BAX Sample Tablet, Real-Time Salmonella

Transcription

1 This SDS adheres to the standards and regulatory requirements of the United States and may not meet the regulatory requirements in other countries. SECTION 1. PRODUCT AND COMPANY IDENTIFICATION Product name : Product Grade/Type : MSDS Number : Manufacturer : E.I. DuPont de Nemours and Co Market Street Wilmington, DE Product Information : Transport Emergency : CHEMTREC: (outside the U.S ) Other information : OSHA Hazard Communication Standard (29 CFR ) requirements for Material Safety Data Sheets do not apply to this product. This product is excluded as an article. Information on any potential hazards associated with product are discussed in this datasheet. SECTION 2. HAZARDS IDENTIFICATION Potential Health Effects Carcinogenicity None of the components present in this material at concentrations equal to or greater than 0.1% are listed by IARC, NTP, or OSHA, as a carcinogen. SECTION 3. COMPOSITION/INFORMATION ON INGREDIENTS Component CAS-No. Concentration 1 / 5

2 Inert Ingredients >99% SECTION 4. FIRST AID MEASURES Skin contact : The material is not likely to be hazardous by skin contact, but cleaning the skin after use is advisable. Eye contact Inhalation Ingestion General advice : Hold eye open and rinse slowly and gently with water for minutes. Remove contact lenses, if present, after the first 5 minutes, then continue rinsing eye. Consult a physician if necessary. : Is not an expected route of exposure under normal conditions. : Is not considered a potential route of exposure. If swallowed Call a physician immediately. : No hazards which require special first aid measures. SECTION 5. FIREFIGHTING MEASURES Flammable Properties Flash point : no data available Fire and Explosion Hazard : Not a fire or explosion hazard. Suitable extinguishing media : Use extinguishing measures that are appropriate to local circumstances and the surrounding environment. SECTION 6. ACCIDENTAL RELEASE MEASURES NOTE: Review FIRE FIGHTING MEASURES and HANDLING (PERSONNEL) sections before proceeding with clean-up. Use appropriate PERSONAL PROTECTIVE EQUIPMENT during clean-up. Safeguards (Personnel) : No special precautions required. 2 / 5

3 Spill Cleanup Accidental Release Measures : Sweep up and shovel into suitable containers for disposal. : Follow applicable Federal, State/Provincial and Local laws/regulations. SECTION 7. HANDLING AND STORAGE Handling (Personnel) : NO HAZARDS FOUND. USE GOOD INDUSTRIAL PRACTICES. Storage Storage temperature : Keep refrigerated. : 2-8 C (36-46 F) SECTION 8. EXPOSURE CONTROLS/PERSONAL PROTECTION Engineering controls : Use only with adequate ventilation. Personal protective equipment Skin and body protection : Wear protective clothing such as gloves, apron, boots, or coveralls, as appropriate. Exposure Guidelines Exposure Limit Values None established. SECTION 9. PHYSICAL AND CHEMICAL PROPERTIES Form : tablet Color : white SECTION 10. STABILITY AND REACTIVITY Stability : Stable Hazardous reactions : Polymerization will not occur. 3 / 5

4 SECTION 11. TOXICOLOGICAL INFORMATION Further information : no data available SECTION 12. ECOLOGICAL INFORMATION Additional ecological information : no data available SECTION 13. DISPOSAL CONSIDERATIONS Waste Disposal : In accordance with local and national regulations. SECTION 14. TRANSPORT INFORMATION Not regulated in transportation by DOT/IMO/IATA. SECTION 15. REGULATORY INFORMATION SARA 313 Regulated Chemical(s) California Prop. 65 : This material does not contain any chemical components with known CAS numbers that exceed the threshold (De Minimis) reporting levels established by SARA Title III, Section 313. : Chemicals known to the State of California to cause cancer, birth defects or any other harm: none known 4 / 5

5 SECTION 16. OTHER INFORMATION Trademark of E.I. du Pont de Nemours and Company. Registered trademark of E.I. du Pont de Nemours and Company The information provided in this Safety Data Sheet is correct to the best of our knowledge, information and belief at the date of its publication. The information given is designed only as a guidance for safe handling, use, processing, storage, transportation, disposal and release and is not to be considered a warranty or quality specification. The information relates only to the specific material designated and may not be valid for such material used in combination with any other materials or in any process, unless specified in the text. Significant change from previous version is denoted with a double bar. 5 / 5