FM-CI Cochlear Implant Adaptor Instructions for Use

Transcription

1 FM-CI Cochlear Implant Adaptor Instructions for Use

2 Contents FM-CI adaptor features 4 Amigo receiver features 5 Adaptor cords 6-7 System setup 8-9 Inserting batteries 10 Wearing instructions FM system listening check Troubleshooting Warranty Important notice Please familiarise yourself with the entire contents of this booklet before using your Amigo FM-CI Adaptor. The booklet contains various statements, safety instructions and important information about the use and handling of your Amigo FM-CI Adaptor. Oticon recommends the FM-CI cochlear implant adaptor be fitted by a Hearing Care Professional trained to fit and program the speech processor to which the adaptor will be attached. 2 3

3 4 4 FM-CI Adaptor Features Tamper proof battery compartment (size 13 battery) 2. Audio output 3. Gain control 4. Belt/clothing clip 5. Europin jack 6. Hook and loop velcro 5 1 Amigo receiver features (sold separately) 1. Europins LED status indicator 3. 3-position mode switch 4. Channel seek/toggle (R2 only) 5. Europin rotation lock 4 Turns on the Amigo receiver and FM-CI adaptor. Mode setting depends on the CI-processor used. Turns off the Amigo receiver and FM-CI adaptor. 5

4 Adaptor cords (sold separately) Adaptor cords are used to connect the FM-CI adaptor to the various speech processors. Cords are available with different lengths and plug styles to allow users flexibility when connecting to their particular processor. Additional adaptors and adaptor cords specific to the speech processor may be required to accommodate the FM system. These can be obtained directly from the CI manufacturer. FM-CI adaptor CI adaptor cord Speech processor Adaptor cords Cord name Part number Cord properties Length Processor end Plug style CI EMI filter 20 in 50 cm 3.5mm, audio straight CI k + EMI filter 5 in 12 cm 3.5mm, audio straight CI k + EMI filter 14 in 35 cm 3.5mm, audio straight CI k 3 in 7 cm 3.5mm, audio* 90 CI k 20 in 50 cm 3.5mm, audio* straight CI k 20 in 50 cm Microtronic CS44 straight CI k + 1nF 5 in 12 cm 3.5mm, audio 90 CI k + 1nF 20 in 50 cm 3.5mm, audio straight * Stereo, all others mono 6 7 Adaptor end

5 System setup The FM-CI adaptor can be fitted to the speech processors through a combination of the correct adaptor cord, FM-CI gain setting, Amigo receiver gain setting and Amigo receiver three position switch. Additional adaptors and adaptor cords specific to the speech processor may be required to accommodate an FM system. These can be obtained directly from the CI manufacturer. Consult the FM-CI fitting guide for more detailed instructions. It may be necessary to make changes in the speech processor program options to accommodate an FM system and maximize user benefits. Speech processor programming options may vary from product to product and manufacturer to manufacturer. Oticon recommends the FM-CI cochlear implant adaptor be fitted by a Hearing Care Professional trained to fit and program the speech processor to which the adaptor will be attached. System setup IMPORTANT! The cochlear implant speech processors and FM systems contain sophisticated electronic components. It is important to verify speech processor functionality and FM system functionality independently, prior to connecting the systems together. (See page 18 for listening check details). Assuring independent system functionality will greatly assist in fine tuning and troubleshooting. 8 9

6 Inserting batteries Use a small screwdriver to open the tamperproof battery compartment on the FM-CI adaptor and insert a size 13 battery. Note the polarity markings on the battery door for proper battery orientation. Wearing instructions Depending on how the processor is worn, it may be necessary to experiment with different FM-CI adaptor cords and FM-CI adaptor placement to ensure an optimal balance between wearing comfort and FM reception quality. Warning: Never change the battery in front of infants, small children or people with learning difficulties. If a battery is swallowed, see a doctor immediately

7 Wearing instructions The FM-CI adaptor can be attached to your clothing via the included clip. To ensure the best FM reception, place the FM-CI adaptor on the front of your chest. Wearing instructions With body-worn processors you have two wearing options: Option 1: Connect the adaptor to the processor using a short cord. Attach the FM-CI adaptor directly to the processor by removing the clothing clip and using the hook and loop tape. Option 2: Connect the adaptor to the processor using a long cord. Attach the FM-CI adaptor to the user s clothing using the attached clothing clip

8 Wearing instructions The CI headpiece can be a source of electromagnetic interference (EMI) and radio frequency (RF) interference for FM receivers, depending on the settings of the processor program. To optimise FM reception, quality and transmission range the FM- CI adaptor should be placed a minimum of 12 in/30 cm from the CI headpiece. 12In/ 30cm FM system listening check A listening check should be performed on the FM system prior to connecting it to the CI speech processor. Using a hearing instrument with an FM adaptor: Attach audio shoe to the hearing instrument. Attach the Amigo receiver to the audio shoe and switch to the o position. Turn on the hearing instrument and the Amigo FM transmitter and begin speaking into the microphone. Listen to the audio output using stetoclips to avoid feedback

9 FM system listening check NOTE: For specific details on hearing instrument compatibility visit Ensure the hearing instrument battery is new, the Amigo transmitter batteries are fully charged and the Amigo receiver and transmitter are on the same channel. Troubleshooting Processor Checklist Verify that the correct coil cable is being used Verify all connections are in place and cords are not damaged Verify that the batteries are new Perform a listening check FM Checklist Verify that the transmitter is ON and batteries are fully charged Verify that the receiver three position switch is in the correct setting Verify all connections are in place and cords are not damaged 16 17

10 No FM Signal Turn the processor OFF, then ON to reset the processor Verify that the Amigo receiver gain is on the correct setting Verify that the Amigo transmitter and receiver are ON and are on the same channel Verify that the processor and FM-CI adaptor have new batteries and that the Amigo transmitter is fully charged Intermittent Sound Turn the processor OFF, then ON to reset the processor Verify that the processor and FM-CI adaptor have new batteries and that the Amigo transmitter is fully charged Verify the Amigo receiver is firmly attached to the FM adaptor and that the FM adaptor cords are firmly attached to the processor If an accessory microphone is being used for the transmitter, make sure that the connections are clean, firmly attached and the cord is not damaged. Short FM Range For maximum range, the Amigo transmitter should have the external antenna (or microphone cord) attached and it should be hanging freely. Do not coil or wrap the antenna around the transmitter Static/Interference Verify that the correct adaptor cord is being used Change transmitter and receiver channels Remove obstructions between transmitter and receiver Move away from sources of EMI (electromagnetic interference): fluorescent lights, computer monitors, televisions, some digital cell phones, etc

11 Manufacturer s warranty The manufacturer, Oticon, issues a one-year limited warranty to the original consumer of this product. This warranty comes into effect upon the date of original purchase of this equipment, and will remain in effect for one calendar year from that date. Please notice that extended warranties may apply in your country. Please contact your local Hearing Care Professional for more information. What is covered by this warranty? Any electronic component which, because of workmanship, manufacturing or design defects, fails to function properly under normal use d uring the life of this warranty will be replaced or repaired at no charge for parts or labour when returned to the point of purchase. Transportation is paid by the customer. If it is determined that repair is not feasible, the entire unit may be replaced with an equivalent unit upon mutual agreement of the Hearing Care Professional and customer. What is not covered by this warranty? This one-year limited warranty does not cover: Malfunctions resulting from abuse, neglect or accident. Peripheral accessories as itemised within the product brochure, when such items are later than 90 days from the original purchase. Batteries. Instruments connected, installed, used or adjusted in a manner contrary to the instructions provided. Consequential damages and damages resulting from delay or loss of this instrument. The exclusive remedy under this warranty is strictly limited to repair or replacement as herein provided. Products damaged in transit unless investigated by the shipper and returned to the warrantor with the investigation report

12 The manufacturer reserves the right to make changes in the design or construction of any of its instruments at any time without incurring any obligation to make any changes whatsoever on units previously purchased. This warranty is in lieu of all other expressed warranties by the manufacturer. No representative or person is authorized to represent or assume for the manufacturer any liability in connection with the sale or use of this product other than as set forth above. If your Amigo system requires service under the terms of this warranty, carefully package the instrument to prevent damage in transit and return it to the point of purchase. Include a detailed description of the problem, your full name, billing and shipping address and telephone number. The above warranty does not affect any legal rights that you might have under applicable national legislation governing sale of consumer goods. Your point of purchase may have issued a warranty that goes beyond the clauses of this limited warranty. Please consult your point of purchase for further information. Hereby Oticon declares that this Amigo is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. Declaration of conformity is available at Oticon A/S Kongebakken 9 DK-2765 Smørum Denmark

13 Warnings Amigo parts can be dangerous if swallowed: The Amigo system is not a toy and therefore should be kept out of the reach of children and anyone else who might swallow parts or otherwise cause injury to themselves. Special attention should be paid to the smaller components in order to prevent children from swallowing them and perhaps choking. Never change the battery and never connect the receiver to the hearing instrument in front of infants, small children or persons with learning difficulties. If a part is swallowed, see a doctor immediately. Date of purchase: Amigo serial numbers: Microphone: Receiver left: Receiver right: Oticon A/S 9, Kongebakken DK-2765 Smørum 0543 Waste from electronic equipment must be handled according to local regulations. 24

14 / Printed in Denmark

15 / Printed in Denmark