SCOPE OF ACCREDITATION TO ISO/IEC 17025:2005

Transcription

1 SCOPE OF ACCREDITATION TO ISO/IEC 17025:2005 TUV RHEINLAND OF NORTH AMERICA INC. 12 Commerce Road Newtown, CT Mr. Bruce Fagley: x ELECTRICAL Valid to: August 31, 2018 Certificate Number: In recognition of the successful completion of the A2LA evaluation process, (including an assessment of the laboratory s compliance with A2LA s ENERGY STAR Accreditation Program requirements 1 accreditation is granted to this laboratory to perform the following energy efficiency, product safety, and electromagnetic compatibility (EMC) tests: Test Description: Test Method(s) 2 : Emissions 3 Radiated and Conducted (up to 40 GHz) 47 CFR, FCC Part 15B (using ANSI C ); 47 CFR, FCC Part 18 (using FCC MP-5, 1986); ICES-003, Issue 6; IEC/CISPR 11; EN 55011; AS/NZS CISPR 11; AS/NZS CISPR 11:2004; IEC/CISPR 14-1; AS/NZS CISPR 14.1:2010; EN ; EN 55022; IEC/CISPR 22; AS/NZS CISPR 22; CISPR 22; CAN/CSA-CEI/IEC CISPR 22; EN 55032; CISPR 32; KN 32; CNS (up to 6 GHz); CNS ; VCCI V-3 (up to 6 GHz); TCVN 7189:2009 (CISPR 22:2006); KN 11; KN 14-1; KN14-2; KN 22 Current Harmonics IEC ; EN ; EN Flicker and Fluctuations IEC ; EN ; EN Immunity 3 Electrostatic Discharge IEC ; EN Radiated (up to 6 GHz) Electrical Fast Transient / Burst IEC ; EN IEC ; EN (A2LA Cert. No ) Revised 11/30/2016 Page 1 of 6

2 Test Description: Test Method(s) 2 : Immunity 3 (cont.) Surge IEC ; EN Conducted IEC ; EN Power Frequency Magnetic Field Voltage Dips, Short Interrupts, and Voltage Variations Conducted, Common Mode Disturbances (0 to 150) KHz IEC ; EN IEC ; EN IEC ; EN Generic / Product Specific KN 24; KN 35; EMC Standards 3,4 EN ISO 14982; EN ; EN ; EN ; EN ; EN ; EN 50270; EN ; EN ; EN ; EN/IEC ; KN ; EN ; EN ; KN ; EN ; KN ; EN ; KN ; EN ; KN ; EN ; EN ; EN ; EN ; EN ; EN/IEC ; EN/IEC ; EN ; CISPR 12; EN 55013; EN 12016; EN ; EN 60945; KN 60945; IEC 60533; KN 60533; EN 50428; EN ; EN 61547; EN ; EN 55020; EN 55024; EN 12895; ISO 13766; EN ; ETSI EN ; ETSI EN ; EN 1155; EN 62233; IDA TS EMC (Singapore); EN , KN (only clauses 5.3, 6.1); EN 50293; EN (only clauses 4.13 & 5.13) Testing for the above Generic / Product Specific EMC standards is via the Emissions and Immunity test methods. (A2LA Cert. No ) Revised 11/30/2016 Page 2 of 6

3 Test Description: Test Method(s) 2 : Product Safety Household EN/IEC/CSA/UL : General Requirements; EN/IEC/CSA : Vacuum Cleaners and Water Suction Cleaning; EN/IEC/CSA/UL : Shavers, Hair Clippers; EN/IEC/CSA : Grills, Toasters and Similar; EN/IEC/CSA : Floor Treatment and Wet Scrubbing Machines; EN/IEC/CSA : Kitchen Appliances; EN/IEC/CSA : Appliances for Heating Liquids; EN/IEC/CSA : Appliances for Skin or Hair Care; EN/IEC/CSA : Sewing Machines; EN/IEC/CSA : Battery Chargers; EN/IEC/CSA : Room Heaters; EN/IEC/CSA : Massage Appliances; EN/IEC/CSA : Pumps; EN/IEC/CSA : Commercial Forced Convection Ovens, Steam Cookers and Steam-Convection Ovens; EN/IEC/CSA : Clothes Dryers and Towel Rails; EN/IEC/CSA : Ironers; EN/IEC/CSA : Portable Heating Tools and Similar Equipment; EN/IEC/CSA : Oral Hygiene Appliances; EN/IEC/CSA : Whirlpool Baths; EN/IEC/CSA : Commercial Electric Kitchen Machines; EN/IEC/CSA : Air Cleaning Appliances; EN/IEC/CSA : Commercial Dispensing Appliances and Vending; EN/IEC/CSA : Fans; EN/IEC/CSA : Foot Warmers and Heating Mats; EN/IEC/CSA : Amusement Machines and Personal Service Machines; EN/IEC/CSA : Toilets; EN/IEC/CSA : Drives for Vertically Moving Garage Doors; EN/IEC/CSA : Drives for Rolling Shutters, Awnings, Blinds Information Technology EN/IEC/CSA/UL ; EN/IEC/CSA/UL ; EN/IEC/CSA/UL ; EN/IEC/CSA/UL ; EN/IEC 62040; IEC/UL Audio / Video EN/IEC/CSA/UL Lab, Test & Measurement IEC/EN/CSA/UL ; IEC/EN/CSA/UL ; IEC/EN ; IEC/EN (A2LA Cert. No ) Revised 11/30/2016 Page 3 of 6

4 The below tests are performed using the above Product Safety standards - Input Current - Steady Force Test - Durability of Markings - Drop Test - Access to Live Parts - Stress Relief - Energy Hazards - Wall or Ceiling Mounted Equipment - Capacitance Discharge - Handles and Manual Controls - TNV Circuits, Limits, Connections, Voltages Generated Externally - Battery Overcharge / Discharge and Reverse Current Measurements - SELV Circuits - Spillage Tests - Telecommunication Network Separation and Protection - Protection Against Hazardous Moving Parts - Limited Current Circuits, Values - Thermal Requirements - Limited Power Sources - Temperature Rise - Resistances of Earthing Conductors - Resistance to Abnormal Heat - Component Failure and Abnormal Operation - Touch Current and Protective Conductor Current - Creepage Distances, Clearances - Electric Strength - Working Voltage - Humidity Conditioning - Thermal Cycling and Thermal Aging - Fluid Pressure and Leakage - Mechanical Strength - Voltage Surge / Impulse - Enclosed and Sealed Parts - Stability - Ionizing Radiation - Sound Pressure Level - Torque - Resistance to Fire - Power Supply Output / Transformer / Accessible Connector Overload Excluded Measurements: - Laser - Vibration - Photobiological - Oxygen Bomb - Cord Reel - Specially Protected Equipment (IP rated) (A2LA Cert. No ) Revised 11/30/2016 Page 4 of 6

5 Test Description: Test Method(s) 2 : Energy Efficiency Verification Testing for Canada IEC/EN 62301; CAN/CSA C ; CAN/CSA C802.2 California Efficiency Commission (CEC) Efficiency Testing Product Family Guidelines: Consumer Audio & Video Large Battery Charger Systems Portable Electric Spas Supporting Test Method(s): IEC 62087:2002(E) Energy Efficiency Battery Charger System Test Procedure Version 2.2 dated November 12, 2008 CEC Appliance Efficiency Regulations Section 1604(g)(2) Power Supplies US EPA Test Method dated Small Battery Charger Systems 10 CFR (aa) - Appendix Y to Subpart B of Part 430, Uniform Test Method for Measuring the Energy Consumption of Battery Chargers Televisions 10 CFR Section (h) (Appendix H to Subpart B of Part 430) EPA ENERGY STAR Testing Product Family Supporting Test Methods(s): Guidelines: Computers ENERGY STAR Program Requirements for Computers Version 6.1; ENERGY STAR Test Method for Computers (August 2014) With reference to IEC (2011); IEC62623(2012); IEC (1997); EPRI Generalized Test Protocol for Calculating the Energy Efficiency of Internal AC-DC and DC-DC Power Supplies Enterprise Servers Imaging Equipment ENERGY STAR Program Requirements for Computer Servers Version 2.0; ENERGY STAR Test Method for Computer Servers (April 2013) With reference to IEC (2011); Standard Performance Evaluation Corporation (SPEC) most current Server Efficiency Rating Tool (SERT); EPRI Generalized Test Protocol for Calculating the Energy Efficiency of Internal AC-DC and DC-DC Power Supplies ENERGY STAR Program Requirements for Imaging Equipment Version 2.0; Test Method for Determining Imaging Equipment Energy Use (September 2014) With reference to IEC (2011) (A2LA Cert. No ) Revised 11/30/2016 Page 5 of 6

6 1 A2LA provides accreditation to the U.S. EPA s Conditions and Criteria for Recognition of Laboratories for the ENERGY STAR Program by verifying an organization s compliance to A2LA document R222 - Specific Requirements - EPA ENERGY STAR Accreditation Program and to the related test methods listed above. Accreditation by A2LA does not infer Recognition by the EPA for ENERGY STAR testing. Please verify this organization s recognition status at the EPA s website, located at 2 When the date, revision or edition of a test method standard is not identified on the scope of accreditation, the laboratory is required to be using the current version within one year of the date of publication, per part C., Section 1 of A2LA R101 - General Requirements - Accreditation of ISO-IEC Laboratories. 3 Field testing services are available for this test and this laboratory meets A2LA R104 General Requirements: Accreditation of Field Testing and Field Calibration Laboratories for this test. 4 For Product Family Standards listed on this scope of accreditation, the laboratory is found to be compliant with all test methods referenced within the Product Family Standard. As such, if outdated versions of the specific test methods are identified by the Product Family Standards listed on this scope of accreditation, it is not necessary to explicitly list the outdated versions of the specific test methods on the scope. In addition, the laboratory is capable of issuing accredited test reports to the outdated versions of the specific test methods although the outdated versions are not listed on this scope of accreditation. (A2LA Cert. No ) Revised 11/30/2016 Page 6 of 6

7 Accredited Laboratory A2LA has accredited TUV RHEINLAND OF NORTH AMERICA INC. Newtown, CT for technical competence in the field of Electrical Testing This laboratory is accredited in accordance with the recognized International Standard ISO/IEC 17025:2005 General requirements for the competence of testing and calibration laboratories. This laboratory also meets the A2LA R222 - Specific Requirements - EPA ENERGY STAR Accreditation Program. This accreditation demonstrates technical competence for a defined scope and the operation of a laboratory quality management system (refer to joint ISO-ILAC-IAF Communiqué dated 8 January 2009). Presented this 17 th day of November President and CEO For the Accreditation Council Certificate Number Valid to August 31, 2018 For the tests to which this accreditation applies, please refer to the laboratory s Electrical Scope of Accreditation.