How To Write A Pcs Report

Size: px

Start display at page:

Download "How To Write A Pcs Report"

Felix Blankenship
3 years ago
Views:

1 Page : 1 of 6 PACS PACS Instrument Health Prepared by Checked by Approved by Approved by Approved by Name Function Date Signature H. Feuchtgruber, K. Okumura Authorized by O. H. Bauer PM Authorized by A. Poglitsch PI 04-Jun-08

Function Date Signature H. Feuchtgruber, K.

2 Page : 2 of 6 DISTRIBUTION RECORD Issue / Revision Draft 1.0 Distribution Date 04-Jun-08 Intern Extern Department Name Qty Company Name Qty MPE Bauer MPE Sturm MPE Poglitsch MPE Wiezorrek \ MPE Wieprecht Electronic Archives at Leuven

$Poglitsch MPE Wiezorrek \ MPE Wieprecht Electronic$

3 Page : 3 of 6 DOCUMENT CHANGE RECORD Issue / Date Rev. Draft Mar-08 Change Notice Number Modified Pages or Paragraphs Remarks / Nature of Change First draft Table of Content DISTRIBUTION RECORD...2 Intern...2 Extern Scope Applicable Documents Data Preparation Analysis of SPACON Report Analysis of general HK data Specific Analysis for Spectroscopy ODs Specific Analysis for Photometry ODs Instrument Health Report Content ANNEXES SPACON Report Trend Analysis Plots Selected Science Analysis Plots...6

..2 Extern...2 1 Scope...4 2 Applicable Documents...4 3 Data Preparation...4 4 Analysis of SPACON Report...4 5 Analysis of general HK data.

4 Page : 4 of 6 1 Scope This PACS ground segment operations procedure describes the required daily activities and data analysis in order to asses the general instrument health status. It shall be followed each time the data of a PACS OD becomes available after a DTCP. 2 Applicable Documents AD-1 PACS ICC Scenario during Operations, PICC-ME-SD-001 AD-2 PACS Hardware Implementation Plan, Draft AD-3 PACS User Manual, PACS-ME-UM Data Preparation - Get via still TBD path, the report of the MOC/SPACON daily basic health check procedure. - The data of the entire OD under investigation shall be accessible from within a PACS IA session. As a first step: - All TM(3,25) packets (house keeping) of PACS from the past OD - All TM(5,x) packets (events) of PACS from the past OD (x=1,2,4) - All TM(1,x) packets (TC verification) of PACS from the past OD (x=1,2,3,7,8) Second step: - All Level 0 data shall be available from within a PACS IA session 4 Analysis of SPACON Report The report of the SPACON will contain at least (see AD-3) all information about rejected commands and negative acknowledgements of sub-units from the past OD. It will also contain a list of all events TM(5,x) which have been issued by PACS during the past OD and possible recovery actions taken by the SPACON according to AD-3. Events of type TM(5,1) require to be checked and analyzed offline by the ICC member in charge of this PACS instrument health check monitoring. In case of other event sub-types or non-zero rejected commands and negative acknowledgements, the ICC manager has to be contacted in order to initiate further actions. 5 Analysis of general HK data PACS regular HK data shall be analyzed by means of the PACS Trend-analysis tool in PCSS. Important checks to be done for each OD: - Check that DM_CHOP_CUR_POS within limits

2 Applicable Documents AD-1 PACS ICC Scenario during Operations, PICC-ME-SD-001 AD-2 PACS Hardware Implementation Plan, Draft AD-3 PACS User Manual, PACS-ME-UM-002 3 Data Preparation - Get via still

5 Page : 5 of 6 - Check that DM_GRAT_CUR_POS within limits - Check duration of FW turns (via DM_FWSP_CUR_POS and DM_FWPH_CUR_POS) - Check CS1 and CS2 resistance (via DM_CS1_RES_VAL and DM_CS2_RES_VAL) - Plot all PACS temperature sensors for past OD: Listed on S2K AND PA and PA Compare results against expectations and previous ODs. Report any anomaly or unexpected behaviour to the ICC manager. 6 Specific Analysis for Spectroscopy ODs Only in case the past OD was running PACS spectroscopy, the following analysis should be done: - Plot all CRE dummy channel signals as a function of time during the past OD - Plot all CRE open channel signals as a function of time during the past OD - Print median and mean slopes of each OBSID within the past OD in order to identify possible saturation cases. Compare results against expectations and previous ODs. Report any anomaly or unexpected behaviour to ICC manager. 7 Specific Analysis for Photometry ODs Only in Case the past OD was running PACS photometry, the following analysis should be done. Compare results against expectations and previous ODs. Report any anomaly or unexpected behaviour to the ICC manager. 8 Instrument Health Report Content Title: Instrument Health Report AUTHOR: DATE: OD number: SUB-Instrument: (SPEC, PHOT, Non-Prime) Report body = results of analysis, if any 8.1 ANNEXES SPACON Report Just as copy of the original from MOC

Report any anomaly or unexpected behaviour to the ICC manager.

6 Page : 6 of Trend Analysis Plots See section Selected Science Analysis Plots See section 6 and 7.