> portable series URPTFM URPTFM/S URPT/MIC/B... URPT/MIC/S/B... URPRFM URPRFM/S URPR/MIC/B... URP-T front and rear view Features > URPT FEATURES: all Microphonic and Stereophonic versions uses the same size. URPT output power from 20 W to 40 W depening the working frequency. > WORKING FREQUENCIES URPT: URPTFM works on FM band 87,5-108 MHz. Microphonic and Stereophonic version works on (Mhz) 190 310 (/B10), 315 400 (/B20), 405 465 (/B30), 470 545 (/B40), 780 885 (/B50), 890 970 (/B60). > WORKING FREQUENCIES URPR: URPRFM works on FM band 87,5-108 MHz. Microphonic version works (Mhz) on 215 265 (/B10), 430 480 (/B20). > OPERATING EFFICIENCY: power supply from 10 Vcc to 30 Vcc with continuity. > PRIMARY APPLICATION: high portability for employment also on motor vehicles (both light and heavy), or installation with low environmental impact supplies by batteries or photovoltaic panels. > USER-FRIENDLY FEATURES: easy setting/control, by means of a userfriendly graphic interface on the front panel, all the diagnostic and control parameters are displayed (frequency, output power (URPT), measurements, etc ). > HARDWARE FEATURES: ultralight transmitter in about 3,9kg. > REGULATORY COMPLIANCE: state-of-the-art technology and design results in equipment that is in full compliance with FCC, CCIR, and EC standards. 88
Nomadics FM Transmitters & Radio Links radio links URP-R front and rear view Caratteristiche > URPT FEATURES: tutte le versioni microfonica e stereo utilizzano lo stesso chassis. La potenza di uscita dell'urpt è compresa fra 20 W e 40 W dipendenti dalla frequenza di lavoro. > WORKING FREQUENCIES URPT: la versione URPTFM lavora alle frequenze della banda FM 87,5-108 MHz. Le versioni stereo o microfonica lavorano nelle frequenze (Mhz) da 190 310 (/B10), da 315 400 (/B20), da 405 465 (/B30), da 470 545 (/B40), da 780 885 (/B50) e da 890 970 (/B60). > WORKING FREQUENCIES URPR: la versione URPRFM lavora alle frequenze della banda FM 87,5-108 MHz. Le versioni microfoniche lavorano alle frequenze (Mhz) da 215 265 (/B10), da 430 480 (/B20). > PRIMARY APPLICATION: elevata portabilità per impieghi anche su veicoli a motore (sia pesanti che leggeri), o in postazioni a basso impatto ambientale provviste di batterie o pannelli fotovoltaici. > USER-FRIENDLY FEATURES: facile impostazione/controllo, mediante una semplice interfaccia grafica sul pannello frontale, tutti i parametri di diagnosi e di controllo vengono visualizzati (come frequenza, potenza di uscita (URPT), misure, ecc...). > HARDWARE FEATURES: trasmettitore ultraleggero dal peso di 3,9 kg. > REGULATORY COMPLIANCE: tecnologia moderna e pienamente rispondente alle normative EC, FCC ed CCIR. > OPERATING EFFICIENCY: alimentazione a batteria da 10 Vcc a 30 Vcc con continuità. 89
> portable series Technical specifications URPTFM URPTFM/S URPT/MIC/B URPT/MIC/S/B Parameters Conditions Values Values Values Values GENERALS /B10: 30 W /B20: 30 W Rated output power 30W /B30: 40 W /B40: up to 40 (depends of frequency) W /B50: 20 W /B60: 20 W Modulation type Direct carrier frequency modulation ALC ON Operational mode Mono, MPX Mono, MPX, Stereo (audio bandwith 50-12,5 KHz) ALC OFF Mono, MPX, Stereo (audio bandwith 40-100 KHz) Display Alphanumerical LCD - 2 x 16 Environmental working temperature from -10 C to 50 C /B10: 190 310 /B20: 315 400 Frequency range /B30: 405 465 87,5 108 Mhz (other frequency on request) /B40: 470 545 /B50: 780 885 /B60: 890 970 Frequency programmability (other steps on request) From software Step 10 Khz From software Step 5 Khz Frequency stability WT from -10 C to 50 C ±1 ppm Modulation Capability typical 200 Khz - - typical 200 Khz Spurious & harmonic suppression <70 dbc Asynchronous AM S/N ratio Referred to 100% AM, with no de-emphasis 60 dbc Referred to 100% AM, FM deviation Synchronous AM S/N ratio 75 khz by 400Hz sine, 50 dbc without de-emphasis Audio Filters 5 / 7,5 / 10 / 12,5 Khz 5 / 7,5 / 10 / 12,5 Khz Preemphasis 0/25/50 (CCIR) µs, 75 (FCC) µs / 750 µs MONO OPERATION RMS @ ± 75 khz peak, HPF 20Hz - 52 db (RMS @ ± 7 khz peak) LPF 23 khz, 50 µs de-emphasis > 75 db 52 db (RMS @ ± 7 khz peak) > 75 db MPX OPERATION RMS @ ± 75 khz peak, HPF 20Hz - no LPF Not available > 75 db Not available > 75 db Frequency response 40 Hz 100 KHz ± 0.3 db Total Harmonic Distortion THD+N 40 Hz 100 KHz 0,3 Khz 0.08 Khz 0,3 Khz 0.08 Khz STEREO OPERATION RMS @ ± 75 khz peak, HPF 20Hz - LPF 23 khz, 50 µs de-emphasis, Not available > 75 db Not available > 75 db L & R demodulated Frequency response 40 Hz 15 KHz Not available ± 0.3 db Not available ± 0.3 db Total Harmonic Distortion THD+N 40 Hz 15 KHz Not available 0.04 % Not available 0.04 % Stereo separation Not available > 60 db Not available > 60 db AUDIO INPUTS Left-Mono \ Input 1 Type balanced 600, 2,2 or 10 k (Ohm) Right/Mono \ Input 2 Type balanced 600 or 10 k (Ohm) 90
URPTFM URPTFM/S URPT/MIC/B URPT/MIC/S/B Parameters Conditions Values Values Values Values AUDIO INPUTS MPX unbalanced/rds \ Input 3 Type unbalanced 600, 2,2 or 10 k (Ohm) SCA1 \ Input 4 Type unbalanced 600, 2,2 or 10 k (Ohm) Microphone 3,5 mm Jack Type Stereo with selectable phantom (for electred mic) OUTPUTS RF output Type N Type 50 (Ohm) Type 3,5 mm Jack Headphone outptut 25 (Ohm) > 200 mv AUXILIARY CONNECTIONS Accessory Interface DB15 M Telemetry Interface DB15 F POWER REQUIREMENTS AC Supply Voltage 90 130 or 180 250 VAC AC Primary power AC Power Consumption about 200 W IEC Standard DC Supply Voltage 12-30 V DC Power Input DC Current < 13 A DC Power Consumption about 140 W DB15 (ACCESSORY) MECHANICAL SPECIFICATION Phisical Dimensions (W x H x D) 355x85x295 mm Weight about 4 kg STANDARD COMPLIANCE Safety EN 60215:1989 + EN60215/A1:1992-07 + EN60215/A2:1994-09 EMC EN 301 489-1 V1.4.1 (2002-08) + EN 301 489-11 V1.2.1 (2002-11) Spectrum Optimization EN 302 018-2 V1.2.1 (2005-06) radio links All pictures are RVR s property and they are only indicative and not binding. The pictures can be modified without notice. These are general specifications. They show typical values and are subject to change without notice. Revision: 03/09 91
> portable series Technical specifications URPR/FM URPR/FM/S URPR/MIC/B Parameters Conditions Values Values GENERALS Frequency range (other frequency on request) 87.5 /108 MHz 215/265 MHz 430/480 Mhz Modulation type Direct carrier frequency modulation Display Alphanumerical LCD - 2 x 16 Environmental working temperature from -10 C to 50 C RF input impedance 50 Ohm Frequency programmability From software Step 10 Khz Frequency stability from -10 C to 50 ±1 ppm Deemphasis 0/25/50 (CCIR) µs, 75 (FCC) µs, 750 µs Intermediary Frequencies (IF) IF: 70 MHz / 10,7 MHz / 700 KHz MONO OPERATION RF INPUT -47 dbm, RMS @ ± 7 khz peak, HPF 20Hz - LPF 23 khz, 75 ÌS de-emphasis 50 db RF INPUT -47 dbm, RMS @ ± 7 khz peak, HPF 20Hz - LPF 23 khz, 75 ÌS de-emphasis 48 db Frequency response 40 Hz 12,5 KHz, 75 ÌS de-emphasis ±0,5 db Total Harmonic Distortion THD+N 40 Hz 15 KHz 3 % INPUTS RF input type N impedance 50 Ohm OUTPUTS Mono front balanced (one pair) XLR Male from -12 to 12 dbu Mono front unbalenced BNC from -12 to 12 dbu Mono rear balanced DB15 M from -12 to 12 dbu 10.7 MHz IF OUT BNC 50 Ohm POWER REQUIREMENTS AC supply voltage 90 250 VAC AC Primary power AC power consumption about 40 VA IEC Standard DC supply voltage 12-30 V DC power input DC corrent < 2,5 A DC power consumption about 30 W DB15 (ACCESSORY) MECHANICAL SPECIFICATION Phisical Dimensions (W x H x D) 355x85x295 mm Weight About 3,5 Kg STANDARD COMPLIANCE Safety EN 60215:1989 + EN60215/A1:1992-07 + EN60215/A2:1994-09 EMC EN 301 489-1 V1.4.1 (2002-08) + EN 301 489-11 V1.2.1 (2002-11) All pictures are RVR s property and they are only indicative and not binding. The pictures can be modified without notice. These are general specifications. They show typical values and are subject to change without notice. Revision: 03/09 Ordering information Options for URPT/S/B... & URPTFM/S - Opzioni per URPT/S/B... & URPTFM/S Code Description /AUDIGIN-URPT Digital audio input URPT Opzione scheda ingressi audio digitali 92
Ordering information URP Unit versions - Versioni URP Code Description URPTFM Microphonic transmitter 87,5-108MHz 30W Pw Trasmettitore microfonico 87,5-108MHz 30W Pw URPTFM/S Stereophonic transmitter 87,5-108MHz 30W Pw Trasmettitore stereofonico 87,5-108MHz 30W Pw URPT/MIC/B10 Microphonic transmitter 190-310 MHz 30W Pw Trasmettitore microfonico 190-310 MHz 30W Pw URPT/MIC/B20 Microphonic transmitter 315-400 MHz 30W Pw Trasmettitore microfonico 315-400 MHz 30W Pw URPT/MIC/B30 Microphonic transmitter 405-465 MHz 40W Pw Trasmettitore microfonico 405-465 MHz 40W Pw URPT/MIC/B40 Microphonic transmitter 470-545 MHz 40W Pw Trasmettitore microfonico 470-545 MHz 40W Pw URPT/MIC/B50 Microphonic transmitter 780-885 MHz 40W Pw Trasmettitore microfonico 780-885 MHz 40W Pw URPT/MIC/B60 Microphonic transmitter 890-970 MHz 20W Pw Trasmettitore microfonico 890-970 MHz 20W Pw URPT/S/B10 Stereophonic transmitter 190-310MHz 30W Pw Trasmettitore stereofonico 190-310MHz 30W Pw URPT/S/B20 Stereophonic transmitter 315-400 MHz 30W Pw Trasmettitore stereofonico 315-400 MHz 30W Pw URPT/S/B30 Stereophonic transmitter 405-465 MHz 30W Pw Trasmettitore stereofonico 405-465 MHz 30W Pw URPT/S/B40 Stereophonic transmitter 470-545 MHz 40W Pw Trasmettitore stereofonico 470-545 MHz 40W Pw URPT/S/B50 Stereophonic transmitter 780-885 MHz 20W Pw Trasmettitore stereofonico 780-885 MHz 20W Pw URPT/S/B60 Stereophonic transmitter 890-970 MHz 20W Pw Trasmettitore stereofonico 890-970 MHz 20W Pw radio links URP Unit versions - Versioni URP Code Description URPRFM Microphonic receiver 87,5-108 MHz Ricevitore microfonico 87,5-108 MHz URPR/MIC/B10 Microphonic receiver 215-265 MHz Ricevitore microfonico 215-265 MHz URPR/MIC/B20 Microphonic receiver 430-480 MHz Ricevitore microfonico 430-480 MHz RVR Elettronica S.p.A. Via del Fonditore, 2/2c Zona Industriale Roveri 40138 Bologna Italy Phone: +39 051 6010506 Fax: +39 051 6011104 e-mail: info@rvr.it web: http://www.rvr.it ISO 9001:2000 certified since 2000 93