GAS GRILL # Built-In NG Gas Grill Installation Guide NG NG. Assembly - Pg. 7

Transcription

1 GAS GRILL Built-In NG Gs Grill Instlltion Guide Assemly - Pg NG NG #5686 YOU MUST READ THIS OWNERS GUIDE BEFORE OPERATING YOUR GAS BARBECUE. DANGER If you smell gs:. Shut off gs to the pplince.. Extinguish ny open flmes.. Open lid. 4. If odor continues, keep wy from the pplince nd immeditely cll your gs supplier or your fire deprtment. Leking gs my cuse fire or explosion which cn cuse serious odily injury or deth, or dmge to property. WARNING:. Do not store spre LPG cylinder within 0 feet (m) of this pplince.. Do not store or use petrol or other flmmle liquids or vpors within 5 feet (8m) of this pplince. WARNING: Follow ll lek-check procedures crefully in this mnul prior to recue opertion. Do this even if the recue ws deler-ssemled. NOTICE TO INSTALLER: These instructions must e left with the owner nd the owner should keep them for future use. THIS GAS APPLIANCE IS DESIGNED FOR OUTDOOR USE ONLY. WARNING: Do not try to light this pplince without reding the Ignition Instructions section of this mnul /8/ NG AU - AUSTRALIA

2 BUILT-IN CUTOUT DIMENSIONS ISLAND STRUCTURE CONFIGURATION OPTIONS There re severl configurtion options for the grill nd gs supply ccess of your Islnd structure. The common options (A, B, C) re illustrted in the Islnd Structure Configurtion Options tle. A ISLAND STRUCTURE CONFIGURATION OPTION B C Summit 4-urner/6-urner grill Gs supply LOCATING YOUR GRILL When determining suitle loction for your Summit gs grill instlltion, give ttention to concerns such s exposure to wind, proximity to trffic pths, nd keeping ny gs supply lines s short s possile. Never locte the Summit gs grill in grge, reezewy, shed, under n unprotected overhng, or other enclosed re. Locte the grill nd structure so there is enough room to sfely evcute the re in cse of fire. CLEARANCE FROM SURFACES OR STRUCTURES WARNING: Clernce from ny surfce or structure is 4" (60 mm) from the ck nd sides of the grill. Refer to TYPICAL GAS SUPPLY INSTALLATION efore strting instlltion. WARNING: The structure, islnd, countertops, nd djcent work res for the uilt-in grill instlltion must e uilt from noncomustile mterils only. NOTE: If you hve questions on wht mterils re considered noncomustile, contct your locl uilding mterils supplier or fire deprtment. BUILT-IN STRUCTURE CUTOUT DIMENSIONS All dimensions re to finished surfces. WARNING: All countertop finished surfces must e constructed of noncomustile mteril. CLEARANCES 4" (60 mm) ny surfce 7" (686 mm) minimum for lid clernce BUILT-IN CUTOUT GENERAL DIMENSIONS TOLERANCES 4" (864 mm) 4" (067 mm) ±/4" (6 mm) 6" (94 mm) 6" (94 mm) mx 4 5/6" (68 mm) 4 5/6" (68 mm) ±/4" (6 mm)

3 GENERAL CONSTRUCTION DETAILS The Summit Built-In unit should e on site efore construction egins. For ese of instlltion, the grill will e pushed on its csters into the uilt-in structure. The instlltion of this grill requires level floor pd surfce () nd countertop surfce. The floor pd surfce must e constructed from solid mterils nd must e level nd smooth. Proper sugrde mterils must e used under the floor pd to prevent mterils from settling nd heving. Rotisserie Outlet If the supporting structure is going to hve n electricl outlet for rotisserie, it should e on the left side of the structure. BUILT-IN CUTOUT DIMENSIONS The recue illustrted my hve slight differences to the model purchsed. c BUILT-IN CUTOUT DETAILED DIMENSIONS " minimum* (60 mm) 4" minimum* (60 mm) DIMENSIONS 6 /" (49 mm) 6 /" (49 mm) /8" (8 mm) /8" (8 mm) 4 0 /" (67 mm) minimum 0 /" (67 mm) minimum 5 4 5/6" (68 mm) 4 5/6" (68 mm) 6 6" (94 mm) mximum 6" (94 mm) mximum 7 4" (864 mm) Built-In frme 4" (067 mm) Built-In frme For countertop tretment: recommended /4" (9 mm) overhng. Gs inlet c Access for electric on left hnd side 4

4 GAS SUPPLY BUILT-IN GAS LINE LOCATIONS Note: Leve n ccess in the islnd structure for gs supply nd regultor service tht is not inside the grill structure. Note: Are should e kept cler of shrp, jgged, or extremely rsive surfces to void possile dmge to gs supply lines. Exercise cution when pulling gs lines through uilt-in structure. TYPICAL NATURAL GAS SUPPLY INSTALLATION We recommend tht this instlltion e done y LICENSED professionl. Generl Specifictions For Piping Note - Contct your locl municiplity for uilding codes regulting outdoor gs grill instlltions. In sence of Locl Codes, you must conform to the ltest edition AS560/ AG-60. mnul shut-off vlve indoors should e instlled in the rnch fuel line in n ccessile loction ner the supply line. with yonet fittings, AGA # CAUTION: If young children re in the re, locking vlve should e considered. when gs connections re mde.. Note: The informtion provided in this mnul is generl for typicl instlltions. We cnnot cover ll possile instlltion ides. We recommend, prior to instlltion, tht you contct your municiplity for locl uilding codes nd your locl fire deprtment for instlltion verifiction. BUILT-IN GAS LINE LOCATIONS c TOLERANCES 6 /" (49. mm) 6 /" (49. mm) ±/8" (. mm) /8" (8.6 mm) /8" (8.6 mm) ±/8" (. mm) /" (6.5 mm) /" (6.5 mm) ±/8" (. mm) Pln view right Side view c Gs inlet

5 GAS SUPPLY CONNECTION CONNECT GAS SUPPLY A 58 inch (47. cm) corrugted gs line is connected to the mnifold of the grill. A) Hrd pipe the gs supply to n ccess for gs supply shutoff. B) Connect the gs supply line (from the gs supply shutoff) to the regultor. CONNECTION CHART 5 4 Front view of typicl nturl gs routing From gs supply Regultor 4 Gs Flow 5 Right side pnel of grill

6 VENTILATION WARNING: Ventiltion holes must e provided in the structure t the top nd ottom to provide ventiltion in the event of gs lek. Ventiltion holes cn e locted in low visiility re nd should e protected y screening mteril to prevent rodents nd insects from entering the structure. Air holes will lso help dry moisture. Note: These drwings re only reference. minimum of 00 squre inches (54 squre cm) of venting per side. re is not locked y interior supports of the structure. DANGER Filure to follow recommended minimum venting instructions cn cuse gs to collect in the structure in the event of gs lek. This my result in fire or n explosion which cn cuse serious odily injury or deth, nd dmge to property. VENTILATION ATTENTION: This product hs een sfety tested nd is only certified for use in specific country. Refer to country designtion locted on outer crton. These prts my e gs crrying or gs urning components. Plese contct Weer-Stephen Products LLC Customer Service Deprtment for genuine Weer-Stephen Products LLC replcement prt(s) informtion. WARNING: Do not ttempt to mke ny repir to gs crrying, gs urning, igniter components or structurl components without contcting Weer-Stephen Products LLC Customer Service Deprtment. Your ctions, if you fil to follow this Product Wrning, my cuse fire, n explosion, or structurl filure resulting in serious personl injury or deth s well s dmge to property. WEBER-STEPHEN PRODUCTS LLC Designed nd engineered y Weer-Stephen Products LLC Delwre limited liility compny, locted t 00 Est Dniels Rod, Pltine, Illinois U.S.A. Printed in U.S.A.