Cisco Catalyst UPOE Power Splitter Overview Cisco is the industry leader in delivering power over Ethernet to reduce cost of power bill, power management and total cost of ownership. Following industry standard POE (IEEE802.3af) and POEP (IEEE802.3at), Cisco doubles the power supplied over Ethernet to 60W via UPOE (Universal Power Over Ethernet) on Catalyst 4500E Series Switches and line cards. As part of the UPOE solution, Cisco provides a power splitter that takes an UPOE input and split it into one Ethernet output and one DC power line output. With this power splitter, Catalyst 4500E Series Switches can power any device that is within 12V range. This plug and play UPOE solution provide a wide range of power services and greatly reduce the cost of the power used in the buildings and offices. Figure 1. Cisco Catalyst 4500E Series UPoE Power Splitter The standalone power splitter takes a UPOE input from the WS-X4748-UPOE+V line card port and provides one POE/POEP RJ45 port and one DC power output connector that can support up to 60W or 12V. A 60W input power from UPOE is shared between the POE/POEP and the DC power output lines. Figure 2. Cisco Catalyst 4500E Series UPoE Power Splitter Input View Figure 3. Cisco Catalyst 4500E Series UPoE Power Splitter Output View 2011 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 1 of 6
The is a passive device that takes 55V from a Catalyst 4500 UPOE line card port and efficiently passes the power to one POE/POEP load and one 12V load. It also comes with a choice of three cables that are used to connect to a variety of end devices that are POE/POEP agnostic. Table 1 provides the specification of the Power Splitter and Table 2 provides the associated connector Cables. Table 1. Specification UPOE Power Splitter Input Output Output Cables Category 5 cable Category 5 cable Connector RJ45 RJ45 Flying leads DC barrel connector Watts 60W 25.5W 47.5W Table 2. Cables Specifications Cables Description Length Reference Applications WS-CAB-UPOE-12-9MM WS-CAB-UPOE-9-9MM WS-CAB-UPOE-FLY9MM Cable DC power cord 12 MM to 9 MM 6 feet Cable DC power cord 9 MM to 9 MM 6 feet Cable DC power cord Flying leads to 9 MM 4 feet 6 feet Samsung BX2250 or XL2270 monitors 6 feet Tandberg E30, EX60 or C20 Telepresence systems 4 feet Physical Security Business Unit (PSBU) such as door strike and gateway There are two LED s located on the Output panel of the. The LED right next to the POE/POEP port is green when power is delivered over the POE/POEP pass-through port and is off when power is not being delivered. The bi-color LED positioned next to the 12V DC power output connector indicates the power is either delivered over a single pair, both pairs or off. Table 3. LED Specifications Cables Green Orange Off POE/POEP LED Power is delivered Not Applicable No power device detected or no power 12V DC Power LED Power is delivered through both pairs Power is delivered through only one pair Off Switch Setup is a passive device and it requires the switch it is connected to force the UPOE power to be delivered to its input port. Following CLI (Command Line Interface) commands are required after the UPOE Power Splitter is connected to the UPOE port of a Catalyst 4500E switch. ##ena ##conf t ##int gix/y % x is the slot number and y is the port number ##sh ## power inline four- pair forced ## no sh ## end 2011 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 2 of 6
Environmental Conditions require the following conditions: Operating temperature: 32 to 104ºF (0 to 40ºC) Storage temperature: -40 to 167ºF (-40 to 75ºC) Relative humidity: 10 to 90 percent, noncondensing Operating altitude: -60 to 3000 meters (m) Regulatory Standards Compliance Table 9 lists the regulatory standards compliance of the. Table 4. Specification Regulatory Standards Compliance Standard Regulatory compliance CE Marking Safety UL 60950 CAN/CSA-C22.2 No. 60950 EN 60950 IEC 60950 AS/NZS 60950-1 GB4943-2001 GB9254-2008 EMC FCC Part 15 (CFR 47) Class A AS/NZS CISPR22 Class A CISPR22 Class A EN55022 Class A ICES003 Class A VCCI Class A EN61000-3-2 EN61000-3-3 KN22 Class A CNS13438 Class A EN55024 CISPR24 EN300386 KN24 Ordering Information Table 11 lists the ordering information for s and Cables under the Cisco Catalyst 4500E Series Chassis. Table 5. Ordering Information Product Number WS-UPOE-12VPSPL WS-CAB-UPOE-12-9MM WS-CAB-UPOE-9-9MM WS-CAB-UPOE-FLY9MM Description Cable DC power cord 12 MM to 9 MM 6 feet Cable DC power cord 9 MM to 9 MM 6 feet Cable DC power cord Flying leads to 9 MM 4 feet 2011 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 3 of 6
Cisco Limited Lifetime Hardware Warranty The Cisco limited lifetime hardware warranty (LLW) includes 10-day advance hardware replacement for as long as the original end user owns the product. Table 12 describes the limited lifetime hardware warranty. Your formal warranty statement, including the warranty applicable to Cisco software, appears in the Cisco information packet that accompanies your Cisco product. We encourage you to review carefully the warranty statement shipped with your specific product before use. For additional information on warranty terms, visit http://www.cisco.com/go/warranty. Adding a Cisco technical services contract to your device coverage provides benefits not available with warranty, including access to the Cisco Technical Assistance Center (TAC), a variety of hardware replacement options to meet critical business needs, updates for licensed Cisco IOS Software, and registered access to the extensive Cisco.com knowledge base and support tools. Table 12 describes the benefits and features of Cisco technical services. For information about Cisco Technical Services, go to http://www.cisco.com/go/ts. 2011 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 4 of 6
Table 6. Limited Lifetime Hardware Warranty Cisco Limited Lifetime Hardware Warranty 1 Warranty duration EoL policy Hardware replacement Effective date TAC support Cisco.com access As long as the original end user continues to own or use the product, except for the fan and power supply, which are limited to 5 years. In the event of discontinuance of product manufacture, Cisco warranty support is limited to 5 years from the announcement of discontinuance. Cisco or its service center will use commercially reasonable efforts to ship a replacement part within 10 business days after receipt of the RMA request and confirmation that a replacement part is appropriate response. Actual delivery times may vary depending on customer location. Hardware warranty commences from the date of shipment to the customer (and in case of resale by a Cisco reseller, not more than 90 days after original shipment by Cisco). None Warranty allows guest access only to Cisco.com 1 Cisco reserves the right to refund the purchase price as its exclusive warranty remedy. Cisco and Partner Services for Expanding the Borderless Network Drive borderless network innovation, optimize operational efficiencies, establish business flexibility, and gain competitive advantage using intelligent, personalized services from Cisco and our partners. Through a discovery process that begins with understanding your business objectives, we help you integrate the next-generation Cisco Catalyst 4500-E Series Switches into your architecture and incorporate network services onto that platform. Sharing knowledge and leading practices, we support your success every step of the way as you deploy, absorb, manage, and scale new technology. Choose from a flexible suite of support services designed to meet your business needs and help you maintain high-quality network performance while controlling operational costs. Table 13 shows the Cisco technical services available for Cisco Catalyst 4500-E Series Switches. For additional information about Cisco services, visit http://www.cisco.com/go/services. Table 7. Cisco Technical Services for Cisco Catalyst 4500-E Series Switches Technical Services Cisco SMARTnet Service Around-the-clock, global access to the Cisco Technical Assistance Center (TAC) Unrestricted access to the extensive Cisco.com resources, communities, and tools Next-business-day, 8x5x4, 24x7x4, and 24x7x2 advance hardware replacement 2 and onsite parts replacement and installation available Ongoing operating system software updates within the licensed feature set 1 Proactive diagnostics and real-time alerts on Smart Call Home-enabled devices Cisco Smart Foundation Service Next business day advance hardware replacement as available Business hours access to SMB TAC (access levels vary by region) Access to Cisco.com SMB knowledge base Online technical resources through Smart Foundation Portal Operating system software bug fixes and patches Cisco Focused Technical Support Services Three levels of premium, high-touch services are available: Cisco High-Touch Operations Management Service Cisco High-Touch Technical Support Service Cisco High-Touch Engineering Service Valid Cisco SMARTnet or SP Base contracts on all network equipment are required. Notes: 1. Cisco operating system updates include the following: maintenance releases, minor updates, and major updates within the licensed feature set. 2. Advance hardware replacement is available in various service-level combinations. For example, 8x5xNBD indicates that shipment will be initiated during the standard 8-hour business day, 5 days a week (the generally accepted business days within the relevant region), with next business day (NBD) delivery. Where NBD is not available, same day ship is provided. Restrictions apply; please review the appropriate service descriptions for details. 2011 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 5 of 6
Printed in USA C78-436089-10 06/11 2011 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 6 of 6