C STYLE Linden D D STYLE Linden D 3 bedroom and/or Linden D D STYLE 4

Transcription

1 All work shall be completed to the most current approved building code for that designed trade work in Snohomish County, City of Everett, Washington State. Any activity that will affect any other neighboring units will need to have at minimum a 48 hour notice. Plan accordingly to give Everett Housing Authority staff enough time to generate these notices and deliver them. If conditions come up that are not normal or unexpected make sure to immediately notify the Everett Housing Authority s designated personnel. The Grandview Homes Development was constructed in the late 1950 s. All units are of similar construction and vary slightly in the floor plan. Over the past 15 years the Housing Authority has completed 133 of the 148 units of interior rehab. This project is for the remaining 15 units. Unit House Street Type # for each style B STYLE Locust B 1 story-2 bedroom Locust B B STYLE Linden C Linden C Linden C Locust C Locust C Locust C C STYLE 2 story-2 bedroom C STYLE Linden D D STYLE Linden D 3 bedroom and/or Pine D (accessible units) Linden D D STYLE 4 9th Street E E STYLE 9th 2 story-3 bedroom Street E Pine E E STYLE 3 UNITS PENDING 15 apx Square Footage-each ,086 Summary of Work

2 1: Asbestos and non-asbestos flooring material removal 2: Demolition Everett Housing Authority has completed many in house asbestos and lead surveys as well as hired consultants to conduct surveys. The drywall does has asbestos in the joint compound. As a system it is under 1%. This means removing a complete wall of drywall and not just patches and sections of the wall. The demo of the drywall is not considered an abatement project HOWEVER the use of water, heppa vacuum and proper PPE is required. The flooring in the units, most of the samples have come back as Positive for asbestos. Instead of continuing to sample the material in each unit we are presuming the flooring throughout to be Hot and thus needs to be abated. Throughout the units you will have one layer of VAT. There are areas that do contain multiple layers. Normally the top layer of VCT and mastic is Negative for asbestos but the bottom layer is Positive. Following state regulations for conducting abatement work needs to be adhered to. Typically up stairs the abatement is done by removing the first layer of underlayment making it much easier in the abatement process. Then the subfloor is renailed and then new 3/8 inch CDX plywood is installed. Turn off water Turn off gas Turn off electric to needed breakers (lock out-tag out) Demo and remove all light fixtures throughout the unit Demo and save trim around both front door and rear door Demo doors, jamb, trim, windows, casework, shelving, blinds Demo and remove cabinets from both the kitchen and the bathroom Demo and remove the shower doors and assembly from bathroom Demo and remove bath and utility room exhaust fans Demo all heat register covers, cold air covers and all outlet and switch covers Demo the tongue and groove cedar walls and ceilings in utility room Demo and remove all plywood closets through out Demo and remove trim underneath stair treads if applicable Demo and remove trim/casing around attic access Demo and remove all exterior walls and interior walls of drywall using the wet method and utilizing the hepa vacuum Party wall has 1/2 soundboard attached shall also be removed Summary of Work

3 3: Mechanical rough 4: Plumbing rough in. 5: Electrical rough in. 6: Carpentry and sheetrock. Demo and remove all ceiling drywall on both floors if applicable using wet methods and hepa vacuum Remove all nails, screw and attached objects from demo process Remove any cove base that remains 7: Installation of cabinets and laminates. 8: Flooring installation. 9: Mechanical, plumbing and electrical finish and trim. 1) All exterior walls must be demoed. a. Provide one price to remove all drywall throughout the unit including ceilings. b. Provide alternate price for cost to remove all drywall needed to complete electrical, plumbing, insulation and HVAC 2) Attic insulation: Upgrade existing to meet current insulation requirements 3) Water shut off should be located and if it is shared with the adjacent unit it needs to be separated. a. If it is a single shut off a new valve will be installed (See current plumbing scope). b. Contractor will need to verify remaining units that may share one water shut-off to be extended, i. Provide unit cost for a single shut-off and a price to install a splitter and creating 2 separate shut-offs to each individual unit. 4) Install draft stop between the units. Framing will be 24 inches on center and 5/8 drywall installed and fire taped. 5) On some units the electrical panel must be moved before framing. 6) Most of the framing is non bearing but there may be those instances where a bearing wall will be affected. Plan accordingly. 7) Put in backing where needed for cabinets, handrails, and other fixtures 8) In the bathroom install ½ inch acx plywood at the tub surround area unless it occurs in a demising wall and then 5/8 water board is installed. There is also a wall built on the edge of the bath tub eliminating the need for the three sided shower door. Make sure to maintain clearance for the toilet. Summary of Work

4 Specialties: 24 x36 mirror with polished edge and attachment brackets 30 x36 mirror with polished edge and attachment brackets Holcomb two panel shower enclosure 9) A separate contractor will install the windows. You will need to trim out with one by material creating a solid wood window box and then trimmed in 356 style molding. 10) In the bathroom install the Broan ZB110M and downstairs in the utility room will be installed the Broan ZB80M. 11) The utility room must have proper ventilation for combustion air. a. Use the 5 chimney duct lining kit through the chimney. This will vent both the furnace and the gas water heater. The gas line will need to be altered when we transition from electric to gas. b. Make sure to insulate all ducting where necessary per code requirements. 12) HVAC: HVAC: Day & Night ICP # N8MSL A - rambler Day & Night ICP # N8MSL A - two story Thermostat-digital-programmable 13) Electrical work consists of demo and removal of all old wiring and panel box. Completely rewire the unit to current code. This will include outlets, switches, telephone and cable as well as low volt for the furnace. Fixtures: 13W Fluorescent AFX lighting(hd#324512)-ext. light Nuvo light vanity fixture Nuvo light flush mount ceiling - hallway Nuvo light flush mount ceiling - bedrooms Nuvo light flush mount ceiling - kitchen sink Cooper APW-GPW232 - Kitchen/Utility 14) Exterior walls and party walls shall be insulated with R13 unfaced batts. Party walls need to have draft stop installed. a. Foam through holes both old and new from plumbing, electrical and others b. Insulate under the stairwell c. Insulate around the tub enclosure d. Insulate around chimney chase on both floors if applicable Summary of Work

5 15) Soffits are built in the kitchen to hide ducting. This framing will be constructed using 1 ½ X 1 ½ angle metal. 16) Drywall is completed throughout the unit. 17) Texture in the units is knockdown. 18) Paint: Must meet the Evergreen Sustainable Development Standard i. Sherwin-Williams: ProMar 400 Semi Gloss EHA Off White 19) All doors in this project are solid core doors. The trim is a 356 style of casing and needs to be real wood and not MDF. This goes for all doors and windows within the project. 20) Plumbing: Plumbing Fixtures: AO Smith ProMax Series 200/201 Model-GCV-50 ProFlo Kitchen Sink - PFSR clips for self rimming sinks - PFCLIP Niagara Stealth - NN7717WH & NN7714 Moen Chateau lavatory faucet/pop up #L64625 Moen Chateau chrom posi-temp tub/shower #L2369EP Sterling white composite drop-in Oval bath sink with overflow # Moen Chateau kitchen faucet #67425 American Standard Cambridge 5ft. # ) Formica backsplashes are installed behind the top and bottom cabinets protecting the walls. The countertops are pre-formed with waterfall front. Countertops are installed over 5/8 inch particleboard strips. The cabinet in the kitchen over the fridge has been changed in all units to a 33 cabinet from the old 30 as shown on the blueprints. a. Cornerstone Series with 100% plywood box construction, b. Door/Frame: solid raised panel, c. Drawer: Hardwood Dovetail drawer, d. Hanging rail-3/4 x 3 multi-ply hardwood plywood in wall cabinets, ¾ x 7 ¼ solid wood at top of base cabinets, e. Back panel-all cabinets-nominal 1/8 or ¼ multi-ply hardwood, f. Top and bottom panels-nominal ½ multi-ply hardwood, g. End panels-nominal ½ multi-ply hardwood dadoes to receive tops and bottoms, and inserted into face frame. Natural finish inside and outside, stained to match doors, h. Finish: Factory applied stain, sealer, and top coats. i. Color Selection: Medium Natural 22) Tub surrounds are one piece formica a. Wilsonart i. Color Selection: Tungsten EV. 23) Vertical blinds are installed throughout the unit. Mini blinds are installed at bathroom location as well as when there is a window above the kitchen sink. Summary of Work

6 Specialties: Alabaster vertical 3.5" with headband unit Alabaster horizontal 1" vinyl mini blind w/ metal headband 24) Appliances: Appliances: Broan 30" White range hood (190cfm) GE 18.0 cu. Ft. refridgerator - #GTH18EBEWW GE 30" ADA electric range - # JBS45DFWW HotPoint 30" Electric Range - RB525D Broan ZB110M Ultra Green 110CFM mutli speed fan Broan ZB80M 80CFM multi speed fan 24) Final cleaning is done. VCT is cleaned of scuff marks and after a final mopping, two coats of wax is applied. Technical Divisions may also contain additional information. Summary of Work