GPS TRACKER SETUP GUIDE

Transcription

1 HOW TO SETUP YOUR TRACKER TO FOLLOW ON CORVUSGPS.COM GPS TRACKER SETUP GUIDE FOR XEXUN, COBAN OR OTHER BRANDS TK102 * TK102-2 * TK103 * TK103-2 * TK102-B * TK103-A/B/C AND MORE FOR MORE INFORMATION PLEASE VISIT

2 We support many different GPS Trackers CorvusGPS.com is compatible with many different Traditional GPS tracker and EverTrack Mobile GPS Tracker app. From Home, Office or On the Go Be anywhere, with CorvusGPS.com's Mapping software you can receive accurate data on the location of your Fleet. DOWNLOAD MAP APP FOR TABLETS AND SMARTPHONES

3 Supported TK examples A few model from the TK series supported by CorvusGPS.com s Online GPS Tracking Software FOR MORE INFORMATION PLEASE VISIT OUR WEBSITE

4 TABLE OF CONTENT 1. What kind of device you have? 1.1 Xexun type GPS trackers 1.2 Coban type GPS trackers 1.3 Devices with 12 digit ID 1.4 Other brands 2. XEXUN type Configure with SMS commands 3. COBAN type Configure with SMS commands 4. The most frequent problems and solutions 4.1 Wrong APN settings 4.2 No GPS signal 4.3 Invalid IMEI 4.4 IMEI vs. 12 digit ID 4.5 No Coordinates at the chosen interval 4.6 If the device does not respond to SMS commands IMPORTANT NOTES! Place the SIM card to a cellphone and please check these few things: SIM card has not run out of credit SIM PIN code request is disabled Caller ID display is turned on After you make sure the steps above are successfully completed, insert the SIM card to your GPS tracker and check the next page.

5 1. What kind of device you have? STEP #1 1.1 Xexun type GPS trackers Trackers with a number at the end of the model are usually (but not always) Xexun type: TK102, TK102-2, TK103, TK103-2 If you have a Xexun type GPS tracker click here to continue: HOW TO CONFIGURE A XEXUN TYPE GPS TRACKER Coban type GPS trackers Trackers with a letter at the end of the model are usually (but not always) Coban type: TK102- B, TK103- B, GPS103- A/B/C If you have a Xexun type GPS tracker click here to continue: HOW TO CONFIGURE A COBAN TYPE GPS TRACKER Devices with 12 digit ID If the IMEI of your device contains (eg.: ) then you have a great chance that your device is from this type. If you have a device with a 12 digit ID TRY TO FOLLOW THE STEPS AT THE CONFIGURATION INSTRUCTIONS BUT USE THE COMMANDS FROM THE MANUAL YOU RECEIVED FROM THE SELLER When you add the tracker to our system you need to select TK102 (12 digit ID) in our wizard. CHECK HOW TO GET THE 12 DIGIT ID FROM THE IMEI NUMBER Other brands There are a lot of manufacturer who produce trackers with the same design as TK102 or TK103 but sometimes the configuration and the communication of the tracker is totally different. Check your manual and try to determinate that the commands are similar to Xexun or Coban. If not similar to any of them then TRY TO FOLLOW THE STEPS AT THE CONFIGURATION INSTRUCTIONS BUT USE THE COMMANDS FROM THE MANUAL YOU RECEIVED FROM THE SELLER

6 STEP #2 2. XEXUN type - Configure with SMS commands Turn ON your GPS tracker and follow these steps carefully. After every (except the t030s***n123456) SMS you must receive an OK message from the tracker as a response - otherway the configuration wasn t successful. Send all of these SMS commands to the tracker correctly with spaces : No. Command Info 1st begin reset all settings to factory default 2nd apn xyz sets the required APN for GPRS configuration 1 3rd apnuser xyz sets the USERNAME for GPRS connection (optional) 1,2 4th apnpasswd xyz sets the PASSWORD for GPRS connection (optional) 1,2 5th adminip sets our server's IP address and Port number 6 6th t 030 s***n sets the report time interval to 30 seconds 3 1 The " xyz " depends on your mobile phone company, for more information ask your SIM supplier or check their website! 2 Do not send this messages if you don t need USERNAME and PASSWORD for the GPRS connection! 3 The report interval must NOT be less than 5s (max time for simple TK102 and TK103 is 30s) is the default password, if you changed you need to use your chosen one 5 Do not forget to use "spaces" in the commands! 6 Check the IP and Port settings at under the Support menu point NOT WORKING? CLICK HERE FOR THE MOST FREQUENT PROBLEMS AND SOLUTIONS

7 STEP #2 3. COBAN type - Configure with SMS commands Turn ON your GPS tracker and follow these steps carefully. After every SMS (except the fix030s***n123456) you must receive an OK message from the tracker as a response otherway the configuration wasn t successful. Send all of these SMS commands to the tracker correctly with spaces : No. Command Info 1st begin reset all settings to factory default 2nd GPRS sets the device to GPRS mode (default mode is SMS) 3rd APN xyz sets the required APN for GPRS connection 1 4th up user psw sets the Username and Password for GPRS connection (optional) 1,2 5th adminip sets our server's IP address and Port number 6 6th fix 030 s***n sets the report time interval to 30 seconds 3 1 The xyz user and password depends on your SIM provider, for more information check their website or call them up! 2 Do not send this messages if you don t need USERNAME and PASSWORD for the GPRS connection! 3 The report interval must NOT be less than 20s (max time for simple TK102 and TK103 is 30s) is the default password, if you changed you need to use your chosen one 5 Do not forget to use "spaces" in the commands! 6 Check the IP and Port settings at under the Support menu point NOT WORKING? CLICK HERE FOR THE MOST FREQUENT PROBLEMS AND SOLUTIONS

8 4. The most frequent problems and solutions 4.1 Wrong APN settings This is the most common issue why a device is not working. Please ask your SIM provider about the actual APN, APN username and APN password. Double check that the APN is configured well. We also suggest to check this APN list, it may help: No GPS signal These devices usually don t send anything if GPS signal is weak and no GPS fix, so when the location wasn t determined. For the first GPS fix it will need some time, so place the tracker outdoor, where the GPS signal is good and let it working for minutes. 4.3 Invalid IMEI When you try to add your device to CorvusGPS.com s tracking system the wizard informs you that the IMEI you entered is invalid. This means that this number is not a valid IMEI so it s not guaranteed to work at all or it might not be unique so it s possible that more than one device sends data with the same ID. Please check the numbers again but if you have not made a mistake in this case we can t add this device to our system, please contact with the seller to suggest you another software. 4.4 IMEI vs. 12 digit ID In the last few months there were lots of TK devices on the market with 12 digit ID instead of IMEI code. If the IMEI of your device contains (eg.: ) then you have a great chance that your device is from this type. In this case you need to do the following: The example IMEI is: Remove the first 4 character: And write a 0 to the front: So as an example if your IMEI is then your 12 digit ID is Now you need to add the device to your account with selecting TK102 (12 digit ID) device type in the wizard and using your 12 digit ID. 4.5 No Coordinates at the chosen interval If you see this message in our tracking software that means that we have not received any data from your device yet. In this case please check point 4.1 and 4.2 to fix the problem. If you selected the Time interval option instead of Last position in the tracking software then it only means that there isn t any stored data from your device in that interval.

9 4.6 If the device does not respond to SMS commands - SIM card has run out of credit - SIM card s PIN code request is not disabled - SIM card not placed well into the SIM socket - Caller ID display is not enabled - The battery is dead - The tracker is dead - There is already a device with the same IMEI on the network

10 LIST OF ALL XEXUN COMMANDS (Some of these commands are not supported by TK102-2.) FUNCTION COMMANDS EXAMPLE Password modification password+old password+space+new password password P.S:the password should be 6 digitals Authorization admin+password+space+cellphone number admin P.S:there are 4 other numbers can set as the masters,use the same way to set them. IP and Port Setting adminip+password+space+ip address+space+port adminip P.S:When you need the tracker has the way of GPRS transferring,this is the necessary setting. APN setting APN+password+space+the user's APN APN internet P.S:When you need the tracker has the way of GPRS transferring,this is the necessary setting.and APN refers to the GSM card's APN. APN user name setting Apnuser+password+space+apn's username apnuser come P.S:If the APN has user name,this is the command to setting this. APN password setting Apnpasswd+password+space+apn's password apnpasswd cmet P.S:If the APN has password,this is the command to setting this. Interval tracking t030s005n+password t030s005n P.S:T=time,s=second,m=minutes,h=hour,n=times,t030s005n means track 5 times for 30s interval, "***" means countless times.and the minimum interval time is 5 seconds(new vesion tracker),30 seconds(old vesion),the maximum times is 250 times. Tracking mode tracker+password tracker P.S:If you need switch the other modes to tracking mode,you need send this commands. Track once tracking one / or call the tracker once tracking one P.S:If you want to have the tracker only report once,send tracking one to the tracker,or call the tracker once. Listen in mode monitor+password monitor P.S:If you need switch the other modes to listen in,you need send this commands. When you use the tracker first time,call the tracker,tracker reports you the coordinates,send monitor123456,call the tracker you will hear what happen around the tracker. Geofence stockade+password+space+longitude,latitude;longitude,latitude stockade , ; , P.S:Send this sms command to the tracker,then if the tracker run out the area you have set,it will send "stockade"with the location to you. Movement Alert move+password move P.S:The tracker will move 500m at least,or you cannot get this alert."move with the location" Overspeed Alert speed+password+space+080 speed P.S:The unit of the speed is km which is the orignal data from the GPS,and if the speed less then 30km/h,you won't get the alert "speed+location" Low battery Alert no needing to set up No needing to set up P.S:When the back up battery is less than 3.7V,it will send " L". Initialization begin+password begin123456

11 P.S"To cancel all the settings,you need this commands,but if you forget the password,you need update the firmare. IMEI Checking imei+password imei P.S:If you want to know the IMEI number of the tracker,you need this command. SOS no needing to set up No need to set up P.S:When someone press the SOS,you will get the information of 'help me with the coordinates". Ignition alert fortify+password fortify P.S:Only for the vehicle tracker,there are two wires connect the ACC(ignition),if you send "fortify123456",then anyone switch on the vehicle,it will send alert. Ignition Status checking fortified+password fortified P.S:If you want to make sure that the tracker in under this function,send this commands,and tracker will reply you. Main power losing alert no needing to set up No need to set up P.S:If the main power is losing,the tracker will send "battery". Time zone setting Time zone+password+space+gmt time Time zone P.S:"UK time is time zone "currently. Individual Website setting Home+pasword+space+the user's webite home P.S:If "tracker" wants make the returned sms has their domain name,they can set "home Relay on/off (stop engine) Powercar+password+space+1 (or 0) Powercar P.S:Only the vehicle tracker has this function,"powercar /0" 1=on,0=off Shake Alert (with the motion sensor) shake+password+space 1-10 shake P.S:Only the new version tracker has this function,from 0-10,means from shake heavily to softly,1 means the heaviest,10 means the softest.0=off Read SD card Readsd+password+space+1 readsd P.S:Only the new version tracker has this function,where there is not GPRS connection,tracker records the information into the SD card and when there comes the GPRS connection,tracker sends all the information to the server.1=on,0=off. SMS report smslinkone+password smslinkone Send report in SMS (it s working during the gprs communication too ) Restart tracker restart+password restart P.S:This command is restart the tracker.