v02.54 (C) Copyright , American Megatrends, Inc.

Transcription

1 1

2 Main OC Tweaker Advanced H/W Monitor Boot Security Exit System Overview System Time [ 17:00:09] System Date [Wed 10/24/2012] BIOS Version : 980DE3/U3S3 P1.00 Processor Type : AMD FX(tm)-8150 Eight Core Processor (64bit) Processor Speed : 3600MHz Microcode Update : 600F12/ L1 Cache Size : 384KB L2 Cache Size : 8192KB L3 Cache Size : 8192KB Total Memory : 2048MB Single-Channel Memory Mode DDR3_A1 : 2048MB/667MHz DDR3_1333 DDR3_A2 :None DDR3_B1 :None DDR3_B2 :None Use [Enter], [TAB] or [SHIFT-TAB] to select a field. Use [+] or [-] to configure system Time. +- Change Field Tab Select Field v02.54 (C) Copyright , American Megatrends, Inc. 2

3 Main OC Tweaker Advanced H/W Monitor Boot Security Exit EZ Overclocking Load Optimized CPU OC Setting CPU Configuration Overclock Mode CPU Frequency (MHz) PCIE Frequency (MHz) Spread Spectrum Boot Failure Guard Boot Failure Guard Count CPU Active Core Control AMD Turbo Core Technology AMD C-State Support AMD APM Processor Maximum Frequency North Bridge Maximum Frequency Processor Maximum Voltage Multiplier/Voltage Change [Press Enter] [200] [100] [3] [All Cores] x MHZ x MHz V Overclocking may cause damage to your CPU and motherboard. It should be done at your own risk and expense. Enter Go to Sub Screen v02.54 (C) Copyright , American Megatrends, Inc. 3

4 Main OC Tweaker Advanced H/W Monitor Boot Security Exit EZ Overclocking Load Optimized CPU OC Setting CPU Configuration Overclock Mode CPU Frequency (MHz) PCIE Frequency (MHz) Spread Spectrum Boot Failure Guard Boot Failure Guard Count CPU Active Core Control AMD Turbo Core Technology AMD C-State Support AMD APM Processor Maximum Frequency North Bridge Maximum Frequency Processor Maximum Voltage Multiplier/Voltage Change [Press Enter] [200] [100] [3] [All Cores] x MHZ x MHz V [Manual] Overclocking may cause damage to your CPU and motherboard. It should be done at your own risk and expense. Enter Go to Sub Screen v02.54 (C) Copyright , American Megatrends, Inc. 4

5 OC Tweaker Memory Timing Power Down Enable Bank Interleaving Channel Interleaving CAS Latency (CL) TRCD TRP TRAS Command Rate TRC TWR TRFC TRRD TWTR TRTP TFAW TCWL +- Change Option F1 General Help F9 Load Defaults F10 Save and Exit ESC Exit 5

6 6

7 Main OC Tweaker Advanced H/W Monitor Boot Security Exit Advanced Settings Options for CPU WARNING : Setting wrong values in below sections may cause system to malfunction. CPU Configuration Chipset Configuration ACPI Configuration Storage Configuration PCIPnP Configuration Floppy Configuration SuperIO Configuration USB Configuration BIOS Update Utility Instant Flash Enter Go to Sub Screen v02.54 (C) Copyright , American Megatrends, Inc. 7

8 Advanced CPU Configuration Cool'n'Quiet Secure Virtual Machine Enhanced Halt State(C1E) CPU Thermal Throttle +- Change Option F1 General Help F9 Load Defaults F10 Save and Exit ESC Exit 8

9 Advanced Chipset Settings Onboard HD Audio Front Panel Onboard Lan Primary Graphics Adapter [PCI] + - Change Option 9

10 Advanced ACPI Settings Suspend To RAM Check Ready Bit Away Mode Support Restore on AC / Power Loss Ring-In Power On PCI Devices Power On PS / 2 Keyboard Power On RTC Alarm Power On ACPI HPET Table [Power Off] [By OS] Select auto-detect or disable the STR feature. +- Change Option 10

11 Advanced Storage Configuration Onboard SATA Controller SATA Operation Mode SATA IDE Combined Mode Onboard SATA3 Operation Mode [AHCI] [AHCI] Configure onboard serial ATA controller. IDE1 Master IDE1 Slave SATAII_1 SATAII_2 SATAII_3 SATAII_4 SATAII_5 SATAII_6 [Hard Disk] [Not Detected] [Not Detected] [Not Detected] [Not Detected] [Not Detected] [Not Detected] [Not Detected] +- Change Option F1 General Help F9 Load Defaults F10 Save and Exit ESC Exit 11

12 Advanced Advanced PCI / PnP Settings PCI Latency Timer PCI IDE BusMaster [32] Value in units of PCI clocks for PCI device latency timer register. +- Change Option Advanced Floppy Configuration 1 Floppy A [1.44 MB 3 2 "] Select the type of floppy drive connected to the system. +- Change Option 12

13 Advanced Configure Super IO Chipset OnBoard Floppy Controller Serial Port Address Infrared Port Address [3F8 / IRQ4] Allow BIOS to Enable or Disable Floppy Controller. +- Change Option 13

14 Advanced USB Configuration USB Controller USB 2.0 Support Legacy USB Support USB 3.0 Controller To enable or disable the onboard USB controllers. USB Keyboard/Remote Power On USB Mouse Power On +- Change Option v02.54 (C) Copyright , American Megatrends, Inc. 14

15 Main OC Tweaker Advanced H/W Monitor Boot Security Exit Hardware Health Event Monitoring CPU Temperature M / B Temperature : 37C/98F : 27C/80F Enable/Disable CPU Quiet Fan Function. CPU Fan Speed Chassis Fan Speed Power Fan Speed : 4722 RPM :N/A :N/A Vcore V V V CPU Fan Setting ChassisFan1Setting : 1.216V : 3.248V : 5.136V : V F1 F9 F10 ESC General Help Load Defaults Save and Exit Exit 15

16 Main OC Tweaker Advanced H/W Monitor Boot Security Exit Boot Settings Boot Settings Configuration Configure Settings during System Boot. 1st Boot Device 2nd Boot Device 3rd Boot Device 4th Boot Device Hard Disk Drives Removable Drives CD/DVD Drives [1st Floppy Device] [HDD: PM - HDS722580VL] [CD/DVD: 3S-CD-ROM C] [USB] Enter Go to Sub Screen v02.54 (C) Copyright , American Megatrends, Inc. Boot Boot Settings Configuration Full Screen Logo AddOn ROM Display Boot From Onboard LAN Bootup Num-Lock [On] Disabled: Displays normal POST messages. Enabled: Displays OEM Logo instead of POST messages. + - Change Option 16

17 Main OC Tweaker Advanced H/W Monitor Boot Security Exit Security Settings Supervisor Password : Not Installed User Password : Not Installed Change Supervisor Password Change User Password Install or Change the password. Enter Change v02.54 (C) Copyright , American Megatrends, Inc. 17

18 Main OC Tweaker Advanced H/W Monitor Boot Security Exit Exit Options Save Changes and Exit Discard Changes and Exit Discard Changes Load BIOS Defaults Load Performance Setup Default Load Power Saving Setup Default Exit system setup after saving the changes. F10keycanbeused for this operation. Enter Go to Sub Screen v02.54 (C) Copyright , American Megatrends, Inc. 18