Industrial Rugged Metal USB

Transcription

1 Industrial Rugged Metal USB Generation 4 HERCULES-P Series Product Specification INDUSTRIAL Rugged Metal USB Flash Disk Generation 4 Version 01V0 Document No. 100-xRUFD-MPT4 November 2014 APRO CO., LTD. Phone: Fax:

2 This document is for information use only and is subject to change without prior notice. APRO Co., Ltd. assumes no responsibility for any errors that may appear in this document, nor for incidental or consequential damages resulting from the furnishing, performance or use of this material. No part of this document may be reproduced, transmitted, transcribed, stored in a retrievable manner or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written consent of an officer of APRO Co., Ltd. All parts of the APRO documentation are protected by copyright law and all rights are reserved. APRO and the APRO logo are registered trademarks of APRO Co., Ltd. Product names mentioned herein are for identification purposes only and may be trademarks and/or registered trademarks of their respective companies APRO Corporation. All rights reserved. Revision History Revision Description Date 1.0 Initial release 2014/11/14

3 Contents CONTENTS 1. INTRODUCTION SCOPE SYSTEM FEATURES FLASH MANAGEMENT TECHNOLOGY - STATIC WEAR LEVELING PRODUCT SPECIFICATIONS SYSTEM ENVIRONMENTAL SPECIFICATIONS SYSTEM POWER REQUIREMENTS SYSTEM PERFORMANCE SYSTEM RELIABILITY PHYSICAL SPECIFICATIONS CONFORMAL COATING INTERFACE DESCRIPTION APRO RUGGED METAL USB FLASH DISK INTERFACE PIN ASSIGNMENTS APPENDIX A: ORDERING INFORMATION PART NUMBER LIST PART NUMBER DECODER: APPENDIX B: LIMITED WARRANTY APRO Rugged Metal USB Flash Disk Generation 4 HERCULES-P Series 2014 APRO Co., Ltd.

4 Product Specification 1. Introduction APRO Industrial Rugged Metal USB Flash Disk Generation 4 HERCULES-P Series, is specified as 2.0 High Speed Device, Mass Storage Class; USB-IF (USB Implementers Forum), WHQL (Window Hardware Quality Labs), EMI and IP-54/ IP-68 waterproof tests certified. In addition to being as a removable storage device, RUFD - Generation 4 can also be configured as a bootable disk for system recovery. Also, its random access performance exceed the minimum requirement of Read Boost feature found in Microsoft Vista operating system, in which randomly access blocks of information are saved into RUFD - Generation 4 for boosting up the average performance. They are available in 128MB, 256MB, 512MB, 1GB, 2GB, 4GB, 8GB and 16GB capacities by Toshiba SLC Flash IC.. Rugged Metal USB - Generation 4 HERCULES-P Series also offers unique customization for OEM customers by laser carvings Scope This document describes the key features and specifications of Rugged Metal USB Generation 4 HERCULES-P Series System Features Full metal enclosure design to endure various rough environments IP-54 & IP-68 Waterproof metal casing design USB 2.0 interface downwards compatible to USB 1.1 USB 2.0 Mass Storage compliant Standard grade operating temperature 0 C to 70 C, and Industrial Grade, -40 C to +85 C Support partition management for Disk Lock and Password Protection Supports Ready Boost for Microsoft Vista O.S. Capacities from 128MB to 16GB 1.3. Flash Management Technology - Static Wear Leveling In order to gain the best management for flash memory, APRO Rugged Metal USB HERCULES-P Series supports Static Wear-leveling technology to manage the Flash system. The life of flash memory is limited; the management is to increase the life of the flash product. A static wear-leveling algorithm evenly distributes data over an entire Flash cell array and searches for the least used physical blocks. The identified low cycled sectors are used to write the data to those locations. If blocks are empty, the write occurs normally. If blocks contain static data, it moves that data to a more heavily used location before it moves the newly written data. The static wear leveling maximizes effective endurance Flash array compared to no wear leveling or dynamic wear leveling APRO Rugged Metal USB Flash Disk Generation 4 HERCULES-P Series 2014 APRO Co., Ltd.

5 Product Specification 2. Product Specifications For all the following specifications, values are defined at ambient temperature and nominal supply voltage unless otherwise stated System Environmental Specifications Table 1: Environmental Specification APRO Rugged Metal USB Flash Disk HERCULES-P Series Standard Grade SRUFDxxxG-MPCTC-4 Industrial Grade WRUFDxxxG-MPITI-4 Temperature Operating: Non-operating: 0ºC ~ +70ºC -20ºC ~ +80ºC -40ºC ~ +85ºC -50ºC ~ +95ºC Humidity Operating & Non-operating: 10% ~ 95% non-condensing Vibration Operating & Non-operating: 7 Hz to 2K Hz, 20G, 3 axes Shock Operating & Non-operating: 0.5ms, 1500 G, 3 axes 2.2. System Power Requirements Table 2: Power Requirement APRO Rugged Metal USB Flash Disk HERCULES-P Series DC Input Voltage (VCC) 100mV max. ripple(p-p) Standard Grade SRUFDxxxG-MPCTC-4 5V±10% +5V Current (Maximum average value) Reading Mode : Writing Mode : Idle Mode : 120 (max.) 139 (max.) 75 (max.) 2.3. System Performance Table 3: System Performances Data Transfer Mode supporting USB 2.0 Average Access Time 0.6 ms (estimated) Maximum Performance Capacity 128MB 256MB 512MB 1GB 2GB 4GB 8GB 16GB Sequential Read (MB/s) Sequential Write(MB/s) Note: (1). All values quoted are typically at 25 and nominal supply voltage. (2). Testing of the Rugged Metal USB Flash Disk maximum performance was performed under the following platform: - Computer with Intel i5 3.5GHz processor - Windows 7 Professional operating system APRO Rugged Metal USB Flash Disk Generation 4 HERCULES-P Series 2014 APRO Co., Ltd.

6 Product Specification 2.4. System Reliability Wear-leveling Algorithms Bad Blocks Management ECC Technology Endurance Data Retention Table 4: System Reliability Static Wear-leveling Supportive 72 bits per 1024 bytes Un-limited Read Cycles Endurance Management enables five years minimal useful life 10 years 2.5. Physical Specifications Refer to Table 5 and see Figure 1 for Rugged Metal USB Flash Disk HERCULES-P Series physical specifications and dimensions. Table 5: Physical Specifications of APRO Rugged Metal USB Flash Disk HERCULES-P Series Length: Width: Thickness: Weight: mm mm mm 25 g / 0.88 oz Figure 1: APRO Rugged Metal USB Flash Disk Generation 4 Dimension APRO Rugged Metal USB Flash Disk Generation 4 HERCULES-P Series 2014 APRO Co., Ltd.

7 Product Specification Conformal coating Conformal coating is a protective, dielectric coating designed to conform to the surface of an assembled printed circuit board. Commonly used conformal coatings include silicone, acrylic, urethane and epoxy. APRO applies only silicone on APRO storages products upon requested especially by customers. The type of silicone coating features good thermal shock resistance due to flexibility. It is also easy to apply and repair. Conformal coating offers protection of circuitry from moisture, fungus, dust and corrosion caused by extreme environments. It also prevents damage from those Flash storages handling during construction, installation and use, and reduces mechanical stress on components and protects from thermal shock. The greatest advantage of conformal coating is to allow greater component density due to increased dielectric strength between conductors. APRO uses MIL-I-46058C silicon conformal coating 3. Interface Description 3.1. APRO Rugged Metal USB Flash Disk interface APRO Rugged Metal USB Flash Disk is equipped with standard USB Type A connector. Figure 2: USB Type A Connector 3.2. Pin Assignments There are total of 4 pins in the USB Type A Connector. The pin assignments are listed in below table 6. Table 6 - Pin Assignments Pin Number Pin Name Function Pin 1 Vcc Power Pin 2 USB - The pairs are used to transmit Pin 3 USB + Address, Data and Command. Pin 4 Vss Ground APRO Rugged Metal USB Flash Disk Generation 4 HERCULES-P Series 2014 APRO Co., Ltd.

8 Appendix A: Ordering Information Appendix A: Ordering Information 1. Part Number List APRO Rugged Metal USB Flash Disk Generation 4 HERCULES-P Series Product Picture Grade Standard grade (0ºC ~ 70ºC) Industrial Grade ( -40ºC ~ +85ºC ) 128MB SRUFD128M-MPCTC-4(/C) WRUFD128M-MPITI-4(/C) 256MB SRUFD256M-MPCTC-4(/C) WRUFD256M-MPITI-4(/C) 512MB SRUFD512M-MPCTC-4(/C) WRUFD512M-MPITI-4(/C) 1GB SRUFD001G-MPCTC-4(/C) WRUFD001G-MPITI-4(/C) 2GB SRUFD002G-MPCTC-4(/C) WRUFD002G-MPITI-4(/C) 4GB SRUFD004G-MPCTC-4(/C) WRUFD004G-MPITI-4(/C) 8GB SRUFD008G-MPCTC-4(/C) WRUFD008G-MPITI-4(/C) 16GB SRUFD016G-MPCTC-4(/C) WRUFD016G-MPITI-4(/C) 2. Part Number Decoder: X1 X2 X3 X4 X5 X6 X7 X8 X9-X11 X12 X13 X14 X15-Z1-C X1 : Grade S: Standard Grade operating temp. 0º C ~ 70 º C W: Wide Temp Grade- operating temp. -40º C ~ +85 º C X2 : The material of case R : Rugged Metal X3 X4 X5 : Product category UFD : USB Flash Disk X6 X7 X8 X9 : Capacity 128M: 128MB 002G: 2GB 256M: 256MB 004G: 4GB 512M: 512MB 008G: 8GB 001G: 1GB 016G 16GB X11 : Controller M : SMI (HERCULES-P Series) X12 : Controller version A, B, C.. X13 : Controller Grade C : Commercial grade I : Industrial grade X14 : Flash IC T : Toshiba SLC-NAND Flash IC X15 : Flash IC grade / Type C : Commercial grade I : Industrial grade Z1 : Housing Generation 4 : Generation 4 Housing C : Reserved for specific requirement C : Conformal-coating APRO Rugged Metal USB Flash Disk Generation 4 HERCULES-P Series 2014 APRO Co., Ltd.

9 Appendix B: Limited Warranty Appendix B: Limited Warranty APRO warrants your Rugged Metal USB Flash Disk against defects in material and workmanship for the life of the drive. The warranty is void in the case of misuse, accident, alteration, improper installation, misapplication or the result of unauthorized service or repair. The implied warranties of merchantability and fitness for a particular purpose, and all other warranties, expressed or implied, except as set forth in this warranty, shall not apply to the products delivered. In no event shall APRO be liable for any lost profits, lost savings or other incidental or consequential damages arising out of the use of, or inability to use, this product. BEFORE RETURNING PRODUCT, A RETURN MATERIAL AUTHORIZATION (RMA) MUST BE OBTAINED FROM APRO. Product shall be returned to APRO with shipping prepaid. If the product fails to conform based on customers purchasing orders, APRO will reimburse customers for the transportation charges incurred. WARRANTY PERIOD: SRUFDxxxx-MPCTC-4(/C) 3 years WRUFDxxxx-MPITI-4(/C) 5 years The warranty period is able to extend. Please contact APRO and/or Your APRO distributors for more information APRO Rugged Metal USB Flash Disk Generation 4 HERCULES-P Series 2014 APRO Co., Ltd.