The laboratory fulfils the requirements for periodic emission measurement according to ČSN P CEN/TS 15675:2009

Transcription

1 Page 1 of 8 Testing laboratory working site: Working place 1: Technické služby ochrany ovzduší Praha a.s. Testing Laboratory for Measuring Pollutants, Jenečská 146/44, Praha Working place 3: Organizational unit Letná 27, , Košice, Slovensko The laboratory fulfils the requirements for periodic measurement according to ČSN P CEN/TS 15675:2009 Tests: The laboratory has a flexible scope of accreditation permitted as detailed in the Annex. Updated list of activities provided within the flexible scope of accreditation is available at the laboratory from the Quality Manager. The Laboratory is qualified to provide expert opinions and to interpret test results. 1* Determination of mass concentration of particulate matter in s by gravimetry 2a* Determination of mass components in s by NDIR method (NO a NO 2 ) (SO 2 ) (CO) (CO 2 ) (NO, NO 2, SO 2, CO 2, CO, O 2 ) IP 100/2005 (STN ISO 9096) (ČSN EN ) IP 200a/2005 (STN ISO 10396) (ČSN EN 15259) (ČSN ISO 10849) (ČSN ISO 7935) (ČSN EN 15058) (STN ISO 12039) (STN ISO12039)

2 Page 2 of 8 2b* Determination of mass components in s by chemiluminescence method (NO a NO 2 ) 2c* Determination of mass components in s by FID method (TOC) 2d* Determination of mass components in s by paramagnetic method (O 2 ) 2e* Determination of mass components in s by electrochemical method (NO,NO 2, CO,O 2 ) 2f* Determination of volume concentration of CO 2 by balance calculation from element analysis and amount of burned fuel IP 200b/2005 (STN ISO 10396) (ČSN EN 15259) (ČSN EN 14792) (ČSN ISO 12039) IP 200c/2005 (STN ISO 10396) (ČSN EN 15259) (ČSN EN 13526) (ČSN EN 12619) IP 200d/2005 (STN ISO 10396) (ČSN EN 15259) (ČSN EN 14789) (ČSN ISO 12039) IP 200e/2005 (SOP M-01) (ČSN EN ) IP 200f/2005 IP (OTN ŽP 2008)

3 Page 3 of 8 3a* Determination of the velocity and volume flow rate IP 300/2005 (ČSN ISO 10780) 3b* Determination of volume concentration of CO 2 by balance calculation from element analysis and amount of burned fuel 3c* Determination of the water vapour in ducts by manual electro-capacitance method 4 Reserved 5 E Determination of the mass concentration of gases and vapours taken into liquid by the calculation from measured values (SO 2 )* (HCl)* (HF)* (Ammonia)* (Sulfane)* (Cl 2 )* (HCN)* (HCOOH, CH 3 COOH)* (Total Reduced Sulphur)* IP (OTN ŽP 2008) (ČSN EN 14790, M-07) (SOP M-10) IP 500/2007 (ČSN EN 14791, ČSN ISO 7934) (ČSN EN 1911, ČSN ) (ČSN , STN ISO 15713) (ČSN ) (ČSN ) (ČSN ) (EPA CTM 33) (STN ) (EPA Met. 16A)

4 Page 4 of 8 6 Determination of the mass concentration of metals by the calculation from measured values (As, Cd, Cr, Co, Cu, Mn, Ni, Pb, Sb, Tl, V)* (Hg)* (Cr 6+ )* (Be, Se, Zn)* (Te, Sn)* 7 Determination of mass concentration of persistent organic compounds by the calculation from measured values (PCDD/PCDF, PCB)* (PAH)* 8 Determination of mass concentration of volatile organic compounds (VOCs*) by capture on solid sorbent by calculation from measured values 9 Reserved 10 Determination of concentration of odour substances by dynamic olfactometry 11* Demonstration of quality of IP 600/2006 (ČSN EN 14385) (ČSN EN 13211, EMEP) (EPA Met. 0061) (EPA Met. 29) (OTN ŽP 2028) IP700/2007 (ČSN EN 1948) (ISO 11338) IP 800/2007 (ČSN EN 13649) (ČSN EN ISO 16017) (EPA Met. 0011) IP 1000/2006 (ČSN EN 13725) IP 1100/2006 automated measuring systems

5 Page 5 of 8 automated measuring systems 12 Reserved 13* Measurement of operating efficiency of 2nd stage petrol vapour recovery system by "wet method" B (ČSN EN 14181) (art.6 (QAL2) art.8 (AST)) IP 1300/2012 (pren ) petrol vapours 1) Asterisk at the ordinal number identifies the tests performed outside the laboratory premises. 2) Asterisk at the test procedure name indicates that the laboratory determination of an analyte in the sample is subcontracted to an accredited testing laboratory. 3) Number one at the number of standard indicates that this standard applies to gas turbines only. Annex: Flexibility type: according to MPA Type 1 Type 2 Type 3 All testing procedures Ordinal numbers of tests Type 1 The laboratory can include updated standardised and/or technically equivalent test methods in the scope of accreditation provided the measuring principle is observed, Type 2 includes type 1. In addition, the laboratory can modify the existing test methods (both standardised and in-house procedures) and/or extend the range of tested parameters in given scope of accreditation provided the measuring principle is observed, Type 3 includes types 1 and 2. Furthermore, the laboratory can develop other test methods within the accredited tests. No changes can be made by the laboratory in the tests not included in the annex (fixed scope of accreditation). Sampling: Ordinal number Sampling procedure name 1 Sampling of solid pollutants in s (Isokinetic sampling with Sampling procedure identification IP 100/2005 (STN ISO 9096) Sampled object

6 Page 6 of 8 Ordinal number Sampling procedure name automatic or manual isokinetic control) 2 4 Reserved Sampling of gases and vapours by absorption of liquids (non-isokinetic and isokinetic sampling with automatic or manual isokinetic control) (SO 2 ) 5 (HCl) (HF) (Ammonia) (Sulfane) (Cl 2 ) (HCN) (HCOOH, CH 3 COOH) (Total Reduced Sulphur) Sampling procedure identification (ČSN EN ) IP 500/2007 (ČSN EN 14791, ČSN ISO 7934) (ČSN EN 1911, ČSN ) (ČSN , STN ISO 15713) (ČSN ) (ČSN ) (ČSN ) (EPA CTM 33) (STN ) (EPA Met. 16A) Sampled object

7 Page 7 of 8 Ordinal number Sampling procedure name 6 Sampling of metals by condensation absorption method (Isokinetic sampling with automatic or manual isokinetic control) (As,Cd, Cr, Co, Cu, Mn, Ni, Pb, Sb, Tl, V) (Hg) (Cr 6+ ) (Be, Se, Zn) (Te, Sn) 7 Sampling of persistent organic compounds by dilution method (Isokinetic sampling with automatic or manual isokinetic control) (PCDD/PCDF, PCB) (PAH) 8 Sampling of organic compounds by capture on a solid sorbent 9 Reserved 10 Sampling of odour substances Sampling procedure identification IP 600/2006 (ČSN EN 14385) (ČSN EN 13211, EMEP) (EPA Met. 0061) (EPA Met. 29) (OTN ŽP 2028) IP 700/2007 (ČSN EN ) (ISO ) IP 800/2007 (ČSN EN 13649) (ČSN EN ) (EPA Met. 0011) IP 1000/2006 (ČSN EN 13725) Sampled object

8 Page 8 of 8 Explanations and abbreviations: IP internal regulation SOP standard operating procedure NDIR nondispersive infrared spectrometry FID flame ionization detection VOCs volatile organic compounds TOC total organic carbon PCDD/PCDF polychlorinated dibenzodioxins/polychlorinated dibenzofurans PCB polychlorinated biphenyls PAH polycyclic aromatic hydrocarbons EMEP manual of sampling and chemical analysis Emission waste gas containing pollutants, which is released in a controlled way or leaks into atmosphere from air pollution sources air OTN ŽP branch technical standard of environment - SR OU organizational unit STN Slovak technical standard ČSN Czech technical standard EPA U.S. Environmental protection agency pren Draft European Standard