Ultra Pro & Ultra Pro Lo Kick Scooters

Transcription

1 Ultra Pro & Ultra Pro Lo Kick Scooters Owner s Manual Read and understand this entire manual before allowing child to use this product! For assistance contact Razor. DO NOT RETURN TO STORE. NOTE: Manual illustrations are for demonstration purposes only. Illustrations may not reflect exact appearance of actual product. Specifications subject to change without notice. Version 1_01_10 Item Number: Ultra Pro Ultra Pro Lo

2 Contents Safety Warnings... 1 Before you begin... 2 Assembly Instructions... 2 Check Before Riding... 3 Safety Tips... 4 Warranty... 4 Safety Warnings AN IMPORTANT MESSAGE TO PARENTS: This manual contains important information. For your child s safety, it is your responsibility to review this information with your child and make sure that your child understands all warnings, cautions, instructions and safety topics. Razor USA recommends that you periodically review and reinforce the information in this manual with younger riders and that you are reuired to inspect and maintain your child s scooter to insure their safety. GENERAL WARNING: Scooter riding can be a hazardous activity. Scooters can, and are intended to move and it is therefore possible to get into dangerous situations and/or lose control and/or fall. If such things occur you can be seriously injured or die. LIKE ANY OTHER MOVING PRODUCT, USING A SCOOTER CAN BE A DANGEROUS ACTIVITY AND MAY RESULT IN INJURY OR DEATH EVEN WHEN USED WITH PROPER SAFETY PRECAUTIONS. USE AT YOUR OWN RISK AND USE COMMON SENSE. Always wear safety euipment such as helmet, knee pads and elbow pads. Always wear a helmet when riding your scooter and keep the chinstrap securely buckled. Always wear shoes. Ride on smooth, paved surfaces away from motor vehicles. Avoid sharp bumps, drainage grates, and sudden surface changes. Scooter may suddenly stop. Avoid streets and surfaces with water, sand, gravel, dirt, leaves, and other debris. Wet weather impairs traction, braking, and visibility. Do not ride at night. Brake will get hot from continuous use. Do not touch after braking. Avoid excessive speed associated with downhill rides. Adults must assist children in the initial adjustment procedures to assemble the scooter. Obey all local traffic and scootering laws and regulations. Watch out for pedestrians. Check and secure all fasteners before every ride. Replace worn or broken parts immediately. Do not exceed 220 pounds (100 kilograms) on the Ultra Pro and Ultra Pro Lo scooters. Do not allow children under age eight (8) to use the Ultra Pro scooter. All children and preteens should ride with adult guidance at all times. Rider weight does not necessarily mean a child s size is appropriate to fit or maintain control of the scooter. A parent s decision to allow his or her child to ride this product should be based on the child s maturity, skill and ability. This scooter was manufactured for performance and durability but it is not impervious to damage. Trick riding can over stress or damage any product, including this scooter, and the rider assumes all risks associated with high-stress activity. ACCEPTABLE RIDING PRACTICES AND CONDITIONS Direct parental supervision is reuired. Scooters are meant to be used only in controlled environments free of potential traffic hazards and not on public streets. Do not allow your child to ride a scooter in any areas where vehicle traffic is present. Child must maintain a hold on the handlebars at all times. Never allow more than one child at a time to ride a scooter. Never use near steps, sloped driveways, hills, roadways, alleys or swimming pool areas. Do not ride a scooter in wet weather. Scooters are intended for use on solid, flat, clean and dry surfaces such as pavement or level ground without loose debris such as rocks or gravel. Wet, slick or uneven and rough surfaces may impair traction and contribute to possible accidents. Do not ride a scooter in mud, ice, puddles or water. Avoid excessive speeds that can be associated with downhill rides. Never risk damaging surfaces such as carpet or flooring by use of a scooter indoors. Do not ride at night or when visibility is impaired. PROPER RIDING ATTIRE Always ensure child is wearing proper protective euipment such as an approved safety helmet. A helmet may be legally reuired by local law or regulation in your area. A child should always wear shoes, never ride barefooted or in sandals, and keep shoelaces tied and out of the way of the wheels. FAILURE TO USE COMMON SENSE AND HEED THE ABOVE WARNINGS FURTHER INCREASES RISK OF SERIOUS INJURY. USE AT YOUR OWN RISK AND WITH APPROPRIATE AND SERIOUS ATTENTION TO SAFE OPERATION. USE CAUTION. WARNING: ALWAYS INSPECT SCOOTER PRIOR TO RIDING. Properly inspecting and maintaining your scooter can reduce the risk of injury. Always inspect your scooter before riding and regularly maintain it. WARNING: CHECK LOCAL LAWS REGARDING SCOOTER USE. Check local laws and regulations to see where and how you may use your Razor scooter legally. In many states and local areas scooter riders are reuired BY LAW to wear a helmet. Check local laws and regulations regarding laws governing helmet use and scooter operation in your area. 1

3 Before You Begin Remove contents from box. Inspect the contents of the box for scratches in the paint and/or dents that may have occurred during shipping. Because your scooter was partially assembled and packed at the factory, there should not be any problems, even if the box has a few scars or dents. Grip T-tube/ Steering column Handlebar WARNING: DO NOT USE NON-RAZOR PRODUCTS WITH YOUR SCOOTER. Razor scooters have been built to certain Razor design specifications. The original euipment supplied at the time of sale was selected on the basis of its compatibility with the frame, fork and all other parts. Certain aftermarket products may or may not be compatible. Rigid down tube Collar clamp Rear fender/brake Fork headset locknut Front fork Deck Wheels and wheel bearings Reuired Tools 5mm Allen wrench Assembly instructions WARNING: Failure to properly install and tighten the collar clamp may cause the rider to lose control and fall. If you do not understand these instructions or the concept of tighten securely seek the assistance of a ualified mechanic. 1 Loosen the collar clamp and slide it upward. With a clock-wise twisting motion, push and thread the T-tube onto the fork until it bottoms out on the fork headset lock nut. 2 With the front wheel pointed straight ahead, the handlebars suare to the front wheel and the Razor Logo facing the front, tighten the clamp as shown. Tighten securely. 2

4 Check before riding Collar Clamp Using a 5mm allen wrench, check that the collar clamp bolt is tightened securely. Wheels and Bearings Under normal circumstances and conditions, Razor wheels and wheel bearings are maintenance free. Nonetheless, it is the responsibility of the owner or guardian to periodically inspect the wheels for wear and tear, the axle for proper tightness and bearings for side-to-side play and loose parts. When a wheel or wheel bearing develops play, this is an indication of excess wear and replacement is necessary. Replace immediately with only genuine Razor wheels. Worn wheels/bearings are considered normal wear-and-tear and are not covered by the Razor Warranty. Wheels other than genuine Razor wheels may not be compatible with your Razor scooter. The use of anything other than genuine Razor replacement parts may affect your safety and will void your warranty. Cleaning Your Scooter Wipe with a damp cloth to remove dirt and dust. Do not use industrial cleaners or solvents as they may damage the surfaces. Do not use alcohol, alcohol-based or ammonia-based cleaners as they may damage or dissolve the plastic components or soften the decals or decal adhesive. How to Ride Place one foot on the baseboard, push forward with the other foot. Steer. For enhanced cornering, lean slightly into the direction of the turn. For controlled stops, apply the brake by stepping on the rear fender/brake. Razor recommends that you practice applying the brake at various speeds and in an open area free from obstructions before riding your Razor around others. WARNING: Wheelies and other stunt-type riding reduces your ability to maneuver and control your scooter. Take the necessary precautions, such as wearing appropriate protective gear and practice in an area safe for stunt riding and free from obstructions. 3

5 Safety reminders Loose Parts Check and secure all fasteners before every ride. Make sure the collar clamp is locked properly in place before riding. Replacement Parts Replace worn or broken parts immediately. Visit for replacement parts. Safety Gear Always wear proper protective euipment such as an approved safety helmet, elbow pads and kneepads. Always wear shoes (lace-up with rubber soles), never ride barefooted or in sandals, and keep shoelaces tied and out of the way of the wheels. PRE-RIDE CHECKLIST Be Careful! You will see people on TV and maybe even people you know doing tricks and stunts. These are people who have been practicing on scooters for a very long time. Don t try something until you are ready. Avoid steep inclines and don t ride too fast you can lose control and fall. Skateboard parks are not designed for scooters. Never ride in traffic or on the street and watch your surroundings for pedestrians, bikers, boarders and skaters. Maintain a hold on the handlebars at all times. DO NOT RETURN TO STORE Failure to follow these instructions may damage your product and void your warranty. Warranty Razor Limited Warranty The manufacturer warranties this product to be free of manufacturing defects for a period of 6 months from date of purchase. This Limited Warranty does not cover normal wear and tear, or any damage, failure or loss caused by improper assembly, maintenance, or storage. This Limited Warranty will be void if the product is ever used in a manner other than for recreation; modified in any way; rented. The manufacturer is not liable for incidental or conseuential loss or damage due directly or indirectly to the use of this product. Razor does not offer an extended warranty. If you have purchased an extended warranty, it must be honored by the store at which it was purchased. For your records, save your original sales receipt with this manual. Item Number: Ultra Pro Ultra Pro Lo Printed in China for: Razor USA LLC PO Box 3610 Cerritos, CA Copyright Razor USA, LLC. All rights reserved. RAZOR and the Razor Logo Design are among the registered trademarks of Razor USA LLC in the United States and/or select foreign countries. Ultra Pro and Ultra Pro Lo are trademarks of Razor. 4 01/2010