1. Identification of the substance/preparation and the company/undertaking Product name Pure Epoxy Resin Product code JF375E product use A Chemical Anchoring Application Company JCP Construction Products Unit 14 Teddington Business Park Station Road Teddington Middlesex TW11 9BQ Tel +44 208 943 1800 Fax +44 208 943 1140 email jcpenquiries@owlett-jaton.com Telephone number for emergencies Tel +44 208 943 1800 8.30am to 5.00pm Monday to Friday 2. Hazards identification 2.1 Classification of the substance or mixture Classification under CHIP C: R34: Sens; R43; N: R51/53 Most important adverse effects: Causes burns. May cause sensitisation by skin contact. Toxic to aquatic organisms may cause long-term adverse effects in the aquatic environment 2.2 Label Elements Label elements under CHIP Hazard symbols: Risk phrases: Safety phrases: Corrosive Dangerous for the environment R 34: Causes burns R43: May cause sensitisation by skin contact R51/53: Toxic to aquatic organisms, may cause long term adverse effects in the aquatic environment. S2: Keep out of the reach of children. S24: Avoid contact with skin. S26: In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. S36/37/39: Wear suitable protective clothing, gloves and eye/face protection. S45: In case of accident or if you feel unwell, seek medical advice immediately (show product label where possible) S61: Avoid release into the environment. Refer to special instructions/safety data sheets 2.3 Other Hazards Other hazards: PBT: This substance is not identified as a PBT substance Epoxy Resin Page 1 of 5 16/04/2013
3. Composition/Information on ingredients Hazardous ingredients BISPHENOL A-(EPICHLORHYDRIN) {REACTION PRODUCT} 30-40% EINECS CAS CHIP Classification CLP Classification Percent 500-033-5 25068-38-6 Xi: R36/38: Sens.:R43; N:R51/53-30-40% BISPHENOL F-(EPICHLORHYDRIN) EPOXY RESIN 10-20% - 28064-14-4 Xi: R36/38: Sens.:R43; N:R51/53-10-20% 1,3 BENZENEDIMETHANAMINE 216-032-5 1477-55-0 C:R35: Xn:R20/22: Sens.:R43;-:R52/53-1.6 HEXANDIOLDIGLYCIDYLETHER 240-260-4 16096-31-4 Xi: R36/38: Sens.:R43; -:N:R52/53 - P-TERT-BUTYLPHENOL 202-679-0 111-40-0 X1: R36/37/38; N: R51/53-2,2'-IMINODIETHLYAMINE 203-865-4 111-40-0 Xn: R21/22; C: R34; Sens.:R43-4. First aid measures (Symptoms) 4.1 Description of first aid measures Skin contact Remove all contaminated clothes and footwear immediately unless stuck to skin Wash Immediately with plenty of soap and water. Consult a doctor Eye Contact Bathe the eye with running water for 15 minutes. Consult a doctor Ingestion Do not induce vomiting. Wash out mouth with water Consult a doctor. Inhalation Remove casualty from exposure ensuring one's own safety while doing so. If conscious ensure the casualty sits or lies down. Consult a doctor 4.2 Most important symptons and effects, both acute and delayed Skin contact There may be irritation and redness at the site of the contact Eye Contact There may be severe pain. Corneal burns may occur. May cause permanent damage Ingestion Corrosive burns may appear around the lips. There may be vomiting. Onset of symptons may be delayed by a few hours. It is unlikely that this substance will be swallowed due to its physical properties Inhalation Harmful by inhilation Delayed/immediate effects: 4.3 Indication of immediate medical attention and special treatment needed Immediate special treatment Show this safety data sheet to the doctor in attendance 5. Fire fighting measures Extinguishing media Carbon dioxide Dry chemical powder Alcohol resistant foam Exposure hazards In combustion emits toxic fumes of carbon dioxide, carbon monoxide. Protection of firefighters Wear self contained breathing apparatus Epoxy Resin Page 2 of 5 16/04/2013
6. Accidental release measures Personal precautions Refer to section 8 of SDS for personal protection details. Environmental precautions Do not discharge into drains or rivers. Clean up procedures. Transfer to a suitable container. Wash the area with water 7. Handling and Storage Handling Requirements Ensure there is sufficient ventilation in the area Storage conditions Store in a cool, well ventilated area away from heat. Keep away from sources of ignition Suitable packaging Must only be kept in original packaging Specific end use(s): Building and construction work (SU19) 8. Exposure controls/personal protection 8.1 Control perameters Hazardous ingredients: 2,2'Iminodiethylamine Workplace exposure limits Respirable dust State UK 4.3mg/m3 8 hour TWA 15 min. STEL 8 hour TWA 15 min. STEL - - - Engineering measures Ensure there is sufficient ventilation of the area Respiratory protection Self-contained breathing apparatus must be available in case of an emergency Hand protection Protective gloves Eye protection Safety goggles. Ensure eye bath is to hand Skin protection Enviromental Protective clothing Ensure all engineering measures mentioned in section 7 of SDS are in place 9. Physical and Chemical properties State Paste Colour Various Odour Characteristic odour Solubility in water Insoluble Also soluble in Most organic solvents Boiling point/range C >200 Flash point C >100 Relative density 1.25 Epoxy Resin Page 3 of 5 16/04/2013
10. Stability and reactivity Reactivity Stable under recommended transport or storage conditions Stability Stable under normal conditions Hazardous reactions Hazrdous reactions will not occur under normal transport or storage conditions Conditions to avoid Direct sunlight. Heat. Sources of ignition Materials to avoid Acids. Oxidising agents. Amines Haz. Decomp. Products In combustion emits toxic fumes 11. Toxicological information Relevant effects for mixture Effect Corrosivity Sensitisation Route OPT INH DRM DRM Basis Hazardous: calculated Hazardous: calculated Routes of exposure Refer to section 4 of SDS for routes of exposure and symptoms 12. Ecological information Ecotoxisity values not applicable Persistence & degradability No data available Bio accumulative potential Bioaccumulation potential Mobility Insoluble in water. Heavier than water PBT identification This substance is not identified as PBT substance Other adverse effects Toxic to aquatic organisms. May cause long term adverse effects in the aquatic environment 13. Disposal considerations Disposal operations Transfer to a suitable container and arrange for collection by a specialist disposal company. Small quantities of the product can be mixed and allowed to cure then disposed of as solid waste Waste code number 08 04 09 Disposal of packaging Dispose of in a regulated landfill site or othermethod for hazardous or toxic wastes. NB The users attention is drawn to the possible existence of regional or national regulations Epoxy Resin Page 4 of 5 16/04/2013
14. Transport Information UN no. UN1759 Shipping name CORROSIVE SOLID.N.O.S (BISPHENOL A-F EPOXY RESIN) Transport class 8 Packing group III Environmentally hazardous Yes Marine pollutant No Special precautions No special precautions Tunnel code E Transport category 3 15. Regulatory Information Specific regulations Chemical safety assesment A chemical safety assessment has not been carried out for the substasnce or mixture by the supplier 16. Other Information Other information This safety data sheet is prepared in accordance with Commission Regulation (EU) No. 453/210 Risk Phrases used in s.2 & 3 R20/22: Harmful by inhilation and if swallowed R21/22: Harmful in contact with skin and if swallowed R34: Causes burns R35: Causes severe burns R36/37/38: Irritating to eyes, respiratory system and skin R43: May cause sensitisation by skin contact R51/53: Toxic to aquatic organisms, may cause long-term adverse effets in the aquatic environment R52/53: Harmful to aquatic organisms may cause long-term adverse effects in the aquatic environment Legal disclaimer The above information is believed to be correct but does not purport to be all inclusive and shall only be used as a guide. The company shall not be held liable for any damage resulting from handling or from contact with the above product. Environmental care Please do not dispose of uncured material. If disposing please mix any waste product to its cured state Epoxy Resin Page 5 of 5 16/04/2013