Should be kept out of the reach. Read the operation manual carefully and check that the rating data on the rating nameplate corresponds to your power supply. - This wine cooler can only be used for wine storage. The manufacturer cannot be held responsible for any damage due to improper use or repairs made by unqualified personnel. - Before cleaning the cooler, make sure it is unplugged. Never clean the unit with an acid preparation, medical, dilution, gasoline, oil or any other kind of chemical substance that could damage the wine cooler. - Repair should only be made by authorized service agents: Caution - To reduce the risk of fire, when the fuse of the power board is broken, replace only with same type of fuse from authorised service agents. - Free standing installation only. Do not place the appliance on under-floor heating - Do not use extension cords. - Danger: Risk to child safety. Before throwing away your old refrigerator, you must note: - a) Take off the door, - b) Leave the shelves in place, so that children may not easily climb inside. 2

4 TECHNICAL DATA Type DX-12.35DG Volume (liter) 35L Material Case Iron Door Glass Unit Dimension (W H D)(mm) 260*650*495 Packaging Dimension (W H D)(mm) 300*660*535 Net Weight (Kg) 12.4 Gross Weight (Kg) 13.4 Power Consumption (KW h/24h) 0.6 Interal temperature setting Rated Voltage Rated Frequency Input power VAC 50HZ 70W 3

5 ILLUSTRATED STRUCTURE 1. Light 2. Fan Grill 3. Shelf 4. Feet 5. Hinge cover 6. Magnetic Seal 7. Door DISPLAY FUNCTIONS 8. Light button 9.C/F button 10. LCD display 11. Set temp up button 12. Set temp down button 4

6 ELECTRIC PRINCIPLE DIAGRAM Ⅴ OPERATION OF REFRIGERATOR - The internal temperature of the thermoelectric refrigerator depends on the room temperature. The refrigerator can be adjusted within the range of (± 1 C), when it is located in an ideal room temperature of When first switching on, without putting any bottles inside the refrigerator, the product can be cooled to 15 after 1.5 hours and after 2~2.5 hours more it will reach the temperature programmed by the manufacturer. - When turning the refrigerator on, the cooling system activates automatically. - When the power is connected, the cooling system starts to work. - The temp you want can be set by touching and with your finger. When the inside temperature is higher than the set point, the cooling system starts working normally. When the inside temperature is lower than the set point, the cooling system stops working, then it starts automatically again when temperature rises above the set point. At this point, the refrigerator automatic conditions allowing a constant control of temperature and energy saving cycle, in fact during this phase, the cooling system stops while cold distribution (by fans) acts more slowly and promotes a larger energy saving. - The Light can be turned OFF or ON by touching the sensor button.if you forget to turn OFF the light, it will turn off after 10 Min. NOTE: - Shortly after you set the temperature, the LCD display will show the temperature levels that you have set in the cooler. Once you have done this, the LCD display will show the actual temperature inside the refrigerator, a value that will be change until it reaches the set temperature. 5

7 PARTICULAR PRECAUTIONS - In order to function at its best, this wine cooler needs to be placed on a level surface, with 2cm space at each side and 10cm at the back, maintaining a good airflow. - Use the adjustable feet to level the unit. - Avoid direct sunlight and high temperatures, do not place the unit on the top of a refrigerator. - Shelves are designed for 750ml bordeaux type bottles. If you store burgundy bottles, please remove the lower shelves to store bottles. - Avoid, as much as possible, putting bottles or any object in front of the fans, this will block the cold air flow and as a result, temperatures will not be consistant. - Do not place heavy articles on the top of the cellar. MAINTENANCE - Shut off power supply before cleaning the cabinet - Take out wine and shelves, and then clean the cabinet with soda water first and then with clean water. - Do not use soap or detergent on the cabinet - Clean the cabinet regularly. 6

8 TROUBLESHOOTING Symptoms Possible cause Solutions - Plug not in - Put in the plug - Low voltage - Ensure normal voltage - Fuse broken - Change fuse No cooling Not cold enough inside Peculiar smell inside refrigerator Internal flashing light - The refrigerator is placed too near heat source; - Bad ventilation; - Fans don t work; - The door is not closed tightly or opened too frequently or for too long a time. - Check whether there are any sour sources inside - Set temperature higher than inner temperature; - The automatic defrost function is working - Keep the refrigerator away from sunshine or other heat source; - Place the refrigerator in an area with good ventilation and keep items away from the fans; - Check whether the plug is connected or change the fan; - Close the door tightly and don t open the door too frequently or for too long a time. - Wrap/clean the source or take it out - Adjust the adjustor - Normal function. No repair needed Frost on the cold sink - Too much humidity or too low temperature inside the unit - Remove the plug, stop the power, and defrost by hand, Connect power again when the ice thaws 7