Use this guide to identify the internal and external network ports on your McAfee

Transcription

1 Port Identification Guide McAfee Firewall Enterprise 2011 Model Appliances Use this guide to identify the internal and external network ports on your McAfee Firewall Enterprise appliance (hereinafter Firewall Enterprise). Note: If this document does not contain your Firewall Enterprise model, check mysupport.mcafee.com for current and legacy Port Identification Guide documents. In this guide... S model appliances on page 2 S1104 on page 2 S2008 on page 2 S3008 on page 2 F model appliances on page 3 210F on page 3 410F, 510F, and RM700F on page F on page F and 2150F on page F on page 6 E model appliances on page 7 410E on page 7 510E on page 7 510E-Fib on page E-E on page E-X on page E-E Fib on page E and 2150E on page E-Fib and 2150E-Fib on page E on page E-Fib on page 12 McAfee Firewall Enterprise 2011 Model Appliances Port Identification Guide 1

2 S model appliances S model appliances Use the diagrams in this section to identify the internal and external network ports on your S model appliance. Note: Do not connect a network cable to the serial port. S1104 RS-232 serial Front view S2008 RS-232 serial Front view Management network Note: Do not use the management network port during initial firewall configuration. After initial configuration is complete, you can configure it to suit your needs. For instructions, refer to KnowledgeBase article KB70307 at mysupport.mcafee.com. S3008 Remote Management Module port RS-232 serial Front view Note: Management network Do not use the management network port during initial firewall configuration. After initial configuration is complete, you can configure it to suit your needs. The Remote Management Module provides IP-based health monitoring and maintenance features. You must configure the Remote Management Module before using it. For instructions, refer to KnowledgeBase article KB70307 at mysupport.mcafee.com. 2 McAfee Firewall Enterprise 2011 Model Appliances Port Identification Guide

3 F model appliances F model appliances Use the diagrams in this section to identify the internal and external network ports on your F model appliance. Your Firewall Enterprise model number is located on a label on top of the chassis. Find that model number in this guide, and use the corresponding diagram to identify your network ports. 210F on page 3 410F, 510F, and RM700F on page F on page F and 2150F on page F on page 6 210F 410F, 510F, and RM700F Four network cards are available for this appliance. Each card type has a unique label: HB, SB, SE, or HE. HB, SB, or SE label HE label McAfee Firewall Enterprise 2011 Model Appliances Port Identification Guide 3

4 F model appliances 1100F Six network cards are available for this appliance. Each card type has a unique label: HB, SB, SE, HE, SC, or HD. Note: The following diagrams apply to multiple port configurations, so the empty PCI slots shown below might be populated on your Firewall Enterprise appliance. HB, SB, or SE label HE label SC label HD label 4 McAfee Firewall Enterprise 2011 Model Appliances Port Identification Guide

5 F model appliances 2100F and 2150F Four network cards are available for this appliance. Each card type has a unique label: HB, SB, SE, or HE. Note: The following diagram applies to multiple port configurations, so the empty PCI slots shown below might be populated on your Firewall Enterprise appliance. HB, SB, or SE label HE label McAfee Firewall Enterprise 2011 Model Appliances Port Identification Guide 5

6 F model appliances 4150F Four network cards are available for this appliance. Each card type has a unique label: HB, SB, SE, or HE. Note: The following diagram applies to multiple port configurations, so the empty PCI slots shown below might be populated on your Firewall Enterprise appliance. HB, SB, or SE label HE label 6 McAfee Firewall Enterprise 2011 Model Appliances Port Identification Guide

7 E model appliances E model appliances Use the diagrams in this section to identify the internal and external network ports on your E model appliance. Your Firewall Enterprise model number is located on a label on top of the chassis. Find that model number in this guide and use the corresponding diagram to identify your network ports. If your appliance has an optional card, an additional identifier is added to the chassis label: X = PCI-X, E = PCIe, Fib = Fiber. For example, if your model is 1100E with a PCI-X card, the label on the appliance would read 1100E with an additional sticker reading X. You would use the diagram for 1100E-X. The following models are included in this section: 410E on page E-E Fib on page 9 510E on page E and 2150E on page 9 510E-Fib on page E-Fib and 2150E-Fib on page E-E on page E on page E-X on page E-Fib on page E This appliance is available in four-port and eight-port configurations. Four-port Eight-port 510E This appliance is available in four-port, six-port, and ten-port configurations. Note: The following diagram applies to multiple port configurations, so the empty PCI slot shown below might be populated on your Firewall Enterprise appliance. McAfee Firewall Enterprise 2011 Model Appliances Port Identification Guide 7

8 E model appliances 510E-Fib Two network cards are available for this appliance. Each card type has a unique label: SC or HC. Note: The following diagrams apply to multiple port configurations, so the empty PCI slots shown below might be populated on your Firewall Enterprise appliance. SC label HC label 1100E-E Two network cards are available for this appliance: one is unlabeled, the other is labeled HB or SB. Note: The following diagrams apply to multiple port configurations, so the empty PCI slots shown below might be populated on your Firewall Enterprise appliance. Unlabeled card Labeled card, HB or SB 8 McAfee Firewall Enterprise 2011 Model Appliances Port Identification Guide

9 E model appliances 1100E-X 1100E-E Fib 2100E and 2150E Two network cards are available for this appliance: one is unlabeled, the other is labeled HB or SB. Unlabeled card Labeled card, HB or SB McAfee Firewall Enterprise 2011 Model Appliances Port Identification Guide 9

10 E model appliances 2100E-Fib and 2150E-Fib Four network cards are available for this appliance: Two-port card Six-port card labeled SC Six-port card labeled HC Six-port card labeled HD Note: The following diagrams apply to multiple port configurations, so the empty PCI slots shown below might be populated on your Firewall Enterprise appliance. Two-port card Six-port card, SC label Six-port card, HC or HD label 10 McAfee Firewall Enterprise 2011 Model Appliances Port Identification Guide

11 E model appliances 4150E Two network cards are available for this appliance: one is unlabeled, the other is labeled HB or SB. Unlabeled card Labeled card, HB or SB McAfee Firewall Enterprise 2011 Model Appliances Port Identification Guide 11

12 E model appliances 4150E-Fib Two network cards are available for this appliance: one is unlabeled, the other is labeled HB or SB. Unlabeled card Labeled card, HB or SB For support information, visit mysupport.mcafee.com. Copyright 2010 McAfee, Inc. All Rights Reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form or by any means without the written permission of McAfee, Inc., or its suppliers or affiliate companies A00 12 McAfee Firewall Enterprise 2011 Model Appliances Port Identification Guide