Candy Floss Maker User Manual

Transcription

1 Candy Floss Maker User Manual Model No.: SBL-2804 Rev 2 READ AND SAVE THESE INSTRUCTIONS Note: The specifications and/or components of this appliance are subject to change without prior notice.

2 1 Before First Use Important Safeguards Components Instruction For Use Set Up Operation Cleaning Troubleshooting Farmers 2 Year Chefmate Replacement Warranty Page 2 of 11

3 1 Before First Use Read and follow all the instructions in this Instruction Manual even if you feel you are familiar with the product, and find a place to keep it handy for future reference. Your attention is drawn to the section IMPORTANT SAFEGUARDS. This Is Not A Toy. For your convenience, record the complete model number (located on the product identification plate) and the date you purchased the product, together with your purchase receipt and attach to the warranty and service information. Retain in the event that warranty service is required. 2 Important Safeguards When using any electrically powered product, basic safety precautions should always be followed, including the following: WARNING - to reduce the risk of fire, electrical shock or injury to persons or property: Always operate the product from a power source of the same voltage, frequency and rating as indicated on the product identification plate. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Operate on a level surface. Operating the appliance on sinks, drain boards or uneven surfaces should be avoided. Avoid touching hot surfaces, use handles and knobs. When using the product, ensure that there is sufficient air space above and around all sides for air circulation. Do not reach for an appliance that has fallen into water. Switch OFF at the power point and unplug immediately. Under no circumstances must the electrical parts, including the plug and cord of the appliance be placed in water or other liquids. Allow to cool completely before cleaning and storing away. Page 3 of 11

4 Do not disassemble the appliance. There are no user serviceable parts inside. Keep appliance out of reach of children. Take care that children cannot touch the appliance when it is hot and make sure they cannot pull the mains cord. Burns can occur from touching hot metal parts, hot liquids or steam. Caution is required on surfaces where heat may cause a problem an insulated heat pad is recommended, VERY IMPORTANT: Ensure that appliance does not get wet (water splashes etc.). Do not use appliance with wet hands. Do not use near sinks, baths or showers. Position the power supply lead properly so that it will not be walked on or pinched by items placed on or against them. Use this appliance only for its intended use. This Appliance is intended for household use only and not for commercial or industrial use. Do not use this appliance if it has been dropped or any part of appliance (including cord or plug) has been damaged. Take this appliance to your nearest authorised service centre or qualified dealer for inspection or repair. Use only accessories recommended or supplied by an authorised service centre or qualified dealer. The use of accessories not intended for use with this appliance may cause injuries to the user or damage to the appliance. Do not place this unit on other appliances, on uneven surfaces or where it could be subject to heat sources (e.g. radiators or stoves), direct sunlight, excessive dust This Appliance should not be used outdoors, placed near a hot gas or electrical burner or placed in a heated oven. Do not operate this appliance underneath or near flammable or combustible materials (e.g. curtains). The appliance should always be switched off before connecting or disconnecting from the power supply. Never pull the cord to disconnect the plug from the wall socket. Page 4 of 11

5 Any type of servicing, apart from ordinary cleaning, must be carried out by an authorised service centre or qualified dealer. There are no user serviceable parts in this appliance. WARNING: do not heat or cook any other items in this appliance. If this appliance is to be used by a third party, please supply this instruction manual with it. Always disconnect the plug from wall socket before moving, cleaning or emptying of food. To avoid an overloaded circuit, do not operate another high current appliance on the same electric circuit. Never move the appliance when in use. Do not leave the appliance unattended when in use. This appliance is not intended to be operated by means of an external timer or separate remote-control system. Ensure children and babies do not play with plastic bags or any of the packaging material. No liability can be accepted for any damage caused by non-compliance with these instructions or any other improper use or mishandling of appliance. READ AND SAVE THESE INSTRUCTIONS Page 5 of 11

6 3 Components Motor Spindle 7 Measuring Spoon 2 Elements 8 Wooden Sticks 3 On / Off Switch 9 Spinner Head 4 Bowl 10 Locking Tab 5 Bowl Cover 11 Element Post 6 Locating Ring Page 6 of 11

7 4 Instruction For Use Carefully unpack the appliance and remove all packaging materials. Clean each part with warm water, dishwashing liquid and a sponge then dry them carefully. Do Not immerse the electrical components in water or liquid. Ensure there are no foreign objects on or in the element compartment. Place the Base on a stable and flat surface. 4.1 Set Up After cleaning and thoroughly drying the Bowl, Bowl Cover, Locating Ring and Spinner Head, slide the Bowl all the way down over the Element Post. Align the lugs (on the inside of the Bowl) under the metal locking tabs on the side of the element post by rotating the bowl until the lugs are located under the locking tabs. Make sure it is secured and locked into position. To remove, rotate the bowl until the lugs are free from under the locking tabs and pull straight up and off. Locate Lugs under locking Tabs Place the Bowl Cover and Locating Ring on top of the bowl and ensure it is located properly. Fit the Spinner Head to the Motor Spindle ensuring the Slots in the shaft of the Spinner Head line up with the Pins in the Motor Shaft. Pins Slots Page 7 of 11

8 4.2 Operation Ensuring the On / Off Switch is in the OFF position, plug into the power point and switch on. Switch On the unit - the Spinner Head will start to spin and the elements will start to heat up. Allow to preheat for at least 5 minutes at which time you can prepare the sugar and sticks. After preheating, turn the switch to the OFF position. The Spinner Head will stop spinning and the elements will turn off, however, take care as the Spinner Head and surrounding components will be very hot. Measure a level of sugar with the measuring spoon. Using the measuring spoon supplied, pour a level spoon of sugar into the centre receptacle in the top of the Spinner Head as shown. Switch the unit ON again and the Spinner head will start to spin and the elements will start to heat up. When you can see the Candy Floss web begin to fly out across the bowl, start to collect it on the wooden stick by holding the stick horizontally. Twirl the stick with your fingers while you circle the bowl. Continue to collect the Candy Floss making sure you are collecting it all. When all the sugar has been dispensed, turn the unit off. Page 8 of 11

9 Once the Spinner Head has come to a complete stop you can pour another measure of sugar in the Spinner Head and begin again. CAUTION: While the Candy Floss Maker is in operation or just finished operating, DO NOT TOUCH THE ROTATING SPINNER HEAD AS IT SPINS VERY FAST AND WILL BE VERY HOT! The Candy Floss web should been flowing more quickly as the unit should be sufficiently warmed up. NOTES: For optimum results, be sure to turn the unit ON and allow it to preheat for at least 5 minutes before starting. This allows the unit to properly warm up before beginning to actually spin the Candy Floss. Only add sugar to the Spinner Head when it has completely stopped. Never use ingredients other than pure granulated sugar or Candy Floss Sugar (Fairy Floss Sugar) as this will cause clogging. DO NOT overfill the sugar receptacle in the Spinner Head. DO NOT cover the appliance when operating or hot. 5 Cleaning Turn off and unplug and let cool prior to cleaning. After cooling, remove the Spinner Head by pulling it straight up. To remove the Bowl, rotate the bowl until the lugs are free from under the locking tabs in the element post and pull straight up and off. Wash parts in warm water, rinse and dry. Use a slightly damp sponge, clean the outside of the base unit and wipe with a towel to dry. Do not use abrasive creams, solvents, steel wool or scouring pads as they will damage the product. Do Not immerse the electrical components in water or liquid. Do Not place components in the dishwasher. Page 9 of 11

10 NOTE: Candy Floss is made by heating sugar. This turns the sugar granules into a liquid form. The liquid sugar is forced out of tiny holes in the Spinner Head by centrifugal force as the Spinner Head spins. As the liquid sugar hits the air, it returns to a solid but fluffy material that you would recognise as Candy Floss. Please ensure the Spinner Head is cleaned properly after every use. If not, the holes will get clogged and the liquid sugar will not be able to flow through the tiny holes property and the unit will not work correctly. DO NOT IMMERSE ELECTRICAL COMPONENTS IN WATER OR LIQUID. 6 Troubleshooting Problem Possible Reason Remedy Excessive Vibration / Noisy Operation Candy Floss web not flowing when spinning. Too Much Sugar Added Spinner Head not fitted correctly No Sugar in Spinner Head Spinner Head not hot enough The Spinner Head is clogged Wrong Type of Sugar used Use Less Sugar Ensure slots in Spinner Head shaft are slotted over the pins in the Motor Drive Spindle. Turn off unit, allow head to stop spinning then add sugar Always preheat the spinner head as described under the heading Operation. Do Not leave the unit sitting for too long after preheating before adding the sugar and restarting the unit. Always clean the Spinner Head thoroughly after use. Soak in hot water to dissolve the sugar clogging the holes in the Spinner Head. If still blocked, attach the Spinner Head and spin (without sugar added) and with the element on for approximately 10 minutes to melt and discard the sugar clog Use only granulated sugar or special Candy Floss Sugar. Page 10 of 11

11 7 Farmers 2 Year Chefmate Replacement Warranty Your Chefmate product is covered by a replacement warranty for a period of two years from the date of purchase from The Farmers Trading Company Ltd. During the warranty period, Farmers warrants to the original purchaser of this Chefmate product that the product will be free from defects in materials or workmanship. If your Chefmate product fails to operate satisfactorily, please return it to a Farmers store. You must supply proof of purchase from Farmers with all warranty claims. The replacement warranty does not cover: Normal wear and tear Minor or cosmetic defects that do not affect the functioning of the product Damage Unreasonable use or use to an unreasonable extent This warranty becomes invalid if we reasonably believe that the product has been damaged, subjected to unreasonable use, misused, abused, incorrectly installed, tampered with, connected to an electrical supply not corresponding with the name plate specification, or subjected to power surges. This warranty does not limit or affect any rights a domestic purchaser may have under the Consumer Guarantees Act If you use this product for the purposes of a business, then to the greatest extent permitted by law, our maximum obligation to you will be limited to the replacement of the product within the warranty period. If this product is no longer available, your Chefmate product will be replaced by an equivalent product with similar specifications. DANGER: For your safety, you must not tamper with this Chefmate product. Do not open the product. Do not attempt to service the product. This product contains no user serviceable components. Important: Please retain this warranty card and your proof of purchase from Farmers Name: Address: Date of purchase: Name of product: Model No.: For customer service and product information in New Zealand please contact Farmers Support Centre 21 Laidlaw Way Flat Bush Auckland contactus@farmers.co.nz Read and Save These Instructions Page 11 of 11