A Test Lab Techno Corp.

Transcription

1 EMF ASSESSMENT REPORT Product Name : 3G Wireless Router Applicant : Shenzhen StrongRising Electronics Co.,Ltd Address : Room ,6th floor,innovation and Technology Park 13 buliding,shangsha,futian District, Shenzhen,China Trade Mark : N/A Model Number : AW930,AW920,AW926 Test Specification : EN62311:2008 EN50385:2002 Issue Date : 28, September 2013 Issue by A Test Lab Techno Corp. No , Changan Street, Bade City, Taoyuan County 334, Taiwan R.O.C. Tel: / Fax: Taiwan Accreditation Foundation accreditation number: 1330 Note: This report shall not be reproduced except in full, without the written approval of A Test Lab Techno Corp. This document may be altered or revised by A Test Lab Techno Corp. personnel only, and shall be noted in the revision section of the document. The client should not use it to claim product endorsement by TAF, or any government agencies. The test results in the report only apply to the tested sample. Page 1 of 11

2 Revision History Rev. Issue Date Revisions Revised By 00 28, September 2013 Initial Issue Page 2 of 11

3 Verification of Compliance Issued Date: 2013/09/28 Product Name Applicant : 3G Wireless Router : Shenzhen StrongRising Electronics Co.,Ltd Address : Room ,6th floor,innovation and Technology Park 13 buliding,shangsha,futian District, Shenzhen, China Trade Name Model Number EUT Rated Voltage Applicable Standard Test Result Performing Lab. : N/A : AW930,AW920,AW926 : Battery 3.7 V : EN62311:2008 EN50385:2002 : Complied : A Test Lab Techno Corp. No , Changan Street, Bade City, Taoyuan County 334, Taiwan R.O.C. Tel: / Fax: Taiwan Accreditation Foundation accreditation number: The above equipment has been tested by A Test Lab Techno Corp., and found compliance with the requirements set forth in the R&TTE Directive 1999/5/EC and technical standards mentioned above. The results of testing in this report apply only to the product/system, which was tested. Other similar equipment will not necessarily produce the same results due to production tolerance and measurement uncertainties. Approved By : Reviewed By : (Manager) (Yung Tan Tsai) (Testing Engineer) (Eric.lee) Page 3 of 11

4 TABLE OF CONTENTS 1 General Information EUT Description Test Site Environment Method of measurement Applicable Standard Technical Requirements Specification in EN Technical Requirements Specification in EN Test Result Conclusion Page 4 of 11

5 1 General Information 1.1. EUT Description Applicant Applicant Address Manufacturer Manufacturer Address Product Type Trade Name Shenzhen StrongRising Electronics Co.,Ltd Room ,6th floor,innovation and Technology Park 13 buliding,shangsha,futian District, Shenzhen,China Dongguan Branch of Shenzhen StrongRising Electronics Co.,Ltd Qingping Road No.2 Qinghutou Village Tangxia Town,Dongguan city,guangdong Province,China 3G Wireless Router N/A Model Number AW930,AW920,AW926 The only difference between AW930,AW920 and AW926 is the model name due to Model Difference market requirement. IMEI Number IMEI: GSM 900 (E-GSM): 880 MHz 915 MHz (TX); 925 MHz 960 MHz (RX); DCS1800: 1710 MHz 1785 MHz (TX); 1805 MHz 1880 MHz (RX); Operating Frequency WCDMA BAND I:1920~1980 MHz (TX), 2110 ~ 2170 MHz (RX); WCDMA BAND Ⅷ:880 MHz 915 MHz (TX); 925 MHz 960 MHz (RX); Wi-Fi: 2412~2472 MHz (TX/RX); GSM Internal antenna Type of Antenna WCDMA wifi Internal antenna Internal antenna 1.2. Test Site Environment Items Required (IEC 68-1) Actual Temperature ( C) Humidity (%RH) Barometric pressure (mbar) Page 5 of 11

6 2 Method of measurement 2.1. Applicable Standard EN62479:Assessment of electronic and electrical equipment related to human exposure restrictions for electromagnetic fields (0 Hz 300 GHz) EN50385: Product Standard to Demonstrate the Compliances of Radio Base Stations and Fixed Terminal Stations for Wireless Telecommunication Systems with the Basic Restrictions or the Reference Levels Related to Human Exposure to Radio Frequency Electromagnetic Fields (110 MHz - 40 GHz) - General Public The electronic and electrotechnical apparatus shall comply with the basic restriction as specified in Annex II of Council Recommendation 1999/519/EC Technical Requirements Specification in EN General Description of Applied Standards EN Generic standard to demonstrate the compliance of electronic and electrical apparatus with the basic restrictions related to human exposure to electromagnetic fields (0 Hz 300 GHz) is to demonstrate the compliance of apparatus with the basic restrictions or reference levels on exposure of the general public related to electric, magnetic, electromagnetic fields as well as induced and contact current. Limit: According to EN 62311, the criteria listed in the below table shall be used to evaluate the environmental impact of human exposure to radio-frequency (RF) radiation as specified table 2 of Council Recommendation 1999/519/EC. Page 6 of 11

7 Frequency Range Reference levels for electric, magnetic and electromagnetic fields (0 Hz to 300 GHz, unperturbed rms values) E-field (V/m) H-field (A/m) B-field (µt) Equivalent plane wave Power Density Seq (W/m2) 0-1 Hz x x Hz x 10 4 / f 2 4 x 10 4 / f Hz /f 5000/f khz 250/f 4/f 5/f khz 250/f khz MHz /f 0.92/f MHz 87/f 1/2 0.73/f 0.92/f MHz MHz f 1/ f 1/ f 1/2 f/ GHz Notes: 1. ƒ as indicated in the frequency range column. 2. For frequencies between 100 khz and 10 GHz, Seq, E 2, H 2, and B2 are to be averaged over any six-minute Period. 3. For frequencies exceeding 10 GHz, Seq, E 2, H 2, and B2 are to be averaged over any 68/ƒ minute period (ƒ in GHz). 4. No E-field value is provided for frequencies < 1 Hz, which are effectively static electric fields. For most people the annoying perception of surface electric charges will not occur at field strengths less than 25 kv/m. Spark discharges causing stress or annoyance should be avoided. Assessment methods Page 7 of 11

8 2.3. Technical Requirements Specification in EN This standard is limited to apparatus which is intended for use by the general public as defined in the Council Recommendation 1999/519/EC of 12 July 1999 on the limitation of exposure of the general public to electromagnetic field (0 Hz to 300 GHz)(Official Journal L199 of 30 July 1999). This generic standard applies to electronic and electrical apparatus for which no dedicated product-or product family standard regarding human exposure to electromagnetic fields applies. This generic standard does not cover equipment, which fulfils the requirements given in EN or is medical equipment as defined in the Council Directive 93/42/EEC of 14 June 1993 concerning medical devices. The frequency range covered is 0 Hz to 300 GHz. The object of this standard is to demonstrate the compliance of such apparatus with the basic restrictions or reference levels on exposure of the general public related to electric, magnetic, electromagnetic fields and contact current. Limit According to EN 50385: 2002, the criteria listed in the following table shall be used to evaluate the environmental impact of human exposure to radio-frequency (RF) radiation as specified 1999/519/EC. Frequency Range Reference levels for electric, magnetic and electromagnetic fields (0 Hz to 300 GHz, unperturbed rms values) E-field (V/m) H-field (A/m) B-field (µt) Equivalent plane wave Power Density Seq (W/m2) 0-1 Hz x x Hz x 10 4 / f 2 4 x 10 4 / f Hz /f 5000/f khz 250/f 4/f 5/f khz 250/f khz MHz /f 0.92/f MHz 87/f 1/2 0.73/f 0.92/f MHz MHz f 1/ f 1/ f 1/2 f/ GHz Page 8 of 11

9 Notes: 1. ƒ as indicated in the frequency range column. 2. For frequencies between 100 khz and 10 GHz, Seq, E 2, H 2, and B2 are to be averaged over any six-minute Period. 3. For frequencies exceeding 10 GHz, Seq, E 2, H 2, and B2 are to be averaged over any 68/ƒ minute period (ƒ in GHz). 4. No E-field value is provided for frequencies < 1 Hz, which are effectively static electric fields. For most people the annoying perception of surface electric charges will not occur at field strengths less than 25 kv/m. Spark discharges causing stress or annoyance should be avoided. Assessment methods According to EN 50385: 2002, far field calculation method will be applied to the EUT. The antenna of the product, under normal use condition is at least 300cm away from the body of the user. Warning statement to the user for keeping at least 300cm separation distance and the prohibition of operating to a person has been printed on the user s manual. So, this product under normal use is located on electromagnetic far field between the human bodies. According to EN 50385: 2002, the far field calculation formula is Where: P = Input Power of the antanna (W) G = antenna gain relative to an isotropic antenna(numeric) θ,ф = elevation and azimuth angles to point of investigation r = distance from observation point to the antenna(m) ηo = characteristic impedance of free space D = antenna of length (m) Page 9 of 11

10 3 Test Result For WiFi: Mode Frequency (MHz) Output Power (dbm) Output Power (W) E-Field (V/m) E-Field Limit (V/m) Result b Pass g Pass n-HT Pass Standard applied EN62311: n-HT Pass Note: Antenna Gain (numeric): for WiFi antenna. The distance from observation point to the antenna is over 20 cm. For GSM&WCDMA: Mode Frequency (MHz) Output Power (dbm) Output Power (W) E-Field (W/m2) E-Field Limit (W/m2) Result GSM Pass DCS Pass WCDMA Band I Pass Standard applied EN50385:2002 WCDMA Band Ⅷ Pass Note: Antenna Gain (numeric): 1.000for GSM&WCDMA antenna The distance from observation point to the antenna is over 20 cm. Page 10 of 11

11 4 Conclusion The measurement results comply with the relevant limits for general public exposure specified as reference levels in the Council Recommendation 1999/519/EC....End of Report... Page 11 of 11