The world s first. Technology

Transcription

1 CO2 Fractional Laser System The world s first Ablation + Non-Ablation Technology

2 New Stream of skin rejuvenation Conventional CO2 Laser >>> An excessive ablation Ablative Er-YAG >>> Low thermal effect Early 1980 s Non Ablative PDL >>> Less approval IPL >>> Poor effectiveness Skin Laxity IPL >>> Poor effectiveness RF >>> Only thermal effect Fraction Er-Glass >>>>>>> Less penetration CO2 Fractional >>>>>>> Ideal ablation and better penetration!! 21 century

3 Why CO 2 Fractional? High Conventional CO 2 Lasers CO 2 Fractional w/ RF + IR (Qray) EFF FECTIVENE ESS Chemical Peels Er-YAG RF Machines IPL Low SAFETY High

4 Why CO 2 Fractional? Ablative Erbium 2940nm Erbium (2940nm) is very ablative. In fact, it is so ablative that minimal heat is deposited in the dermis (therefore, no collagen stimulation) Non-ablative Erbium (1520nm, 1540nm) CO2 10,600nm CO2 provides an ideal combination of epidermal ablation and heat to the dermis Near-infrared wavelengths (from g ( 1064nm 1600nm) provide NO ablation (no immediate contraction) and only provide heat

5 Fractional Laser System About Qray-FRX Qray-FRX is the world s first ablation and non-ablation combined technology. Qray-FRX is combined with two main technologies for not only re-surfacing but also collagen re-modeling. CO 2 fractional laser is a perfect solution of all fractional procedure. In order to reduce thermal damage and to enhance the beam quality, Qray adopts 5 different scanning modes including random and double-line line,and equipped with RF tube In consideration of collagen re-modeling, Qray-FRX adopts also IR +RF technology. This technology benefits skin lifting by the role of infra-red red and radio frequency as the stimulation of dermis layer without epi-dermal damages. Ablation Non-ablation Synergy Effect CO 2 Fractional IR+RF Q-ray FRX 5 Scan Mode & High beam Quality Dual RF bipolar Ablation & Non-ablation Harmony

6 Fractional Laser System IR + RF hand piece Co2 Fractional Laser hand piece 10.4 LCD Touch Screen

7 Fractional Laser System Why Q-ray FRX? Qray-FRX provides 3 independent d functions in one integrated t platform Fractional Mode Conventional CO 2 Mode RF with IR Mode Laser Power : 1 ~ 30 Watts (step 1) Pixel Pitch : 0.5 ~ 2.0 mm (step 0.1) Dot Cycle : 1 ~ 5 time(step 0.1) Figure : Scanning Pattern : Aiming Beam : 1 ~ 10 (step 1) CW Mode Operation : Single or Continuous Laser Power : 1 ~ 10 Watts (step 1) On time : 0.1 ~ 1 sec. (step 0.05) Pulse Mode Laser Power : 1 ~ 10 Watts (step 1) Frequency : 1 ~ 20 Hz (step 1) Pulse Duration : 10 ~ 50 ms (step 2) Light (I.R.) : 1 ~ 3 (step 1) RF Power : 10 ~ 150 J/cm 2 (step 5) Cooling : 3 Steps (1,3,5, degree) Repetition : Auto / Manual

8 Fractional Mode To be the best quality of fractional laser? Qray has them all!! 1 st consideration 2 nd Consideration 3 rd Consideration 4 th Consideration Are each sizes of laser beam uniform? Are each laser beams spread uniformly and equally on all over spot? Is each spot size small enough? Does it have various scanning mode to reduce the thermal damage? Beam hole Heat deposited High risk of thermal damage on overlapped area!! Does it need any solution?

9 Fractional Mode What is the key factor to have the best beam quality? Galvanometer for Scanner CO 2 Laser Tube Micro Lens A laser beam quality is absolutely depend on tube, scanner and micro lens!!

10 Fractional Mode About CO 2 Laser Tube Water cooling Merit 1) Simple manufacturing process 2) Low cost!! Sealed Glass DC Tube Demerit 1) Unstable laser power 2) CO 2 mixture gases corrode electrode 3) CO 2 mixture gases are dwindling naturally Regular replacement is necessary!! Air cooling Merit 1) A high and stable laser power by high pressed waveguide RF and fast pumping 2) Permanent life cycle by metal sealed off 3) Compact size Waveguide RF Tube Demerit 1) High cost

11 Fractional Mode About Scanning Mode Fractional laser Beam Heat deposited Thermal Damage High risks of thermal damage on the overlapped heat deposited area!! Q-ray FRX s unique scanning system Standard Breeze Refresh Random Double

12 Light Mode INFRA RED + RADIO FREQUENCY

13 Light Mode What is LIGHT (IR+RF) mode for? CO 2 fractional laser effects on epi-dermal layer dramatically but, there is some limitation to effect on deep dermis layer. That is, CO 2 fractional laser has an excellent result for the resurfacing procedure such as acne scar and wrinkle treatment. On the other hand, in fact CO 2 fractional method is not the best for the procedures that requires collagen remodeling such as skin rejuvenation. To overcome this kind of weak point by the characteristic of CO 2 fractional laser, Qray-FRX has come to adopt RF + IR technology combined on fractional platform. CO 2 fractional laser Radio Frequency with Infra Red working range working range

14 Light Mode How does the IR+RF work? Qray-FRX s IR+RF has adopted the technology that radiate high radio frequency and infra red ray at the same time to maximize the cure effect of skin tissue. This new type of method supplements the weak point of existing high frequency method, and more powerful IR ray is being used to deliver thermal effect into DERMIS layer for the formation of collagen. Qray-FRX s RF is equipped with 2 pairs of bi-polar electrodes and enable RF energy to deliver onto dermis layer more efficiently and deeper. RF + IR Fibroblast stimulation Collagen Elastin Fiber generation Wrinkle improvement

15 Light Mode How does the IR+RF work? Energy Energy RF 100ms 1. Cooling system Protect Epidermis layer from the heat Switchover to Standby Mode automatically when the temp. of skin surface gets high. IR 350ms Time Time 2. Infra Red Ray (700 ~ 2000 nm) Increase the temp of Dermis layer Act as a guide of RF Dermis Epi- dermis Subcutaneous 3. RF- Bipolar Diode 1MHz Focused stimulation on the heated dermis layer

16 Light Mode How does the IR+RF work? 1 st Stage Cooling Effect Protect epidermis layer from the heat Keep maintaining epi-dermis cool and dermis warm 2 nd Stage I R transmitting I R, wave length of 700 ~ 2000 nm penetrates only up to dermis layer It enables RF energy to reach to dermis layer more efficiently 3 rd Stage R.F. transmitting RF current seeks and flows into an area of low resistance, which is heated by IR Provide treatment without pain and anxiety of erythema & edema

17 Light Mode Advantages of the IR+RF Dual type bipolar RF system It detects the existing high radio frequency energy, applies more energy, and transmits thermal effect into the dermis layer and makes collagen be reformed more efficiently. Light Hand-piece It is designed ergonomically with light weight for long time operation. Less pain for patients, No side effects such as erythema and edema Dual type bipolar consists of 2 pairs thus the energy delivery is diversified to each side of bipolar pair, which means that the patient feels less pain. Easy to operation on display panel It can be controlled by touch screen for the selection of operation mode, the strength of power and the degree of cooling. No consumable parts are required Qray-FRX s handpiece guarantees up to 1 million shots of IR.

18 Fractional & IR + RF system Qray-FRX FRX s Specification CO 2 Fractional Laser IR + RF Laser Type Ultra Pulse, nm RF Electrode Dual Bipolar Co2 Tube All metal sealed off waveguide RF Tube RF Output 150J/ cm2 Ultra Pulse Power Max. 30W IR wavelength 700 ~ 2000nm Pulse Duration 20 ~ 400 μs Spot size 12 x 8mm Scanning size 3x3mm ~ 20x20mm Skin Impedance Online control Dot Pitch ~20mm ~2.0mm Repetition Rate 0.5,0.7, sec, Manual Scan mode Standard, Refresh, Breeze, Chill, Double Cooling Contact cooling, LCD Touch Screen

19 Fractional & IR + RF system Qray-FRX FRX s application (recommendation) CO 2 Fractional laser Scars (acne, Surgical, Burn) Pigmented skin Winkle Pores minimization Skin Tone & Texture Stretch Mark Fractional Skin Resurfacing Infra Red + Radio Frequency Winkle Facial Lifting Acne Pores minimization Main Treatment area ; -. Epi-dermis layer Main Treatment area ; -. Dermis layer -. Superficial dermis layer -. Hypo-dermis layer

20 Fractional & IR + RF system Qray-FRX FRX s advantages 1. Economical expectation ti 1-1. Three functions (CO 2 fractional laser, conventional CO 2 laser and IR + RF), are in one platform No additional accessories and No consumable parts are necessary. ( ex. Handpiece tip or, CO 2 tube ) 2. Operational efficiency 2-1. With integrated one platform, three kinds of procedure are available much faster. (ex. IR+RF procedure Fractional procedure > Conventional CO 2 procedure) 2-2. Using scatter mode, much faster procedure is available in fractional mode By the function of auto repetition mode (0.5/0.7/1.0sec), operation time for IR+RF procedure is nearly 3 times faster than others Multi-therapy with other equipment is available Qray-FRX CO 2 Fractional IR + RF Other equipments Thermage, Polaris or MTS Existing fractional, IPL or Thermage CO 2 Fractional IR + RF Conventional CO 2

21 Fractional & IR + RF system Qray-FRX FRX s advantages 3. System safety 3-1. Waveguide RF tube : Adopting high power RF tube, the beam quality is superior than DC tube and laser beam is thinner and uniform thus, patients feel less pain and minimize side effects Various scanning modes : Qray-FRX s unique scanning modes prevent patients from thermal damages safely Dual bipolar electrode and contact cooling system : In IR+RF procedure, these two functions protect epi-dermis layer from the burning might be happened by overheat. 4. Easy maintenance 4-1. Qray-FRX has an access port for convenient diagnostic by connection with computer and easy to correct it in case of system error and easy to up-grade system. 4-2 Qray-FRX adopts an independent operation module respectively Therefore even though 4 2. Qray FRX adopts an independent operation module respectively. Therefore, even though one is not working the other is not affected.

22 Fractional & IR + RF system Combine these treatments for an optimum result you can be very with and be proud to show off your new face.!! CO 2 Fractional IR+RF Ablation Non-ablation Synergy Effect CO 2 Fractional IR+RF Q-ray FRX 5 Scan Mode & High beam Quality Dual RF bipolar Ablation & Non-ablation Harmony

23 Clinical Photos Before After 2 treatments by CO 2 fractional & IR+RF treatment

24 Clinical Photos Before 5 days after 1 treatment by CO 2 fractional & IR+RF

25 Clinical Photos Right after treatment 4 days after 1 treatment by CO2 fractional

26 Clinical Photos Before 3 weeks after 3 treatments by only IR + RF

27 Clinical Photos Before 4 days after 1 treatment by CO2 fractional & IR+RF

28 Clinical Photos Before 4 days after 1 treatment by CO2 fractional & IR+RF

29 Fractional & IR + RF system