Annex to the Accreditation Certificate D-PL according to DIN EN ISO/IEC 17025:2005

Transcription

1 Deutsche Akkreditierungsstelle GmbH Annex to the Accreditation Certificate D-PL according to DIN EN ISO/IEC 17025:2005 Period of validity: to Holder of certificate: Deutsche WindGuard Consulting GmbH Oldenburger Straße 65, Varel Tests in the fields: Measurement of Wind Turbine Power Curves; Wind Measurements at Sites and Potential Sites of Wind Turbines; Site Specific Energy Yield Evaluations for Wind Farms; Noise Emission Measurement and Noise Immission Measurement; Determination of Noise Immission; Determination of Shadow Immission; Site Suitability Studies; Determination of noise; Load Measurement on Wind Turbines Abbreviations used: see last page 1 Measurement of Wind Turbine Power Curves QM-PKL-MP-VA Rev. 011 Standard Operating Procedure Measurement of Wind Turbine Power Curves in connection with CD IEC Edition IEC This document is a translation. The definitive version is the original German annex to the accreditation certificate. 1/7

2 DIN EN IEC DIN EN Version FGW TR 2 Rev FGW TR5 Rev CDV IEC Version Wind Turbines - Part 12-1: Power Wind turbine generator systems - Part 12: Wind turbine power performance testing Wind turbine generator systems - Part 12: Wind turbines power performance testing Power Performance measurement procedure Technische Richtlinien - Teil 2: Bestimmung von Leistungskurve und standardisierten Energieerträgen Technische Richtlinien - Teil 5: Bestimmung und Anwendung des Referenzertrags Wind turbines - Part 12-2: Power based on nacelle anemometry Cup Anemometer Calibration Procedure 2 Wind Measurements at Sites and Potential Sites of Wind Turbines QM-PKL-MV-VA Rev. 010 Standard Operating Procedure Wind Measurements at Sites and Potential Sites of Wind Turbines FGW TR 6 Rev Version Technische Richtlinien - Teil 6: Bestimmung von Windpotenzial und Energieerträgen Evaluation of Site Specific Wind Conditions Period of validity: to Translation - 2/7

3 Version CD IEC Edition IEC st edition Cup Anemometer Calibration Procedure 3 Site Specific Energy Yield Evaluations for Wind Farms QM-PKL-EE-VA Rev. 005 Standard Operating Procedure Site Specific Energy Yield Evaluations for Wind Farms FGW TR 6 Rev Version Technische Richtlinien - Teil 6: Bestimmung von Windpotenzial und Energieerträgen Evaluation of Site Specific Wind Conditions 4 Noise Emission Measurement and Noise Immission Measurement QM-PKL-MN-VA Rev Standard Operating Procedure Noise Emission Measurement and Noise Immission Measurement IEC Ed CDV IEC Ed FGW TR 1 Rev Wind turbines - Part 11: Acoustic noise measurement techniques Wind turbines - Part 11: Acoustic noise measurement techniques Technischen Richtlinie für Windenergieanlagen - Teil 1: Bestimmung der Schallemissionswerte Period of validity: to Translation - 3/7

4 DIN EN ISO/IEC DIN DIN Beiblatt DIN amendment Measnet, V LAI DIN ISO IEA R&D Wind Recommended Practices Wind turbine generator systems - Part 14: Declaration of sound power level and tonality values of wind turbines Determination of rating levels from measurement data - Part 1: Noise immission in the neighbourhood Measurement and assessment of lowfrequency noise immissions in the neighbourhood - Guidelines for the assessment for industrial plants Acoustics - Determination of tonal components of noise and determination of a tone adjustment for the assessment of noise immissions Acoustic Noise Measurement Procedure Sechste Allgemeine Verwaltungsvorschrift zum Bundes-Immissionsschutzgesetz (Technische Anleitung zum Schutz gegen Lärm - ) Hinweise zum Schallimmissionsschutz bei Windenergieanlagen (Länderausschuss für Immissionsschutz) Acoustics - Attenuation of sound during propagation outdoors Recommended Practices for Wind Turbine Testing 10. Measurement of Noise Immission from Wind Turbines at Noise Receptor Locations Period of validity: to Translation - 4/7

5 5 Determination of Noise Immissions QM-PKL-PN-VA Rev Standard Operating Procedure Determination of Noise Immissions DIN ISO LAI Sechste allgemeine Verwaltungs-vorschrift zum Bundesimmissionsschutzgesetz (Technische Anleitung zum Schutz gegen Lärm - ) Acoustics - Attenuation of sound during propagation outdoors - Part 2: General method of calculation Hinweise zum Schallimmissionsschutz bei Windenergieanlagen (Länderausschuss für Immissionsschutz) 6 Determination of Shadow Immission QM-PKL-PS-VA Rev Standard Operating Procedure Determination of Shadow Immission LAI DIN VDI 3789 Sheet Hinweise zur Ermittlung und Beurteilung der optischen Immissionen von Windenergieanlagen (Länderausschuss für Immissionsschutz) Daylight in interiors - principles Environmental meteorology - Interactions between atmosphere and surfaces - Calculation of short-wave and long-wave radiation Vorgaben und Empfehlungen sowie Erlasse der Immissionsschutzbehörden der Bundesländer Period of validity: to Translation - 5/7

6 7 Site Suitability Studies QM-PKL-SA-VA Rev. 000 Standard Operating Procedure Site Suitability Studies IEC nd Edition 1998 IEC rd Edition IEC A1 3 rd Edition 2010 Procedure Version Wind turbine generator systems - Part 1: Safety Requirements Wind Turbines - Part 1: Design Requirements Wind turbines - Part 1: Design requirements Evaluation of Site Specific Wind Conditions 8 Determination of noise General administrative regulation on installations requiring licensing according to the German Industrial Code - Technical instructions on protection against noise - TA Noise VDI 2058 Sheet Assessment of working noise in the vicinity including the standards and guidelines listed in it BlmSchV (BGBl. I, P. 504) Sixth general administrative regulation of the Federal Immission Control Act - Technical instruction for the protection against noise - TA Noise including the standards and guidelines listed in it Fourth ordinance for the implementation of the Federal Immission Control Act (ordinance on plants requiring licensing) Period of validity: to Translation - 6/7

7 The listed test methods meet the requirements of the Special knowledge proofs for determinations in the field of immission control ( Module Immission Control ) as of 15 th September The competence is attested for Group V for the test and technical areas of activity regulated by the immission control Technical in charge: Deputy technical in charge: Stefan Kieselhorst Markus Meyer zu Himmern 9 Load Measurement on Wind Turbines QM-PKL-ML-VA Rev Standard Operating Procedure for Load Measurements on Wind Turbines and Safety and Function Tests IEC GL Wind Guidelines Edition 2010 IEC rd Edition Wind turbine generator systems - Part 13: Measurements of mechanical loads Germanischer Lloyd - Rules and Guidelines - IV: Industrial Services - Guidelines for the Certification of Wind Turbines - Chapter 10.5: Test of Turbine Behaviour Wind turbines - Part 1: Design Requirements Abbreviations used: BWE FGW IEA IEC QM Bundesverband Wind Energie Fördergesellschaft Windenergie International Energy Agency International Electrotechnical Commission International Network for Harmonised and Recognised Measurements in Wind Energy WindGuard Quality Management Period of validity: to Translation - 7/7