! encor e networks TM

Transcription

1 ! encor e networks TM Version A, March 2008 Document Part Number Copyright 2008 Encore Networks, Inc. All rights reserved. BANDIT II and BANDIT III Document Set List of Modules Note: For lists of documents within the modules, see the Detailed List of Modules. The BANDIT II and BANDIT III Document Set contains the following modules. A. Document Information Module B. Start-Up Module C. Product Overview Module D. BANDIT II Hardware Reference Module E. BANDIT III Hardware Reference Module F. General Hardware Reference Module G. Wireless Set-Up Module H. Software Configuration Module I. Routing Module J. VPN Configuration Module K. Software Management Module L. System Upgrade Module Detailed List of Modules Note: Each document resides in the home module for its main topic. Some documents are included in additional modules, to provide information in useful order for the additional topics. Documents retain numbering for their home modules. A Document Information Module Title Page Notices Copyrights and Trademarks For information on trademarks, safety, limitations of liability, and similar topics, see Notices.

2 b BANDIT II and BANDIT III Document Set Publication Notice Hardware Compliance Safety Information Product Warranty Technical Support Limitation of Liability Conventions Where to Find BANDIT Product Documentation B Start-Up Module Note: If quick installation is the principal concern, see the following: BANDIT II QuickStart Package BANDIT III QuickStart Package We strongly recommend that you review all documents listed below. However, the QuickStart guides, indicated in the list below, provide instructions for a quick, standard installation. (The QuickStart guides are also packaged by product, as shown in the list above.) TOC/LOT/LOF: Home Contents of the Start-Up Module 1 Start-Up Comments Basic Safety Guidelines Site Planning Worksheets BANDIT II Hardware Installation Guide [Adjunct A for QuickStart Guides] [Adjunct B for QuickStart Guides] [1 st of 2 QuickStart Guides for BANDIT II ] BANDIT III Hardware Installation Guide [1 st of 2 QuickStart Guides for BANDIT III ] Using FastCONNECT Using the ELIOS Software Activating a Wireless Card in a Carrier Network BANDIT Quick Software Configuration Guide Configuring a BANDIT Product for Virtual Private Networks ILR-100 /SignalPath Quick Setup Guide C Product Overview Module TOC/LOT/LOF: Home Contents of the Product Overview Module Document 1: The BANDIT Device in the Network [2 nd of 2 QuickStart Guides] 1. The home contents of this module are limited because most of the documents in this module are home documents of other modules.

3 Detailed List of Modules c Document A: Site Planning Worksheets Document B: Glossary Document C: Default Passwords D BANDIT II Hardware Reference Module TOC/LOT/LOF: Home Contents of the BANDIT II Hardware Reference Module (Document 1 of General Hardware Reference Module): Unpacking the BANDIT Chassis and Preparing It for Installation Document 1: BANDIT II Hardware Description (Document 4 of General Hardware Reference Module): Wireless Cards for BANDIT Products Document 2: BANDIT II Hardware Installation Guide Document A: BANDIT II Hardware Specifications (Document C of General Hardware Reference Module): Basic Safety Guidelines Adjunct module: General Hardware Reference Module E BANDIT III Hardware Reference Module TOC/LOT/LOF: Home Contents of the BANDIT III Hardware Reference Module (Document 1 of General Hardware Reference Module): Unpacking the BANDIT Chassis and Preparing It for Installation Document 1: BANDIT III Hardware Description (Document 2 of General Hardware Reference Module): Expansion Ports for the BANDIT Products (Document 3 of General Hardware Reference Module): HD26 Serial Expansion Port (Document 4 of General Hardware Reference Module): Wireless Cards for BANDIT Products Document 2: BANDIT III Hardware Installation Guide Document A: BANDIT III Hardware Specifications (Document A of General Hardware Reference Module): Changing the Card in a BANDIT Product s Expansion Slot (Document B of General Hardware Reference Module): Changing the SIM in a BANDIT Product s GSM Card (Document C of General Hardware Reference Module): Basic Safety Guidelines Adjunct module: General Hardware Reference Module F General Hardware Reference Module TOC/LOT/LOF: Home Contents of the General Hardware Reference Module Document 1: Unpacking the BANDIT Chassis and Preparing It for Installation

4 d BANDIT II and BANDIT III Document Set Document 2: Expansion Ports for the BANDIT Products Document 3: HD26 Serial Expansion Port Document 4: Wireless Cards for BANDIT Products Document A: Changing the Card in a BANDIT Product s Expansion Slot Document B: Changing the SIM in a BANDIT Product s GSM Card Document C: Basic Safety Guidelines Adjunct module: BANDIT II Hardware Reference Module Adjunct module: BANDIT III Hardware Reference Module G Wireless Set-Up Module 2 Wireless Cards for BANDIT Products Changing the Card in a BANDIT Product s Expansion Slot Changing the SIM in a BANDIT Product s GSM Card Activating a Wireless Card in a Carrier Network Basic Safety Guidelines H Software Configuration Module TOC/LOT/LOF: Home Contents of the Software Configuration Module Document 1: Using the ELIOS Software Document 2: BANDIT Quick Software Configuration Guide Document 3: Expanded Software Configuration Guide Document 4: Port Configuration Document 5: Protocol Configuration Document A: Supervisory Port Settings for the BANDIT Products Document B: Using FastCONNECT Document C: Configuring the BANDIT III Alarm Port Document D: Loading Software into a BANDIT Product Document E: Activating a Wireless Card in a Carrier Network Document F: ILR-100 /SignalPath Quick Setup Guide Document G: Setting a BANDIT Device Up as a Terminal Server (Expanded Guide) Special adjunct document: Remote Access to SignalPath Devices 3 Submodule: Routing Module Submodule: VPN Configuration Module 2. This module does not have a table of home contents, because all documents used in this module are home documents of other modules. 3. This document is from Encore Networks Signaling Documentation.

5 Detailed List of Modules e I Routing Module TOC/LOT/LOF: Home Contents of the Routing Module Document 1: Routing Configuration Document 2: IP Routing in the BANDIT Products Document 3: Routing with Frame Relay Document 4: X.25 Routing Document 5: Routing with SNA Document A: IP/VPN Policy Document B: IP Quality of Service Document C: Address Translation Document D: The BANDIT Device as Firewall Document E: Generic Route Encapsulation Note: The Routing Module is a submodule of the Software Configuration Module. J VPN Configuration Module TOC/LOT/LOF: Home Contents of the VPN Configuration Module Document 1: BANDIT Products in Virtual Private Networks Document 2: Configuring a BANDIT Product for Virtual Private Networks Document 3: Revising a BANDIT Product s VPN Configuration Document 4: Testing and Tracking VPN Connections (Document A of Routing Module): IP/VPN Policy Document A: VPNC Scenario for IPsec Interoperability Document B: Scenarios for Operation with a VPN Client Note: The VPN Configuration Module is a submodule of the Software Configuration Module. K Software Management Module TOC/LOT/LOF: Home Contents of the Software Management Module Document 1: System Management Document 2: Using the Telnet Protocol in a BANDIT Product Document 3: Configuring BANDIT Products for SNMP Document 4: Port Data Capture Document A: Monitoring Statistics for a BANDIT Product (Document D of Software Configuration Module): Loading Software into a BANDIT Product

6 f BANDIT II and BANDIT III Document Set L System Upgrade Module 4 Changing the Card in a BANDIT Product s Expansion Slot Changing the SIM in a BANDIT Product s GSM Card Loading Software into a BANDIT Product Basic Safety Guidelines 4. This module does not have a table of home contents, because all documents used in this module are home documents of other modules.